Search NASA⌕ Search

NASA NTRS · 20230014111

Assessing Helicopter Pilots’ Detect and Avoid and Collision Avoidance Performance with ACAS Xr

Abstract

The latest variant of the Federal Aviation Administration’s Airborne Collision Avoidance System (ACAS X) is being designed for both crewed and uncrewed rotorcraft. Referred to as ACAS Xr, the system joins a suite of other ACAS X variants poised to replace the Traffic Alert and Collision Avoidance System (TCAS II). ACAS Xr is tuned to support current-day helicopter platforms as well as electric Vertical Takeoff and Landing (eVTOL) vehicles that are still under development. Given this flexibility, ACAS Xr may be used by helicopter crews currently in operation or by remotely-operated eVTOL aircraft in the emerging Advanced Air Mobility (AAM) market. To cover the range of potential uses, two distinct configurations are being proposed for ACAS Xr: Collision Avoidance System (CAS) and Detect and Avoid (DAA). Under the CAS configuration, ACAS Xr provides minimal caution-level alerting but issues directive warning-level alerting and guidance. The DAA configuration, by contrast, provides caution-level alerting and guidance, in addition to the warning-level alerting and guidance. The current study was performed as part of the National Aeronautics and Space Administration’s AAM project. Six helicopter pilots were recruited to fly a variety of scripted traffic scenarios in a full-motion, crewed eVTOL simulator. Participants flew 60 encounters over two days, reacting to pre-recorded intruder aircraft that were scripted to fly into the participant’s aircraft from different approach angles, relative altitudes, and during different phases of flight. The pilots flew half of the encounters with the CAS configuration and half with the DAA configuration. Within each block of 30 encounters, pilots experienced 10 conflicts while in cruise, 10 in hover, and 10 while on approach to a heliport. Results showed that pilot response times were consistently under 5 seconds for RAs and under 10 seconds for DAA alerts, when present, during all three phases of flight. Unsurprisingly, the DAA configuration was associated with lower rates of en-route and high-severity losses of DAA well clear compared to the CAS configuration in all phases of flight except for the terminal area. Rates of losses of DAA well clear were found to be substantially higher in the Hover scenario, compared to Cruise. Pilots failed to fully comply with RAs at a rate of 0.10-0.18 in all conditions except for the DAA configuration in the Hover scenario, which was associated with a higher non-compliance rate of 0.4 due to Descend RAs issued at low altitudes. The implications of these results with regards to the ongoing development of ACAS Xr is discussed.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R Conrad Rorie, Casey L Smith, Megan Mitchell, Christian Schmitz. Assessing Helicopter Pilots’ Detect and Avoid and Collision Avoidance Performance with ACAS Xr. https://ntrs.nasa.gov/citations/20230014111

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

ACAS Xr Part Task Sim, Preliminary Experiment Design

In early 2022, the Human Autonomy Teaming Lab (NASA Ames Research Center) will conduct a manned, human-in-the-loop (HITL) simulation. This part task HITL will begin the lab’s Hazard Perception and Avoidance (HPA) technical work under NASA’s Advanced Air Mobility (AAM), Automated Flight and Contingency Management (AFCM) Sub-Project. The goals will be to assess levels of automation for manned, electric vertical takeoff and landing (eVTOL) aircraft. This simulation will test manual and automated Resolution Advisory (RA) responses and return-to-course (RTC) maneuvers for the first version of the Airborne Collision Avoidance System’s (ACAS) rotary-wing (Xr) variant. This will be conducted on a fixed-based simulator designed to fly eVTOL aircraft while maneuvering for intruding traffic. Variables for this study include levels of autonomy (i.e., manual and automated) as well as the types of alerts at the onset of conflicts (i.e., Corrective and RA). The data collected will include response times, losses of well clear, and maneuver sizes and durations as well as subjective ratings like acceptability, perceived workload, and meaningful human control. Additional details and future anticipations are also discussed.

air taxis↗

Hazard Perception & Avoidance (HPA): Part Task 1 - Results Outbrief

n April 2022, the Human Autonomy Teaming Lab (NASA Ames Research Center) conducted a manned, human-in-the-loop (HITL) simulation. This part task HITL began the lab’s Hazard Perception and Avoidance (HPA) technical work under NASA’s Advanced Air Mobility (AAM), Automated Flight and Contingency Management (AFCM) Sub-Project. The goals were to assess levels of automation for manned, electric vertical takeoff and landing (eVTOL) aircraft. This simulation tested manual and automated Resolution Advisory (RA) responses and return-to-course (RTC) maneuvers for the first version of the Airborne Collision Avoidance System’s (ACAS) rotary-wing (Xr) variant. This was conducted on a fixed-based simulator designed to fly eVTOL aircraft while maneuvering for intruding traffic. Variables for this study included levels of autonomy (i.e., manual and automated) as well as the types of alerts at the onset of conflicts (i.e., Corrective and RA). The data collected included response times, losses of well clear, and maneuver sizes and durations as well as subjective ratings like acceptability, and perceived workload. Additional details and future anticipations are also discussed.

air taxis↗

Assured Vehicle Automation 1 Sim - Results Outbrief

In early 2022, the Human Autonomy Teaming Lab (NASA Ames Research Center) conducted a manned, human-in-the-loop (HITL) simulation. This part-task HITL began the lab’s Hazard Perception and Avoidance (HPA) technical work under NASA’s Advanced Air Mobility (AAM), Automated Flight and Contingency Management (AFCM) Sub-Project. The results of that sim guided the objectives of the current study, which were to examine pilots’ use of the Airborne Collision Avoidance System (ACAS) rotorcraft variant (Xr) v2 in multiple phases of flight with two separate Xr Modes, fully leverage Xr v2 features (e.g., use radar altimeter data to inform low altitude Resolution Advisory [RA] behavior, utilize the ability to designate “terminal-area intruders,” and display airspeed-based Detect and Avoid [DAA] guidance), emulate a “Traffic Advisory” (TA), and present Xr in a higher-fidelity environment. Therefore, this study was conducted in the Vertical Motion Simulator, and the variables included Phase of Flight (En-route, Hover, and Approach) as well as ACAS Xr Mode (TA/RA and DAA). The data collected included response times, losses of well clear, and maneuver sizes and durations as well as subjective ratings like acceptability and usability. Additional details and future anticipations are also discussed.

air taxis↗