Basic Research in Functional Ceramics for Power and Energy Applications

The crack initiation of nuclear fuel pellets, driven by extreme temperature gradients, is a critical factor impacting reactor performance. Although this fact is widely acknowledged, there is limited fracture toughness data for specimens with representative geometry and fabricated using relevant processing methods. Here, to address this, a new chevron-notched short-rod specimen configuration with diameter and length both equal to 10 mm, representative of a conventional fuel pellet and tested in tension, was developed in an attempt to validly measure Mode I fracture toughness, K Ic . Test calibration was carried out by testing polycrystalline ZrO 2 , SiC, and Si 3 N 4 ceramics fabricated with conventional fuel pellet geometry and known fracture toughnesses. The results suggest that the method described in this paper produces valid K Ic measurements using conventional ceramic fuel pellets.

Ceramics↗

DOE OSTI2025

Strength and thermal shock resistance of porous reaction-bonded silicon nitride by direct nitriding of binder jet additively manufactured silicon

The direct nitridation of binder jet additively manufactured silicon to produce porous silicon nitride was explored. The Taguchi Design of Experiments method was used to systematically study the effect of time, temperature, and nitrogen flow rate on the direct nitriding of binder jet additively manufactured silicon to produce porous reaction-bonded silicon nitride (RBSN). Highly porous (61%) samples with high conversion (99%) to silicon nitride were achieved using a thermal profile that utilized two isothermal holds. Further, it was shown that these samples exhibited thermal shock resistance and a low coefficient of thermal expansion. These results indicate that RBSN is readily achievable through additive manufacturing.

Ceramics↗

NASA NTRS2019

Slow Crack Growth of Boron Nitrides for Electric Propulsion Components

The Deep Space Gateway requires thruster systems to maintain spatial position. One control system being considered involves Hall thrusters. Historically, Hall thruster discharge channels have used several grades of hot-pressed hexagonal boron nitride. This study compliments data presented at ICACC (International Conference and Expo on Advanced Ceramics and Composites) 2018 and investigates the fracture toughness and slow crack growth parameters of several commercially available boron nitride grades including HP, M, M26, and Shapal Hi-M. The prior work revealed that some grades of BN absorb water and change strength thus presenting a philosophical conundrum on crack growth test methods. Advantages of different test methods will be discussed. The grades selected for this study are of interest because their available billet size is sufficient for Hall thruster discharge channels, or because they have heritage in Hall thruster applications. Ultimately, the data will be used to perform material selection, system design and reliability analyses.

Ceramics↗