Technical Notes: Theodorsen’s and Garrick’s Flutter Calculations: Revisited

As NASA prepares to launch ICESAT-II there are significant efforts underway to plan for aircraft under-flights to calibrate the onboard lasers and to validate data products. This presentation will begin with an overview of recent airborne science missions including Operation Ice Bridge that have focused observations on the arctic. This will be followed by results from recent NASA sponsored unmanned aircraft missions and a discussion how these new observing technologies can contribute to future research in the Arctic. Information on recent icing wind tunnel testing and comparisons with icing prediction models will also be shared leading to discussions on specific challenges in adapting systems to harsh arctic conditions.

Aircraft↗

NASA NTRS2018

Further Examinations of Bimodal SLD Ice Accretion in the NASA Icing Research Tunnel

An ice shape database has been created to document ice accretions on a 72-inch chord NACA 23012 airfoil model resulting from an exposure to a Supercooled Large Drop (SLD) icing cloud with a bimodal drop size distribution. The ice shapes created were documented with photographs, laser scanned surface measurements over a section of the model span, and measurement of the ice mass over the same section of each accretion. The icing conditions used in the test matrix were based upon previously measured ice shapes on the same model to connect the current database to previously measured information. Ice shapes resulting from the bimodal distribution as well as from equivalent mono-modal drop size distributions were obtained and compared. Results indicate that the ice shapes resulting from the bimodal drop size distributions had higher mass and volume values than their mono-modal distribution equivalents as well as having icing limits that extended further back on the chord of the model.

Aircraft↗

NASA NTRS2016

Cooling of Electric Motors Used for Propulsion on SCEPTOR

Benefits of Electric Power: Reduced energy consumption, Lower emissions, Less noise. Traction motors: Permanent magnet, Synchronous, High torque at low rotational speeds, High power density, (High concentration of heat). Annular inlet: Very compatible with PM motors, (Provides cooling where needed, No need for complicated ducting, Leads to a larger motor diameter which is beneficial for motor torque) Effect of prop wash on heat transfer coefficients: Assumed propeller induced turbulence would increase heat transfer coefficients, Holmes, Obara Yip reported 'propeller slipstream showed little if any apparent effect of the slip stream', Derlaga @ LaRC also found little change in heat transfer in the wake of the propeller.

Aircraft↗