Progress Report on Graphite-Salt Intrusion Studies

Abstract

The document reports on the design, construction, testing and initial operation of the ORNL graphite intrusion system with pressurized molten salts. This technical memorandum is responsive to work package AT-20OR04060203, “Graphite-Salt Studies” —ORNL”, and fulfills Milestone M3AT20OR040602035 “Report on graphite-salt intrusion studies”.The report outlines the procedure of graphite intrusion experiments, which follows the ASTM standard guidance, and the procedures of other characterization measurements of graphite physical properties, also based on ASTM standard methods. A set of 12 graphite grades of various origin and properties went through preliminary characterizations, and six of them were further selected for intrusion experiments with molten FLiNaK. The results are discussed in the context of graphite physical properties and are compared with a several results from literature. The correlation between molten salt impregnation and mercury intrusion, first proposed by MSRE scientists, is discussed in detail. Pending collection of more data, the mercury intrusion porosimetry technique may possibly be used as a rapid method for screening and down selection of graphite grades with extremely low salt intrusion, as required for operation in molten salt reactors. This new system will generate data non only on intrusion behavior, but will also generate a wide range of salt- impregnated graphite samples that will be further analyzed with advanced characterization techniques for better understanding of the effect of salt intrusion on the properties of nuclear graphite. It expected that these results and future results obtained with this system will help advance our understanding of the factors controlling the extent of salt penetration in graphite and of the relationship with intrinsic structural properties of various grades. Together, correlating direct measurements results and graphite structural properties should allow development of a predictable model that could be used for selection and qualification of optimal graphite grades, tailored to design operation conditions and molten salt properties.