Search NASA⌕ Search

DOE OSTI · 1669204

Hanging String Cuts in SPR Caverns: Modeling Investigation and Comparison with Sonar Data

Abstract

Investigation of leaching for oil sales includes looking closely at cavern geometries. Anomalous cavern "features" have been observed near the foot of some caverns subsequent to partial drawdowns. One potential mitigation approach to reducing further growth of preexisting features is based on the hypothesis that reducing the brine string length via a "string cue' would serve to move the zone associated with additional leaching to a location higher up in the cavern and thus away from the preexisting feature. Cutting of the hanging string is expected to provide a control of leaching depth that could be used to "smooth" existing features and thus reduce geomechanical instability in that region of the cavern. The SANSMIC code has been used to predict cavern geometry changes (i.e., the extent of cavern growth with depth) based on variable input parameters for four caverns: West Hackberry 11 (WH11), West Hackberry 113 (WH113), Big Hill 104 (BH104), Big Hill 114 (BH114). By comparing the initial sonar geometry with resultant geometries calculated by the SANSMIC code, conclusions may be drawn about the potential impact of these variables on future cavern growth. Ultimately, these conclusions can be used to assess possible mitigation strategies such as the potential advantage of cutting versus not cutting a brine string. This work has resulted in a recommendation that a hanging string cut of 80 ft in WH11 would be beneficial to future cavern geometry, while there would be little to no benefit to string cuts in the other three caverns investigated here. The WH11 recommendation was followed in 2019, resulting in an operational string cut. A sonar performed after the string cut showed no adverse leaching in the area of the preexisting flare, as expected from the results of the preliminary SANSMIC runs described in this report. Additional SANSMIC modeling of the actual amount of injected raw water resulted in good agreement with the post-cut sonar.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Zeitler, Todd, Chojnicki, Kirsten. 2020-09-01. Hanging String Cuts in SPR Caverns: Modeling Investigation and Comparison with Sonar Data. https://doi.org/10.2172/1669204

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Carbon Capture and Utilization for Protein and Fatty Acids

The unlimited release version of the final report for the "Carbon Capture and Utilization for Protein and Fatty Acids" project. This project advanced an integrated open raceway algae cultivation and processing system to engineering scale for carbon capture and utilization (CCU) from the flue gas of a naphtha-fired power plant.

02 PETROLEUM↗

Oil in Alaska North Slope Gas Hydrate Reservoir: Micro-CT and Flow Simulation Insights into Permeability

Gas hydrate-bearing sands on the Alaska North Slope (ANS) host minor volumes of crude oil whose impact on formation permeability has never been quantified relative to a gas hydrate reservoir system. Here, we combine in situ pressure-core microcomputed-tomography (μ-CT), thermogravimetric analysis (TGA), gas-chromatography–mass-spectrometry (GC–MS), scanning-electron microscopy coupled with energy-dispersive spectroscopy (SEM-EDS), and Stokes-flow simulation to (i) quantify oil saturation, (ii) infer its source, and (iii) evaluate its influence on permeability after gas-hydrate dissociation. μ-CT and SEM-EDS imaging identify the host sediment as silty, with some grain-coating clay present. Eight representative 3003-voxel subvolumes extracted from a preserved pressure core (Core 15P-3c, from the B1 sand (unit B), HYDRATE 02 Geo Data Well (GDW), 886.96–887.29 m measured depth, MD) exhibit porosities of 0.34–0.37 and an average oil saturation of 0.09 ± 0.03, in comparison to an independent TGA-based estimate of 0.16. GC-MS fingerprints obtained from an adjacent depressurized core (Core 17P-1, 891.37–891.44 m MD), together with oil pore habit revealed by μ-CT, suggest that the oil is partly native but also includes contributions from mineral oil-based drilling fluid contamination. Further analysis of oil–porewater interactions and flushing tests confirms that native oil saturation in the analyzed samples ranges from 0.04 to 0.08 with an average of approximately 0.06, and the oil is highly immobile. Flow simulations demonstrate that the native oil saturation of ≈0.06 reduces permeability by approximately 50% due to both pore blockage and increased flow-path tortuosity. These findings reveal the potential presence of native oil within the ANS gas hydrate reservoir and suggest that future simulation models may need to account for its impact on permeability to improve long-term performance predictions of gas and water production.

02 PETROLEUM↗

Quantum Enhanced Fiber Sensing for Oil and Gas Applications (Final Technical Report)

The major goal of the project was to develop a quantum sensing approach compatible with current infrastructure in the oil and gas industry that could provide a quantum enhancement, with a focus towards pipeline leak detection. The proposed approach to achieving this goal consisted of the use of quantum states of light to enhance the sensitivity of fiber optic sensors beyond the classical limit. To address the limitations of existing commercial leak detection, the project focused on the study of two technologies: distributed acoustic sensors (DAS) and fiber Bragg grating (FBG)-based sensors. The initial phase of the project centered around the identification and mitigation of dominant sources of classical noise to enable operation at the classical shot noise limit (SNL). The second phase focused on the use of quantum resources to obtain sensitivities beyond the classical SNL. The final phase sought to combine quantum noise reduction techniques with advanced dynamical classical noise cancelation approaches.

02 PETROLEUM↗