Copper Dendrites and Surface Engineering for Enhanced CO2 Reduction Research Report Paper

Abstract

The electrocatalytic reduction of CO 2 (CO 2 R) into hydrocarbon fuels, such as ethylene and ethanol, provides an attractive pathway towards closing the industrial carbon cycle and producing chemicals using renewable electricity. Existing CO 2 R technologies can exhibit C 2+ product selectivity above 74% and operating current densities over 1.3 A/cm 2 , but none can achieve both simultaneously, limiting the commercial viability and scalability of this technology. Low CO 2 concentrations at the catalyst surface and competing side reactions such as the hydrogen evolution reaction (HER) inhibit C 2+ faradaic efficiencies and operational current densities. Additionally, the use of high surface area cathode geometries to increase operational current densities is under-investigated. In this work, we electrodeposit a macroporous copper dendrite film to form high surface area cathodes. These structures are then coated with a combination of hydrophobic/hydrophilic ionomers to achieve high electrochemically active surface areas (ECSA), form regions of intrinsic porosity, and maximize catalytic availability of CO 2 . Using these techniques, we hope to maximize C 2+ faradaic efficiencies (FE) and geometric partial current densities. The treated cathode compound macrostructure (~10μm-sized pores, and ~μm-long dendrites) and concomitant surface area allows increased geometric current densities while the ionomer coating simultaneously inhibits HER and increases hydrogen availability to improve C 2+ selectivity. Our results show that careful engineering of the catalyst-electrolyte interface can enhance CO 2 reduction product selectivity and efficiency.