NRC Multiphysics Analysis Capability Deployment (FY2020--Part 3)

Abstract

This report details progress and activities of Idaho National Laboratory (INL) on the NRC project ”Development and Modeling Support for Advanced Non-Light Water Reactors.” The tasks completed for this report are as follows: First, Task 2c: Explicit modeling of pebble transient temperature response. In this simulation, the PBMR-400 reactor experiences a 20 second power ramp from 100% to 150% power. This is followed by a similar reduction in the power back to 100%. Several multiscale pebble coupling approaches are tested with one pebble per mesh element in the active core region. The results show good conservation behavior and the stability of the coupling. Next, Extended scope part 1: An assessment of the computational efficiency of the DFEM heat transfer solver shows good scalability. The DFEM solver is a factor of 4 more expensive in solution time than the FEM solver for heat transfer problems due to the increased number of degrees of freedom. Nonetheless, the DFEM approach provides the user with the flexibility to model gap heat transfer problems. Then Extended scope part 2: the GapHeatTransferInterfaceMaterial was improved to give the user increased flexibility with the modeling of heat transfer through gaps with the DFEM solver. A number of gap parameters can now be coupled both through functions and variables. Finally, Extended scope part 3: demonstration of how the gap width between hexagonal fuel cells can be calculated during a heat up transient and used in the GapHeat- TransferInterface model. A full domain DFEM model with gap expansion is coupled to a SubApp that models the thermal expansion of the base plate. The results show the expected physical behavior, although have not been fully bench- marked at this point in time.