Search NASA⌕ Search
Home/Archive/DOE OSTI

DOE OSTI · 1991236

Nuclear Structure and Decay Data for A=44 Isobars

Chen, Jun·Singh, Balraj
View original source ↗Read source document ↗Export metadata ↓

Abstract

Experimental nuclear spectroscopic data are evaluated for 12 known nuclides of mass number A=44 (Si, P, S, Cl, Ar, K, Ca, Sc, Ti, V, Cr, Mn). Detailed evaluated information are presented for each reaction and decay. Recommended values combining all available data are provided for all spectroscopic properties of each level, γ-ray, and decay radiation. No excited states have yet been identified in 44 Si, 44 P, 44 Cr, and 44 Mn. Information for excited states in 44 Cl and 44 V are limited. Nuclides of 44 S, 44 Ar and 44 K have been studied via only a few reactions and decays, while 44 Ca, 44 Sc and 44 Ti are the most investigated nuclides through various reactions and decays. Evaluators note that the half-life of the g.s. of 44 S has been measured independently, with fairly good statistics, in three references, most precise being 100 ms 1 by 2004Gr20, but this value is in disagreement with the values of 125.5 ms 25 and 119 ms 6 by 2022Tr03, and 123 ms 10 by 1995So03. We adopted the unweighted average of this discrepant dataset. Another outstanding issue is that of the β + -delayed proton decay of 44 Cr g.s. to 44 V, where the T=2, 0 + IAS state in 44 V is expected to be strongly populated by a superallowed β transition, but has not been definitely identified as discussed in detail by 2020Fu05. A detailed study of 44 Cr decay is required to unravel the status of the T=2, 0 + IAS state in 44 V. Furthermore, this work supersedes earlier ENSDF evaluations of A=44 by 2011Ch39 and 1999Ca45.

Explore related subjects

73 NUCLEAR PHYSICS AND RADIATION PHYSICS

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Chen, Jun, Singh, Balraj. 2023-07-07. Nuclear Structure and Decay Data for A=44 Isobars. https://doi.org/10.1016/j.nds.2023.06.001

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

DOE OSTI2026

Design-informed neutronics assessment of long-lived fission product transmutation in a tokamak fusion reactor blanket

This study presents a neutronics-based assessment of the feasibility and viability of transmuting six major long-lived fission products (LLFPs) from light-water reactors, namely 99 Tc, 129 I, 79 Se, 93 Zr, 126 Sn, and 135 Cs, within the blanket region of a tokamak fusion reactor, using the MIT ARC design as a concrete fusion configuration. Monte Carlo neutronics simulations were performed to evaluate LLFP transmutation and to compare the results with a reference boiling water reactor (BWR). The results indicate that transmutation of all six LLFPs is neutronics-feasible in fusion reactors, with transmutation half-lives significantly shorter than their natural decay half-lives. For elemental targets, transmutation of 135 Cs, 126 Sn, and 93 Zr was found potentially viable, as the net mass transmuted exceeded that achievable in the reference BWR under identical target volume and irradiation time. When isotopically separated targets were considered, transmutation of 126 Sn and 93 Zr appeared potentially viable. A parametric study demonstrated that plasma geometry modifications can enhance local neutron flux, increasing the transmuted 93 Zr mass by approximately 33% and reducing the transmutation half-life from approximately 240 years to 180 years. Repositioning the target and adjusting material layer thickness reduced the transmutation half-life of 93 Zr to 67 years and increased the net mass transmuted by a factor of 50. Furthermore, these results demonstrate that fusion reactors can enable LLFP transmutation beyond the practical limits of thermal fission reactors and highlight the critical role of reactor and blanket design optimization. Engineering and fuel-cycle considerations required for deployment are beyond the scope of this neutronics-focused study.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2026

A hybrid Monte Carlo-deterministic second moment method with efficient variance reduction

In this work, we present a hybrid method that combines Monte Carlo with deterministic finite element methods to solve a linear Boltzmann transport equation. Our hybrid method runs orders of magnitude faster than Monte Carlo, without sacrificing accuracy, for a proxy problem from radiative transfer that contains both optically-thick and optically-thin material. We believe that this is the first demonstration of a hybrid Second Moment Method in more than one spatial dimension, the first to consider more than one material, and the first to use variance reduction. Our variance reduction approach arises from an asymptotic analysis in which we show that the magnitude of the scattering source grows without bound. We transform the problem to compute the deviation of the radiation intensity from isotropy. The magnitude of the source in the transformed problem is bounded, and the quality of the hybrid method solution is dramatically improved by a substantial reduction in the variance.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗