Search NASA⌕ Search

DOE OSTI · 22572384

Nuclear Data Sheets for A = 79

Also available from

Abstract

Nuclear spectroscopic information for known nuclides of mass number 79 (Ni,Cu,Zn,Ga,Ge,As,Se,Br,Kr,Rb, Sr,Y,Zr) has been evaluated and presented together with adopted energies, Jπ, and decay modes of levels in these nuclei. No data are yet available for excited states in {sup 79}Ni, {sup 79}Cu and {sup 79}Zr. The half–life of {sup 79}Se, a nuclide of importance in reactor–irradiated fuel composition has been measured by several independent groups and reported in a number of publications after 1995, and seems to be converging to a narrow margin of experimental values. These measurements were likely prompted by a recommendation made in the 1993 update of A = 79 nuclides (1993Si28), that since a 1949PaZZ report, there had been no measurement until 1993, and that based on simulation studies by 1993HeZW, the value listed in 1949PaZZ, and cited in all data tables and charts for 44 years, was quite likely in error, being too low by a factor of 10. According to conclusions in recent papers such as 2014Do20, there is still room for improvement in the measurement of this half–life, and further experiments are expected. This evaluation supersedes earlier Nuclear Data Sheets for A = 79 (2002Si13,1993Si28, 1982Si21,1975Ur03).

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Singh, Balraj. 2016-07-15. Nuclear Data Sheets for A = 79. https://doi.org/10.1016/j.nds.2016.06.002

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Design-informed neutronics assessment of long-lived fission product transmutation in a tokamak fusion reactor blanket

This study presents a neutronics-based assessment of the feasibility and viability of transmuting six major long-lived fission products (LLFPs) from light-water reactors, namely 99 Tc, 129 I, 79 Se, 93 Zr, 126 Sn, and 135 Cs, within the blanket region of a tokamak fusion reactor, using the MIT ARC design as a concrete fusion configuration. Monte Carlo neutronics simulations were performed to evaluate LLFP transmutation and to compare the results with a reference boiling water reactor (BWR). The results indicate that transmutation of all six LLFPs is neutronics-feasible in fusion reactors, with transmutation half-lives significantly shorter than their natural decay half-lives. For elemental targets, transmutation of 135 Cs, 126 Sn, and 93 Zr was found potentially viable, as the net mass transmuted exceeded that achievable in the reference BWR under identical target volume and irradiation time. When isotopically separated targets were considered, transmutation of 126 Sn and 93 Zr appeared potentially viable. A parametric study demonstrated that plasma geometry modifications can enhance local neutron flux, increasing the transmuted 93 Zr mass by approximately 33% and reducing the transmutation half-life from approximately 240 years to 180 years. Repositioning the target and adjusting material layer thickness reduced the transmutation half-life of 93 Zr to 67 years and increased the net mass transmuted by a factor of 50. Furthermore, these results demonstrate that fusion reactors can enable LLFP transmutation beyond the practical limits of thermal fission reactors and highlight the critical role of reactor and blanket design optimization. Engineering and fuel-cycle considerations required for deployment are beyond the scope of this neutronics-focused study.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

A hybrid Monte Carlo-deterministic second moment method with efficient variance reduction

In this work, we present a hybrid method that combines Monte Carlo with deterministic finite element methods to solve a linear Boltzmann transport equation. Our hybrid method runs orders of magnitude faster than Monte Carlo, without sacrificing accuracy, for a proxy problem from radiative transfer that contains both optically-thick and optically-thin material. We believe that this is the first demonstration of a hybrid Second Moment Method in more than one spatial dimension, the first to consider more than one material, and the first to use variance reduction. Our variance reduction approach arises from an asymptotic analysis in which we show that the magnitude of the scattering source grows without bound. We transform the problem to compute the deviation of the radiation intensity from isotropy. The magnitude of the source in the transformed problem is bounded, and the quality of the hybrid method solution is dramatically improved by a substantial reduction in the variance.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗