Search NASA⌕ Search

DOE OSTI · 2282641

Nuclear Data Sheets for A=24

Abstract

Here, evaluated spectroscopic data and level schemes from radioactive decay and nuclear reaction studies are presented for 24 N, 24 O, 24 F, 24 Ne, 24 Na, 24 Mg, 24 Al, and 24 Si. This evaluation for A=24 supersedes the earlier one by R. B. Firestone (2007Fi14). Highlights of this evaluation are the following: In 24 O, the 7.4- and 7.65-MeV groups reported in 1 H( 24 O,p') (2012Ts03) and 9 Be( 26 F,nX) (2011Ho05), respectively, are considered as separate states in this evaluation, since the former one was observed to decay by only one neutron emission to 23 O, while the latter one by two sequential neutrons to 22 O. Based on assigned configurations, the 7.4- and 7.6-MeV groups are tentatively assigned negative and positive parities, respectively. Additional study would be useful to determine if these states are same or different. In 24 Na, 2014Fi01 (n,γ) proposed Jπ=(0,1,2) - for 4048.8 keV level based on weaker population from the capture state (J π =1 + ,2 + ) and mentioned to reexamine the J π =0 + assignment, suggested in earlier evaluations (1990En08, 2007Fi02). This evaluation includes the first observation of E0 transition, strength ρ 2 (E0)=0.380 70, for the 6432 keV transition from 0 + state at 6432 to 0 + g.s. in 24 Mg reported in 2020Do10. Authors proposed the first-excited 0+ state of 24 Mg to be superdeformed. In 24 Al, the excited level energies deduced from ( 3 He,t) measurements reported by different research groups vary significantly and it was not clear if some of those levels were same or different. Additional measurements are needed.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Basunia, M. Shamsuzzoha, Chakraborty, Anagha. 2022-12-09. Nuclear Data Sheets for A=24. https://doi.org/10.1016/j.nds.2022.11.002

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Design-informed neutronics assessment of long-lived fission product transmutation in a tokamak fusion reactor blanket

This study presents a neutronics-based assessment of the feasibility and viability of transmuting six major long-lived fission products (LLFPs) from light-water reactors, namely 99 Tc, 129 I, 79 Se, 93 Zr, 126 Sn, and 135 Cs, within the blanket region of a tokamak fusion reactor, using the MIT ARC design as a concrete fusion configuration. Monte Carlo neutronics simulations were performed to evaluate LLFP transmutation and to compare the results with a reference boiling water reactor (BWR). The results indicate that transmutation of all six LLFPs is neutronics-feasible in fusion reactors, with transmutation half-lives significantly shorter than their natural decay half-lives. For elemental targets, transmutation of 135 Cs, 126 Sn, and 93 Zr was found potentially viable, as the net mass transmuted exceeded that achievable in the reference BWR under identical target volume and irradiation time. When isotopically separated targets were considered, transmutation of 126 Sn and 93 Zr appeared potentially viable. A parametric study demonstrated that plasma geometry modifications can enhance local neutron flux, increasing the transmuted 93 Zr mass by approximately 33% and reducing the transmutation half-life from approximately 240 years to 180 years. Repositioning the target and adjusting material layer thickness reduced the transmutation half-life of 93 Zr to 67 years and increased the net mass transmuted by a factor of 50. Furthermore, these results demonstrate that fusion reactors can enable LLFP transmutation beyond the practical limits of thermal fission reactors and highlight the critical role of reactor and blanket design optimization. Engineering and fuel-cycle considerations required for deployment are beyond the scope of this neutronics-focused study.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

A hybrid Monte Carlo-deterministic second moment method with efficient variance reduction

In this work, we present a hybrid method that combines Monte Carlo with deterministic finite element methods to solve a linear Boltzmann transport equation. Our hybrid method runs orders of magnitude faster than Monte Carlo, without sacrificing accuracy, for a proxy problem from radiative transfer that contains both optically-thick and optically-thin material. We believe that this is the first demonstration of a hybrid Second Moment Method in more than one spatial dimension, the first to consider more than one material, and the first to use variance reduction. Our variance reduction approach arises from an asymptotic analysis in which we show that the magnitude of the scattering source grows without bound. We transform the problem to compute the deviation of the radiation intensity from isotropy. The magnitude of the source in the transformed problem is bounded, and the quality of the hybrid method solution is dramatically improved by a substantial reduction in the variance.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗