Fluoride salt static freezing study

Abstract

Molten salt reactor designs such as the FHR must consider the safety implications of freezing, requiring the development of thermal hydraulics models that account for freezing behavior. Pipe models that couple heat transfer, fluid dynamics, and phase change physics will require verification and validation. A static freezing study is being conducted to provide an initial set of validation data with LiF-BeF{sub 2} (FLiBe). The study will also be performed with LiF-NaF-KF (FLiNaK) in order to quantify the distortion that arises from using FLiNaK as a non-toxic surrogate salt for thermal-hydraulic studies. In order to develop the numerical model, accurate inputs for the thermal hydraulic properties of the two salts of interest need to be measured near the freezing point. For this reason, a series of three experiments including Differential Scanning Calorimetry (DSC) measurements, the Density Measurement Experiment, and the Static Freezing Experiment are being conducted to determine these thermo-physical properties at temperatures near the freezing point. The Static Freezing Experiment is also designed to determine the degree of supercooling that FLiBe and FLiNaK experience. Supercooling is a temperature depression below the freezing point that the liquid experiences before freezing initiates. Increased supercooling in a liquid flowing through a pipe leads to increased dendritic freezing and an increased likelihood of pipe blockage and freeze-shut. Based on previous research on supercooling in water and non-fluoride salts, supercooling is likely affected most strongly by cooling rate and sample size (as well as salt purity). No data has been generated previously on supercooling in fluoride salts such as FLiBe and FLiNaK. The results of this set of DSC, Density Measurement and Static Freezing experiments will be used in an ongoing fluoride salt freezing study being conducted to develop pipe freezing models for molten salts to be used in safety analysis. The thermal hydraulic properties measured in this study will serve as inputs for all future models. With the supercooling behavior of both salts quantified, it can be assessed whether supercooling must be included in future thermal hydraulic models. The validated Static Freezing Experiment model can then serve as the framework for a pipe freezing model and eventually a 1D system code.