Search NASA⌕ Search

DOE OSTI · 2476888

Single-channel and single-energy partial-wave analysis with continuity improved through minimal phase constraints

Abstract

Single-energy partial-wave analysis has often been applied as a way to fit data with minimal model dependence. However, remaining unconstrained, partial waves at neighboring energies will vary discontinuously because the overall amplitude phase cannot be determined through single-channel measurements. This problem can be mitigated through the use of a constraining penalty function based on an associated energy-dependent fit. However, the weight given to this constraint results in a biased fit to the data. In this paper, for the first time, we explore a constraining function which does not influence the fit to data. The constraint comes from the overall phase found in multichannel fits which, in the present study, are the Bonn-Gatchina and Jülich-Bonn multichannel analyses. The data are well reproduced and weighting of the penalty function does not influence the result. The method is applied to K⁢Λ photoproduction data and all observables can be maximally well reproduced. While the employed multichannel analyses display very different multipole amplitudes, we show that the major difference between two sets of multipoles can be related to the different overall phases.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Švarc, A., Workman, R. L.. 2024-08-27. Single-channel and single-energy partial-wave analysis with continuity improved through minimal phase constraints. https://doi.org/10.1103/physrevc.110.024614

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Design-informed neutronics assessment of long-lived fission product transmutation in a tokamak fusion reactor blanket

This study presents a neutronics-based assessment of the feasibility and viability of transmuting six major long-lived fission products (LLFPs) from light-water reactors, namely 99 Tc, 129 I, 79 Se, 93 Zr, 126 Sn, and 135 Cs, within the blanket region of a tokamak fusion reactor, using the MIT ARC design as a concrete fusion configuration. Monte Carlo neutronics simulations were performed to evaluate LLFP transmutation and to compare the results with a reference boiling water reactor (BWR). The results indicate that transmutation of all six LLFPs is neutronics-feasible in fusion reactors, with transmutation half-lives significantly shorter than their natural decay half-lives. For elemental targets, transmutation of 135 Cs, 126 Sn, and 93 Zr was found potentially viable, as the net mass transmuted exceeded that achievable in the reference BWR under identical target volume and irradiation time. When isotopically separated targets were considered, transmutation of 126 Sn and 93 Zr appeared potentially viable. A parametric study demonstrated that plasma geometry modifications can enhance local neutron flux, increasing the transmuted 93 Zr mass by approximately 33% and reducing the transmutation half-life from approximately 240 years to 180 years. Repositioning the target and adjusting material layer thickness reduced the transmutation half-life of 93 Zr to 67 years and increased the net mass transmuted by a factor of 50. Furthermore, these results demonstrate that fusion reactors can enable LLFP transmutation beyond the practical limits of thermal fission reactors and highlight the critical role of reactor and blanket design optimization. Engineering and fuel-cycle considerations required for deployment are beyond the scope of this neutronics-focused study.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

A hybrid Monte Carlo-deterministic second moment method with efficient variance reduction

In this work, we present a hybrid method that combines Monte Carlo with deterministic finite element methods to solve a linear Boltzmann transport equation. Our hybrid method runs orders of magnitude faster than Monte Carlo, without sacrificing accuracy, for a proxy problem from radiative transfer that contains both optically-thick and optically-thin material. We believe that this is the first demonstration of a hybrid Second Moment Method in more than one spatial dimension, the first to consider more than one material, and the first to use variance reduction. Our variance reduction approach arises from an asymptotic analysis in which we show that the magnitude of the scattering source grows without bound. We transform the problem to compute the deviation of the radiation intensity from isotropy. The magnitude of the source in the transformed problem is bounded, and the quality of the hybrid method solution is dramatically improved by a substantial reduction in the variance.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗