Search NASA⌕ Search

DOE OSTI · 2478338

Anisotropic magnetism of polymorphic ErAl 3

Abstract

ErAl 3 can form in either a trigonal (α) or cubic (β) polymorph and this paper investigates the physical properties of these polymorphs through characterizations of single crystals grown in an aluminum flux. Here, we demonstrate that polymorph selection can be achieved based on the nominal composition of the crystal growth. Magnetic measurements confirm that both β-ErAl 3 and α-ErAl 3 order antiferromagnetically at low temperatures. β-ErAl 3 undergoes antiferromagnetic ordering at a Néel temperature T N = 5.1 K, and the transition is suppressed continually with applied field. α-ErAl 3 displays more complex behavior, with successive magnetic transitions at T N = 5.7 K and T 2 = 4.6 K for zero field, where heat capacity and dilatometry measurements evidence that these transitions are second and first order, respectively. Under magnetic field, strong anisotropy is revealed in α-ErAl 3 , with several steplike metamagnetic transitions observed below T 2 for H ∥ c. These transitions produce sequential magnetization plateaus near one-half of the apparent saturation magnetization. The electrical resistivity of α-ErAl 3 is strongly coupled to its magnetism. At T = 2 K, we observe a positive magnetoresistance reaching 60%, with distinct anomalies at the metamagnetic transitions. The results are summarized in H-T phase diagrams that demonstrate complex magnetic behavior for α-ErAl 3 , suggesting an important role of competing interactions in this metallic system that possesses characteristics of Ising physics.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Gornicka, Karolina, Ortiz, Brenden R., Christianson, Andrew D., May, Andrew F.. 2024-11-13. Anisotropic magnetism of polymorphic ErAl 3. https://doi.org/10.1103/physrevmaterials.8.114412

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Cyclic moisture reactivation of calcium sorbents for long duration thermochemical energy storage

The transition to a flexible and reliable energy infrastructure, using electro-thermal energy generation technologies such as geothermal, concentrated solar power, and nuclear, usually demands simultaneous advancement of thermal energy storage (TES) to support on-demand electricity generation and industrial applications while mitigating the inherent intermittency of renewable energy sources and power outages from direct energy generation. Among TES technologies, thermochemical energy storage (TCES) based on calcium looping emerges as a compelling high-power energy storage candidate due to its high reaction enthalpy, compatibility with elevated operating temperatures, and abundance of low-cost materials. However, the long-term durability of calcium-based sorbents for TCES is hindered by surface sintering and particle aggregation, leading to performance degradation over repeated thermal cycles. This study explores a moisture hydration-based strategy to regenerate a degraded calcium sorbent and mitigate performance degradation for long duration TCES. The addition of moisture transforms calcium oxide into calcium hydroxide and produces intercalation water layers, associated with a regenerated surface area and reduced calcium oxide crystallite size. Both these effects are beneficial in restoring the sorbents' reactivity for carbonization. Additionally, an optimized hydration-assisted reactivation protocol balances the recovered energy storage capacity with heating penalty required for moisture removal from hydrated samples, resulting in an enhanced energy storage capacity up to 176% compared to benchmark sorbents that undergo cycling without reactivation after 60 cycles. In conclusion, these results highlight the potential of hydration-assisted reactivation to enhance the long-term performance of TCES, providing an effective pathway to advancing electro-thermal storage technologies.

36 MATERIALS SCIENCE↗