Simulation of Creep Deformation and Failure in Graded AM Microstructures

Abstract

This report describes modeling tools and techniques developed to simulate the long-term material performance of 316H stainless steel manufactured using Laser Powder Bed Fusion (LPBF). A physics-based Crystal Plasticity Finite Element model is used to simulate creep in microstructures and to study the roles of grain morphology, porosity, and texture. We describe our modeling methodology, including an orientation-mapping technique to capture the spatially varying crystallographic orientation that results from the build conditions. Our study of microstructural features shows that AM microstructures produced by LPBF tend to creep faster in the build direction, while texture and grain boundaries strengthen the transverse directions. However, when grain-boundary porosity and the consequent cavity growth are included in the model, the transverse directions begin to creep faster. In examining texture, the results indicate that spatially varying orientation arising from the build conditions increases anisotropy in the material, making it critical to account for orientation gradients in the material to accurately model its mechanical behavior. We also describe a material-model calibration campaign in which we calibrated the constitutive model specifically for LPBF 316H stainless steel at 725℃ for both solution-annealed and as-built conditions. Finally, these tools and techniques are used to model creep in microstructures representing different regions of an LPBF material with graded microstructure, owing to intentional variation in processing conditions. The creep simulation results show good agreement with experimental data across all three microstructures, with future work planned to study rupture in the material.