Calculations Document

Abstract

Figure 1 shows a simplified model schematic of the Tetracage target design. In this figure the green lines represent the Tetracage yarns, which consist of two parallel yarns on the top and two parallel yarns on the bottom with the pairs in a cross hatched pattern. For simplicity, as we are only considering vertical forces, we will perform calculations without consideration for the two pairs of yarns being perpendicular to each other. Also worth noting is the model shows the yarns extending directly to the capsule then closely hugging it – in reality, the yarns behave as you would expect where they hug the capsule only as much as the geometry of their deflection allows, similarly to if you held a tennis ball with a pair of parallel strings anchored at opposing ends. The dashed black lines show the path the yarns take straight across from slot glue point to slot glue point before the target is closed and the capsule deforms them. The variable r corresponds to the capsule outer radius. The variable L corresponds to the hohlraum inner radius. The variable a corresponds to the yarn offset from the center of the diagnostic band. The variable d corresponds to the wire deflection vertically.