Search NASA⌕ Search
Home/Archive/DOE OSTI

DOE OSTI · 3505123

Elucidating the impact of stress states on grain boundary passivation in Ni-5Cr using the Rhines pack method

McRobie, Chris [North Carolina State University, Raleigh, NC (United States)] (ORCID:0009000431469407)·Olszta, Matthew [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)]·Hartmann, Josephine [North Carolina State University, Raleigh, NC (United States)] (ORCID:0000000240595059)·Kruska, Karen [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)]·Zhu, Zihua [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)]·Zhai, Ziqing [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)]·Gwalani, Bharat [North Carolina State University, Raleigh, NC (United States)]·Schreiber, Daniel [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)]·Kautz, Elizabeth [North Carolina State University, Raleigh, NC (United States); Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)] (ORCID:0000000263389223)
View original source ↗Read source document ↗Export metadata ↓

Abstract

The oxidation behavior of a Ni–5Cr (at.%) alloy was evaluated at 420 ° C using the Rhines pack method and simultaneous tensile and compressive stress states via a miniature four-point bending fixture. At this moderate temperature, grain boundaries dominate mass transport and the resulting oxidation response. Oxidation produced approximately 1μ⁢m-wide protective Cr 2 O 3 films capping some grain boundaries and penetrative, intergranular Cr-rich oxides at other grain boundaries. Externally applied tensile and compressive stress during oxidation increased the prevalence of Cr 2 O 3 cap formation compared to no applied stress, with tensile stress resulting in more Cr 2 O 3 caps than compressive stress. The observed oxide cap morphology was similar across all test conditions. Regions under compressive stress showed an order of magnitude greater Cr depletion depth along the grain boundary. Chromium nitrides (CrN), likely from N contamination of the Rhines pack cell, were observed both at the oxide–metal interface and intergranularly within the alloy. Collectively these results demonstrate that applied stress promotes localized protective oxide cap formation over grain boundaries, with compressive stress additionally promoting deeper Cr depletion. Furthermore the experimental approach helped separate out the effects of stress on local oxide formation and grain boundary passivation.

Explore related subjects

4 point bendIntergranular oxidationNi-CrPassivationRhines packSelective oxidation

Keep this discovery

BibTeXRIS

McRobie, Chris [North Carolina State University, Raleigh, NC (United States)] (ORCID:0009000431469407), Olszta, Matthew [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)], Hartmann, Josephine [North Carolina State University, Raleigh, NC (United States)] (ORCID:0000000240595059), Kruska, Karen [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)], Zhu, Zihua [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)], Zhai, Ziqing [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)], Gwalani, Bharat [North Carolina State University, Raleigh, NC (United States)], Schreiber, Daniel [Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)], Kautz, Elizabeth [North Carolina State University, Raleigh, NC (United States); Pacific Northwest National Laboratory (PNNL), Richland, WA (United States)] (ORCID:0000000263389223). 2026-08-27. Elucidating the impact of stress states on grain boundary passivation in Ni-5Cr using the Rhines pack method. https://doi.org/10.1016/j.corsci.2026.114179

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

DOE OSTI2026

Atomistic Mechanisms of Stress-Dependent Molten Salt Corrosion in NiCr Alloys

Ni-based structural alloys in molten salt environments often experience simultaneous mechanical loading and corrosive attack, yet the mechanisms governing stress-corrosion interactions remain unclear. Prior studies largely emphasize tensile stress, while the role of compressive stress has received limited attention. Here, reactive molecular dynamics simulations are used to investigate the coupled effects of applied strain and corrosion in Ni 0.75 Cr 0.25 exposed to molten FLiNaK at 800 °C. A Σ5(210) grain boundary model is subjected to tensile (+4%) to compressive (−4%) uniaxial strains, and corrosion behavior is evaluated through fluorine adsorption, charge redistribution, and grain boundary evolution. Tensile strain accelerates intergranular corrosion susceptibility by reducing local atomic packing through elastic dilation and increasing excess free volume at the grain boundary, which enhances atomic mobility and salt infiltration. In contrast, compressive strain can suppress corrosion by promoting the formation of a ridge-like surface layer along the grain boundary, limiting salt access to the underlying alloy. These results provide atomistic insight into how stress states influence grain boundary corrosion in molten salts.

36 - MATERIALS SCIENCE↗
DOE OSTI2026

Thermodynamics of Tritium Trapping by Point Defects at Interfacial Cr-based Phases of the Al Coating

Density functional theory (DFT) simulations have been carried out to evaluate the potential for tritium trapping by metal vacancies in four phases Cr-containing phases (i.e., Cr3Si, Al0.3Cr0.7, Al8Cr5-HT, and Al8Cr5) identified near the interface between the Al coating and 316 stainless steel (316 SS) cladding. In addition, an ab initio thermodynamics approach has been employed to predict the temperature and T2-partial pressure dependence on the thermodynamics of singly tritiated defects. Key results in this work suggest that metal vacancies in the four phases have the potential to favorably trap tritium species, especially Si vacancies in Cr3Si phase. This overall thermodynamic trend can be correlated to the energy cost of having an interstitial tritium in the lattice, which has been calculated to range from 0.17 eV in Al8Cr5-HT to 0.89 eV in Cr3Si. A comparison of the results from this study with previous theoretical works investigating tritium behavior in other Fe-Al phases identified in the aluminide coating, suggests that metal vacancies are generally able to trap tritium in various Fe-Al aluminide phases. Especially, it was found that Si and Al vacancies would be the most efficient to trap for tritium, followed by Cr vacancies, then Fe and Ni vacancies. In the four Cr-based material phases investigated in this work, it is interesting to note that, in the absences of Fe or Ni species, strong interactions between tritium and the metal vacancies are always occurring by the formation of preferential Cr—T bonds (i.e., no Si—T or Al—T bonds were formed).

Sassi, Michel J.↗