Search NASA⌕ Search

DOE OSTI · 963865

Strain evolution in Al conductor lines during electromigration.

Abstract

Monochromatic and white beam synchrotron x rays were used to study the deviatoric strains and full elastic strains in passivated Al conductor lines with near-bamboo structures during electromigration (EM) at 190 C. A strong strain gradient formed in the upstream part of the Al lines. Strains along the downstream part of the lines were smaller and more scattered. Numerical analysis using the Eshelby model and finite element method (FEM) calculations suggest that the moving of atoms during EM in these near-bamboo Al lines is dominated by top and/or bottom interface diffusion, which differs from the reported results for nonbamboo, polycrystalline Al conductor lines, where EM is mainly along the grain boundaries. Local strain measurements and FEM calculations indicate that the EM flux is also nonuniform across the width of the conductor line because of stronger mechanical constraint by the passivation layer near the edges of the line. Plastic deformation is observed during EM by changes in the Laue diffraction patterns. The effective valence |Z*| = 1.8 {+-} 0.4 is determined from the measured strain gradient.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Zang, H, S, Cargill G, Ge, Y, Maniatty, A M, Liu, W. 2008-01-01. Strain evolution in Al conductor lines during electromigration.. https://doi.org/10.1063/1.3041152. https://searchnasa.com/record/osti%3A963865/strain-evolution-in-al-conductor-lines-during-electromigration

Citations retain the original authors and DOI and include this site’s record URL. If this discovery service contributed to your research, you can also cite Search NASA by Indiciae: BibTeX · RIS.

KEEP EXPLORING

Related reports

Cyclic moisture reactivation of calcium sorbents for long duration thermochemical energy storage

The transition to a flexible and reliable energy infrastructure, using electro-thermal energy generation technologies such as geothermal, concentrated solar power, and nuclear, usually demands simultaneous advancement of thermal energy storage (TES) to support on-demand electricity generation and industrial applications while mitigating the inherent intermittency of renewable energy sources and power outages from direct energy generation. Among TES technologies, thermochemical energy storage (TCES) based on calcium looping emerges as a compelling high-power energy storage candidate due to its high reaction enthalpy, compatibility with elevated operating temperatures, and abundance of low-cost materials. However, the long-term durability of calcium-based sorbents for TCES is hindered by surface sintering and particle aggregation, leading to performance degradation over repeated thermal cycles. This study explores a moisture hydration-based strategy to regenerate a degraded calcium sorbent and mitigate performance degradation for long duration TCES. The addition of moisture transforms calcium oxide into calcium hydroxide and produces intercalation water layers, associated with a regenerated surface area and reduced calcium oxide crystallite size. Both these effects are beneficial in restoring the sorbents' reactivity for carbonization. Additionally, an optimized hydration-assisted reactivation protocol balances the recovered energy storage capacity with heating penalty required for moisture removal from hydrated samples, resulting in an enhanced energy storage capacity up to 176% compared to benchmark sorbents that undergo cycling without reactivation after 60 cycles. In conclusion, these results highlight the potential of hydration-assisted reactivation to enhance the long-term performance of TCES, providing an effective pathway to advancing electro-thermal storage technologies.

36 MATERIALS SCIENCE↗