Search NASA⌕ Search

SEARCH · Search NASA

Results for “ACOUSTIC SIMULATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

On some structure-turbulence interaction problems

The interactions between a turbulent flow structure; responding to its excitation were studied. The turbulence was typical of those associated with a boundary layer, having a cross-spectral density indicative of convection and statistical decay. A number of structural models were considered. Among the one-dimensional models were an unsupported infinite beam and a periodically supported infinite beam. The fuselage construction of an aircraft was then considered. For the two-dimensional case a simple membrane was used to illustrate the type of formulation applicable to most two-dimensional structures. Both the one-dimensional and two-dimensional structures studied were backed by a cavity filled with an initially quiescent fluid to simulate the acoustic environment when the structure forms one side of a cabin of a sea vessel or aircraft.

Maekawa, S.↗
NASA NTRS1979

Reduction of rotor-turbulence interaction noise in static fan noise testing

Three effective inlet cleanup methods are described. A flared reverse cone inlet is used to eliminate wakes from the fan casings and/or probe supports. Boundary layer suction is employed ahead of the fan rotor and on the outer flare of the cone to reduce the boundary layer turbulence and remove any residual wakes. To reduce the midstream turbulent intensity and length scales, a turbulence control structure is used which is constructed with both a layer of honeycomb and a fine mesh screen. The effects of these cleanup methods are quantified by measuring the far-field noise in an anechoic chamber, using a high-speed 20-in.-diam fan of the current high passband type. The changes in the turbulent field impinging on this rotor are quantified by mapping the streamwise and transverse turbulent properties (spectra, intensity and length scale) with crossed hot film probes. It is convincingly shown that it is possible to clean up the inlet flow of a static fan noise test facility to a point where the static acoustic data simulate flight data.

Kantola, R. A.↗
NASA NTRS1993

Assessment of Total Variation Diminishing schemes in combustion instability problems

Numerical simulations of acoustic waves in a shear layer and in an idealized combustion chamber using high resolution Total Variation Diminishing (TVD) schemes has been carried out to study the effects of inherent scheme dissipation and dispersion errors of this class of problems. The numerical results are compared against available exact solutions to quantify these errors. Several popular TVD limiters widely used in the Computational Fluid Dynamics (CFD) community have been assessed. Osher-Chakravarthy limiters are modified so that they can be used in explicit schemes. Among all the limiters investigated, Osher-Chakravarthy third-order limiter is identified as having performed the best. It is also found that all TVD schemes have exceptionally small dispersive errors.

Wang, Z. J.↗
NASA NTRS1997

An Investigation of High-Order Shock-Capturing Methods for Computational Aeroacoustics

Topics covered include: Low-dispersion scheme for nonlinear acoustic waves in nonuniform flow; Computation of acoustic scattering by a low-dispersion scheme; Algorithmic extension of low-dispersion scheme and modeling effects for acoustic wave simulation; The accuracy of shock capturing in two spatial dimensions; Using high-order methods on lower-order geometries; and Computational considerations for the simulation of discontinuous flows.

Casper, Jay↗
NASA NTRS2004

An Investigation of the Flow Physics of Acoustic Liners by Direct Numerical Simulation

This report concentrates on reporting the effort and status of work done on three dimensional (3-D) simulation of a multi-hole resonator in an impedance tube. This work is coordinated with a parallel experimental effort to be carried out at the NASA Langley Research Center. The outline of this report is as follows : 1. Preliminary consideration. 2. Computation model. 3. Mesh design and parallel computing. 4. Visualization. 5. Status of computer code development. 1. Preliminary Consideration.

Watson, Willie R.↗
NASA NTRS2010

A Parameter Identification Method for Helicopter Noise Source Identification and Physics-Based Semi-Empirical Modeling

A new physics-based parameter identification method for rotor harmonic noise sources is developed using an acoustic inverse simulation technique. This new method allows for the identification of individual rotor harmonic noise sources and allows them to be characterized in terms of their individual non-dimensional governing parameters. This new method is applied to both wind tunnel measurements and ground noise measurements of two-bladed rotors. The method is shown to match the parametric trends of main rotor Blade-Vortex Interaction (BVI) noise, allowing accurate estimates of BVI noise to be made for operating conditions based on a small number of measurements taken at different operating conditions.

Greenwood, Eric, II↗
NASA NTRS1985

Nonlinear acoustic wave propagation in atmosphere

A model problem that simulates an atmospheric acoustic wave propagation situation that is nonlinear is considered. The model is derived from the basic Euler equations for the atmospheric flow and from the regular perturbations for the acoustic part. The nonlinear effects are studied by obtaining two successive linear problems in which the second one involves the solution of the first problem. Well posedness of these problems is discussed and approximations of the radiation boundary conditions that can be used in numerical simulations are presented.

Hariharan, S. I.↗
NASA NTRS1984

Near field to far field transformations and multiple beam forming and steering

The feasibility of acoustic verification of microwave near field to far field transformation algorithms using the Phased Array Sonic Simulation System was studied. Existing electromagnetic near field measurement techniques and transformation algorithms (equations) were investigated. It was analytically determined that acoustic verification is valid. Acoustic simulation of electromagnetic near field to far field transformations is emphasized. The acoustic simulation of electromagnetic near field to far field transformation is verified for the modal expansion method. In the modal expansion method, data from antenna near field measurements are converted to a summation or spectrum of modes corresponding to wave numbers in the measurement coordinate system. Fourier transformation of those measurements preserves the far field information in a spectral form that is then readily extractable.

Source record↗
NASA NTRS1994

Simulation of Shuttle launch G forces and acoustic loads using the NASA Ames Research Center 20G centrifuge

The high cost and long times required to develop research packages for space flight can often be offset by using ground test techniques. This paper describes a space shuttle launch and reentry simulating using the NASA Ames Research Center's 20G centrifuge facility. The combined G-forces and acoustic environment during shuttle launch and landing were simulated to evaluate the effect on a payload of laboratory rates. The launch G force and acoustic profiles are matched to actual shuttle launch data to produce the required G-forces and acoustic spectrum in the centrifuge test cab where the rats were caged on a free-swinging platform. For reentry, only G force is simulated as the aero-acoustic noise is insignificant compared to that during launch. The shuttle G-force profiles of launch and landing are achieved by programming the centrifuge drive computer to continuously adjust centrifuge rotational speed to obtain the correct launch and landing G forces. The shuttle launch acoustic environment is simulated using a high-power, low-frequency audio system. Accelerometer data from STS-56 and microphone data from STS-1 through STS-5 are used as baselines for the simulations. This paper provides a description of the test setup and the results of the simulation with recommendations for follow-on simulations.

Shaw, T. L.↗
NASA NTRS1986

Studies of acoustic emission from point and extended sources

The use of simulated and controlled acoustic emission signals forms the basis of a powerful tool for the detailed study of various deformation and wave interaction processes in materials. The results of experiments and signal analyses of acoustic emission resulting from point sources such as various types of indentation-produced cracks in brittle materials and the growth of fatigue cracks in 7075-T6 aluminum panels are discussed. Recent work dealing with the modeling and subsequent signal processing of an extended source of emission in a material is reviewed. Results of the forward problem and the inverse problem are presented with the example of a source distributed through the interior of a specimen.

Sachse, W.↗
NASA NTRS1985

Harmonic response of cylindrical and toroidal shells to an internal acoustic field. I - Theory. II - Results

In the first part of the present work concerning the coupled elastic and acoustic response of a system of cylindrical and toroidal shells enclosing an acoustic medium, the theoretical model for the cylindrical and toroidal segments' elastodynamics incorporates an elastic simulation based on transfer matrices, while the acoustic simulation adapts Green's function and curved surface elements. The coupled response is determined by the equilibrium of the acoustic pressure and internal elastic reactions of the shell, and compatibility between acoustic and elastic accelerations at the shell-fluid interface. The second part of this work obtains and discusses numerical results based on the theory for the cases of shell configurations having a plane of symmetry, as well as asymmetric ones. The inadequacy of beam theory in modeling the response of short, thin shell configurations at frequencies above the fundamental elastic resonance is demonstrated.

El-Raheb, M.↗
NASA NTRS1988

Rain simulation studies for high-intensity acoustic nose cavities

Unarmed plastic projectiles can be equipped with small axisymmetric cavities for the generation of intense tones that are useful in training maneuvers. Attention is presently given to the simulation of rainfall in an airstream and the effect of rain droplet impingement on the nose of projectiles, and especially to any penetration or accumulation of water at the base of the cavity that might increase the fundamental cavity frequency and/or reduce the intensity of sound production during rain conditions.

Clayton, R. M.↗
NASA NTRS2015

Near-Field Acoustic Power Level Analysis of F31/A31 Open Rotor Model at Simulated Cruise Conditions, Technical Report II

Near-field acoustic power level analysis of F31A31 open rotor model has been performed to determine its noise characteristics at simulated cruise flight conditions. The non-proprietary parts of the test data obtained from experiments in the 8x6 supersonic wind tunnel were provided by NASA-Glenn Research Center. The tone and broadband components of total noise have been separated from raw test data by using a new data analysis tool. Results in terms of sound pressure levels, acoustic power levels, and their variations with rotor speed, freestream Mach number, and input shaft power, with different blade-pitch setting angles at simulated cruise flight conditions, are presented and discussed. Empirical equations relating models acoustic power level and input shaft power have been developed. The near-field acoustic efficiency of the model at simulated cruise conditions is also determined. It is hoped that the results presented in this work will serve as a database for comparison and improvement of other open rotor blade designs and also for validating open rotor noise prediction codes.

Broadband↗
NASA NTRS1986

Nonlinear acoustic wave propagation in atmosphere

In this paper a model problem is considered that simulates an atmospheric acoustic wave propagation situation that is nonlinear. The model is derived from the basic Euler equations for the atmospheric flow and from the regular perturbations for the acoustic part. The nonlinear effects are studied by obtaining two successive linear problems in which the second one involves the solution of the first problem. Well-posedness of these problems is discussed and approximations of the radiation boundary conditions that can be used in numerical simulations are presented.

Hariharan, S. I.↗