Search NASA⌕ Search

SEARCH · Search NASA

Results for “AIRPLANES - WEIGHT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Simulation study of the oscillatory longitudinal motion of an airplane at the stall

Hybrid simulation of the longitudinal motion of a straight-wing airplane at the stall was studied to investigate the effect of hysteresis in the development of lift and pitching moments on the wing as a function of angle of attack on the occurrence of longitudinal oscillations at the stall. Flight data for the simulated airplane and for various other airplanes are shown for the simulated airplane and for comparison. The results show that oscillations similar to those measured in flight may be obtained by incorporating hysteresis in the lift and pitching-moment curves.

Phillips, W. H.↗
NASA NTRS1978

Development of fire test methods for airplane interior materials

Fire tests were conducted in a 737 airplane fuselage at NASA-JSC to characterize jet fuel fires in open steel pans (simulating post-crash fire sources and a ruptured airplane fuselage) and to characterize fires in some common combustibles (simulating in-flight fire sources). Design post-crash and in-flight fire source selections were based on these data. Large panels of airplane interior materials were exposed to closely-controlled large scale heating simulations of the two design fire sources in a Boeing fire test facility utilizing a surplused 707 fuselage section. Small samples of the same airplane materials were tested by several laboratory fire test methods. Large scale and laboratory scale data were examined for correlative factors. Published data for dangerous hazard levels in a fire environment were used as the basis for developing a method to select the most desirable material where trade-offs in heat, smoke and gaseous toxicant evolution must be considered.

Tustin, E. A.↗
NASA NTRS1979

Precision controllability of the F-15 airplane

A flying qualities evaluation conducted on a preproduction F-15 airplane permitted an assessment to be made of its precision controllability in the high subsonic and low transonic flight regime over the allowable angle of attack range. Precision controllability, or gunsight tracking, studies were conducted in windup turn maneuvers with the gunsight in the caged pipper mode and depressed 70 mils. This evaluation showed the F-15 airplane to experience severe buffet and mild-to-moderate wing rock at the higher angles of attack. It showed the F-15 airplane radial tracking precision to vary from approximately 6 to 20 mils over the load factor range tested. Tracking in the presence of wing rock essentially doubled the radial tracking error generated at the lower angles of attack. The stability augmentation system affected the tracking precision of the F-15 airplane more than it did that of previous aircraft studied.

Sisk, T. R.↗
NASA NTRS1979

Effects of road traffic background noise on judgments of individual airplane noises

Two laboratory experiments were conducted to investigate the effects of road-traffic background noise on judgments of individual airplane flyover noises. In the first experiment, 27 subjects judged a set of 16 airplane flyover noises in the presence of traffic-noise sessions of 30-min duration consisting of the combinations of 3 traffic-noise types and 3 noise levels. In the second experiment, 24 subjects judged the same airplane flyover noises in the presence of traffic-noise sessions of 10-min duration consisting of the combinations of 2 traffic-noise types and 4 noise levels. In both experiments the airplane noises were judged less annoying in the presence of high traffic-noise levels than in the presence of low traffic-noise levels.

Powell, C. A.↗
NASA NTRS1979

Preliminary study of pilot lateral control of two light airplanes near the stall

For two representative light, single-engine airplanes the single-axis piloting task of controlling bank angle with combined aileron and rudder, and a two-axis task of controlling bank angle with aileron and sideslip with rudder have been studied. For these tasks existing divergence criteria have been applied to determine conditions for closed-loop stability for selected flight conditions near the stall; in addition closed-loop stability characteristics and airplane response to bank angle command were calculated. Results obtained from applying the divergence criterion and from calculations of airplane responses to bank angle command indicate that aileron-alone bank angle control is marginally acceptable at high angle of attack. Of the two rudder control techniques considered, rudder used with the aileron in controlling bank angle increasd stability and produced satisfactory responses; the combined bank angle and sideslip control task does not warrant further consideration because of the task difficulty and the small improvement indicated in airplane closed-loop response with this technique.

Moul, M. T.↗
NASA NTRS1979

Analytical investigation of the landing dynamics of a large airplane with a load-control system in the main landing gear

The results of an evaluation of an active load-control landing gear computer program (ACOLAG) for predicting the landing dynamics of airplanes with passive and active main gears are presented. ACOLAG was used in an analytical investigation of the landing dynamics of a large airplane with both passive and active main gears. It was concluded that the program is valid for predicting the landing dynamics of airplanes with both passive and active main gears. It was shown that the active gear reduces airframe-gear forces and airplane motions following initial impact, and has the potential for significant reductions in structural fatigue damage relative to that which occurs with the passive gear.

Mcgehee, J. R.↗
NASA NTRS1980

Wind-tunnel/flight correlation study of aerodynamic characteristics of a large flexible supersonic cruise airplane (XB-70-1). 3: A comparison between characteristics predicted from wind-tunnel measurements and those measured in flight

A program was undertaken by NASA to evaluate the accuracy of a method for predicting the aerodynamic characteristics of large supersonic cruise airplanes. This program compared predicted and flight-measured lift, drag, angle of attack, and control surface deflection for the XB-70-1 airplane for 14 flight conditions with a Mach number range from 0.76 to 2.56. The predictions were derived from the wind-tunnel test data of a 0.03-scale model of the XB-70-1 airplane fabricated to represent the aeroelastically deformed shape at a 2.5 Mach number cruise condition. Corrections for shape variations at the other Mach numbers were included in the prediction. For most cases, differences between predicted and measured values were within the accuracy of the comparison. However, there were significant differences at transonic Mach numbers. At a Mach number of 1.06 differences were as large as 27 percent in the drag coefficients and 20 deg in the elevator deflections. A brief analysis indicated that a significant part of the difference between drag coefficients was due to the incorrect prediction of the control surface deflection required to trim the airplane.

Arnaiz, H. H.↗
NASA NTRS1980

Description of an experimental (hydrogen peroxide) rocket system and its use in measuring aileron and rudder effectiveness of a light airplane

A hydrogen peroxide fueled rocket system, which is to be used as a research tool in flight studies of stall and spin maneuvers, was installed on a light, four place general aviation airplane. The pilot controlled rocket system produces moments about either the roll or the yaw body axis to augment or oppose the aerodynamic forces and inertial moments acting on the airplane during various flight maneuvers, including the spin. These controlled moments of a known magnitude can be used in various ways to help analyze and interpret the importance of the various factors which influence airplane maneuvers. The rocket system and its installation in the airplane are described, and the results of flight rests used to measure rudder and aileron effectiveness at airspeeds above the stall are presented. These tests also serve to demonstrate the operational readiness of the rocket system for future research operations.

Obryan, T. C.↗
NASA NTRS1980

Aerodynamic design optimization of a fuel efficient high-performance, single-engine, business airplane

A design study has been conducted to optimize a single-engine airplane for a high-performance cruise mission. The mission analyzed included a cruise speed of about 300 knots, a cruise range of about 1300 nautical miles, and a six-passenger payload (5340 N (1200 lb)). The purpose of the study is to investigate the combinations of wing design, engine, and operating altitude required for the mission. The results show that these mission performance characteristics can be achieved with fuel efficiencies competitive with present-day high-performance, single- and twin-engine, business airplanes. It is noted that relaxation of the present Federal Aviation Regulation, Part 23, stall-speed requirement for single-engine airplanes facilitates the optimization of the airplane for fuel efficiency.

Holmes, B. J.↗
NASA NTRS1948

Effects of Ice Formations on Airplane Performance in Level Cruising Flight

A flight investigation in natural icing conditions was conducted by the NACA to determine the effect of ice accretion on airplane performance. The maximum loss in propeller efficiency encountered due to ice formation on the propeller blades was 19 percent. During 87 percent of the propeller icing encounters, losses of 10 percent or less were observed. Ice formations on all of the components of the airplane except the propellers during one icing encounter resulted in an increase in parasite drag of the airplane of 81 percent. The control response of the airplane in this condition was marginal.

Preston, G. Merritt↗
NASA NTRS1982

An analytical technique for the analysis of airplane spin entry and recovery

The dynamic equations of motion for a spinning airplane are simplified to facilitate the analysis of spin entry and recovery maneuvers. Solutions of a nonlinear, first order equation for spin rate enable calculation of spin entry and recovery times and control required for recovery. The analysis is applied to a light airplane for which both aerodynamic data, rotory balance wind tunnel tests, and spin flight test data have been obtained. A comparison of predicted and actual transient spin responses is made which supports the validity of the analytical approach taken but which also illustrates the difficulty in obtaining accurate aerodynamic data for spinning airplanes. Certain normalized parameters of the reduced state spin equation suggest criteria for assessing the transient spin characteristics of light airplanes.

Taylor, L. W., Jr.↗
NASA NTRS1982

Correlation and assessment of structural airplane crash data with flight parameters at impact

Crash deceleration pulse data from a crash dynamics program on general aviation airplanes and from transport crash data were analyzed. Structural airplane crash data and flight parameters at impact were correlated. Uncoupled equations for the normal and longitudinal floor impulses in the cabin area of the airplane were derived, and analytical expressions for structural crushing during impact and horizontal slide out were also determined. Agreement was found between experimental and analytical data for general aviation and transport airplanes over a relatively wide range of impact parameter. Two possible applications of the impulse data are presented: a postcrash evaluation of crash test parameters and an assumed crash scenario.

Carden, H. D.↗
NASA NTRS1982

Wind-tunnel studies of the effects of stimulated damage on the aerodynamic characteristics of airplanes and missiles

As an aid in assessing the aerodynamic effects of battle damage that might be sustained by military airplanes or missiles, several wind tunnel investigations were performed at the Langley Research Center in which damage was simulated with models by the removal of all or parts of the wing and tails. Results of the investigations indicate that the loss of a major part of the vertical tail will probably result in the loss of an airplane in any speed range. The loss of major parts of the horizontal tail generally results in catastrophic instability in the subsonic range but, at low supersonic speeds, and for some planform configurations at subsonic speeds, may allow stable flight to the extent that the airplane might return to friendly territory before the pilot must eject. The results further indicate that major damage to the wing, up to the point of the complete removal of one wing panel, and major damage to the horizontal tail may be sustained without necessarily causing the loss of the airplane or pilot.

Spearman, M. L.↗
NASA NTRS1983

Analysis of Nonplanar Wing-tip-mounted Lifting Surfaces on Low-speed Airplanes

Nonplanar wing tip mounted lifting surfaces reduce lift induced drag substantially. Winglets, which are small, nearly vertical, winglike surfaces, are an example of these devices. To achieve reduction in lift induced drag, winglets produce significant side forces. Consequently, these surfaces can seriously affect airplane lateral directional aerodynamic characteristics. Therefore, the effects of nonplanar wing tip mounted surfaces on the lateral directional stability and control of low speed general aviation airplanes were studied. The study consists of a theoretical and an experimental, in flight investigation. The experimental investigation involves flight tests of winglets on an agricultural airplane. Results of these tests demonstrate the significant influence of winglets on airplane lateral directional aerodynamic characteristics. It is shown that good correlations exist between experimental data and theoretically predicted results. In addition, a lifting surface method was used to perform a parametric study of the effects of various winglet parameters on lateral directional stability derivatives of general aviation type wings.

Vandam, C. P.↗
NASA NTRS1984

Use of a discontinuous wing leading-edge modification to enhance spin resistance for general aviation airplanes

Spin resistance of two typical general aviation airplanes has been studied. Improvement in spin resistance due to an outboard wing leading-edge modification was evaluated through wind-tunnel and flight tests. The basic airplanes would readily enter a spin; however, with the wing modification the airplanes were highly spin resistant. Spin resistance has been related to the angle of attack of the outer wing panel and the yaw rate as a step toward development of guidelines for design of more spin resistant airplanes.

Dicarlo, D. J.↗
NASA NTRS1985

Comparison of wind velocity in thunderstorms determined from measurements by a ground-based Doppler radar and an F-106B airplane

As a part of the NASA Storm Hazards Program, the wind velocity in several thunderstorms was measured by an F-106B instrumented airplane and a ground-based Doppler radar. The results of five airplane penetrations of two storms in 1980 and six penetrations of one storm in 1981 are given. Comparisons were made between the radial wind velocity components measured by the radar and the airplane. The correlation coefficients for the 1980 data and part of the 1981 data were 0.88 and 0.78, respectively. It is suggested that larger values for these coefficients may be obtained by improving the experimental technique and in particular by slaving the radar to track the airplane during such tests.

Usry, J. W.↗
NASA NTRS1985

Techniques for accommodating control effector failures on a mildly statically unstable airplane

Commercial airplanes are becoming increasingly more sophisticated, placing an increasing burden on pilots to detect and resolve the exhaustive set of possible control effector failures. Automatic techniques are needed to either reconfigure an existing control law or restructure a new control law after failure. A discrete control law has been designed for the longitudinal channel of a mildly statically unstable commercial airplane, to track the glideslope during the approach to landing phase of flight. Single effector failures with time delays for failure detection and identification are analyzed for both the reconfigured and restructured control laws, and results are compared with those from previous research using a statically stable airplane. Strategies considered include reconfiguration and restructuring with new flight conditions. Validation of all cases is made using a 6 DOF nonlinear airplane simulation.

Ostroff, A. J.↗
NASA NTRS1985

Design of static reaction gantry for an ultralight airplane destruction test

The steel gantry superstructure needed to perform an airplane static test is described. Standard civil engineering design practices are used to react the loads generated by an airplane in flight. Reaction columns are mounted on a structural floor to carry the wing airloads and the downward acting fuselage loads are carried directly into the floor. The gantry can accommodate a general aviation airplane or rotorcraft. An immediate use for an ultralight airplane is shown as an example configuration of the four main steel frames.

Smith, H. W.↗