Search NASA⌕ Search

SEARCH · Search NASA

Results for “CROSS COUPLING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Squeeze effects in radial face seals

Squeeze effects in a liquid lubricated radial face seal are analyzed. The analysis considers face misalignment with both axial and angular vibrations of the primary seal ring. Translational, rotational, and cross-coupled damping coefficients of the fluid film are derived analytically from a solution of the Reynolds equation utilizing the narrow seal approximation. Results are given for a wide range of practical radius ratios. At each radius ratio, the complete range of angular misalignment - from parallel faces to touch down - is covered. It is shown that squeeze effects in face seals are usually larger than the more familiar hydrodynamic effects. These effects play an important role in the seal's mechanism of operation and therefore have to be considered in any realistic seal model.

Etsion, I.↗
NASA NTRS1979

Motion sickness susceptibility during rotation at 30 rpm in free-fall parabolic flight

To make comparisons with experimental motion sickness susceptibility in Skylab missions, subjects were tested during free fall in parabolic flight and in ground-based simulation tests. They were rotated at 30 rpm in a rotating litter chair (RLC) with head fixed, head swiveling left-to-right, or with 90 degree forward and return head and body movements. Stressful accelerations similar to those in the Skylab RLC were generated only in the tests aloft, where subjects who made 'forward and return' movements (generating cross-coupled angular accelerations) were substantially more prone to motion sickness than those with either head fixed or head swiveling left-to-right. However, with head swiveling, susceptibility was slightly higher in the laboratory than aloft.

Graybiel, A.↗
NASA NTRS1980

Antenna pattern correction procedures for the Scanning Multichannel Microwave Radiometer /SMMR/

Procedures for correcting antenna temperature measurements and retrieving the true brightness temperatures are developed for the Scanning Multichannel Microwave Radiometer (SMMR) flown on the Seasat-A and Nimbus-G satellites. These procedures are necessary to meet the measurement accuracies required for deriving sea surface temperatures and wind speeds. It is shown that sidelobe contributions and polarization cross-coupling are major effects to be accounted for, in addition to some unique features of the SMMR instrument such as integration times and antenna scan characteristics. Methods are presented for data averaging and data reformatting, these are to be used with geophysical parameter retrieval algorithms.

Njoku, E. G.↗
NASA NTRS1980

Space motion sickness - Skylab revisited

Biomedical findings in the area of space motion sickness of the Skylab missions are reviewed and compared with the results of laboratory simulations. The motion sickness experiences of the three Skylab crews are related, and it is pointed out that of the nine astronauts, four were not sick at all, and of the five who were sick, only two vomited. In addition, it is noted that soon after recovery all five were immune in a provocative test based on the generation of cross-coupled angular accelerations while they executed head movements during rotation, in which they had manifested symptoms before the flight. Is is concluded that the findings indicate that susceptibility to motion sickness on earth is not a reliable predictor of susceptibility to motion sickness in orbit, and that free fall is a partial motion environment. Difficulties in dealing with motion sickness under operational conditions and the limitations of antimotion sickness remedies are noted.

Graybiel, A.↗
NASA NTRS1980

Design of a multivariable integrated control for a supersonic propulsion system

An inlet/engine/nozzle integrated control mode for the propulsion system of an advanced supersonic commercial aircraft was studied. Results show that integration of these control functions can result in both operational and performance benefits for the propulsion system. For example, this integrated control mode may make it possible to minimize the use of inlet bypass doors for shock position control. This may be of benefit to the aircraft as a result of minimizing: (1) bypass bleed drag effects; (2) perturbations to the aircraft resulting from the side thrust effect of the bypass bleeds; and (3) potential unstarts of the inlet. A conceptual integrated control mode was developed which makes use of many cross coupling paths between inlet and engine control variables and inlet and engine sensed variables. A multivariable control design technique based upon linear quadratic regulator theory was applied to designing the feedback gains for this control to allow a simulation evaluation of the benefits of the integrated control mode.

Beattie, E. C.↗
NASA NTRS1981

Impact of high-alpha aerodynamics on dynamic stability parameters of aircraft and missiles

The aerodynamic phenomena associated with high angles of attack and their effects on the dynamic stability characteristics of airplane and missile configurations are examined. Information on dynamic effects is limited. Steady flow phenomena and their effects on the forces and moments are reviewed. The effects of asymmetric vortices and of vortex bursting on the dynamic response of flight vehicles are reviewed with respect to their influence on: (1) nonlinearity of aerodynamic coefficients with attitude, rates, and accelerations; (2) cross coupling between longitudinal and lateral directional models of motion; (3) time dependence and hysteresis effects; (4) configuration dependencey; and (5) mathematical modeling of the aerodynamics.

Malcolm, G. N.↗
NASA NTRS1981

Engineering evaluations and studies. Report for Ku-band studies, exhibit A

System performance aspects of the Ku band radar communication hardware and investigations into the Ku band/payload interfaces are discussed. The communications track problem caused by the excessive signal dynamic range at the servo input was investigated. The management/handover logic is discussed and a simplified description of the transmitter enable logic function is presented. Output noise produced by a voltage-controlled oscillator chip used in the SPA return-link channel 3 mid-bit detector is discussed. The deployed assembly (DA) and EA-2 critical design review data are evaluated. Cross coupling effects on antenna servo stability were examined. A series of meetings on the acceptance test specification for the deployed assembly is summarized.

Dodds, J. G.↗
NASA NTRS1980

The Magsat scalar magnetometer

The Magsat scalar magnetometer is derived from optical pumping magnetometers flown on the orbiting geophysical observatories. The basic sensor, a cross-coupled arrangement of absorption cells, photodiodes, and amplifiers, oscillates at the Larmor frequency of atomic moments precessing about the ambient field direction. The Larmor frequency output is accumulated digitally and stored for transfer to the spacecraft telemetry stream. In orbit the instrument has met its principal objective of calibrating the vector magnetometer and providing scalar field data.

Farthing, W. H.↗
NASA NTRS1980

A three-axis angular monitoring system for the magnetic field satellite /MAGSAT/ mission

An electro-optical attitude transfer system was developed to monitor the angular orientation of magnetometers deployed at the end of a 20-foot boom extending outboard from the Magsat spacecraft. One autocollimator monitors pitch and yaw attitude, cooperating with a plane mirror at the end of the boom; a second monitors roll (twist) from an offset look-angle, using one dihedral reflector at the boom end and a second on the spacecraft. RMS errors due to all causes including linearity, G-forces, cross-coupling and translation are estimated to be 3.9 arcsec over + or - 180 arcsec excursion in pitch and yaw, and 5.3 to 7.5 arcsec over + or - 300 arcsec roll. Design and fabrication problems relative to the remote dihedral refector proved to be the most challenging, and solutions to these problems will be described.

Collyer, P. W.↗
NASA NTRS1980

A pilot's assessment of helicopter handling-quality factors common to both agility and instrument flying tasks

Results from a series of simulation and flight investigations undertaken to evaluate helicopter flying qualities and the effects of control system augmentation for nap-of-the-earth (NOE) agility and instrument flying tasks were analyzed to assess handling-quality factors common to both tasks. Precise attitude control was determined to be a key requirement for successful accomplishment of both tasks. Factors that degraded attitude controllability were improper levels of control sensitivity and damping and rotor-system cross-coupling due to helicopter angular rate and collective pitch input. Application of rate-command, attitude-command, and control-input decouple augmentation schemes enhanced attitude control and significantly improved handling qualities for both tasks. NOE agility and instrument flying handling-quality considerations, pilot rating philosophy, and supplemental flight evaluations are also discussed.

Gerdes, R. M.↗
NASA NTRS1981

System analysis approach to deriving design criteria (loads) for Space Shuttle and its payloads. Volume 1: General statement of approach

Space shuttle, the most complex transportation system designed to date, illustrates the requirement for an analysis approach that considers all major disciplines simultaneously. Its unique cross coupling and high sensitivity to aerodynamic uncertainties and high performance requirements dictated a less conservative approach than those taken in programs. Analyses performed for the space shuttle and certain payloads, Space Telescope and Spacelab, are used a examples. These illustrate the requirements for system analysis approaches and criteria, including dynamic modeling requirements, test requirements control requirements and the resulting design verification approaches. A survey of the problem, potential approaches available as solutions, implications for future systems, and projected technology development areas are addressed.

Ryan, R. S.↗
NASA NTRS1982

Digital demodulator

A digital demodulator for converting pulse code modulated data from phase shift key (PSK) to non return to zero (NRZ) and to biphase data is described. The demodulator is composed of standard integrated logic circuits. The key to the demodulation function is a pair of cross coupled one shot multivibrators and which with a flip-flop produce the NRZ-L is all that is required, the circuitry is greatly simplified and the 2(v) times bit rate contraint can be removed from the carrier. A flip-flop, an OR gate, and AND gate and a binary counter generate the bit rate clock (BTCK) for the NRZ-L. The remainder of the circuitry is for converting the NRZ-L and BTCK into biphase data. The device was designed for use in the space shuttle bay environment measurements.

Shull, T. A.↗
NASA NTRS1981

A pad perturbation method for the dynamic coefficients of tilting-pad journal bearings

A pad assembly method for analyzing tilting-pad bearings is presented. The method results in the complete coefficient matrix for a tilting-pad bearing; the matrix is independent of the pad inertia, the pitch frequency and the number of degrees of freedom of the pad. A pad assembly method is used because it allows the collection of more bearing data with less computer time than a brute force iterative procedure. The results given show the complete dynamical matrices for a five-pad tilting-pad bearing both including and ignoring the damping effects of the unloaded (top) pads. For a symmetrical tilting-pad bearing the reduced cross-coupling coefficients are zero when the moment of inertia of the pad is ignored.

Allaire, P. E.↗
NASA NTRS1982

Electrostatic disturbance forces on a 3-axis drag-free sensor

The electrostatic analysis of a multiple-capacitance 3-axis drag-free sensor is presented in this paper. The instrument consists of a proof-mass (a dense metallic ball) floating freely inside a spherical cavity enclosed by the sensor plates and the shield. Since the ball and the cavity are not necessarily concentric, the problem in three-dimensional potential theory for electrostatics is solved by the method of boundary perturbations and specifically in terms of spherical harmonics. The capacitance outputs of the instrument and the electrostatic forces acting on the system are derived as non-linear functions of the ball position, ball charge and the sensor plate potentials. The instrument sensitivity and cross-coupling effects are discussed. The analysis may also be useful for electrostatic gyros and suspensions.

Hagstrom, T.↗
NASA NTRS1984

Theory for Eccentric and Misalined Annular Seals

Theory describes behavior of eccentric and angularly-misalined incompressible-fluid shaft seals. Direct and cross-coupled stiffness and damping coefficients expressed in terms of degree of eccentricity and coefficients of concentric system.

Jackson, E.↗
NASA NTRS1982

An analysis of aerodynamic requirements for coordinated bank-to-turn autopilots

Two planar missile airframes were compared having the potential for improved bank-to-turn control but having different aerodynamic properties. The comparison was made with advanced level autopilots using both linear and nonlinear 3-D aerodynamic models to obtain realistic missile body angular rates and control surface incidence. Cortical cross-coupling effects are identified and desirable aerodynamics are recommended for improved coordinated (BTT) (CBTT) performance. In addition, recommendations are made for autopilot control law analyses and design techniques for improving CBTT performance.

Arrow, A.↗
NASA NTRS1982

Experiment measurement of Alford's force in axial-flow turbomachinery

Results of experimental measurements made on a small high speed, axial flow test apparatus are presented to verify the existence of Alford's force (that circumferential variation of blade-tip clearances in axial-flow turbomachinery will produce cross-coupled (normal to the eccentricity) aerodynamic forces on the rotor) and to investigate the validity of his mathematical prediction model.

Vance, J. M.↗
NASA NTRS1983

Gravity probe-B control subsystem

The purpose of this document is to identify and briefly examine the control problems of the proposed Gravity Probe-B spacecraft. Suggestions are made for control thruster geometry, dynamics, and maximum output value. Maximum total thrust is also a consideration since all thrusters expel gaseous helium produced from a common liquid supply. Control philosophy and preliminary designs are presented for both the attitude and drag free control systems. A radial separation of the spacecraft center of mass and the center of the proof mass cavity produces cross coupling between the attitude and drag free systems. The low available thrust implies that this separation, throughout the mission, must be kept within very close tolerance and for this reason an onboard mass balance control system may be necessary. Simulation was performed only to the extent necessary to show the control concepts to be feasible.

Farmer, J.↗