Search NASA⌕ Search

SEARCH · Search NASA

Results for “Cruise control”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS2005

Pneumatic Flap Performance for a 2D Circulation Control Airfoil, Steady and Pulsed

Circulation Control technologies have been around for 65 years, and have been successfully demonstrated in laboratories and flight vehicles alike, yet there are few production aircraft flying today that implement these advances. Circulation Control techniques may have been overlooked due to perceived unfavorable trade offs of mass flow, pitching moment, cruise drag, noise, etc. Improvements in certain aspects of Circulation Control technology are the focus of this paper. This report will describe airfoil and blown high lift concepts that also address cruise drag reduction and reductions in mass flow through the use of pulsed pneumatic blowing on a Coanda surface. Pulsed concepts demonstrate significant reductions in mass flow requirements cor Circulation Control, as well as cruise drag concepts that equal or exceed conventional airfoil systems.

Jones, Gregory S.↗
NASA NTRS2010

Inlet Flow Control and Prediction Technologies for Embedded Propulsion Systems

Fail-safe inlet flow control may enable high-speed cruise efficiency, low noise signature, and reduced fuel-burn goals for hybrid wing-body aircraft. The objectives of this program are to develop flow control and prediction methodologies for boundary-layer ingesting (BLI) inlets used in these aircraft. This report covers the second of a three year program. The approach integrates experiments and numerical simulations. Both passive and active flow-control devices were tested in a small-scale wind tunnel. Hybrid actuation approaches, combining a passive microvane and active synthetic jet, were tested in various geometric arrangements. Detailed flow measurements were taken to provide insight into the flow physics. Results of the numerical simulations were correlated against experimental data. The sensitivity of results to grid resolution and turbulence models was examined. Aerodynamic benefits from microvanes and microramps were assessed when installed in an offset BLI inlet. Benefits were quantified in terms of recovery and distortion changes. Microvanes were more effective than microramps at improving recovery and distortion.

McMillan, Michelle L.↗
NASA NTRS1975

Design definition study of a lift/cruise fan technology V/STOL airplane: Summary

A two-engine three-fan V/STOL airplane was designed to fulfill naval operational requirements. A multimission airplane was developed from study of specific point designs. Based on the multimission concept, airplanes were designed to demonstrate and develop the technology and operational procedures for this class of aircraft. Use of interconnected variable pitch fans led to a good balance between high thrust with responsive control and efficient thrust at cruise speeds. The airplanes and their characteristics are presented.

Zabinsky, J. M.↗
NASA NTRS1989

Experimental investigation of the high angle of attack characteristics of a high performance general aviation aircraft

Scale model wind tunnel tests and full scale flight tests have been conducted for the Questair Venture general aviation aircraft configuration in order to investigate its high angle-of-attack aerodynamics. Attention is given to the formulation of a wing leading-edge modification capable of enhancing stall departure characteristics. This modification, which involved both outboard wing leading-edge droop and two chordwise leading-edge slots, is found to produce almost no wing-rock tendency when tested on a wind tunnel free-to-roll apparatus; in the full-scale aircraft, the modification yielded gentle, controllable stall characteristics with little cruise and climb performance penalty.

Meyer, H. F.↗
NASA NTRS1992

Supersonic LFC: Challenges and opportunities

The discussion and viewgraphs on supersonic laminar control are provided. The high fuel fractions required for long range supersonic airplanes give significant leverage to technologies for cruise drag reduction such as laminar flow control (LFC). Fuel burn benefits are further enhanced when sizing effects are considered. These effects may even be powerful enough to reduce airplane production cost over a turbulent baseline. This is an important goal for LFC technology development. The results of aerodynamics studies on the application of LFC technology to the highly swept wings of supersonic airplanes are presented. Important questions of applicability, realistic benefit, and critical application issues, addressed in a NASA-sponsored study conducted by McDonnell Douglas Corporation in 1987-88 are reviewed. Efforts aimed at establishing the feasibility of demonstrating extensive laminarization on the F-16XL-2 airplane are summarized.

Powell, Arthur G.↗
NASA NTRS2000

Fluid Mechanics, Drag Reduction and Advanced Configuration Aeronautics

This paper discusses Advanced Aircraft configurational approaches across the speed range, which are either enabled, or greatly enhanced, by clever Flow Control. Configurations considered include Channel Wings with circulation control for VTOL (but non-hovering) operation with high cruise speed, strut-braced CTOL transports with wingtip engines and extensive ('natural') laminar flow control, a midwing double fuselage CTOL approach utilizing several synergistic methods for drag-due-to-lift reduction, a supersonic strut-braced configuration with order of twice the L/D of current approaches and a very advanced, highly engine flow-path-integrated hypersonic cruise machine. This paper indicates both the promise of synergistic flow control approaches as enablers for 'Revolutions' in aircraft performance and fluid mechanic 'areas of ignorance' which impede their realization and provide 'target-rich' opportunities for Fluids Research.

Bushnell, Dennis M.↗
NASA NTRS1991

Control concept for maneuvering in hypersonic flight

This research investigates an approach to provide precise, coordinated maneuver control during excursions from a hypersonic cruise flight path while observing the necessary flight condition constraints. The approach achieves specified guidance commands by resolving altitude and cross-range errors into a load factor and bank angle command through a coordinate transformation which acts as an interface between outer loop guidance controls and inner loop flight controls. This interface, referred to as a 'resolver', applies constraints on angle-of-attack and dynamic pressure perturbations while prioritizing altitude regulation over crossrange. An unpiloted test simulation, in which the resolver was used to drive inner-loop flight controls, produced time histories of responses to guidance commands at Mach numbers of 6, 10, 15, and 20. It is shown that angle-of-attack and throttle perturbation constraints, combined with high-speed flight effects and the desire to maintain constant dynamic pressure, significantly impact the maneuver envelope for a hypersonic vehicle. Turn rate, climb rate, and descent rate limits are expressed in terms of these constraints.

Raney, David L.↗
NASA NTRS1987

Pre- and post-flight-test models versus measured skyship-500 control responses

The dynamical equations-of-motion (EOM) for cruising airships require nonconventional terms to account for buoyancy and apparent-mass-effects, but systematic validation of these equations against flight data is not available. Using a candidate set of EOM, three comparisons are made with carefully-measured describing functions derived from frequency-sweep flight tests on the Skyship-500 airship. The first compares the pre-flight predictions to the data; the second compares the 'best-fit' equations to data at each of two airspeeds and the third compared the ability to extrapolate from one condition to another via airship-specific scaling laws. Two transient responses are also compared. The generally good results demonstrate that fairly simple, perturbation equation models are adequate for many types of flight-control analysis and flying quality evaluations of cruising airships.

Jex, Henry R.↗
NASA NTRS1972

An investigation of the landing characteristics of the NASA-MSC August 1969 baseline orbiter configuration in ground effect

A 0.05 scale model of the NASA-MSC August 1969 baseline shuttle craft was tested in Texas A&M University's 7- x 10-foot low speed wind tunnel facility. The purpose of the test was to determine the landing aerodynamic characteristics of the shuttle craft vehicle in ground effect and to evaluate control surface hinge moments experienced in the cruise and landing operational phases of flight. Analysis of the final data will allow evaluation of vehicle flight stability in ground effect and estimation of vehicle control surface power system requirements.

Chambliss, E. B.↗
NASA NTRSDate not supplied

X-57 High-Lift Propeller Control Schedule Development

The NASA X-57 distributed electric propulsion flight demonstrator uses a high-lift propeller system to maintain low-speed capability with a highly loaded, cruise-efficient wing. Previous research showed that the control scheme for the high-lift propellers was a crucial factor to enable an adequate balance between stabilized glideslope control and appropriate lift margin during the approach-to-landing phase of flight. This paper expands the high-lift propeller control considerations to include all phases of low-speed flight, including preflight, taxi, takeoff, initial climb, approach, and landing. Two control modes, termed airspeed and fixed mode, are developed in this paper. The airspeed mode varies propeller torque based on equivalent airspeed to account for different phases of ground and flight operations. The fixed mode operates the high-lift propeller system at a fixed rotational speed to account for failures in the air data system, preflight checkout, and high-performance takeoff operations. Modeling of the high-lift propellers within the X-57 low-speed flight envelope shows that (1) the structural rotational speed limit of the propeller blades limits their effectiveness at higher altitudes and airspeeds, (2) the speed setting of the fixed mode is set by the maximum torque of the airspeed mode, and (3) minimizing the potential for windmilling in non-standard conditions sets the torque schedule at higher speeds. Additionally, the fixed mode is shown to provide an increased climb rate during normal takeoff operations.

Nicholas K. Borer↗
NASA NTRS1976

Variable stream control engine concept for advanced supersonic aircraft: Features and benefits

The Variable Stream Control Engine is studied for advanced supersonic cruise aircraft. Significant environmental and performance improvements relative to first generation supersonic turbojet engines are cited. Two separate flow streams, each with independent burner and nozzle systems are incorporated within the engine. By unique control of the exhaust temperatures and velocities in two coannular streams, significant reduction in jet noise is obtained.

Howlett, R. A.↗
NASA NTRS1987

Failure detection and identification for a reconfigurable flight control system

Failure detection and identification logic for a fault-tolerant longitudinal control system were investigated. Aircraft dynamics were based upon the cruise condition for a hypothetical transonic business jet transport configuration. The fault-tolerant control system consists of conventional control and estimation plus a new outer loop containing failure detection, identification, and reconfiguration (FDIR) logic. It is assumed that the additional logic has access to all measurements, as well as to the outputs of the control and estimation logic. The pilot may also command the FDIR logic to perform special tests.

Dallery, Francois↗
NASA NTRS1988

Low-speed wind-tunnel test of a STOL supersonic-cruise fighter concept

A wind-tunnel investigation was conducted to examine the low-speed static stability and control characteristics of a 0.10 scale model of a STOL supersonic cruise fighter concept. The concept, referred to as a twin boom fighter, was designed as a STOL aircraft capable of efficient long range supersonic cruise. The configuration name is derived from the long twin booms extending aft of the engine to the twin vertical tails which support a high center horizontal tail. The propulsion system features a two dimensional thrust vectoring exhaust nozzle which is located so that the nozzle hinge line is near the aircraft center of gravity. This arrangement is intended to allow large thrust vector angles to be used to obtain significant values of powered lift, while minimizing pitching moment trim changes. Low speed stability and control information was obtained over an angle of attack range including the stall. A study of jet induced power effects was included.

Coe, Paul L., Jr.↗
NASA NTRS1984

Road load simulator tests of the Gould phase 1 functional model silicon controlled rectifier ac motor controller for electric vehicles

The test results for a functional model ac motor controller for electric vehicles and a three-phase induction motor which were dynamically tested on the Lewis Research Center road load simulator are presented. Results show that the controller has the capability to meet the SAE-J227a D cycle test schedule and to accelerate a 1576-kg (3456-lb) simulated vehicle to a cruise speed of 88.5 km/hr (55 mph). Combined motor controller efficiency is 72 percent and the power inverter efficiency alone is 89 percent for the cruise region of the D cycle. Steady state test results for motoring, regeneration, and thermal data obtained by operating the simulator as a conventional dynamometer are in agreement with the contractor's previously reported data. The regeneration test results indicate that a reduction in energy requirements for urban driving cycles is attainable with regenerative braking. Test results and data in this report serve as a data base for further development of ac motor controllers and propulsion systems for electric vehicles. The controller uses state-of-the-art silicon controlled rectifier (SCR) power semiconductors and microprocessor-based logic and control circuitry. The controller was developed by Gould Laboratories under a Lewis contract for the Department of Energy's Electric and Hybrid Vehicle program.

Gourash, F.↗
NASA NTRS1971

A proposed criterion for aircraft flight in turbulence

A proposed criterion for aircraft flight in turbulent conditions is presented. Subjects discussed are: (1) the problem of flight safety in turbulence, (2) new criterion for turbulence flight where existing ones seem adequate, and (3) computational problems associated with new criterion. Primary emphasis is placed on catastrophic occurrences in subsonic cruise with the aircraft under automatic control. A Monte Carlo simulation is used in the formulation and evaluation of probabilities of survival of an encounter with turbulence.

Porter, R. F.↗