Search NASA⌕ Search

SEARCH · Search NASA

Results for “Gas processing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10

Investigation of N2O Production from 266 and 532 nm Laser Flash Photolysis of O3/N2/O2 Mixtures

Tunable diode laser absorption spectroscopy has been employed to measure the amount of N2O produced from laser flash photolysis of O3/N2/O2 mixtures at 266 and 532 nm. In the 532 nm photolysis experiments very little N2O is observed, thus allowing an upper limit yield of 7 x 10(exp -8) to be established for the process O3 + N2 yield N2O + O2, where O3 is nascent O3 that is newly formed via O(3P(sub J)) + O2 recombination (with vibrational excitation near the dissociation energy of O3). The measured upper limit yield is a factor of approx. 600 smaller than a previous literature value and is approximately a factor of 10 below the threshold for atmospheric importance. In the 266 nm photolysis experiments, significant N2O production is observed and the N2O quantum yield is found to increase linearly with pressure over the range 100 - 900 Torr in air bath gas. The source of N2O in the 266 nm photolysis experiments is believed to be the addition reaction O(1D(sub 2)) + N2 + M yields (k(sub sigma)) N2O + M, although reaction of (very short-lived) electronically excited O3 with N2 cannot be ruled out by the available data. Assuming that all observed N2O comes from the O(1D(sub 2)) + N2 + M reaction, the following expression describes the temperature dependence of k(sub sigma) (in its third-order low-pressure limit) that is consistent with the N2O yield data: k(sub sigma) = (2.8 +/- 0.1) x 10(exp -36)(T/300)(sup -(0-88+0.36)) cm(sup 6) molecule(sup -2)/s, where the uncertainties are 2(sigma) and represent precision only. The accuracy of the reported rate coefficients at the 95% confidence level is estimated to be 30 - 40% depending on the temperature. Model calculations suggest that gas phase processes initiated by ozone absorption of a UV photon represent about 1.4% of the currently estimated global source strength of atmospheric N2O. However, these processes could account for a significant fraction of the oxygen mass-independent enrichment observed in atmospheric N2O, and they appear to be the first suggested photochemical mechanism that is capable of explaining the altitude dependence of the observed mass -independent isotopic signature.

Estupinan, E. G.↗

Large Eddy Simulation (LES) of Particle-Laden Temporal Mixing Layers

High-fidelity models of plume-regolith interaction are difficult to develop because of the widely disparate flow conditions that exist in this process. The gas in the core of a rocket plume can often be modeled as a time-dependent, high-temperature, turbulent, reacting continuum flow. However, due to the vacuum conditions on the lunar surface, the mean molecular path in the outer parts of the plume is too long for the continuum assumption to remain valid. Molecular methods are better suited to model this region of the flow. Finally, granular and multiphase flow models must be employed to describe the dust and debris that are displaced from the surface, as well as how a crater is formed in the regolith. At present, standard commercial CFD (computational fluid dynamics) software is not capable of coupling each of these flow regimes to provide an accurate representation of this flow process, necessitating the development of custom software. This software solves the fluid-flow-governing equations in an Eulerian framework, coupled with the particle transport equations that are solved in a Lagrangian framework. It uses a fourth-order explicit Runge-Kutta scheme for temporal integration, an eighth-order central finite differencing scheme for spatial discretization. The non-linear terms in the governing equations are recast in cubic skew symmetric form to reduce aliasing error. The second derivative viscous terms are computed using eighth-order narrow stencils that provide better diffusion for the highest resolved wave numbers. A fourth-order Lagrange interpolation procedure is used to obtain gas-phase variable values at the particle locations.

Bellan, Josette↗

Water Atomization of Barium Fluoride: Calcium Fluoride for Enhanced Flow Characteristics of PS304 Feedstock Powder Blend

PS304 is a plasma spray deposited solid lubricant coating with feedstock composed of NiCr, Cr2O3, Ag, and BaF2-CaF2 powders. The effects of rounded BaF2-CaF2 particles on the gravity-fed flow characteristics of PS304 feedstock have been investigated. The BaF2-CaF2 powder was fabricated by water atomization using four sets of process parameters. Each of these powders was then characterized by microscopy and classified by screening to obtain 45 to 106 micron particles and added incrementally from 0 to 10 wt% to the other constituents of the PS304 feedstock, namely nichrome, chromia, and silver powders. The relationship between feedstock flow rate, measured with the Hall flowmeter, and concentration of fluorides was found to be linear in each case. The slopes of the lines were between those of the linear relationships previously reported using angular and spherical fluorides and were closer to the relationship predicted using the rule of mixtures. The results offer a fluoride fabrication technique potentially more cost-effective than gas atomization processes or traditional comminution processes.

Stanford, Malcolm K.↗

Experimental studies of circumstellar, interstellar and interplanetary refractory grain analogs

Experimental techniques for studying the processes which occur during the life cycle of a refractory grain are reviewed. Consideration is given to the construction of a differentially-pumped beam-mass spectrometer which is expected to determine the relative stability of small clusters in the Fe-Mg-Si-O and Ca-Ti-Al-O systems as a function of temperature and pressure. Also, a smoke generator has been constructed to produce gram quantities of amorphous grains for use in thermal annealing and hydrous alteration studies of smokes containing Fe-Mg-Al-Ti-Ca-Si-O and Cl. Topics of the studies include the properties of grains produced in a flow condensation apparatus, the sorption efficiency of Si2O3 smokes for AR gas, the processing of ices containing refractory precursors such as SiH4 or Fe(CO)5 plus water, and the residue from 1 MeV bombardment and warming of an amorphous Fe-SiO smoke.

Nuth, J. A.↗

Atomic Processes in X-ray Photoionized Gas

It has long been known that photoionization and photoabsorption play a dominant role in determining the state of gas in nebulae surrounding hot stars and in active galaxies. Recent observations of X-ray spectra demonstrate that these processes are also dominant in highly ionized gas near compact objects, and also affect the transmission of X-rays from the majority of astronomical sources. This has led to new insights into the understanding of what is going on in these sources. It has also pointed out the need for a better atomic cross sections for photoionization and absorption, notably for processes involving inner shells. In this talk I will discuss these issues, what is known and where more work is needed.

Kallman, Timothy↗

What can be Learned from X-ray Spectroscopy Concerning Hot Gas in Local Bubble and Charge Exchange Processes?

What can be learned from x-ray spectroscopy in observing hot gas in local bubble and charge exchange processes depends on spectral resolution, instrumental grasp, instrumental energy band, signal-to-nose, field of view, angular resolution and observatory location. Early attempts at x-ray spectroscopy include ROSAT; more recently, astronomers have used diffuse x-ray spectrometers, XMM Newton, sounding rocket calorimeters, and Suzaku. Future observations are expected with calorimeters on the Spectrum Roentgen Gamma mission, and the Solar Wind Charge Exchange (SWCX). The Geospheric SWCX may provide remote sensing of the solar wind and magnetosheath and remote observations of solar CMEs moving outward from the sun.

Snowden, Steve↗

Inelastic molecular collisions

Collision cross sections direct measurement for determining macroscopic reaction rates in inelastic molecular collision processes in gas dynamics

Utterback, N. G.↗

Development of propulsion for high atmospheric pressure or dense environments

The development of a propulsion system that employs a detonating propellant is described, and the need for such a system and its use in certain planetary atmospheres are demonstrated. A theoretical formulation of the relevant gas-dynamic processes was developed, and a related series of experimental tests were pursued.

Varsi, G.↗

Photochemistry chemical kinetics in the interstellar medium.

Gas phase processes involving interstellar molecules are considered. The primary process is photodissociation in the ambient radiation field. In obscured regions, a combination of Johnson's (1965) and Stecher's (1969) Perseus extinction curves was used to obtain the radiation field as a function of the extinction at 5,500 A. On the basis of laboratory measurements, it is concluded that the molecules of water, ammonia, methane, and formaldehyde have lifetimes less than one hundred years.

Donn, B.↗

Chemical depletion of the ionosphere

A theoretical study of the chemical and gas dynamical processes resulting from the release of reactive gases into the daytime ionosphere is discussed. Only point releases, such as from an explosion or a pulsed jet, are considered. Some scientific uses of the artificial reduction of the ionospheric plasma are considered.

Bernhardt, P. A.↗

Development and testing of a wet oxidation waste processing system

The wet oxidation process is considered as a potential treatment method for wastes aboard manned spacecraft for these reasons: (1) Fecal and urine wastes are processed to sterile water and CO2 gas. However, the water requires post-treatment to remove salts and odor; (2) the residual ash is negligible in quantity, sterile and easily collected; and (3) the product CO2 gas can be processed through a reduction step to aid in material balance if needed. Reaction of waste materials with oxygen at elevated temperature and pressure also produces some nitrous oxide, as well as trace amounts of a few other gases.

Weitzmann, A. L.↗

Hydrogen production by water decomposition using a combined electrolytic-thermochemical cycle

A proposed dual-purpose power plant generating nuclear power to provide energy for driving a water decomposition system is described. The entire system, dubbed Sulfur Cycle Water Decomposition System, works on sulfur compounds (sulfuric acid feedstock, sulfur oxides) in a hybrid electrolytic-thermochemical cycle; performance superior to either all-electrolysis systems or presently known all-thermochemical systems is claimed. The 3345 MW(th) graphite-moderated helium-cooled reactor (VHTR - Very High Temperature Reactor) generates both high-temperature heat and electric power for the process; the gas stream at core exit is heated to 1850 F. Reactor operation is described and reactor innards are illustrated. A cost assessment for on-stream performance in the 1990's is optimistic.

Farbman, G. H.↗

Role of condensed phase details in the oscillatory combustion of composite propellants

The response functions of composite propellants are theoretically derived, including explicitly the pressure-dependent degradation term in the condensed phase, hypothesizing that the overall rate-limiting reactions are in the relatively low temperature condensed phase. The method of 'inner' and 'outer' expansions with the reduced activation energy as the singular perturbation parameter has been employed. The results cover subsurface reactions with and without surface reactions, adiabatic and uniform-combustion models for the quasi-steady gas phase processes. The response functions display several experimentally observed features like dependence on mean pressure and the instability behavior of some 'zero-n' propellants.

Kumar, R. N.↗

Purging means and method for Xenon arc lamps

High pressure Xenon short-arc lamp with two reservoirs which are selectively connectable to the lamp's envelope is described. One reservoir contains an absorbent which will absorb both Xenon and contaminant gases such as CO2 and O2. The absorbent temperature is controlled to evacuate the envelope of both the Xenon and the contaminant gases. The temperature of the absorbent is then raised to desorb only clean Xenon while retaining the contaminant gases, thereby clearing the envelope of the contaminant gases. The second reservoir contains a gas whose specific purpose is, to remove the objectional metal film which deposits gradually on the interior surface of the lamp envelope during normal arc operation. The origin of the film is metal transferred from the cathode of the arc lamp by sputtering or other gas transfer processes.

Miller, C. G.↗

Nuclear track and compositional studies of olivines in CI and CM chondrites

The CI and CM chondrites, with bulk chemical compositions closely resembling solar values, are important for the study of early solar system processes. Noble gas and particle track studies have revealed that a majority of the CI and CM chondrites contain precompaction solar wind and solar flare irradiation records. A quantitative understanding of these records is important because it would allow constraints to be placed on the environment in which the irradiation occurred, and, therefore, on the mode of evolution of the CI and CM chondrites. The present investigation is concerned primarily with fossil track evidence, taking into account selected specimens of several CI and CM chondrites. In addition, the results are presented of extensive studies of the angular distributions of tracks in irradiated grains from four CM chondrites. The results provide information on the exposure geometry of the grains.

Goswami, J. N.↗

Numerical simulations of loops heated to solar flare temperatures. I - Gasdynamics. II - X-ray and UV spectroscopy

The NRL's Dynamic Flux Tube Model is used to numerically simulate the dynamic response of a coronal magnetic loop to an energy input of the order encountered in solar flares. The coronal plasma is heated by the deposition of flare energy at the top of the loop to more than 10 million K, yielding a conduction front that moves toward the chromosphere, where the plasma is heated by the large downward conductive flux and ablates upward to the coronal part of the loop at velocities of a few hundred km/sec. The conduction front simultaneously produces chromospheric ablation and compresses the material ahead of it. With the aid of compressional instabilities, the compressed plasma grows throughout the flare heating phase, presenting a possible source of the flare optical continuum emission which is correlated with soft X-ray radiation. The observational consequences of rapidly heated loop gas dynamic processes are discussed. In the second part of this presentation, the dynamical calculation results previously obtained are used to predict the spectral line intensities, profiles and wavelengths of several X-ray lines and the UV line of Fe XXI at 1354.1 A. Three different viewing orientations of the loop are considered.

Cheng, C.-C.↗

Liquid fuel spray processes in high-pressure gas flow

Atomization of single liquid jets injected downstream in high pressure and high velocity airflow was investigated to determine the effect of airstream pressure on mean drop size as measured with a scanning radiometer. For aerodynamic - wave breakup of liquid jets, the ratio of orifice diameter D sub o to measured mean drop diameter D sub m which is assumed equal to D sub 32 or Sauter mean diameter, was correlated with the product of the Weber and Reynolds numbers WeRe and the dimensionless group G1/square root of c, where G is the gravitational acceleration, 1 the mean free molecular path, and square root of C the root mean square velocity, as follows; D sub o/D sub 32 = 1.2 (WeRe) to the 0.4 (G1/square root of c) to the 0.15 for values of WeRe 1 million and an airstream pressure range of 0.10 to 2.10 MPa.

Ingebo, R. D.↗