Search NASA⌕ Search

SEARCH · Search NASA

Results for “Ka”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

High-performance Ka-band and V-band HEMT low-noise amplifiers

Quarter-micron-gate-length high-electron-mobility transistors (HEMTs) have exhibited state-of-the-art low-noise performance at millimeter-wave frequencies, with minimum noise figures of 1.2 dB at 32 GHz and 1.8 dB at 60 GHz. At Ka-band, two-stage and three-stage HEMT low noise amplifiers have demonstrated noise figures of 1.7 and 1.9 dB, respectively, with associated gains of 17.0 and 24.0 dB at 32 GHz. At V-band, two stage and three-stage HEMT amplifiers yielded noise figures of 3.2 and 3.6 dB, respectively, with associated gains of 12.7 and 20.0 dB at 60 GHz. The 1-dB-gain compression point of all the amplifiers is greater than +6 dBm. The results clearly show the potential of short-gate-length HEMTs for high-performance millimeter-wave receiver applications.

Duh, K. H. George↗
NASA NTRS1990

Optical control of an 8-element Ka-band phased array using a high-speed optoelectronic interconnect

Optical distribution of control signals in electronically steered phased array antennas is being considered. A demonstration experiment is described in which a high speed hybrid GaAs optoelectronic integrated circuit (OEIC) was used to control an eight element phased array antenna. The OEIC, which accepts a serial optical control signal as input and converts it to 16 demultiplexed parallel outputs, was used to control the monolithic GaAs phase shifters of a Ka-band patch panel array antenna. Antenna pattern switching speeds of 2.25 microsec, limited by interface circuitry, were observed.

Richard, M. A.↗
NASA NTRS1990

A real-time signal combining system for Ka-band feed arrays using maximum-likelihood weight estimates

A real-time digital signal combining system for use with Ka-band feed arrays is proposed. The combining system attempts to compensate for signal-to-noise ratio (SNR) loss resulting from antenna deformations induced by gravitational and atmospheric effects. The combining weights are obtained directly from the observed samples by using a sliding-window implementation of a vector maximum-likelihood parameter estimator. It is shown that with averaging times of about 0.1 second, combining loss for a seven-element array can be limited to about 0.1 dB in a realistic operational environment. This result suggests that the real-time combining system proposed here is capable of recovering virtually all of the signal power captured by the feed array, even in the presence of severe wind gusts and similar disturbances.

Vilnrotter, V. A.↗
NASA NTRS1990

A CDMA architecture for a Ka-band Personal Access Satellite System

A Code Division Multiple Access (CDMA) architecture is currently being studied for use in a Ka-band Personal Access Satellite System (PASS). The complete architecture consisting of block diagrams of the user terminal, the supplier station, the network management center, and the satellite is described along with the access methods and frequency/time plans. The complexity of developing this system using the CDMA architecture is compared to that of a Frequency Division Multiple Access (FDMA) architecture. The inherent advantages and disadvantages of the two architectures are compared and their respective capacities are discussed.

Motamedi, Masoud↗
NASA NTRS1989

User RF requirements for a Ka-band data relay satellite link

The user G/T and EIRP requirements were determined for a data relay satellite link consisting of a forward link to 360 Mbps at 23 GHz and a return link to 2 Gbps at 26.5 GHz. Hardware for this data link would be a modular expansion to the NASA Data Link Module. Calculations were based on a data relay satellite model of predetermined characteristics patterned after the NASA Tracking and Data Relay Satellite (TDRS). The desired data rates could be achieved with a G/T of 21.7 dB/deg K (forward link) and an EIRP of 68.2 dBW (return link) for the user satellite. Hardware configurations meeting these requirements are discussed in terms of RF performance, efficiency, reliability, and modular flexibility. A planar array configuration emerges as the logical candidate for most NASA missions. Pertinent Ka-band technology and certain ongoing research efforts are reviewed. Areas of particular interest include new power device families, 0.25-micron low-noise HEMT technology, and fiber optic distribution and control of RF arrays.

Copeland, David J.↗
NASA NTRS1990

Control of a GaAs monolithic Ka-band phase shifter using a high-speed optical interconnect

The use of a high-speed optical interconnect in the control of a Ka-band GaAs monolithic phase shifter is described. A 16-b serial control signal was used to modulate the output of a laser transmitter, and the transmitted optical signal was detected and demultiplexed into 16 parallel electrical outputs using a high-speed hybrid GaAs optoelectronic integrated circuit. Four of the parallel output lines were interfaced to the 4-b phase shifter, and high-speed, optically controlled switching of the phase shifter was observed at clock frequencies to 30 MHz using an interferometric technique.

Bhasin, K. B.↗
NASA NTRS1991

Measurement techniques for cryogenic Ka-band microstrip antennas

The measurement of cryogenic antennas poses unique logistical problems since the antenna under test must be embedded in a cooling chamber. A method of measuring the performance of cryogenic microstrip antennas using a closed cycle gas cooled refrigerator in a far field range is described. Antenna patterns showing the performance of gold and superconducting Ka-band microstrip antennas at various temperatures are presented.

Richard, M. A.↗
NASA NTRS1991

A portable Ka-band front-end test package for beam-waveguide antenna performance evaluation. Part 1: Design and ground tests

A unique experimental method was used to test the beam waveguide (BWG) antenna at Deep Space Station (DDS) 13 in the Goldstone Deep Space Communications Complex near Barstow, California. The methodology involved the use of portable test packages to make measurements of operating noise temperatures and antenna efficiencies (as functions of antenna pointing angles) at the Cassegrain focal point and the final focal point located in a subterranean pedestal room. Degradations caused by the BWG mirror systems were determined by making comparisons of the measured parameters at the two focal points of the antenna. Previous articles were concerned with the design, performance characteristics, and test results obtained with an X-band test package operating at 32 GHz. Noise temperature measurement results are presented for the Ka-band test package in an on-the-ground test configuration.

Otoshi, T. Y.↗
NASA NTRS1991

A transportable 50 kA dual mode lightning simulator

A transportable lightning simulator was designed, built and tested, which is capable of delivering more than 50 kA to an 8 micro-H test object. The simulator was designed to be a versatile device in the lightning laboratory while meeting the requirements of MIL-STD-1757A for component E current waveforms. The system is capable of operating in either a ringing mode with a Q greater than 5 and a nominal frequency of 160 kHz, or a unipolar mode with no hardware configuration changes. The ringing mode is obtained by the LCR series circuit formed by the pulse generator and test object. The unipolar mode is obtained by closing an electrically triggered crowbar switch at peak current. The simulator exceeds the peak current requirement and rate of rise requirements for MIL-STD-1757A in both the ringing and unipolar modes. The pulse half width in the unipolar mode is in excess of 50 microsec and the action is in excess of 10(exp 5) A(exp 2)s. The design, component values, and test results are presented.

Salisbury, K.↗
NASA NTRS1991

Status of Ka-band TWT transmitter technology

The TWT types that are available for application to SEI are reviewed and evaluated in terms of their level of development and their suitability for use in space. The NASA OAET program for enhancement of efficiency and lifetime of TWT's is reviewed and the application of this technology to Ka-band devices is illustrated.

Dayton, James A., Jr.↗
NASA NTRS1990

Use of elliptical orbits for a Ka-band personal access satellite system

The use of satellites in elliptical orbits for a Ka-band personal communications system application designed to provide voice and data service within the continental U.S. is examined. The impact of these orbits on system parameters such as signal carrier-to-noise ratio, roundtrip delay, Doppler shift, and satellite antenna size is quantized for satellites in two elliptical orbits, the Molniya and the ACE orbits. The number of satellites necessary for continuous CONUS coverage has been determined for the satellites in these orbits. The increased system complexity brought about by the use of satellites at such altitudes is discussed.

Motamedi, Masoud↗
NASA NTRS1990

Multiple access capacity trade-offs for a Ka-band personal access satellite system

System capability is critical to the economic viability of a personal satellite communication system. Ka band has significant potential to support a high capacity multiple access system because of the availability of bandwidth. System design tradeoffs are performed and multiple access schemes are compared with the design goal of achieving the highest capacity and efficiency. Conclusions regarding the efficiency of the different schemes and the achievable capacities are given.

Dessouky, Khaled↗
NASA NTRS1991

Ka-band mobile and personal systems development at JPL

Expanding the commercial applications of space is one of the primary goals of NASA. Throughout the eighties NASA has pursued this objective by sponsoring and undertaking the development of system concepts, enabling high risk technologies, and actual proof of concept demonstration hardware. In the mobile and personal arena, or the so-called low data rate applications area, JPL is NASA's lead center. JPL's focus of activities has been the Mobile Satellite-Experiment (MSAT-X) project, which developed mobile communication technologies at L-band, and its present successors, which aim to expand the mobile arena by exploiting Ka-band.

Dessouky, K.↗
NASA NTRS1991

A personal communications network using a Ka-band satellite

The feasibility of portable communications terminals that can provide 4.8-kbps voice communications to a hub station via a Ka-band geosynchronous satellite was investigated. Tradeoffs are examined so that the combined system of the hub and gateway earth stations, the satellite, and the personal terminals can provide a competitive service in terms of cost, availability, and quality. A baseline system is described using a spacecraft with approximately 140 spot beams that cover CONUS with 5-watt power amplifiers in each beam. Satellite access in both the forward and return directions uses Frequency Division Multiple Access/Code Division Multiple Access (FDMA/CDMA) with a chip rate of 2.5 Mchip/sec. An experiment is recommended using the Advanced Communications Technology Satellite (ACTS) to demonstrate some of the features of the portable terminal concept.

Palmer, L. C.↗
NASA NTRS1992

Ka-band dual frequency array feed for a low cost ACTS ground terminal

Because of low cost and ease of fabrication, microstrip arrays are attractive as feeds for reflector antenna systems. The development of a 4 x 4 microstrip array which will be used as a feed for a low cost Advanced Communications Technology Satellite (ACTS) ground terminal is described. The array feed consisting of four 2 x 2 subarrays is fed with coplanar waveguide power dividing networks. The patch radiator is designed to excite two orthogonal, linearly polarized waves at Ka-band frequencies (around 20 and 30 GHz). Test results for the developed array are presented.

Lee, Richard Q.↗
NASA NTRS1992

Measurement techniques for cryogenic Ka-band microstrip antennas

The measurement of cryogenic antennas poses unique logistical problems since the antenna under test must be embedded in the cooling chamber. A method for measuring the performance of cryogenic microstrip antennas using a closed cycle gas-cooled refrigerator in a far field range is described. Antenna patterns showing the performance of gold and superconducting Ka-band microstrip antennas at various temperatures are presented.

Richard, M. A.↗
NASA NTRS1992

A low-power, high-efficiency Ka-band TWTA

NASA has developed a new class of Ka-band TWT amplifiers (TWTAs) which achieve their high efficiency/low power performance goals by means of an advanced dynamic velocity taper (DVT). The DVT is characterized by a continuous, nonlinear reduction in helix pitch from its initial synchronous value in the output section of the TWT to near the end of the helix. Another efficiency-maximizing feature is the inclusion of a multistage depressed collector employing oxygen-free, high-conductivity Cu electrodes treated for secondary electron emission suppression by means of ion bombardment. An efficiency of 43 percent is expected to be reached.

Curren, Arthur N.↗