Search NASA⌕ Search

SEARCH · Search NASA

Results for “OUTPUT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Control logic to track the outputs of a command generator or randomly forced target

A procedure is presented for synthesizing time-invariant control logic to cause the outputs of a linear plant to track the outputs of an unforced (or randomly forced) linear dynamic system. The control logic uses feed-forward of the reference system state variables and feedback of the plant state variables. The feed-forward gains are obtained from the solution of a linear algebraic matrix equation of the Liapunov type. The feedback gains are the usual regulator gains, determined to stabilize (or augment the stability of) the plant, possibly including integral control. The method is applied here to the design of control logic for a second-order servomechanism to follow a linearly increasing (ramp) signal, an unstable third-order system with two controls to track two separate ramp signals, and a sixth-order system with two controls to track a constant signal and an exponentially decreasing signal (aircraft landing-flare or glide-slope-capture with constant velocity).

Trankle, T. L.↗
NASA NTRS1977

Spacelab output processing system architectural study

Two different system architectures are presented. The two architectures are derived from two different data flows within the Spacelab Output Processing System. The major differences between these system architectures are in the position of the decommutation function (the first architecture performs decommutation in the latter half of the system and the second architecture performs that function in the front end of the system). In order to be examined, the system was divided into five stand-alone subsystems; Work Assembler, Mass Storage System, Output Processor, Peripheral Pool, and Resource Monitor. The work load of each subsystem was estimated independent of the specific devices to be used. The candidate devices were surveyed from a wide sampling of off-the-shelf devices. Analytical expressions were developed to quantify the projected workload in conjunction with typical devices which would adequately handle the subsystem tasks. All of the study efforts were then directed toward preparing performance and cost curves for each architecture subsystem.

Source record↗
NASA NTRS1978

Eigenvalue/eigenvector assignment using output feedback

The problem of pole-assignment in a linear time-invariant multivariable system using output feedback is considered. New sufficient conditions are derived to assign an almost arbitrary set of min (n, m+r-1) distinct eigenvalues, where n, m, and r are the number of states, inputs, and outputs, respectively. The analysis also highlights the freedom in selection of closed-loop eigenvectors which can be used for response shaping.

Srinathkumar, S.↗
NASA NTRS1978

Temperature dependence of optically dumped far-infrared (FIR) laser output power

The temperature dependence of the small signal gain and saturation power are derived using temperature-dependent rates in a four-level model. An expression is developed for the output power of a far-infrared oscillator as a function of temperature for both fixed pressure and fixed density. The results are valid in the regime of homogeneous broadening of the rotational transition and Doppler broadening of the pump transition. It is shown that, for most lasers, both the small signal gain and the saturation power decrease with increasing temperature. These effects have the overall result of increasing output power with decreasing temperatures.

Lawandy, N. M.↗
NASA NTRS1979

Temperature dependence of optically pumped far-infrared /FIR/ laser output power

The temperature dependence of the small signal gain and saturation power are derived using temperature-dependent rates in a four-level model. An expression is developed for the output power of a far-infrared oscillator as a function of temperature for both fixed pressure and fixed density. The results are valid in the regime of homogeneous broadening of the rotational transition and Doppler broadening of the pump transition. It is shown that, for most lasers, both the small signal gain and the saturation power decrease with increasing temperature. These effects have the overall result of increasing output power with decreasing temperatures.

Lawandy, N. M.↗
NASA NTRS1980

The correlation of the output of a binary convolutional encoder

In this paper we discuss the correlation properties of the output of a binary convolutional encoder. We consider both random statistically independent inputs and first-order Markov inputs. It is shown that for random inputs, the ensemble average of the product of the outputs of a convolutional encoder taken two at a time is always either 0 or 1, and that for almost all good codes the ensemble average is always 0.

Braff, M.↗
NASA NTRS1980

Radiative energy output of the 5 September 1973 flare

Measurements of the radiative energy output of the solar flare of Sept. 5, 1973, over a wavelength range of more than ten decades, from below 1 A to above 1 m are presented. Observations of soft X-rays (0.5-20 A), XUV and EUV lines (171-1863 A) and EUV continua (1400-1960 A), H alpha radiation, visible lines and continua (3700-8700 A) and radio emission (centimeter to meter wavelengths) were obtained concurrently by Skylab and ground-based instruments. Estimates of power output at flare maximum are obtained for the observed wavelengths with uncertainty of at least half an order of magnitude, due to corresponding uncertainties in EUV and visible fluxes. Taking into account energy radiated at unobserved wavelengths and the characteristic time of the best-reduced data (the soft X-ray), calculations indicate a total radiated flare energy of approximately 4 x 10 to the 29th erg.

Canfield, R. C.↗
NASA NTRS1980

Output of acoustical sources

Acoustic radiation from a source, here viewed as an immobile point singularity with periodic strength and a given multipolar nature, is affected by the presence of nearly structural elements (e.g., rigid or impedance surfaces) as well as that of a background flow in the medium. An alternative to the conventional manner of calculating the net source output by integrating the energy flux over a distant control surface is described; this involves a direct evaluation of the secondary wavefunction at the position of the primary source and obviates the need for a (prospectively difficult) flux integration. Various full and half-planar surface configurations with an adjacent source are analyzed in detail, and the explicit results obtained, in particular, for the power factor of a dipole brings out a substantial rise in its output as the source nears the sharp edge of a half-plane.

Levine, H.↗
NASA NTRS1980

Thermionic converter output as a function of collector temperature

Surprisingly few data are available on the variation of thermionic converter output with collector temperature. In this study the output power density has been measured as a function of collector temperature (at a fixed emitter temperature of 1650 K) for six converters with different electrode combinations. Collector temperatures ranged from 750 to 1100 K. For collector temperatures below 900 K, converters built with sublimed molybdenum oxide collectors gave the best performance.

Stark, G.↗
NASA NTRS1980

Programming input-output operations in FORTRAN on magnetic tape

The subprogram MTCFF was designed for carrying out input-output operations in FORTRAN on magnetic tape within the framework of the DOS ES EVM operation system. It is possible, by means of this subprogram, to perform any input-output operations of interest to the programmer such as recording and reading various control operations in the direct and reverse directions, even though for these purposes the facilities of the language FORTRAN itself are limited. The subprogram can also be used in programs written in other programming languages.

Gorokov, V. N.↗
NASA NTRS1981

New output improvements for CLASSY

Additional output data and formats for the CLASSY clustering algorithm were developed. Four such aids to the CLASSY user are described. These are: (1) statistical measures; (2) special map types; (3) formats for standard output; and (4) special cluster display method.

Rassbach, M. E.↗
NASA NTRS1980

Output rate of magma from active central volcanoes

For part of their historic records, nine of the most active volcanoes on earth have each erupted magma at a nearly constant rate. These output rates are very similar and range from 0.69 to 0.26 cu m/s. The volcanoes discussed - Kilauea, Mauna Loa, Fuego, Santiaguito, Nyamuragira, Hekla, Piton de la Fournaise, Vesuvius and Etna - represent almost the whole spectrum of plate tectonic settings of volcanism. A common mechanism of buoyantly rising magma-filled cracks in the upper crust may contribute to the observed restricted range of the rates of output.

Wadge, G.↗
NASA NTRS1979

On the algebraic geometry of the output feedback pole placement map

Pole placement by output feedback is based on a concept that a transfer function can be considered as a curve in a Grassmanian manifold, so that pole placement consists of finding a special hypersurface in the manifold which intersects the curve at a prescribed set of points. An equation is derived for the number of different gains which yield the same set of poles in the case where the number of output feedback gains equals the number of poles of the system.

Brockett, R. W.↗
NASA NTRS1982

Ultrasonic input-output for transmitting and receiving longitudinal transducers coupled to same face of isotropic elastic plate

The quantitative understanding of ultrasonic nondestructive evaluation parameters such as the stress wave factor were studied. Ultrasonic input/output characteristics for an isotropic elastic plate with transmitting and receiving longitudinal transducers coupled to the same face were analyzed. The asymptotic normal stress is calculated for an isotropic elastic half space subjected to a uniform harmonic normal stress applied to a circular region at the surface. The radiated stress waves are traced within the plate by considering wave reflections at the top and bottom faces. The output voltage amplitude of the receiving transducer is estimated by considering only longitudinal waves. Agreement is found between the output voltage wave packet amplitudes and times of arrival due to multiple reflections of the longitudinal waves.

Williams, J. H., Jr.↗
NASA NTRS1982

Coupled rotor/airframe vibration analysis program manual. Volume 2: Sample input and output listings

Sample input and output listings obtained with the base program (SIMVIB) of the coupled rotor/airframe vibration analysis and the external programs, G400/F389 and E927 are presented. Results for five of the base program test cases are shown. They represent different applications of the SIMVIB program to study the vibration characteristics of various dynamic configurations. Input and output listings obtained for one cycle of the G400/F389 coupled program are presented. Results from the rotor aeroelastic analysis E927 also appear. A brief description of the check cases is provided. A summary of the check cases for all the external programs interacting with the SIMVIB program is illustrated.

Cassarino, S.↗
NASA NTRS1982

Active flutter suppression using optical output feedback digital controllers

A method for synthesizing digital active flutter suppression controllers using the concept of optimal output feedback is presented. A convergent algorithm is employed to determine constrained control law parameters that minimize an infinite time discrete quadratic performance index. Low order compensator dynamics are included in the control law and the compensator parameters are computed along with the output feedback gain as part of the optimization process. An input noise adjustment procedure is used to improve the stability margins of the digital active flutter controller. Sample rate variation, prefilter pole variation, control structure variation and gain scheduling are discussed. A digital control law which accommodates computation delay can stabilize the wing with reasonable rms performance and adequate stability margins.

Source record↗
NASA NTRS1980

An improved output feedback control of flexible large space structures

A special output feedback control design technique for flexible large space structures is proposed. It is shown that the technique will increase both the damping and frequency of selected modes for more effective control. It is also able to effect integrated control of elastic and rigid-body modes and, in particular, closed-loop system stability and robustness to modal truncation and parameter variation. The technique is seen as marking an improvement over previous work concerning large space structures output feedback control.

Lin, Y. H.↗