An omnidirectional microwave antenna for use on spacecraft.
Omnidirectional microwave parallel plate waveguide fed antenna design for flush mounted broadband spacecraft, noting equatorial and polar patterns
Cockrell, C. R.↗
SEARCH · Search NASA
Results for “PARALLEL PLATE”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Aperture radiation from an axially slotted elliptical conducting cylinder using geometrical theory of diffraction.
Equatorial radiation pattern of parallel plate TEM mode axial slot on elliptical conducting cylinders, using wedge diffraction and creeping wave theory
Balanis, C. A.↗
Prediction of windage power loss in alternators
Simplified equations and constants, based on laminar and turbulent flow theory between parallel plates, estimate windage loss in rotating electrical machinery. Comparison of calculated results and experimental data for smooth cylindrical rotor and slotted alternator yields 7 percent maximum variation between calculated and experimental data.
Vrancik, J. E.↗
Large area pulse ionization chamber for measurement of extremely heavy cosmic rays
Parallel plate ionization chamber for identifying relativistic cosmic ray nuclei
Binns, W. R.↗
Anode phenomena in high-current discharges
Pinch and parallel-plate discharges, and analysis of anode region of quasi-steady MPD arc
Oberth, R. C.↗
Large-area pulse ionization chamber for measurement of extremely heavy cosmic rays
Large area parallel-plate pulse ionization chamber for high altitude balloon measurements of relativistic cosmic ray heavy nuclei
Binns, W. R.↗
Pulsed electromagnetic gas acceleration
Experimental data were combined with one-dimensional conservation relations to yield information on the energy deposition ratio in a parallel-plate accelerator, where the downstream flow was confined to a constant area channel. Approximately 70% of the total input power was detected in the exhaust flow, of which only about 20% appeared as directed kinetic energy, thus implying that a downstream expansion to convert chamber enthalpy into kinetic energy must be an important aspect of conventional high power MPD arcs. Spectroscopic experiments on a quasi-steady MPD argon accelerator verified the presence of A(III) and the absence of A(I), and indicated an azimuthal structure in the jet related to the mass injection locations. Measurements of pressure in the arc chamber and impact pressure in the exhaust jet using a piezocrystal backed by a Plexiglas rod were in good agreement with the electromagnetic thrust model.
Jahn, R. G.↗
The interaction of moderately strong shock waves with thick perforated walls of low porosity
A theoretical prediction is given of the flow through thick perforated walls of low porosity resulting from the impingement of a moderately strong traveling shock wave. The model was a flat plate positioned normal to the direction of the flow. Holes bored in the plate parallel to the direction of the flow provided nominal hole length-to-diameter ratios of 10:1 and an axial porosity of 25 percent of the flow channel cross section. The flow field behind the reflected shock wave was assumed to behave as a reservoir producing a quasi-steady duct flow through the model. Rayleigh and Fanno duct flow theoretical computations for each of three possible auxiliary wave patterns that can be associated with the transmitted shock (to satisfy contact surface compatibility) were used to provide bounding solutions as an alternative to the more complex influence coefficients method. Qualitative and quantitative behavior was verified in a 1.5- by 2.0-in. helium shock tube. High speed Schlieren photography, piezoelectric pressure-time histories, and electronic-counter wave speed measurements were used to assess the extent of correlation with the theoretical flow models. Reduced data indicated the adequacy of the bounding theory approach to predict wave phenomena and quantitative response.
Grant, D. J.↗
Development of MHD flow in the entrance region of a channel.
A general method has been developed for determining the developing magnetohydrodynamic flow in the entrance region of a parallel-plate channel. Closed form solutions are obtained. Numerical results are presented for the development of velocity distribution, pressure drop, and magnetohydrodynamic entrance length at different Hartmann numbers. At large Hartmann numbers, the magnetic field effect becomes dominant and the magnetohydrodynamic entrance length becomes negligible. Also, the pressure drop is enhanced by the magnetic field. Comparison of results with direct numerical analysis shows excellent agreement.-
Wu, S. T.↗
Thermal modeling of a cryogenic turbopump for space shuttle applications.
Thermal modeling of a cryogenic pump and a hot-gas turbine in a turbopump assembly proposed for the Space Shuttle is described in this paper. A model, developed by identifying the heat-transfer regimes and incorporating their dependencies into a turbopump system model, included heat transfer for two-phase cryogen, hot-gas (200 R) impingement on turbine blades, gas impingement on rotating disks and parallel plate fluid flow. The ?thermal analyzer' program employed to develop this model was the TRW Systems Improved Numerical Differencing Analyzer (SINDA). This program uses finite differencing with lumped parameter representation for each node. Also discussed are model development, simulations of turbopump startup/shutdown operations, and the effects of varying turbopump parameters on the thermal performance.
Knowles, P. J.↗
Welding of aluminum with linear ribbon explosives.
A small-scale simplified, parallel plate process of welding aluminum with very small quantities of lead-sheathed linear ribbon RDX explosive is described. The results of the welding of five different alloys, obtained by using this technique, show that the weld strengths are up to 90% of the parent metal tensile strength.
Bement, L. J.↗
A liquid xenon radioisotope camera.
A new type of gamma-ray camera is discussed that makes use of electron avalanches in liquid xenon and is currently under development. It is shown that such a radioisotope camera promises many advantages over any other existing gamma-ray cameras. Spatial resolution better than 1 mm and counting rates higher than one million C/sec are possible. An energy resolution of 11% FWHM has recently been achieved with a collimated Hg-203 source using a parallel-plate ionization chamber containing a Frisch grid.
Zaklad, H.↗
Calculation of energy deposition distributions for simple geometries
When high-energy charged particles pass through a thin detector, the ionization energy loss in that detector is subject to fluctuations or straggling which must be considered in interpreting the data. Under many conditions, which depend upon the charge and energy of the incident particle and the detector geometry, the ionization energy lost by the particle is significantly different from the energy deposited in the detector. This problem divides naturally into a calculation of the energy loss that results in excitation and low-energy secondary electrons which do not travel far from their production points, and a calculation of energy loss that results in high-energy secondary electrons which can escape from the detector. The first calculation is performed using a modification of the Vavilov energy loss distribution. A cutoff energy is introduced above which all electrons are ignored and energy transferred to low energy particles is assumed to be equivalent to the energy deposited by them. For the second calculation, the trajectory of the primary particle is considered as a source of secondary high-energy electrons. The electrons from this source are transported using Monte Carlo techniques and multiple scattering theory, and the energy deposited by them in the detector is calculated. The results of the two calculations are then combined to predict the energy deposition distribution. The results of these calculations are used to predict the charge resolution of parallel-plate pulse ionization chambers that are being designed to measure the charge spectrum of heavy nuclei in the galactic cosmic-ray flux.
Watts, J. W., Jr.↗
Multibeam antenna study, Phase 2
An antenna system concept for point to point communication between any two points in the Continental United States was developed using a synchronous orbit satellite. The design and fabrication of a two dimensional artificial dielectric lens contained in a parallel plate waveguide system is presented. The experimental pattern and voltage standing wave ratio results are listed from tests with four different lenses: a plano-convex natural dielectric (Teflon) lens, a plano-convex artificial dielectric lens, a two-point corrected Teflon lens, and a two-point corrected artificial dielectric lens. A computer simulated design of an operational two lens, 24 beam configuration is also presented. The computer design presents overlays of each beam onto the Continental United States from a fixed synchronous orbit satellite with a definition of these areas where beam-to-beam isolation is not sufficient to permit the reuse of frequency.
Byrnes, P. J.↗
Unsteady, combined radiation and conduction in an absorbing, scattering, and emitting medium.
The transient cooldown of a gray, absorbing, isotropic scattering, emitting, and conducting medium bounded by gray, diffusely emitting and reflecting parallel plates is considered. Numerical solutions are obtained for the initial boundary-value problem with a discontinuous decrease in temperature at one boundary. The quasi-steady equation of radiative transfer is solved using Gaussian quadrature and a matrix eigenvector technique together with explicit numerical solution of the unsteady energy equation. Temperature and energy flux distributions are presented for variations of optical thickness, boundary emissivity, albedo, and conduction-radiation parameter.
Weston, K. C.↗
Energetic particle flux experiment (IMP F and G)
The data reduction procedures and programs for analysis of the IMP F and G energetic particle flux experiments are summarized. The IMP-F experiment contained two thin-window Geiger-Mueller detectors and an ionization chamber. There were two IMP-G experiments: one with six Geiger-Mueller detectors and an ionization chamber, and the other with two funnel mouthed channeltrons in a parallel plate electrostatic analyzer. These experiments measured particles in the energy range above 20 keV (IMP-F) and above approximately 5 keV (IMP-G). A bibliography is presented of papers containing the scientific results. These data were predominantly used for the study of low energy solar particles from flares.
Anderson, K. A.↗
Combined radiation, convection, and conduction for a system with a partially transmitting wall
The net radiation method is developed for systems having both opaque and partially transparent walls. Heat convection is present at the surfaces and heat conduction through the windows is taken into account. Specific equations are derived for a window between two parallel plates, where one plate is at an elevated temperature typical of what would be encountered in an electric furnace, and the other plate is being cooled. A two-band model is used with cutoff wavelengths typical of glass or quartz. Numerical results are obtained for the window temperature and the heat flow through the window. The effect on these quantities of various plate temperatures and emissivities is shown.
Siegel, R.↗
Study of the performance of antennas in magnetized plasmas
The antenna studies were performed in a large magnetized plasma source, a schematic drawing of which is shown. The plasma diagnostics consist of a 70 GHz (4 mm) microwave interferometer for density measurements and of various Langmuir probes for spatially resolved measurements of t sub e, n sub e and the shape of the electron distribution function. All diagnostic data are time-resolved by sample-and-hold techniques so as to yield information about the plasma build-up, the steady-state discharge, and the plasma decay in the afterglow. Whistler waves are excited and detected with various antennas which are inserted into the center of the plasma column through one axial and two orthogonal radial ports. The antennas were tested for their proper dipole response and then calibrated in a known field geometry in air. For the electric dipole, a parallel plate capacitor field was used; the magnetic loop is calibrated in the near-zone field of a long linear conductor of known radio frequency current distribution. Results are presented and discussed.
Stenzel, R. L.↗