Search NASA⌕ Search

SEARCH · Search NASA

Results for “RAMAN SPECTRA”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Raman spectral observation of a new phase observed in nickel electrodes cycled to failure

A ‘new phase’ is reported in nickel electrodes from Ni/H2 boilerplate cells which were cycled to failure in electrolyte of variable KOH concentration (21–36%). Raman spectra clearly show the presence of this phase, and these spectra have been used to estimate the amounts present on these electrodes. Ten of twelve electrodes examined contain this new phase. The cycle life at higher KOH concentrations (31 and 36%) was greatly reduced, and nickel electrodes from these cells exhibited extensive amounts of this new phase. The presence of this ‘new phase’ correlates with cell failure defined by low end of discharge voltages. It is proposed that the lowered capacity and failure of these electrodes was caused by loss of active mass and formation of a phase with reduced electrochemical activity. These results indicate that formation of this new phase is accelerated at higher KOH concentrations.

Patricia L Loyselle↗
NASA NTRS1991

Carbonate stability in the earth's mantle - A vibrational spectroscopic study of aragonite and dolomite at high pressures and temperatures

The structural changes of aragonite and dolomite taking place at high pressures and temperatures were investigated by measuring the Raman spectra of these materials to pressures of 23 and 28 GPa (generated in a diamond anvil cell), respectively; in addition, the IR spectra of aragonite were measured to 40 GPa. The spectroscopic data demonstrated that, at 300 K, dolomite and aragonite samples were stable to pressures of 28 and 41 GPa, respectively. No phase transitions were observed following heating of aragonite and dolomite to temperatures of 2000 K and 800 K, respectively. The mode Grueneisen parameters indicate that the carbonate group in these two minerals is relatively insensitive to pressure, with the dominant compaction mechanism being the compression of the Ca and Mg polyhedra.

Kraft, Susan↗
NASA NTRS1992

Raman scattering of InGaAs/InP grown by uniform radial flow epitaxy

Uniform radial flow epitaxy, a novel growth technique, has been used to grown InGaAs films on InP. Epitaxial layers above and below the critical thickness for the onset of slip were grown. Raman spectroscopy was used to characterize the quality of epitaxial layers, determine alloy composition, and measure the strain. Raman spectra from both pseudomorphic (strained) and relaxed (unstrained) InGaAs films were obtained at 300 and 80 K. The difference in the frequencies of their GaAs-like longitudinal optical phonons was used to calculate stress for the strained InGaAs/InP, leading to a direct formula for the evaluation of the layer stress.

Feng, Z. C.↗
NASA NTRS1992

Nonequilibrium vibrational population measurements in an expanding flow using spontaneous Raman scattering

Vibrational relaxation of nitrogen in a 2D nozzle flow is studied using spontaneous Raman scattering. An electric arc driven shock tube operating as a reflected shock tunnel produces stagnation conditions of 5600 K and 100 atm. A 248 nm KrF laser pulse is focused into the nozzle to produce spatially resolved spontaneous Raman spectra. Vibrational population distributions are derived from the spectra for the states v = 0 to v = 8. The experimental results are compared with two theoretical models: the Landau-Teller relaxation model and a numerical solution of the master equations using transition rates derived from SSH theory. The Landau-Teller correction factor has been measured at 1.0 - 1.5.

Sharma, Surendra P.↗
NASA NTRS1993

Compact Raman Spectrometers Would Detect Hydrogen

Compact Raman spectrometers developed to measure concentrations of hydrogen as low as hundreds of parts per million in air, nitrogen, or other carrier gases. Advantages include speed, dynamic range, and ease of calibration. Design concept incorporates Raman-scattering apparatus into compact instrument of hydrogen leaking into stream of gas or into gas enclosed in small space. Should hydrogen-fueled cars and trucks come into widespread use, instruments used to detect leaks from vehicles and supply equipment, to help prevent explosions. Similar spectrometers developed to detect other gases emitting characteristic Raman spectra.

Helms, William R.↗
NASA NTRS1992

Ion produced cometary organic crust

For several years many experimental results have been obtained on the chemical and physical changes induced by ion and electron irradiation of materials with a view to their Astrophysical relevance. Among the studied effects, one of particular interest is the formation of an organic refractory residue left over after ion irradiation and warming-up at room temperature. We call this residue IPHAC (ion produced hydrogenated amorphous carbon). Although 'in situ' infrared spectroscopy points out the formation of new molecular species during bombardment at low temperature, it is not clear if IPHAC is already formed or if its formation is triggered by temperature increase during warming-up of the irradiated target. Since Raman Spectroscopy is a technique particularly suitable for the analysis of carbonaceous materials, we have thought and build-up an experimental apparatus to obtain Raman Spectra of frozen hydrocarbons during ion irradiation. The present experimental results point out clearly to the formation of IPHAC already at low T and low energy deposition (approximately equal to a few eV/C-atom).

Baratta, G. Antonio↗
NASA NTRS1995

Raman scattering characterization of space solar cell structures

A contactless method for the determination of the free-carrier density and the composition distribution across the thickness of 3-5 multi-layer solar cell structures, using the Raman scattering method, is developed. The method includes a step analysis of Raman spectra from optical phonons and phonon-plasmon modes of different layers. The method provides simultaneous measurements of the element composition and the thickness of the structure's layers together with the free-carrier density. The results of measurements of the free-carrier density composition distributions of the liquid phase epitaxy grown AlGaAs/GaAs and GaSb solar cell structures are presented and discussed.

Mintairov, Alexander M.↗
NASA NTRS1996

Raman Spectrum of Quenched Carbonaceous Composites

Quenched Carbonaceous Composites (QCC's) are products from the ejecta of a hydrocarbon plasma. Two types of QCC, dark QCC and thermally-altered (heated) filmy QCC, have been shown to have a 220 nm absorption feature similar to that seen in the interstellar extinction curve. We present here Raman spectra of the QCCs and compare them with various carbonaceous materials to better understand the structure QCC. We find that structure of QCC is different from that of graphite and more similar to carbonaceous material found in some interplanetary dust particles and chondritic meteorites.

Wada, S.↗
NASA NTRS1997

Qualitative Flow Visualization of a 110-N Hydrogen/Oxygen Laboratory Model Thruster

The flow field inside a 110 N gaseous hydrogen/oxygen thruster was investigated using an optically accessible, two-dimensional laboratory test model installed in a high altitude chamber. The injector for this study produced an oxidizer-rich core flow, which was designed to fully mix and react inside a fuel-film sleeve insert before emerging into the main chamber section, where a substantial fuel film cooling layer was added to protect the chamber wall. Techniques used to investigate the flow consisted of spontaneous Raman spectra measurements, visible emission imaging, ultraviolet hydroxyl spectroscopy, and high speed schlieren imaging. Experimental results indicate that the oxygen rich core flow continued to react while emerging from the fuel-film sleeve, suggesting incomplete mixing of the hydrogen in the oxygen rich core flow. Experiments also showed that the fuel film cooling protective layer retained its integrity throughout the straight section of the combustion chamber. In the converging portion of the chamber, however, a turbulent reaction zone near the wall destroyed the integrity of the film layer, a result which implies that a lower contraction angle may improve the fuel film cooling in the converging section and extend the hardware lifetime.

deGroot, Wim A.↗
NASA NTRS1998

Raman and Photoluminescence Spectroscopy of Nano-crystalline PbTiO3 Sensor Materials with Different Doping Ions

Raman spectra & photoluminescence studies in PbTiO3, have been carried out, as a function of particle size, temperature, pressure and dopants. There appears respectively a distinct temperature-induced soft mode phase transition in each sample whose Curie temperature can be determined from the mean-field theory. The detailed Curie temperature shift in the modified PbTiO3 ceramics by Ba, Sr, La and Zr, has been investigated as a function of particle size. Pressure-induced phase transitions display an obvious diffuse behavior. Room temperature photoluminescence for nanocrystalline Ba(1-x)Pb(x)TiO3 have been observed. These studies favor preparations of high efficiency PbTiO3 sensors.

Katiyar, R. S.↗
NASA NTRS2000

Raman Study of Uncoated and P-bn/sic-coated Hi-nicalon Reinforced Celsian Matrix Composites: Residual Stress in the Fibers - Part 2

Band shifts on Raman spectra were used to assess, at a microscopic scale, the residual strain existing in Hi-Nicalon fibers reinforcing celsian matrix composites. Uncoated as well as p-BN/SiC- and p-B(Si)N/SiC-coated Hi-Nicalon fibers were used as the reinforcements. We unambiguously conclude that the fibers are in a state of compressive residual stress. Quantitative determination of the residual stress was made possible by taking into account the heating induced by laser probing and by using a reference line, of fixed wavenumber. We found fiber compressive residual stress values between 110 and 960 MPa depending on the fiber/matrix coating in the composite. A stress relaxation-like phenomenon was observed at the surface of p-BN/SiC-coated Hi-Nicalon fibers whereas the uncoated or p-B(Si)N/SiC-coated Hi-Nicalon fibers did not show any stress relaxation in the Celsian matrix composites.

Gouadec, Gwenael↗
NASA NTRS1997

A New Probe to Change Curie Temperature of PbTiO3 Sensors

High temperature Raman spectra of nanocrystalline Pb(0.8)Ba(0.2)TiO3, Pb(0.8)Sr(0.2) TiO3, Pb(0.8)La(0.2)TiO3 and Pb(0.8)Ba(0.2)TiO3, have been measured, as a function of particle size. There appears respectively a distinct temperature-induced soft mode phase transition in every sample whose Curie temperature can be determined from the mean-field theory. The detailed Curie temperature shift in modified PbTi03 ceramics by Ba, Sr, La, and Zr, has also been investigated as a function of particle size. This study will favor preparations of high efficiency PbTi03 sensors with an adjustable Curie temperature.

Katiyar, R. S.↗
NASA NTRS2001

Growth Orientation of Carbon Nanotubes by Thermal CVD

Carbon nanotubes with a few shells are synthesized using thermal chemical vapor depositions. The sizes of these carbon nanotubes (CNT) are quite uniform and the length is up to several tens of micrometers. With the particular substrate location for which the substrate surface is normal along or against the gravity vector, different growth orientations of CNT are observed by scanning electron microscopy, though the Raman spectra for samples at different locations are similar to each other. The results suggest the gravitation effects in growth of the long and small diameter CNT.

Zhu, S.↗
NASA NTRS2001

Gravity Effects in Carbon Nanotube Growth by Thermal Chemical Vapor Deposition

Carbon nanotubes are synthesized using thermal chemical vapor deposition. The sizes of these carbon nanotubes (CNT) are quite uniform and the length of the tube is up to several tens of micrometers. With the substrate surface normal either along or against the gravity vector, different growth orientations of CNT are observed by scanning electron microscopy although the Raman spectra are similar for samples synthesized at different locations. These results suggest the gravitation effects in the growth of long and small diameter CNT.

Zhu, S.↗
NASA NTRS2001

A Structural Transition of Carbon Nanotubes?

The superior properties of carbon nanotubes (CNT) are good for many applications. A possible temperature-related structural transition is found in the CNT, which may suggest new applications of CNT. CNT materials have been synthesized on Si substrates by pulsed laser vaporization in various temperatures and pressures. Raman spectroscopy and scanning electron microscopy are used to determine the CNT structure and morphology. It is found that the formation of nanotubes depends strongly on the growth temperatures and high quality multi-wall and single-wall nanotubes were produced at 700 and 990 C, respectively. The radial breath modes of Raman spectra measured in the range of 50 cm(exp -1) to 300 cm(exp -1), indicate that one of samples grown at 700 C is to be dependent on the excitation intensity. The spectra of the sample suggest that the structure is similar to that of multi-wall nanotubes at low excitation intensity (2.5 kW per square centimeter) and it converts to the structure of single-wall nanotubes at higher intensity (25 kW per square centimeter). Measurements taken while cycling the light intensity suggests a reversible transition.

Zhu, Shen↗
NASA NTRS2001

Orientational Growth of Carbon Nanotube for Applications

Since the superior properties of multi-wall carbon nanotubes (MWCNT) could improve numerous devices such as electronics and sensors, many efforts have been made in investigating the growth mechanism of MWCNT to synthesize high quality MWCNT. Most applications require uniform aligned CNT. In this presentation, a directional growth of CNT will be reported. Carbon nanotubes are synthesized using thermal chemical vapor deposition. Temperature and pressure are two important growth parameters for fabricating carbon nanotubes. It is found that the nanotube diameter distribution mainly depends on the growth-temperature. With the substrate surface normal either along or against the gravity vector, different growth orientations of MWCNT are observed by scanning electron microscopy although the Raman spectra are similar for samples synthesized at different locations. The sizes of these carbon nanotubes in each sample are quite uniform and the length of the tube is up to several tens of micrometers. These results suggest the gravitation effects in the growth of long and small diameter CNT.

Zhu, Shen↗
NASA NTRS2002

Seeking and Identifying Phyllosilicates on Mars - A Simulation Study

In a simulation of seeking phyllosilicates on Mars, terrestrial ocean sediments were found to provide high quality Raman spectra of clays with low interfering fluorescence because most organic residues had been converted to graphitic carbon. Additional information is contained in the original extended abstract.

Wang, A.↗