Search NASA⌕ Search

SEARCH · Search NASA

Results for “REFLECTION COEFFICIENT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Fabrication and surface characterization of composite refractory compounds suitable for thermionic converters

Procedures for fabricating high purity single crystals of LaB6 and SmB6 have been developed. Auger spectroscopy shows that a clean surface can be obtained by thermal heating at 1700 K; such a clean surface gives a value of B/La of 2.3 to 2.6 for the (100) face. The measured thermionic and FERP work functions of the (100) face of LaB6 are 2.47 and 2.28 eV, respectively. The electron reflection coefficient for LaB6(100) increases near zero primary energy to 0.5. Flash thermal desorption of an oxygen dosed surface showed that B2O3 is the desorption product at 1600 to 1700 K. A work function increase of 1.6 eV was observed on oxygen adsorption on LaB6(100). Thermal desorption of Co occurs at approximately 1300 K. A reduction of the work function to 1.39 eV was observed on adsorption of a partial monolayer of Cs on LaB6(100). The evaporation of LaB6 occurs as atomic La and B with a value of B/La of 6 to 3 in the temperature range 1700 to 2000 K. The activation energies of desorption for La and B are 6.3 + or - 0.3 and 6.8 + or - 0.3 eV, respectively.

Swanson, L. W.↗
NASA NTRS1975

Effect of flow on the acoustic resonances of an open-ended duct

The effect of flow on the acoustic resonances of an open-ended, hard-walled duct is analyzed. The flow produces acoustic losses both in the interior of the duct and at the ends. Unless the duct is very long, typically 100 times the diameter, the losses at the ends dominate. At flow Mach numbers in excess of 0.4 the losses are so large that axial duct resonances are almost completely suppressed. The plane-wave Green's function for the duct with flow is expressed in terms of the (experimentally determined) pressure reflection coefficients at the ends of the duct, and the flow dependence of the complex eigenfrequencies of the duct is obtained. Some observations concerning the noise produced by the flow in the duct are also reported.

Ingard, U.↗
NASA NTRS1975

Measurement of lunar and planetary magnetic fields by reflection of low energy electrons

The paper describes the technique of planetary electron reflection magnetometry (PERM), a method for measuring the magnitude, direction, and scale size of magnetic fields near the surface of the moon and other planetary bodies with weak and small-scale-size surface fields. It is noted that the PERM technique is based on the ability of magnetic fields to reflect charged particles. A qualitative account of the implementation of the technique is presented along with some results obtained by the Apollo 15 and 16 Particles and Fields subsatellites. The quantitative aspects of PERM are treated by examining solutions to the equation of motion of a charged particle in a magnetic field, computing reflection coefficients on the basis of trajectory calculations, and determining the direction of the lunar surface magnetic field. The sensitivity of the PERM technique is calculated, and effects of lunar electric fields and spacecraft potentials on the measurements are described. Extension of the technique to Mars and Venus is discussed.

Anderson, K. A.↗
NASA NTRS1976

A multi-modal solution for the transmission of sound in nonuniform ducts

The method of weighted residuals in the form of a modified Galerkin method with boundary residuals is developed for the study of the transmission of sound in nonuniform ducts carrying a steady compressible flow. In this formulation the steady flow is modeled as essentially one-dimensional but with a kinematic modification to force tangency of the flow at the duct walls. Good agreement has been obtained with known results for transmission and reflection coefficients in hard walled ducts up to near sonic velocities. In ducts with acoustically compliant boundaries good comparisons have been more difficult to achieve except at low Mach numbers. The problem of transmission in a straight, acoustically treated duct with a uniform flow has been formulated and the Galerkin method used with basis functions derived from the case when flow is absent. Results indicate that favorable comparisons with exact computations can be obtained if care is taken in choosing the basis functions.

Eversman, W.↗
NASA NTRS1976

A new method for solving problems of sound radiation from a duct for the case of low Mach number

A method for rapidly solving duct end-plane impedance problems is presented which is based on deriving a form of the Helmholtz integral formula expressing the normal derivative of the acoustic pressure at a boundary point. A set of integral expressions is obtained by satisfying the existing boundary conditions and then solved using a general collocation method. The results obtained for the Levine-Schwinger (1948) problem agree well with the exact values. In the case of a duct flow having a temperature mismatch with the surroundings, the results show an increase in the magnitude of the reflection coefficient for the case of a cold core, and a decrease in its value for the case of a hot core, as compared with the case of exhaust into a uniform medium. A phase change of between pi/2 and pi is nearly always achieved, which indicates the tendency towards maintaining a constant pressure at the exit plane. The method can easily be extended to arbitrary duct shapes as long as they are axisymmetric.

Wahbah, M. M.↗
NASA NTRS1977

Electromagnetic power absorber

Device has reflection coefficient of order of few tenths of percent and is designed to maintain isothermal temperature distribution in high-power microwave and laser applications. Rigid tile functions over broad temperature range and serves as blackbody radiometric standard. Tile modules allow assembly of compact and economical custom-design configurations. Epoxy surface of tiles is insulated with styrofoam against environmental changes and is not subject to convective heat loss. Technique also prevents moisture accumulation and serves as infrared radiation shield.

Iwasaki, R.↗
NASA NTRS1977

Effect of surface roughness on the microwave brightness temperature of soils

The effect of surface roughness on the brightness temperature of a moist terrain was studied through the modification of Fresnel reflection coefficient and using the radiative transfer equation. Model calculations are in good qualitative agreement with the observed dependence of the brightness temperature on the moisture content in the surface layer.

Choudhury, B. J.↗
NASA NTRS1977

Radiation from the open end of a cylindrical or conical pipe and scattering from the end of a rod or slab

The radiation of sound through the open end of a cylindrical or conical pipe of any cross section, or through a hole in a plane wall, is analyzed theoretically. The scattering of a sound wave by the end of a rod or slab is also treated. Only the case in which the wavelength is large compared with a typical radial dimension of the opening or of the end is considered. The method of matched asymptotic expansions is employed. Results on end corrections and reflection coefficients previously obtained by Helmholtz (1860), Rayleigh (1945), and Bazer and Karp (1954), using intuitive arguments, are recovered and verified. Agreement is found with the exact results of Levine and Schwinger (1948) and Vainstein (1948), as well as with the small radial-dimension/wavelength results of Lesser and Lewis (1972), in the cases they treated. In addition various new results are obtained.

Ting, L.↗
NASA NTRS1978

Investigation of ground reflection and impedance from flyover noise measurements

An extensive series of flyover noise tests was conducted for the primary purpose of studying meteorological effects on propagation of aircraft noise. The test airplane, a DC 9-10, flew several level-flight passes at various heights over a taxiway. Two microphone stations were located under the flight path. A total of 37 runs was selected for analysis and processed to obtain a consistant set of 1/3 octave band sound pressure levels at half-second intervals. The goal of the present study was to use the flyover noise data to deduce acoustical reflection coefficients and hence, acoustical impedances.

Chapkis, R. L.↗
NASA NTRS1978

Effect of surface roughness on the microwave emission from soils

The effect of surface roughness on the brightness temperature of a moist terrain was studied through the modification of Fresnel reflection coefficient and using the radiative transfer equation. The modification involves introduction of a single parameter to characterize the roughness. It is shown that this parameter depends on both the surface height variance and the horizontal scale of the roughness. Model calculations are in good quantitative agreement with the observed dependence of the brightness temperature on the moisture content in the surface layer. Data from truck mounted and airborne radiometers are presented for comparison. The results indicate that the roughness effects are greatest for wet soils where the difference between smooth and rough surfaces can be as great as 50K.

Choudhury, B. J.↗
NASA NTRS1977

Reflection and radiation due to a quadrupole near a fluid interface

The reflection of sound at an interface between two fluid half-space in relative motion (one in motion and the other at rest), but with different density and different sound speed, is considered. The reflection coefficient is found in an explicitly closed form. A brief discussion of the effect of mean velocity, i.e., corresponding Mach number on different noise generating quadrupole directivities concludes the presentation of the paper. The graphs provided illustrate this aspect in a rather more convincing way.

Dash, R.↗
NASA NTRS1978

A finite element method for transmission in non-uniform ducts without flow Comparison with the method of weighted residuals

A finite element method is derived for studying the transmission of sound in nonuniform ducts without flow. The method is based on a weighted residuals technique and eight noded isoparametric elements. The method employs two computational schemes: the Helmholtz equation found through conservation equations, and the conservation equations themselves. Solutions are found for transmission and reflection coefficients for both two-dimensional and circular geometries. Numerical solutions are compared with those for a method of weighted residuals in the form of a modified Galerkin method, showing good agreement.

Astley, R. J.↗
NASA NTRS1978

Loaded horizontal antenna over an imperfect ground

The effect of loading for antennas over an imperfect ground is analyzed. The Fresnel reflection coefficient technique is used to derive an E-integral equation for the antenna current. An optimization method is employed to determine the critical loading parameter which enforces a traveling wave current on the antenna. Results are given for the critical loading parameters, antenna currents, input impedances, and radiation patterns for various antenna dimensions and ground parameters. Calculations of the time-domain behavior of the current are presented to show the effect of loading on antenna transient response.

Rahmat-Samii, Y.↗
NASA NTRS1979

Sound radiation from hyperboloidal inlet ducts

This paper presents rigorous solutions for the problem of sound radiation from various inlet ducts including hyperboloidal (or hyperbolic) inlet ducts and circular ducts with wide flange. The numerical results include the complex conversion (or reflection) coefficients and the radiation directivity for the various incident wave modes - spinning modes as well as axisymmetric modes. The analysis utilizes hyperboloidal wave functions which are defined here as a class of eigensolutions of the wave equation for oblate spheroidal coordinates, and is valid for the whole frequency range including frequencies above and below the cutoff frequencies of duct modes involved.

Cho, Y. C.↗
NASA NTRS1979

An impulse test technique with application to acoustic measurements

A method has been presented for measuring the acoustic properties of an absorbent material and a duct/nozzle system (with or without airflow) using a high voltage spark discharge as an impulse source of sound. The cross-spectra of the incident, reflected and transmitted acoustic pressure transients are analyzed by way of a FFT digital processor in the form of complex transfer functions. These transfer functions have a direct relationship to the termination impedance and radiation directivity. The impulse method has been justified by comparisons, with data obtained from existing methods (both experimental and theoretical), that show excellent agreement. Reflection coefficients and radiation impedances of various duct-nozzle systems and their associated far-field directivities are also presented as some of the applications of the impulse technique.

Salikuddin, M.↗
NASA NTRS1979

Effect of surface roughness on the microwave emission from soils

The effect of surface roughness on the brightness temperature of a moist terrain has been studied through the modification of Fresnel reflection coefficient and using the radiative transfer equation. The modification involves introduction of a single parameter to characterize the roughness. It is shown that this parameter depends on both the surface height variance and the horizontal scale of the roughness. Model calculations are in good quantitative agreement with the observed dependence of the brightness temperature on the moisture content in the surface layer. Data from truck mounted and airborne radiometers are presented for comparison. The results indicate that the roughness effects are great for wet soils where the difference between smooth and rough surfaces can be as great as 50 K.

Choudhury, B. J.↗
NASA NTRS1980

Differential correction capability of the GTDS using TDRSS data

A differential correction (DC) capability was implemented in the Goddard Trajectory Determination System (GTDS) to process satellite tracking data acquired via the Tracking and Data Relay Satellite System (TRDRSS). Configuration of the TDRSS is reviewed, observation modeling is presented, and major features of the capability are discussed. The following types of TDRSS data can be processed by GTDS: two way relay range and Doppler measurements, hybrid relay range and Doppler measurements, one way relay Doppler measurements, and differenced one way relay Doppler measurements. These data may be combined with conventional ground based direct tracking data. By using Bayesian weighted least squares techniques, the software allows the simultaneous determination of the trajectories of up to four different satellites - one user satellite and three relay satellites. In addition to satellite trajectories, the following parameters can be optionally solved: for drag coefficient, reflectivity of a satellite for solar radiation pressure, transponder delay, station position, and biases.

Liu, S. Y.↗
NASA NTRS1980

Inlet contour and flow effects on radiation

An experimental investigation of sound radiation from inlets with different contours with and without flow is being conducted to study the possibility of reducing noise radiated by aircraft engines. For each inlet configuration, complex directivity patterns and complex pressure reflection coefficients are measured as a function of a single space-time structure of the wave (up to a frequency of 4000Hz and an azimuthal wave number 6) and of flow velocity (up to Mach number 0.4) in a cylindrical duct located downstream the inlet. Experimental results of radiation from an unflanged duct are compared with theory. Effect of inlet contour and flow are deduced by comparing respectively unflanged duct and bellmouth measurements and, no flow and flow measurements with the bellmouth. Results are presented which indicate that the contour effect is significant near the cut-on frequency of a mode and emphasize the necessity for taking into account the inlet geometry in a radiation prediction. These results show also that internal flow has a weak effect on the amplitude of the directivity pattern

Ville, J. M.↗