SEARCH · Search NASA

Results for “Spares”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10

All sources NASA NTRS DOE OSTI

NASA NTRS1972

RAE-B antenna aspect system

The development of a facsimile camera to serve as the antenna aspect system for the second generation Radio Astronomy Explorer Satellite designated RAE-B is summarized. The camera system consists of two cameras and a data encoder. The program deliverables were two flight cameras, a flight encoder and one spare flight encoder. The RAE-B satellite was originally intended for an earth orbit mission and the facsimile subsystem characteristics were specified with this in mind. Subsequently the flight mission was changed to orbit the moon; however the change occurred too late to significantly influence the facsimile system design. Therefore, this report considers only compliance of the system to earth orbit requirements.

Source record↗

NASA NTRS1972

Technology development and demonstration of a low thrust resistojet thruster

Three thrusters were fabricated to definitized thruster drawings using new rhenium vapor deposition technology. Two of the thrusters were operated using ammonia as propellant and one was operated using hydrogen propellant for performance determination. All demonstrated consistent operational specific impulse performance while demonstrating thermal performance better than the development units from which they evolved. Two of the thrusters were subjected to environmental structural testing including vibration, acceleration and shock loading to specifications. Both of the thrusters subjected to the environmental tests passed all required tests. The third, spare, thruster was introduced into the life test portion of the program. Two thrusters were then subjected to a life cycling test program under typical spacecraft operating power levels. During the life test sequence, the hydrogen thruster accrued 720 operating life test cycles, more than 370 on-off cycles and 365 hours of powered up time. The ammonia accrued approximately 380 on-off cycles and 392.2 on time hours of operation during the 720 cycling hour test. Both thrusters completed the scheduled operational life test in reasonably good condition, structurally integral and capable of indefinite further operation.

Pfeifer, G. R.↗

NASA NTRS1973

Logistics hardware and services control system

Software system permits onsite direct control of logistics operations, which include spare parts, initial installation, tool control, and repairable parts status and control, through all facets of operations. System integrates logistics actions and controls receipts, issues, loans, repairs, fabrications, and modifications and assets in predicting and allocating logistics parts and services effectively.

Koromilas, A.↗

NASA NTRS1972

Optimum spaceborne computer system design by simulation

A deterministic digital simulation model is described which models the Automatically Reconfigurable Modular Multiprocessor System (ARMMS), a candidate computer system for future manned and unmanned space missions. Use of the model as a tool in configuring a minimum computer system for a typical mission is demonstrated. The configuration which is developed as a result of studies with the simulator is optimal with respect to the efficient use of computer system resources, i.e., the configuration derived is a minimal one. Other considerations such as increased reliability through the use of standby spares would be taken into account in the definition of a practical system for a given mission.

Williams, T.↗

NASA NTRS1972

Analysis of space tug operating techniques supplemental report (study 2.4)

An analysis of space tug operating techniques is presented. The subjects discussed are: (1) sustaining engineering requirements, (2) off-site facility requirements, (3) evaluation of tug checkout alternatives, and (4) spares provisioning. Tables of data are included to clarify the written presentation.

Source record↗

NASA NTRS1972

A universal functional object

A scheme is presented for realizing any function, combinational or sequential, in a single universal function scheme, termed the universal function object UF. This scheme is addressed to the problem of the proliferation of the number of parts (cards, chips) necessary for conventional implementation in an LSI technology of a computer system. The UF implementation will use about ten times more circuits than a conventional implementation regardless of the size of the design. The UF approach also includes general-purpose spares for failing circuits. The procedure could be used both at manufacture to increase yields, as well as to achieve automatic repair.

Roth, J. P.↗

NASA NTRS1972

Canonical fluid thermodynamics

The space-time integral of the thermodynamic pressure plays the role of the thermodynamic potential for compressible, adiabatic flow in the sense that the pressure integral for stable flow is less than for all slightly different flows. This stability criterion can be converted into a variational minimum principle by requiring the molar free-enthalpy and the temperature, which are the arguments of the pressure function, to be generalized velocities, that is, the proper-time derivatives of scalar spare-time functions which are generalized coordinates in the canonical formalism. In a fluid context, proper-time differentiation must be expressed in terms of three independent quantities that specify the fluid velocity. This can be done in several ways, all of which lead to different variants (canonical transformations) of the same constraint-free action integral whose Euler-Lagrange equations are just the well-known equations of motion for adiabatic compressible flow.

Schmid, L. A.↗

NASA NTRS1972

Feasibility investigation of a cellularly organized data processor

The application of cellular arrays to NASA missions was studied. Cellular arrays are iterative logical and memory structures which can be programmed to accomplish a wide variety of logical tasks. Used in long-duration space missions, spare cellular arrays can be remotely programmed to replace faulty logical subsystems as the need arises.

Minnick, R. C.↗

NASA NTRS1973

Evaluation of an electrochemical N2/H2 gas separator

A program was successfully completed to evaluate an electrochemical nitrogen/hydrogen (N2/H2) separator for use in a spacecraft nitrogen (N2) generator. Based on the technical data obtained a N2/H2 separator subsystem consisting of an organic polymer gas permeator first stage and an electrochemical second and third stage was estimated to have the lowest total spared equivalent weight, 257 kg (566 lb), for a 15 lb/day N2 generation rate. A pre-design analysis of the electrochemical N2/H2 separator revealed that its use as a first stage resulted in too high a power requirement to be competitive with the organic polymer membrane and the palladium-silver membrane separation methods. As a result, program emphasis was placed on evaluating the electrochemical. A parametric test program characterized cell performance and established second- and third-stage electrochemical N2/H2 separator operating conditions. A design verification test was completed on the second and third stages. The second stage was then successfully endurance tested for 200 hours.

Marshall, R. D.↗

NASA NTRS1973

The effects on cruise drag of installing refan-engine nacelles on the McDonnell-Douglas DC-9

A high speed wind tunnel test has been conducted to determine the effect on cruise drag for installing larger JT8D Refan engine nacelles on the Douglas DC-9. Drag data and wing- and nacelle/pylon/fuselage-channel pressure data are presented. Reduced pylon spares, required to minimize effects of the nacelle installation on low-speed deep stall, were investigated. The reduce span pylons resulted in no adverse interference effects. At typical cruise Mach numbers the measured penalty for the Refan installation was less than estimated due to a favorable effect of the larger entering engine stream tube suppressing the wing upper-surface velocities with subsequent wing compressibility drag reduction. Channel pressures show no shock waves or boundary layer separations.

Callaghan, J. T.↗

NASA NTRS1973

Sparse matrix methods based on orthogonality and conjugacy

A matrix having a high percentage of zero elements is called spares. In the solution of systems of linear equations or linear least squares problems involving large sparse matrices, significant saving of computer cost can be achieved by taking advantage of the sparsity. The conjugate gradient algorithm and a set of related algorithms are described.

Lawson, C. L.↗

NASA NTRS1972

Shuttle sortie simulation using a Lear jet aircraft: Mission no. 1 (assess program)

The shuttle sortie simulation mission of the Airborne Science/Shuttle Experiments System Simulation Program which was conducted using the CV-990 aircraft is reported. The seven flight, five day mission obtained data on experiment preparation, type of experiment components, operation and maintenance, data acquisition, crew functions, timelines and interfaces, use of support equipment and spare parts, power consumption, work cycles, influence of constraints, and schedule impacts. This report describes the experiment, the facilities, the operation, and the results analyzed from the standpoint of their possible use in aiding the planning for experiments in the Shuttle Sortie Laboratory.

Mulholland, D. R.↗

NASA NTRS1972

The ATA-67 Formula for Direct Operating Cost

The ATA formulas for direct operating cost were developed for the purpose of comparing different aircraft, existing or not, on the same route or the same aircraft on different routes. Such characteristics of the airline as crew pay, maintenance procedures, and depreciation schedules are kept constant. In air transportation systems analysis the 1967 ATA formula is usually used with appropriate exceptions or modifications, such as: different maintenance labor rate, total maintenance multiplied by a factor, maintenance burden deleted, different depreciation schedule, or different spares percentages.

Faulkner, H. B.↗

NASA NTRS1975

Automated maintenance for complex hybrid systems

Digital computer, Control Computer Subsystem (CCS), possess high degree of fault tolerance. CCS embodies concepts of self-test and repair. It is capable of monitoring its own performance and of identifying and replacing with standby spare any of its units that fail.

Gilley, G. C.↗

NASA NTRS1973

Extendible-retractable electric field measurement antenna for IMP J

An antenna dispenser mechanism for the IMP J spacecraft was designed, fabricated, and tested. Upon command the mechanism deploys or retracts a conductor for use as a receiving antenna for an electric field measurement experiment. Five identical units were fabricated and tested to the IMP H & J environmental test specification. Of these, four are designated for flight on the IMP J spacecraft and one as a prototype flight spare. The testing program was successfully completed although certain design modifications were required as problems were uncovered by the testing; particularly thermal vacuum operation. The antenna mechanism functions well under the expected environmental and loading conditions. The wear life and load capability of the dry molybdenum disulphide lubricant originally used on the heavily loaded worm and gear pair were disappointing and a substitute material was applied. The lubricant finally applied performed well; although other problems were generated.

Larrick, W.↗

NASA NTRS1974

Unpowered to powered failure rate ratio - A key reliability parameter

It is shown that the initial assumption of the ratio of unpowered to powered failure rates can have a strong influence on the design of a modular system intended for space missions. The analysis is performed for parallel systems and for triple modular redundant systems. Parallel systems are shown to be much more sensitive to the unpowered to powered failure rate ratio than the TMR/Spares systems, however, regardless of which standby redundancy technique is considered, the dependence of the system reliability on this ratio increases as the number of standby spares increases.

Taylor, D. S.↗

NASA NTRS1974

The reliability impact of mission abort strategies on redundant flight computer systems

This correspondence presents a reliability model for a redundant flight computer system with standby sparing, taking into account various mission abort strategies. A mission rule to initiate a mission abort after a predetermined number of detected computer failures and to return to earth with the remaining computers is shown to result in: (1) little improvement of crew safety unless computer error coverage is nearly perfect, and (2) significant degradation in mission success whenever coverage is high.

Filene, R. J.↗

NASA NTRS1974

Development status of solid polymer electrolyte water electrolysis for manned spacecraft life support systems

Details of the design and system verification test results are presented for a six-man-rated oxygen generation system. The system configuration incorporates components and instrumentation for computer-controlled operation with automatic start-up/shutdown sequencing, fault detection and isolation, and with self-contained sensors and controls for automatic safe emergency shutdown. All fluid and electrical components, sensors, and electronic controls are designed to be easily maintainable under zero-gravity conditions. On-board component spares are utilized in the system concept to sustain long-term operation (six months minimum) in a manned spacecraft application. The system is centered on a 27-cell solid polymer electrolyte water electrolysis module which, combined with the associated system components and controls, forms a total system envelope 40 in. high, 40 in. wide, and 30 in. deep.

Nuttall, L. J.↗