Search NASA⌕ Search

SEARCH · Search NASA

Results for “Yaw”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Static and yawed-rolling mechanical properties of two type 7 aircraft tires

Selected mechanical properties of 18 x 5.5 and 49 x 17 size, type 7 aircraft tires were evaluated. The tires were subjected to pure vertical loads and to combined vertical and lateral loads under both static and rolling conditions. Parameters for the static tests consisted of tire load in the vertical and lateral directions, and parameters for the rolling tests included tire vertical load, yaw angle, and ground speed. Effects of each of these parameters on the measured tire characteristics are discussed and, where possible, compared with previous work. Results indicate that dynamic tire properties under investigation were generally insensitive to speed variations and therefore tend to support the conclusion that many tire dynamic characteristics can be obtained from static and low speed rolling tests. Furthermore, many of the tire mechanical properties are in good agreement with empirical predictions based on earlier research.

Tanner, J. A.↗
NASA NTRS1981

Curved-flow, rolling-flow, and oscillatory pure-yawing wind-tunnel test methods for determination of dynamic stability derivatives

The test capabilities of the Stability Wind Tunnel of the Virginia Polytechnic Institute and State University are described, and calibrations for curved and rolling flow techniques are given. Oscillatory snaking tests to determine pure yawing derivatives are considered. Representative aerodynamic data obtained for a current fighter configuration using the curved and rolling flow techniques are presented. The application of dynamic derivatives obtained in such tests to the analysis of airplane motions in general, and to high angle of attack flight conditions in particular, is discussed.

Chambers, J. R.↗
NASA NTRS1981

Curved-flow, rolling-flow, and oscillatory pure-yawing wind-tunnel test methods for determination of dynamic stability derivatives

Dynamic stability derivatives are evaluated on the basis of rolling-flow, curved-flow and snaking tests. Attention is given to the hardware associated with curved-flow, rolling-flow and oscillatory pure-yawing wind-tunnel tests. It is found that the snaking technique, when combined with linear- and forced-oscillation methods, yields an important method for evaluating beta derivatives for current configurations at high angles of attack. Since the rolling flow model is fixed during testing, forced oscillations may be imparted to the model, permitting the measurement of damping and cross-derivatives. These results, when coupled with basic rolling-flow or rotary-balance data, yield a highly accurate mathematical model for studies of incipient spin and spin entry.

Chambers, J. R.↗
NASA NTRS1986

Comparison of computations and experimental data for leading edge vortices - Effects of yaw and vortex flaps

Computations are presented using the conical Euler equations for swept delta wings with leading edge vortices. All the wings have sharp leading edges swept at 75 degrees to the freestream. In addition to an idealized flat plate model, geometrical features also included are thickness, centerbody, and two vortex flaps. Freestream Mach numbers of 1.7 to 2.8, angles of attack of 10 and 12 degrees, and angles of yaw of 0 and 8 degrees are considered. The computations are compared with pitot pressure traverses for one case. Other calculations are compared with pitot pressure traverses for one case. Other calculations are compared with surface pressure data and vapor screen pictures recently obtained at NASA Langley Research Center. The comparisons indicate that the dominant features of these flows are adequately modeled by the Euler equations, but viscous models are needed for the surface boundary layer and secondary separations.

Murman, E. M.↗
NASA NTRS1986

Comparison of computations and experimental data for leading edge vortices - Effects of yaw and vortex flaps

Computations are presented using the conical Euler equations for swept delta wings with leading edge vortices. All the wings have sharp leading edges swept at 75 degrees to the freestream. In addition to an idealized flat plate model, geometrical features also included are thickness, centerbody, and two vortex flaps. Freestream Mach numbers of 1.7 to 2.8, angles of attack of 10 and 12 degrees, and angles of yaw of 0 and 8 degrees are considered. The computations are compared with pitot pressure traverses for one case. Other calculations are compared with surface pressure data and vapor screen pictures recently obtained at NASA Langley Research Center. The comparisons indicate that the dominant features of these flows are adequately modeled by the Euler equations, but viscous models are needed for the surface boundary layer and secondary separations.

Murman, E. M.↗
NASA NTRS1988

Yaw Control At High Angles Of Attack

Hinged, conformal forebody strakes provide control when rudders become ineffective. Device consists of symmetric pair of longitudinally hinged strakes designed to fold completely into forebody contour. Strakes rotate individually out into external flow. Asymmetric flow produced by deployed strake generates sideward force causing aircraft to yaw.

Murri, Daniel G.↗
NASA NTRS1987

Cat vestibular neurons that exhibit different responses to active and passive yaw head rotations

Neurons in the vestibular nuclei were recorded in alert cats during voluntary yaw rotations of the head and during the same rotations delivered with a turntable driven from a record of previous voluntary movements. During both voluntary and passive rotations, 35 percent (6/17) of neurons tested responded at higher rates or for a larger part of the movement during voluntary movements than during the same rotations delivered with the turntable. Neck sensory input was evaluated separately in many of these cells and can account qualitatively for the extra firing present during active movement.

Robinson, F. R.↗
NASA NTRS1988

Attitude analysis of the Earth Radiation Budget Satellite (ERBS) yaw turn anomaly

The July 2 Earth Radiation Budget Satellite (ERBS) hydrazine thruster-controlled yaw inversion maneuver resulted in a 2.1 deg/sec attitude spin. This mode continued for 150 minutes until the spacecraft was inertially despun using the hydrazine thrusters. The spacecraft remained in a low-rate Y-axis spin of .06 deg/sec for 3 hours until the B-DOT control mode was activated. After 5 hours in this mode, the spacecraft Y-axis was aligned to the orbit normal, and the spacecraft was commanded to the mission mode of attitude control. This work presents the experience of real-time attitude determination support following analysis using the playback telemetry tape recorded for 7 hours from the start of the attitude control anomaly.

Kronenwetter, J.↗
NASA NTRS1989

Yaw rate control of an air bearing vehicle

The results of a 6 week project which focused on the problem of controlling the yaw (rotational) rate the air bearing vehicle used on NASA's flat floor facility are summarized. Contained within is a listing of the equipment available for task completion and an evaluation of the suitability of this equipment. The identification (modeling) process of the air bearing vehicle is detailed as well as the subsequent closed-loop control strategy. The effectiveness of the solution is discussed and further recommendations are included.

Walcott, Bruce L.↗
NASA NTRS1992

Enhancing Control Of Helicopter Yaw At Low Speed

Spoilers on tail boom significantly improve yaw control in both right and left sidewinds. Spoilers are two thin plates extending outward, perpendicular to curvature of boom, distance of about 6 percent of total depth of tail boom. Along-the-boom dimensions of spoilers are as long as possible without interfering with such existing critical parts as tail rotor. Further enhancement, spoilers made retractable and automatically deployable as required. Concept applicable to all single-rotor helicopters. Applied as simple economical addition to existing helicopters or incorporated into new helicopter designs.

Kelley, Henry L.↗
NASA NTRS1993

Helicopter low-speed yaw control

A system for improving yaw control at low speeds consists of one strake placed on the upper portion of the fuselage facing the retreating rotor blade and another strake placed on the lower portion of the fuselage facing the advancing rotor blade. These strakes spoil the airflow on the helicopter tail boom during hover, low speed flight, and right or left sidewards flight so that less side thrust is required from the tail rotor.

Wilson, John C.↗
NASA NTRS1933

Rolling, yawing, and hinge moments produced by rectangular ailerons

Ailerons described in references 1, 2, and 3, are summarized in the form of empirical equations which relate the aileron dimensions and displacements to the rolling, yawing, and hinge moments for pitch angles of 0 and 12 degrees, corresponding to angles of attack of the wings of 4 and 16 degrees, respectively.

Heald, R H↗
NASA NTRS1951

Effect of Fuselage and Tail Surfaces on Low-speed Yawing Characteristics of a Swept-wing Model as Determined in Curved-flow Test Section of Langley Stability Tunnel

Results are presented of a wind-tunnel investigation made to determine the influence of the fuselage and tail surfaces on the rotary derivatives in yawing flight of a transonic-airplane configuration having 45 degrees sweptback wing and tail surfaces. The tests were run in the curved-flow test section of the Langley stability tunnel at a Reynolds number of 1.07 X 10 to the sixth power and consisted of balance measurements throughout the angle-of-attack range for several flight-path radii of curvature. The results are compared with data from forced-oscillation and free-oscillation tests, and a description of testing techniques used is included.

WIND TUNNELS↗
NASA NTRS1951

Wind-tunnel Tests at Low Speed of Swept and Yawed Wings Having Various Plan Forms

Results are presented of wind-tunnel tests made at low speed of various small-scale models of sweptback, sweptforward, and yawed wings. The tests covered changes in aspect ratio, taper ratio, and tip shape. Some data were obtained with high-lift devices on sweptback wings and with ailerons on sweptforward wings. The data have been briefly analyzed and some comparisons have been made with the available theory.

HIGH LIFT DEVICES - COMPLETE WINGS↗
NASA NTRS1952

Effect of High-lift Devices on the Low-speed Static Lateral and Yawing Stability Characteristics of an Untapered 45 Degrees Sweptback Wing

Results of a low-speed wind-tunnel investigation to determine the effect of high-lift devices on the static lateral stability derivatives and the yawing derivatives of an untapered 45 degrees sweptback wing are presented. The tests were made in the curved-flow test section of the Langley stability tunnel at a Reynolds number of 1.1 X 10 to the sixth power.

FLAPS, LEADING EDGE - COMPLETE WINGS↗
NASA NTRS1953

Method for calculating the rolling and yawing moments due to rolling for unswept wings with or without flaps or ailerons by use of nonlinear section lift data

The methods of NACA Reports 865 and 1090 have been applied to the calculation of the rolling- and yawing-moment coefficients due to rolling for unswept wings with or without flaps or ailerons. The methods allow the use of nonlinear section lift data together with lifting-line theory. Two calculated examples are presented in simplified computing forms in order to illustrate the procedures involved.

CONTROLS - COMPLETE WINGS↗
NASA NTRS1956

Effects of vertical fins near the nose of the fuselage on the directional and damping-in-yaw stability derivatives of an airplane model under steady-state and oscillatory conditions

A wind-tunnel investigation has been made at low speed to determine the effects of vertical fins placed ahead of the vertical tail on the directional stability and damping-in-yaw characteristics of a swept-wing model under steady-state oscillatory conditions. Various sizes of fins were used above and below the fuselage center line. The vertical-tail size also was varied.

STABILITY, DIRECTIONAL - STATIC↗
NASA NTRS1957

Flight Tests of a Model of a High-wing Transport Vertical-take-off Airplane with Tilting Wing and Propellers and with Jet Controls at the Rear of the Fuselage for Pitch and Yaw Control

An investigation of the stability and control of a high-wing transport vertical-take-off airplane with four engines during constant-altitude transitions from hovering to normal forward flight was conducted with a remotely controlled free-flight model. The model had four propellers distributed along the wing with the thrust axes in the wing chord plane. The wing could be rotated to 90 degrees incidence so that the propeller thrust axes were vertical for hovering flight. An air jet at the rear of the fuselage provided pitch and yaw control for hovering and low-speed flight.

CONTROL, LONGITUDINAL↗