Search NASA⌕ Search

SEARCH · Search NASA

Results for “decomposition”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

The adsorption and decomposition of CO on Pt/111/.

A cylindrical mirror electron energy analyzer has been used to study the adsorption and decomposition of CO on an initially clean Pt(111) surface. The observed rate of adsorption and fractional surface coverage as a function of CO exposure are identical to those observed previously in this laboratory by a flash filament adsorption technique. This result provides an absolute calibration of the Auger spectrometry system for carbon and oxygen. Beam-induced decomposition of CO was observed at high incident fluxes. The surface oxygen coverage decreased exponentially to zero during electron bombardment, while surface carbon decreased and then levelled off at a finite value. CO adsorption studies on this carbon contaminated surface showed decreasing CO adsorption rate and decreasing saturation coverage with increasing carbon contamination.

Martinez, J. M.↗
NASA NTRS1974

Effect of fast neutron, gamma-ray and combined radiations on the thermal decomposition of ammonium perchlorate single crystals

The thermal decomposition kinetics have been determined for ammonium perchlorate crystals subjected to a fast neutron irradiation or to a fast neutron irradiation followed by a gamma-ray irradiation. Qualitatively, the radiation induced changes are similar to those obtained in this and in previous studies, with samples exposed only to gamma rays. The induction period is shortened and the rate constants, obtained from an Avrami-Erofeyev kinetic analysis, are modified. The acceleratory period constant increases and the decay period constant decreases. When compared on an equal deposited energy basis, the fast neutron induced changes are appreciably larger than the gamma-ray induced changes. Some, or all, of the fast neutron induced effects might be attributable to the introduction of localized regions of concentrated radiation damage ('spikes') by lattice atom recoils which become thermal decomposition sites when the crystals are heated.

Herley, P. J.↗
NASA NTRS1973

A decomposition for some operators

A decomposition of some operators is obtained that represents a generalization of Brown's (1953) work on quasi-normal operators. It is shown that the decomposition obtained is of most interest when the operator considered is far from being finite-dimensional. An application of the results obtained to the study of quasi-triangular operators is presented for illustration.

Morrel, B. B.↗
NASA NTRS1977

Modular polynomial arithmetic in partial fraction decomposition

Algorithms for general partial fraction decomposition are obtained by using modular polynomial arithmetic. An algorithm is presented to compute inverses modulo a power of a polynomial in terms of inverses modulo that polynomial. This algorithm is used to make an improvement in the Kung-Tong partial fraction decomposition algorithm.

Abdali, S. K.↗
NASA NTRS1976

Hydrogen production by water decomposition using a combined electrolytic-thermochemical cycle

A proposed dual-purpose power plant generating nuclear power to provide energy for driving a water decomposition system is described. The entire system, dubbed Sulfur Cycle Water Decomposition System, works on sulfur compounds (sulfuric acid feedstock, sulfur oxides) in a hybrid electrolytic-thermochemical cycle; performance superior to either all-electrolysis systems or presently known all-thermochemical systems is claimed. The 3345 MW(th) graphite-moderated helium-cooled reactor (VHTR - Very High Temperature Reactor) generates both high-temperature heat and electric power for the process; the gas stream at core exit is heated to 1850 F. Reactor operation is described and reactor innards are illustrated. A cost assessment for on-stream performance in the 1990's is optimistic.

Farbman, G. H.↗
NASA NTRS1977

Low-work-function surfaces produced by cesium carbonate decomposition

Cesium carbonate (Cs2CO3) was heated to the decomposition temperature of approximately 600 C. The nonvolatile decomposition products were condensed on a nickel substrate while the carbon dioxide was removed by pumping. The deposited material is characterized by an effective work function of between 1.05 and 1.15 eV at 450 K and by photoemission in the visible and near-infrared region of the spectrum. It is suggested that the deposited material consists of Cs2O, possibly Cs2O2, and adsorbed cesium. Silver, evaporated from a heated silver bead, produced the typical photoemissive and thermionic properties of a silver-oxygen-cesium (S-1) photocathode. The material may be of interest for thermionic energy converters and for the formation of silver-oxygen-cesium photocathodes.

Briere, T. R.↗
NASA NTRS1978

The rate of synthesis and decomposition of tissue proteins in hypokinesia and increased muscular activity

During hypokinesia and physical loading (swimming) of rats, the radioactivity of skeletal muscle, liver, kidney, heart, and blood proteins was determined after administration of radioactive amino acids. Tissue protein synthesis decreased during hypokinesia, and decomposition increased. Both synthesis and decomposition increased during physical loading, but anabolic processes predominated in the total tissue balance. The weights of the animals decreased in hypokinesia and increased during increased muscle activity.

Fedorov, I. V.↗
NASA NTRS1978

Decomposition of nitrous oxide and chloromethanes absorbed on particulate matter

The effect of pressure on the heterogeneous thermal and pyrolytic decomposition of nitrous oxides adsorbed on sand was studied. Results indicate that N20 adsorbed on certain sand surfaces can be decomposed by photons which nitrous oxide cannot absorb in the gas phase. There is also a thermal heterogeneous decomposition of nitrous oxide which also produces nitrogen. The photolysis of CC14, CFC13, CF2C12 adsorbed on fused quartz and on different types of sand was also investigated. There was no thermal heterogeneous reaction with any of these chloromethanes. Apparently the larger bond energy of approximately 74 kcal for the C-C1 bond compared to approximately 40 kcal for the N-O bond in N2O makes the thermal reaction inoperative for the chloromethanes.

Rebbert, R. E.↗
NASA NTRS1978

Production and analysis of thermal decomposition products from polymeric materials

A description is presented of a strategy for analyzing the combustion process and the degradation products which are formed. One of three primary objectives in the study of polymer degradation is related to the characterization of the material to be studied and the investigation of the thermal behavior of the material. Another objective is concerned with the definition of the nature of the decomposition process by identification and quantitation of the degradation products. The third objective involves the determination of the mechanism and kinetics of the decomposition process. The methods of sample degradation include pyrolysis, oxidative degradation, flaming combustion, and the use of large-scale combustion chambers. Methods of chemical separation and identification are considered, taking into account low-boiling volatiles, high-boiling volatiles, and ancillary techniques.

Chatfield, D. A.↗
NASA NTRS1979

Experimental setup for decomposition of UF6

The rate at which UF6 decomposes into UF5 and UF4 was determined as a function of neutron fluence. To study UF6 decomposition rate, an absorption cell for VUV and the associated VUV spectroscopy system was used to measure UF6 while under irradiation. The cell contains 50 torr of UF6 at room temperature to insure that the UF6 is in a gaseous state. It is shown that by determining the absorption coefficient below 2100A for UF6, above 2100A for F2, and at 4100A for cell degradation, UF6 decomposition can be measured at a neutron flux of 10 to the 12th power/sq cm for 72 continuous hours.

Rowe, M.↗
NASA NTRS1980

Hydrogen production by photoelectrolytic decomposition of H2O using solar energy

Photoelectrochemical systems for the efficient decomposition of water are discussed. Semiconducting d band oxides which would yield the combination of stability, low electron affinity, and moderate band gap essential for an efficient photoanode are sought. The materials PdO and Fe-xRhxO3 appear most likely. Oxygen evolution yields may also be improved by mediation of high energy oxidizing agents, such as CO3(-). Examination of several p type semiconductors as photocathodes revealed remarkable stability for p-GaAs, and also indicated p-CdTe as a stable H2 photoelectrode. Several potentially economical schemes for photoelectrochemical decomposition of water were examined, including photoelectrochemical diodes and two stage, four photon processes.

Rauh, R. D.↗
NASA NTRS1982

A linear decomposition method for large optimization problems. Blueprint for development

A method is proposed for decomposing large optimization problems encountered in the design of engineering systems such as an aircraft into a number of smaller subproblems. The decomposition is achieved by organizing the problem and the subordinated subproblems in a tree hierarchy and optimizing each subsystem separately. Coupling of the subproblems is accounted for by subsequent optimization of the entire system based on sensitivities of the suboptimization problem solutions at each level of the tree to variables of the next higher level. A formalization of the procedure suitable for computer implementation is developed and the state of readiness of the implementation building blocks is reviewed showing that the ingredients for the development are on the shelf. The decomposition method is also shown to be compatible with the natural human organization of the design process of engineering systems. The method is also examined with respect to the trends in computer hardware and software progress to point out that its efficiency can be amplified by network computing using parallel processors.

Sobieszczanski-Sobieski, J.↗
NASA NTRS1983

Analysis of structural perturbations in systems via cost decomposition methods

It has long been common practice to analyze linear dynamic systems by decomposing the total response in terms of individual contributions which are easier to analyze. Examples of this philosophy include the expansion of transfer functions using: (1) the superposition principle, (2) residue theory and partial fraction expansions, (3) Markov parameters, Hankel matrices, and (4) regular and singular perturbations. This paper summarizes a new and different kind of expansion designed to decompose the norm of the response vector rather than the response vector itself. This is referred to as "cost-decomposition' of the system. The notable advantages of this type of decomposition are: (a) easy application to multi-input, multi-output systems, (b) natural compatibility with Linear Quadratic Gaussian Theory, (c) applicability to the analysis of more general types of structural perturbations involving inputs, outputs, states, parameters. Property (c) makes the method suitable for problems in model reduction, measurement/actuator selections, and sensitivity analysis.

Skelton, R. E.↗
NASA NTRS1983

Decomposition in reliability analysis of fault-tolerant systems

The existing approaches to reliability modeling are briefly reviewed. An examination of the limitations of the existing approaches in modeling ultrareliable fault-tolerant systems illustrates the need to use decomposition techniques. The notion of behavioral decomposition is introduced for dealing with reliability models with a large number of states, and a series of examples is presented. The CARE (computer-aided reliability estimation) and HARP (hybrid automated reliability predictor) approaches to reliability are discussed.

Trivedi, K. S.↗
NASA NTRS1985

Application of singular value decomposition to structural dynamics systems with constraints

Singular value decomposition is used to construct a coordinate transformation for a linear dynamic system subject to linear, homogeneous constraint equations. The method is compared with two commonly used methods, namely classical Gaussian elimination and Walton-Steeves approach. Although the classical method requires fewer numerical operations, the singular value decomposition method is more accurate and convenient in eliminating the dependent coordinates. Numerical examples are presented to demonstrate the application of the method.

Juang, J.-N.↗
NASA NTRS1985

Decomposition of ethylene on small Pd particles

New results have been obtained which contribute to the understanding of hydrocarbon reactions on the surface of highly dispersed metal systems. Small particle of Pd were grown by electron beam evaporation on cleavage planes of high purity natural mica under ultrahigh vacuum conditions. Samples were subsequently characterized by transmission electron microscopy. Average particle sizes ranged from about 1 to 10 nm diameter. The chemisoption and decomposition of C2H4 on the Pd particles was studied using Auger electron spectroscopy and flash thermal desorption. It is shown that (a) C2H4 decomposes on Pd particles at room temperature, (b) specific surface sites are causing decomposition, and (c) the proportion of such active sites is significantly greater for the smaller metal particles. This enhanced reactivity may be due to an increase in the density of step, corner, and edge sites with a decrease in particle size.

Durrer, W. G.↗
NASA NTRS1985

Decomposition of CO2 molecules due to auroral X-rays

It has been reported by SEKIHARA (1981), that the circumpolar measurement from a commercial airliner reported by PRATT and FALCONER (1979) was subjected to a strong influence of a geomagnetic storm, specifically at the beginning stage through the North Pole. The main point of interest was the increase of CO concentration by the order of 10 ppb that took place simultaneously with a temperature decrease of several degrees, which was regarded as a result of enhanced cooling to space due to CO2 decomposition. Later inspection of the original magnetogram of eleven auroral zone stations revealed that the observation started 13 hours after the main phase of a geomagnetic storm, which lasted for 22 hours. A quantitative estimation is made of CO2 decomposition due to auroral X-rays that should take place during the degradation of photoelectrons injected into the lower stratospheres.

Sekihara, K.↗
NASA NTRS1986

Helmholtz decomposition revisited: Vorticity generation and trailing edge condition. I - Incompressible flows

Using the decomposition for the infinite-space, the issue of the nonuniqueness of the Helmholtz decomposition for the problem of the three-dimensional unsteady incompressible flow around a body is considered. A representation for the velocity that is valid for both the fluid region and the region inside the boundary surface is employed, and the motion of the boundary is described as the limiting case of a sequence of impulsive accelerations. At each instant of velocity discontinuity, vorticity is shown to be generated by the boundary condition on the normal component of the velocity, for both inviscid and viscous flows. In viscous flows, the vorticity is shown to diffuse into the surroundings, and the no-slip conditions are automatically satisfied. A trailing edge condition must be satisfied for the solution to the Euler equations to be the limit of the solution of the Navier-Stokes equations.

Morino, L.↗