Search NASA⌕ Search

SEARCH · Search NASA

Results for “delta wings”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Unsteady Navier-Stokes computations past oscillating delta wing at high incidence

The unsteady, thin-layer, compressible Navier-Stokes equations, written in the moving frame of reference for the flow relative motion, is solved for the steady and unsteady supersonic flow around a round-edged delta wing. For supersonic flow, local conical flow solution has been obtained from the three-dimensional equations. Pseudotime stepping is used for the steady flow, while time-accurate stepping is used for the unsteady flow. The computational scheme is an implicit approximately-factored finite volume scheme which uses explicit and implicit dissipation terms. The scheme is verified for the steady flow solution. The scheme is then applied to a delta wing undergoing rolling oscillation at a reduced frequency of 1.137 with 15- deg maximum amplitude about a mean angle of attack of 10 deg for a Mach number of 2 and a Reynolds number of 500,000.

Kandil, Osama A.↗
NASA NTRS1974

Theoretical and experimental longitudinal aerodynamic characteristics of an aspect ratio 0.25 sharp-edge delta wing at subsonic, supersonic, and hypersonic speeds

The suction analogy concept of Polhamus for predicting vortex lift in conjunction with an appropriate potential-flow solution is called the present method. This method is applied to an aspect ratio 0.25 sharp-edge delta wing from a Mach number of 0.143 to 10.4 in free air and at 0.074 in ground effect, and also to an aspect ratio 0.35 triangular crosssectional body at a Mach number of 6.9. The models had subsonic leading edges at the test Mach numbers. Vortex-flow effects could be neither confirmed nor denied to exist at high speeds because of the lack of flow visualization above a Mach number of 0.143. The data, however, could be better predicted by including a vortex-flow effect, although not always to the extent predicted from the present method because of the presence of actual and hypothesized unmodeled flow situations. The method of Nenni and Tung (NASA CR-1860) tended to confirm the existence of vortex flow at hypersonic speeds. The hypersonic-tangent-cone method predicted best the delta-wing results over the test angle-of-attack range and hypersonic Mach number range and did equally as well as the present method for the triangular body.

Fox, C. H., Jr.↗
NASA NTRS1992

Prediction of vortex breakdown on a delta wing

Recent studies of leading-edge vortex flows with computational fluid dynamics codes using Euler or Navier-Stokes formulations have shown fair agreement with experimental data. These studies have concentrated on simulating the flowfields associated with a sharp-edged flat plate 70 deg delta wing at angles of attack where vortex breakdown or burst is observed over the wing. There are, however, a number of discrepancies between the experimental data and the computed flowfields. The location of vortex breakdown in the computational solutions is seen to differ from the experimental data and to vary with changes in the computational grid and freestream Mach number. There also remain issues as to the validity of steady-state computations for cases which contain regions of unsteady flow, such as in the post-breakdown regions. As a partial response to these questions, a number of laminar Navier-Stokes solutions were examined for the 70 deg delta wing. The computed solutions are compared with an experimental database obtained at low subsonic speeds. The convergence of forces, moments and vortex breakdown locations are also analyzed to determine if the computed flowfields actually reach steady-state conditions.

Agrawal, S.↗
NASA NTRS1992

Computational study of the aerodynamics and control by blowing of asymmetric vortical flows over delta wings

The complicated flowfield around a rounded leading-edge delta wing was calculated at angles of attack and yaw with and without tangential leading-edge blowing, using thin-layer Navier-Stokes equations. The effectiveness of blowing for providing roll control at high angle of attack was illustrated, and the saturation effect of increased blowing was captured well. The effect of sideslip was shown to be analogous to asymmetric blowing.

Craig, Ken↗
NASA NTRS1982

Measurement and visualization of skin friction on the leeside of delta wings in supersonic flow

The reported investigation was conducted with the aid of the NASA Ames High Reynolds Number Wind Tunnel. The flow conditions considered involved free stream Mach numbers of 2 and 3, and a Reynolds number of approximately 10,000,000 p. m. The employed model was a delta wing with an angle of 70 deg. A method reported by Tanner (1977) was used for the measurement of the skin friction. This method involves the use of a laser interferometer to determine the change in the thickness of an oil film. The procedure can also be employed for a visualization of skin friction in the form of interferograms. The investigation shows that skin friction measurements can provide a significant contribution to a physical understanding of the flow processes at the delta wing.

Szodruch, J.↗
NASA NTRS1987

Finite-volume Euler and Navier-Stokes solvers for three-dimensional and conical vortex flows over delta wings

A unified central-difference finite-volume Euler and Navier-Stokes solver with four-stage Runge-Kutta time stepping is presented. The computer code developed for this purpose is capable of solving the standard set and nonstandard sets (zero-total-pressure loss) of Euler equations and the thin-layer and full Navier-Stokes equations. Applications are presented for conical supersonic flows with weak shocks using the standard and nonstandard sets of Euler equations, and the thin-layer and full Navier-Stokes equations for sharp and round-edged delta wings. Applications are also presented for three-dimensional transonic and subsonic flows using the standard set of Euler equations for sharp-edged delta wings. The computational results of the different sets of equations are compared with each other and with the experimental results and conclusions on the validity of these sets to these applications, are presented.

Kandil, Osama A.↗
NASA NTRS1979

Leading edge vortex-flap experiments on a 74 deg delta wing

Exploratory wind tunnel tests are reported on a 74 deg. delta wing model. The potential of a vortex flap concept in reducing the subsonic lift dependent drag of highly swept, slender wings is examined. The suction effect of coiled vortices generated through controlled separation over leading edge flap surfaces to produce a thrust component is discussed. A series of vortex-flap configurations were investigated to explore the effect of some primary geometric variables.

Rao, D. M.↗