Search NASA⌕ Search

SEARCH · Search NASA

Results for “electron irradiation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

High temperature annealing of minority carrier traps in irradiated MOCVD n(+)p InP solar cell junctions

Deep level transient spectroscopy was used to monitor thermal annealing of trapping centers in electron irradiated n(+)p InP junctions grown by metalorganic chemical vapor deposition, at temperatures ranging from 500 up to 650K. Special emphasis is given to the behavior of the minority carrier (electron) traps EA (0.24 eV), EC (0.12 eV), and ED (0.31 eV) which have received considerably less attention than the majority carrier (hole) traps H3, H4, and H5, although this work does extend the annealing behavior of the hole traps to higher temperatures than previously reported. It is found that H5 begins to anneal above 500K and is completely removed by 630K. The electron traps begin to anneal above 540K and are reduced to about half intensity by 630K. Although they each have slightly different annealing temperatures, EA, EC, and ED are all removed by 650K. A new hole trap called H3'(0.33 eV) grows as the other traps anneal and is the only trap remaining at 650K. This annealing behavior is much different than that reported for diffused junctions.

Messenger, S. R.↗
NASA NTRS1986

Cell performance and defect behavior in proton-irradiated lithium-counterdoped n(+)p silicon solar cells

Lithium-counterdoped n(+)p silicon solar cells were irradiated by 10-MeV protons, and their performance was determined as a function of fluence. It was found that the cell with the highest lithium concentration exhibited the higher radiation resistance. Deep-level transient spectroscopy studies of deep-level defects were used to identify two lithium-related defects. Defect energy levels obtained after the present 10-MeV irradiations were found to be markedly different than those observed after previous 1-MeV electron irradiations. However, the present DLTS data are consistent with previous suggestion by Weinberg et al. (1984) of a lithium-oxygen interaction which tends to inhibit formation of an interstitial boron-oxygen defect.

Weinberg, I.↗
NASA NTRS1991

Irradiation effects on comets and cometary debris

Experimental results obtained over the past 10 years on the chemical and physical changes induced by ion and electron irradiation of materials relevant to comets are reviewed, and their physical interpretation and their relevance for cometary astrophysics are addressed. Four phases of the irradiation history are considered: the precometary phase, the accretion phase, the cometary phase, and the postcometary phase. The relevant applications of laboratory results are reviewed. The ability of ion irradiation of simple carbon-containing ices to produce complex refractory organic materials is discussed. In the Oort cloud, this process can occur several meters into the surface, so that the buildup of a stable organic crust may occur. Ion irradiation at various stages is compared with other models for the production of organics.

Strazzulla, G.↗
NASA NTRS1979

Electric fields in irradiated dielectrics

An existing model for quantitatively predicting electric field build-up in dielectrics is used to demonstrate the importance of material parameters. Results indicate that electron irradiation will produce 10 to the 6th power V/cm in important materials. Parameters which can alter this build-up are discussed. Comparison to known irradiation induced dielectric charging experiments is discussed.

Frederickson, A. R.↗
NASA NTRS1977

Materials and techniques for spacecraft static charge control

An overview of the design, development, fabrication, and testing of transparent conductive coatings and conductive lattices deposited or formed on high resistivity spacecraft dielectric materials to obtain control static charge buildup on spacecraft external surfaces is presented. Fabrication techniques for the deposition of indium/tin oxide coatings and copper grid networks on Kapton and FEP Teflon films and special frit coatings for OSR and solar cell cover glasses are discussed. The techniques include sputtering, photoetching, silkscreening, and mechanical processes. A facility designed and built to simulate the electron plasma at geosynchronous altitudes is described along with test procedures. The results of material characterizations as well as electron irradiation aging effects in this facility for spacecraft polymers treated to control static charge are presented. The data presents results for electron beam energies up to 30 kV and electron current densities of 30 nA/cm squared. Parameters measured include secondary emission, surface leakage, and through the sample currents as a function of primary beam energy and voltage.

Amore, L. J.↗
NASA NTRS1979

Shallow-homojunction GaAs solar cells

Single-crystal GaAs shallow-homojunction solar cells on GaAs or Ge substrates, without Ga sub 1-x Al sub x As window layers, that have conversion efficiencies exceeding 20% at AM1 (17% at AMO). Using a simple theoretical model, good fits were obtained between computer calculations and experimental data for external quantum efficiency and conversion efficiency of cells with different values of n+ layer thickness. The calculations not only yield values for material properties of the GaAs layers composing the cells but will also permit the optimization of cell designs for space and terrestrial applications. Preliminary measurements indicate that the shallow-homojunction cells are resistant to electron irradiation. In the best test so far, bombardment with 1 x 10 to the 16th power/sq cm fluence of 1 MeV electrons reduced the short-circuit current by only about 6%.

Fan, J. C. C.↗
NASA NTRS2008

In Situ Irradiation and Measurement of Triple Junction Solar Cells at Low Intensity, Low Temperature (LILT) Conditions

The performance of triple junction InGaP/(In)GaAs/Ge space solar cells was studied following high energy electron irradiation at low temperature. Cell characterization was carried out in situ at the irradiation temperature while using low intensity illumination, and, as such, these conditions reflect those found for deep space, solar powered missions that are far from the sun. Cell characterization consisted of I-V measurements and quantum efficiency measurements. The low temperature irradiations caused substantial degradation that differs in some ways from that seen after room temperature irradiations. The short circuit current degrades more at low temperature while the open circuit voltage degrades more at room temperature. A room temperature anneal after the low temperature irradiation produced a substantial recovery in the degradation. Following irradiation at both temperatures and an extended room temperature anneal, quantum efficiency measurement suggests that the bulk of the remaining damage is in the (In)GaAs sub-cell

Quantum Efficiency↗
NASA NTRS1971

Lithium - An impurity of interest in radiation effects of silicon.

Study of the introduction and annealing of defects produced in lithium-diffused float-zone n-type silicon by 30-MeV electrons and fission neutrons. The introduction rate of recombination centers produced by electron irradiation is dependent on lithium concentration and for neutron irradiation is independent of lithium concentration. The introduction rate of Si-B1 centers also depends on the lithium concentration. The annealing of electron- and neutron-produced recombination centers, Si-B1 centers, and Si-G7 centers in lithium-diffused silicon occurs at much lower temperatures than in nondiffused material.

Naber, J. A.↗
NASA NTRS2007

Fluence Uniformity Measurements in an Electron Accelerator Used for Irradiation of Extended Area Solar Cells and Electronic Circuits for Space Applications

It is common to have liquid crystal displays and electronic circuit boards with area sizes of the order of 20x20 sq cm on board of satellites and space vehicles. Usually irradiating them at different fluence values assesses the radiation damage in these types of devices. As a result, there is a need for a radiation source with large spatial fluence uniformity for the study of the damage by radiation from space in those devices. Kent State University s Program on Electron Beam Technology has access to an electron accelerator used for both research and industrial applications. The electron accelerator produces electrons with energies in the interval from 1 to 5 MeV and a maximum beam power of 150 kW. At such high power levels, the electron beam is continuously scanned back and forth in one dimension in order to provide uniform irradiation and to prevent damage to the sample. This allows for the uniform irradiation of samples with an area of up to 1.32 sq m. This accelerator has been used in the past for the study of radiation damage in solar cells (1). However in order to irradiate extended area solar cells there was a need to measure the uniformity of the irradiation zone in terms of fluence. In this paper the methodology to measure the fluence uniformity on a sample handling system (linear motion system), used for the irradiation of research samples, along the irradiation zone of the above-mentioned facility is described and the results presented. We also illustrate the use of the electron accelerator for the irradiation of large area solar cells (of the order of 156 sq cm) and include in this paper the electrical characterization of these types of solar cells irradiated with 5 MeV electrons to a total fluence of 2.6 x 10(exp 15) e/sq cm.

Uribe, Roberto M.↗
NASA NTRS1983

Silicon solar cell characterization at low temperatures and low illumination as a function of particulate irradiation

Various configurations of back surface reflector silicon solar cells including small (2 x 2) cm and large (approx. 6 x 6) cm cells with conventional and wraparound contacts were subjected to 1 MeV electron irradiation and characterized under both Earth orbital and deep space conditions of temperatures and illuminations. Current-Voltage (I-V) data were generated from +65 C to -150 C and at incident illuminations from 135.3 mW/sq cm to 5.4 mW/sq cm for these cells. Degradation in cell performance which is manifested only under deep space conditions is emphasized. In addition, the effect of particle irradiation on the high temperature and high intensity and low temperature and low intensity performance of the cells is described. The cells with wraparound contacts were found to have lower efficiencies at Earth orbital conditions than the cells with conventional contacts.

Whitaker, A. F.↗
NASA NTRS1982

Characteristics of RF resulting from dielectric discharges

This paper presents measurements of the electromagnetic radiation pulses and the replacement current pulses which result from the breakdown of Mylar and Kapton samples. The observed dependence of the characteristics of the replacement current pulse as a function of electron beam energy is discussed. The characteristics of the electromagnetic radiation pulses are also analyzed in the text of this paper. The source of the irradiating electrons is a monoenergetic electron beam whose energy was varied from 12.5 KeV to 25 KeV.

Leung, P.↗
NASA NTRS1989

Deep levels and radiation effects in p-InP

A survey was conducted on past studies of hole traps in InP. An experiment was designed to evaluate hole traps in Zn-doped InP after fabrication, after electron irradiation and after annealing using deep level transient spectroscopy. Data similar to that of Yamaguchi was seen with observation of both radiation-induced hole and electron traps at E sub A=0.45 eV and 0.03 eV, respectively. Both traps are altered by annealing. It is also shown that trap parameters for surface-barrier devices are influenced by many factors such as bias voltage, which probes traps at different depths below the surface. These devices require great care in data evaluation.

Anderson, W. A.↗
NASA NTRS1971

Behavior of lithium in irradiated solar cells.

The current state of the art in radiation resistant lithium-doped silicon solar cells is reviewed. Fabrication techniques are reviewed. Characteristics of lithium-doped cells are discussed. Behavior of lithium-doped cells during 1 MeV electron irradiation are studied for various types of cells. Effects of variations in lithium and oxygen concentration are shown and discussed. Capacitance measurements at various voltages, frequencies and temperatures are used to detect charges in lithium donor concentration and the formation of defects during irradiation. Physical models to explain the observed effects are presented.

Carter, J. R., Jr.↗