Preparation and Structural Characterization of ZrO 2 /CuO x /Cu(111) Inverse Model Catalysts
CO 2 hydrogenation to methanol is regarded as a promising reaction to catalytically convert a major greenhouse gas (CO 2 ) into a value-added product (methanol). In the current study, scanning tunneling microscopy (STM) and X-ray photoelectron spectroscopy (XPS) were applied to investigate the growth mode of low coverages (<0.2 ML) of ZrO 2 in an inverse ZrO 2 /CuOx/Cu(111) system, which has the potential to achieve a high selectivity for a direct CO 2 to methanol transformation. It was found that the morphology of ZrO 2 was strongly affected by the preparation method. The ZrO 2 /CuO x /Cu(111) model catalyst prepared by the oxidation at 600 K of Zr pre-deposited on Cu(111) exhibited substantial mixing of ZrO 2 and CuO x . In contrast, the direct deposition of Zr under an O 2 ambient over CuO x /Cu(111) at 600 K produced small ZrO 2 islands (10-12 nm in size) with a two-dimensional structure (i.e. only one layer of ZrO 2 ). XPS studies indicate that both preparation methods lead to ZrO 2 /CuO x /Cu(111) surfaces. The model catalyst prepared by the direct deposition of Zr in O 2 was annealed up to 700 K in ultra-high vacuum. Both STM and XPS results suggest no apparent change in ZrO 2 , while CuO x was reduced at such annealing conditions. The island size of 10-12 nm observed for ZrO 2 on Cu(111) is much smaller than island sizes seen for CeO 2 (30-50 nm) and ZnO (300-500 nm) on the same substrate, opening the possibility for unique chemical properties