Search NASA⌕ Search

SEARCH · Search NASA

Results for “rendering”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Relation between surface slip topography and stress corrosion cracking in Ti-8 wt % Al

The deformation behavior of Ti-8 wt % Al has been investigated in an inert environment (air), and an aggressive environment (salt water). Details of surface slip geometry were examined by high resolution surface replicas at various stages of deformation in both environments. Specimens aged to contain a fine dispersion of Ti3Al precipitates failed by subcritical crack growth in salt water, whereas specimens in the single phase condition showed no effects of environment on the yield or fracture characteristics. The Ti3Al precipitates produce little change in strength level or slip character compared to the single phase alloy, and there is no evidence of any effects of environment on the character of surface slip. Rather, the presence of trenches along slip bands on the surface of aged specimens suggest that the specific effect of the Ti3Al precipitates is to render the surface slip steps chemically active relative to the surrounding matrix by slip induced dissolution of the particles.

Boyd, J. D.↗
NASA NTRS1974

Stability of fringe counting interferometers

Two configurations of an automatic bidirectional, fringe-counting corner-cube interferometer are compared. They differ only in the method of quadrature phase introduction. The one using polarization coding has good phase stability at optical path differences as large as 955 mm, the one using adjacent beams has such poor phase stability as to render it useless at path differences greater than 700 mm. A useful well-defined alignment procedure is given for the corner-cube interferometer.

Edgerton, J. W.↗
NASA NTRS1974

Properties of Zn-doped GaN. I - Photoluminescence

It is shown that zinc in gallium nitride forms an efficient radiative center emitting blue light at 2.86 plus or minus 0.02 eV and acts as a deep acceptor that can render the crystal insulating. A systematic variation of growth conditions indicates that an optimization of the photoluminescence efficiency is possible. Under nonoptimal conditions lower photon energy emission is obtained.

Pankove, J. I.↗
NASA NTRS1974

On the status of the rotation of Venus

Owing to its extremely slow rotation, Venus must be regarded as a triaxial body with differences of all three principal moments of inertia comparable in magnitude, thus rendering it a body essentially different from a rapidly rotating planet. The dynamical problem then arises of how such a body, with a rotation-period comparable with its orbital period, would be affected by couples exerted upon it by the gravitational action of the sun. Equations for the rotatory motion are set up in a form suitable for numerical solution by machine-calculations, but the problem so presented can be adequately investigated only for a hypothetical planet. Results obtained on this limited basis nevertheless suggest that for the actual planet the direction of the rotation axis may move almost randomly between the two hemispheres defined by the orbital plane and thus that the present direction near the south celestial pole of the orbit may be only a temporary situation.

Lyttleton, R. A.↗
NASA NTRS1974

Finite element solution algorithm for incompressible fluid dynamics

A finite element solution algorithm is established for the two-dimensional Navier-Stokes equations governing the transient motion of a viscous incompressible fluid, i.e., hydrodynamics. Dependent variable transformation renders the differential equation description uniformly elliptic. The finite element algorithm is established using the Galerkin criterion on a local basis within the Method of Weighted Residuals. It is unconstrained with respect to system linearity, computational mesh uniformity or solution domain closure regularity. The finite element matrices are established using a linear 'natural coordinate function' description. Computational solutions using the COMOC computer program illustrate the various features of the algorithm including recirculating flows.

Baker, A. J.↗
NASA NTRS1973

Thermomechanical behavior of a polynorbornadiene

A high-temperature linear amorphous hydrocarbon polymer synthesized cationically from 2,5-norbornadiene was studied thermomechanically with respect to physical transitions and stability in nitrogen. The glass transition temperature was determined to be 320 C (at less than 1 cps), which is probably the highest known for a linear hydrocarbon addition polymer. The thermomechanical technique of torsional braid analysis, together with thermogravimetric analysis, differential thermal analysis, infrared analysis, and solubility studies, was used to investigate the sequential events of the glass transition and degradation. The polymer is of particular interest since it is a high-temperature plastic which in the bulk form would probably need to be processed at high speeds in the vicinity of the glass transition temperature in an inert atmosphere. The presence of tertiary hydrogen atoms should render it amenable to degradation by the earth's environment.

Roller, M. B.↗
NASA NTRS1974

Self-sterilization of bodies during outer planet entry

A body encountering the atmosphere of an outer planet is subjected to heat loads which could result in high temperature conditions that render terrestrial organisms on or within the body nonviable. To determine whether an irregularly shaped entering body, consisting of several different materials, would be sterilized during inadvertent entry at high velocity, the thermal response of a typical outer planet spacecraft instrument was studied. The results indicate that the Teflon insulated cable and electronic circuit boards may not experience sterilizing temperatures during a Jupiter, Saturn, or Titan entry. Another conclusion of the study is that small plastic particles entering Saturn from outer space have wider survival corridors than do those at Jupiter.

Hoffman, A. R.↗
NASA NTRS1974

Techniques of biological contamination avoidance by atmospheric probes

The likelihood of biologically contaminating a planet by an atmospheric probe has a low probability of occurring if the probe is kept biologically clean during terrestrial operations and if the structure remains in tact until the planets life zone is completely penetrated. High standards of cleanliness, monitoring and estimating for remedial actions must be maintained in a probe program. It is not a foregone conclusion, however, that heat sterilization needs to be employed. The use of several techniques having a good potential for lower probe costs are available and appear adequate to render a probe sterile within acceptable bounds. The techniques considered to be satisfactory for minimizing microbial load include: (1) combined heat (at 95-105 C) and gamma radiation; (2) short term heating at 105 + or - 5 C to inactivate all vegetative microbes; (3) irradiation routinely by ultraviolet light; (4) wiping by a bactericidal agent with or without a penetrant; and (5) cleanliness alone.

Defrees, R. E.↗
NASA NTRS1975

Problem of electron contamination

Data are presented from two experiments to demonstrate the effect of electron contamination on X-ray measurements within the magnetosphere. The data are taken from a rocket flight which detected auroral X-rays in the energy range from 2 to 10 keV and from Uhuru measurements of the magnetic field-modulated electron flux. It is shown that the level of electron contamination rendered the rocket observations completely unreliable, but profiles of the charged particle flux as functions of terrestrial longitude were able to be obtained from the Uhuru data. It is stressed that particle contamination of X-ray data will occur even near the equator at high electron threshold energy. Corrective measures are proposed to eliminate the contamination or to reduce or evaluate the effects of such contamination.

Garmire, G.↗
NASA NTRS1975

Access of solar electrons to the polar regions

Riometric and forward-scatter radio-wave absorption measurements at high polar latitudes in both hemispheres are compared with absorption calculations based on satellite observations in the magnetosheath to determine whether a north-south asymmetry in the solar electron flux occurred during a polar-cap absorption (PCA) event. Detection of solar electrons in interplanetary space is shown to have occurred simultaneously with detection of HF radio-wave absorption, indicating that the initial stage of the PCA was due to the arrival of solar electrons. A north-south asymmetry is observed in the electron flux, and it is found that the flux precipitating over the South Pole did not exceed the mean unidirectional intensity of the electrons detected in space. The ratio between fluxes in the low and high polar latitude regions over Antarctica during a period of solar electron anisotropy is found to be comparable with that obtained during periods of isotropy. These results are shown to be consistent with the idea of an open magnetosphere and with the conclusion that an anisotropic solar electron flux may be rendered isotropic at the magnetopause.

Nielsen, E.↗
NASA NTRS1975

Self sterilization of bodies during outer planet entry

As a body encounters the atmosphere of an outer planet, whether accidentally or by plan, it will be subjected to heat loads which could result in high temperature conditions that render terrestrial organisms on or within the body non-viable. To determine whether an irregularly shaped entering body, consisting of several different materials, would be sterilized during inadvertent entry at high velocity, the thermal response of a typical outer planet spacecraft instrument was studied. The results indicate that the Teflon-insulated cable and electronic circuit boards may not experience sterilizing temperatures during a Jupiter, Saturn, or Titan entry. Another conclusion of the study is that small plastic particles entering Saturn from outer space have wider survival corridors than do those at Jupiter.

Hoffman, A. R.↗
NASA NTRS1975

A study of attitude control concepts for precision-pointing non-rigid spacecraft

Attitude control concepts for use onboard structurally nonrigid spacecraft that must be pointed with great precision are examined. The task of determining the eigenproperties of a system of linear time-invariant equations (in terms of hybrid coordinates) representing the attitude motion of a flexible spacecraft is discussed. Literal characteristics are developed for the associated eigenvalues and eigenvectors of the system. A method is presented for determining the poles and zeros of the transfer function describing the attitude dynamics of a flexible spacecraft characterized by hybrid coordinate equations. Alterations are made to linear regulator and observer theory to accommodate modeling errors. The results show that a model error vector, which evolves from an error system, can be added to a reduced system model, estimated by an observer, and used by the control law to render the system less sensitive to uncertain magnitudes and phase relations of truncated modes and external disturbance effects. A hybrid coordinate formulation using the provided assumed mode shapes, rather than incorporating the usual finite element approach is provided.

Likins, P. W.↗
NASA NTRS1975

Operation of the SUPARAMP at 33GHz

A 9mm degenerate parametric amplifier was constructed using a linear, series array of unbiased Josephson junctions as the active, nonlinear element. A balanced diode mixer was used as a synchronous detector, with a single source serving both as the pump and as the mixer local oscillator. A stable, net gain of 15 dB in an instantaneous bandwith (FWHM) of 3.4 GHz was achieved. A system noise temperature of 220 K + or - 5 K (DSB) was measured with a SUPARAMP contribution of only 20 K x or - 10 K. Output saturation was observed and complicates the interpretation of the noise temperature measurements and may render them upper limits. A comparison was made with the results of an earlier 3 cm suparamp. The data is in substantial agreement with theoretical predictions.

Chiao, R. Y.↗
NASA NTRS1975

A study of sound generation in subsonic rotors, volume 2

Computer programs were developed for use in the analysis of sound generation by subsonic rotors. Program AIRFOIL computes the spectrum of radiated sound from a single airfoil immersed in a laminar flow field. Program ROTOR extends this to a rotating frame, and provides a model for sound generation in subsonic rotors. The program also computes tone sound generation due to steady state forces on the blades. Program TONE uses a moving source analysis to generate a time series for an array of forces moving in a circular path. The resultant time series are than Fourier transformed to render the results in spectral form. Program SDATA is a standard time series analysis package. It reads in two discrete time series and forms auto and cross covariances and normalizes these to form correlations. The program then transforms the covariances to yield auto and cross power spectra by means of a Fourier transformation.

Chalupnik, J. D.↗
NASA NTRS1976

Lidar simulation

The feasibility of measuring atmospheric water vapor via orbital lidar is estimated. The calculation starts with laser radar equations representing backscatter with and without molecular line absorption; the magnitudes of off-line backscatter are demonstrated. Extensive prior data on water line strengths are summarized to indicate the available sensitivity to water vapor concentration. Several lidar situations are considered starting with uniform and perturbed atmospheres at 0, 3, 10 and 20 kM (stratosphere) altitudes. These simulations are indicative of results to be obtained in ground truth measurements (ground-based and airborne). An approximate treatment of polar observations is also given. Vertical atmospheric soundings from orbit and from ground stations are calculated. Errors are discussed as regards their propagation through the lidar equation to render the measured water vapor concentration imprecise; conclusions are given as to required laser energy and feasible altitude resolution.

Source record↗
NASA NTRS1976

Extended applications of the vortex lattice method

The application of the vortex lattice method to problems not usually dealt with by this technique is considered. It is shown that if the discrete vortex lattice is considered as an approximation to surface-distributed vorticity, then the concept of the generalized principal part of an integral yields a residual term to the vortex-induced velocity that renders the vortex lattice method valid for supersonic flow. Special schemes for simulating non-zero thickness lifting surfaces and fusiform bodies with vortex lattice elements are presented. Thickness effects of wing-like components are simulated by a double vortex lattice layer, and fusiform bodies are represented by a vortex grid arranged on a series of concentric cylindrical surfaces. Numerical considerations peculiar to the application of these techniques are briefly discussed.

Miranda, L. R.↗
NASA NTRS1976

Plasticized phenolphthalein polycarbonate

Phenolphthalein polycarbonate was successfully plasticized with polychlorinated biphenyls (e.g., Aroclor 1231) or tricresyl phosphate and cast from tetrahydrofuran to give clear films without loss of fire resistance. At loadings of 20 to 30 percent plasticizer the Tg was lowered to approximately 100 C which would render phenolphthalein polycarbonate easily moldable. Although these materials had some mechanical integrity as shown by their film forming ability, the room temperature toughness of the plasticized polymer was not significantly improved over unmodified polymer.

Harrison, E. S.↗
NASA NTRS1975

The effect of atmospheric haze on images of the earth's surface

The adding method to solve the equation of radiative transfer has been applied to a sunlit haze above a reflecting surface. The method was modified to include the effect of inhomogeneities on the underlying surface whose dimensions are less than the mean free path of the photons in the haze. Numerical examples of surface-feature contrast degradation due to haze are presented. This analysis renders it feasible to determine the optical thickness of hazes from haze-degraded images of the ground and also provides a technique to restore ground-image contrast, which has been obscured by haze, in photoelectrically scanned images.

Odell, A. P.↗