SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The possibility of using aperture synthesis to image other planetary systems at submillimeter wavelengths is considered. The approach requires only a small increase in dynamic range over that already demonstrated by the VLA at longer wavelengths. The values of the relevant parameters are calculated and presented.
A quasi-optical reflection cavity intended to be used as the resonant load of a submillimeter wavelength oscillator has been designed, constructed, and tested. The resonator consists of three elements in cascade: a high Q, high finesse folded Fabry-Perot resonator, a lower Q, low finesse Fabry-Perot resonator, and a Littrow mounted diffraction grating. The resonator exhibits a Q of 6600 and 2.5 dB of loss at 63 GHz. The design can be scaled to 1 THz, where waveguide structures become impractical, to serve as the resonator for high frequency quantum well resonant tunneling device oscillators.
Planar antennas with receiving and/or transmitting circuits integrated at focal point. Reflectors formed from shaped dielectric material with metallized parabolic surface serve as basis for wide variety of planar, integrated receiver and transmitter circuits operating at millimeter and submillimeter wavelengths. Used over wide range of frequencies and in variety of modes: as receiver or transmitter, in heterodyne or direct-detection mode, with single element, or with array.
Photometric measurements of three Virgo cluster spirals (NGC4254, NGC4501, and NGC4654) at 160-microns (far-infrared) and 360-microns (submillimeter) wavelengths are compared with theoretical models and observations at other wavelengths. It is shown that the data at the observed wavelengths do not fit any of interstellar dust grain models very well; four possibilities are given in order to explain discrepancies: the observed wavelength points are incorrect; previously observed data is incorrect; both data are incorrect; and the premise of the analysis is incorrect - a composite far-infrared spectrum of normal spiral galaxies is meaningless because they vary considerably in their far-infrared properties. It is also noted that the observed data are inconsistent with models having large cold grains.
It has been known since the early 1940's that radiation can cause an instability in the interstellar medium. Absorbing dust particles in an isotropic radiation field shadow each other by a solid angle which is inversely proportional to the square of the distance between the two particles, leading to an inverse-square attractive force - mock gravity. The effect is largest in an optically thin medium. Recently Hogan and White (HW, hereafter) proposed that if the pre-galactic universe contained suitable sources of radiation and dust, instability in the dust distribution caused by mock gravity may have led to the formation of galaxies and galaxy clusters. In their picture of a well-coupled dust-gas medium, HW show that mock gravity begins to dominate gravitational instability when the perturbation becomes optically thin, provided that the radiation field at the time is strong enough. The recent rocket observation of the microwave background at submillimeter wavelengths by Matsumoto et al. might be from pre-galactic stars, the consequence of the absorption of ultraviolet radiation by dust, and infrared reemission which is subsequently redshifted. HW's analysis omits radiative drag, incomplete collisional coupling of gas and dust, finite dust albedo, and finite matter pressure. These effects could be important. In a preliminary calculation including them, the authors have confirmed that mock gravitational instability is effective if there is a strong ultraviolet radiation at the time, but any galaxies that form would be substantially enriched in heavy elements because the contraction of the dust is more rapid than that of the gas. Moreover, since the dust moves with supersonic velocity through the gas soon after the perturbation becomes optically thin, the sputtering of dust particles by gas is significant, so the dust could disappear before the instability develops significantly. They conclude that the mock gravity by dust is not important in galaxy formations.
The two major sources of confusion that limit the sensitivity of continuum observations at submillimeter wavelengths outside the galactic plane are discussed. One of the sources is the spatial structure of the thermal emission from dust in the Milky Way. The crowding of extragalactic sources at faint levels is the second source of confusion. Estimates of the noise expected from these two types of confusion as a function of wavelength and beam size on the sky are presented and compared to detector and photon noise estimates for proposed spaceborne telescopes.
The general goal was to build a data base containing optical properties, such as reflectance, transmittance, refractive index, in the far infrared to submillimeter wavelength region. This data base would be limited to selected crystalline materials and temperature between 300 and 2 K. The selected materials were: lithium, lead, and strontium; the bromides of potassium and thallium; the carbides of silicone and tungsten; and the materials of KRS5, KRS6, diamond, and sapphire. Last summer, barium fluoride was selected as prototype material for building the data base. This summer the literature search, preparation of the data for barium fluoride was completed. In addition the literature search for data related to the compounds mentioned was completed. The current status is that barium fluoride is in a form suitable for a NASA internal publication. The papers containing the data on the other materials were xeroxed and they are ready to be reduced. On the reverse side, the top figure is a sample combination of data for the index of refraction at 300 K. The lower figure shows the transmittance vs wavelength at 300 and 80 K. These figures are a sample of many which were developed. Since barium fluoride was studied more than most of the materials listed above, it is clear that additional measurements should be made to fill in the gaps present on both temperature and wavelength data.
This paper reports on the design, construction, and implementation of a new chopping secondary mirror system for the Kuiper Airborne Observatory. This observatory facility maintains a 0.91 m diameter telescope in a modified C-141 aircraft at the NASA Ames Research Center. This telescope is routinely used at stratospheric altitudes for astronomical observations at infrared and submillimeter wavelengths that are inaccessible from the ground.
A project to develop precision segmented reflectors (PSRs) which operate at submillimeter wavelengths is described. The development of a light efficient means for the construction of large-aperture segmented reflecting space-based telescopes is the primary aim of the project. The 20-m Large Deployable Reflector (LDR) telescope is being developed for a survey mission, and it will make use of the reflector panels and materials, structures, and figure control being elaborated for the PSR. The surface accuracy of a 0.9-m PSR panel is shown to be 1.74-micron RMS, the goal of 100-micron RMS positioning accuracy has been achieved for a 4-m erectable structure. A voice-coil actuator for the figure control system architecture demonstrated 1-micron panel control accuracy in a 3-axis evaluation. The PSR technology is demonstrated to be of value for several NASA projects involving optical communications and interferometers as well as missions which make use of large-diameter segmented reflectors.
The integrated radiation from galaxies is calculated at far-IR and submillimeter wavelengths. The peak of the far-IR background radiation is 100-130 microns, and its total energy content is 0.5-6 percent of the cosmic microwave background (CMB). At wavelengths longward of 400 microns, the CMB dominates over the far-IR radiation from galaxies in intensity. The autocorrelation of fluctuations from the average angle of the far-IR background of galaxies is calculated. The contribution of galaxies to the anisotropy of the background radiation at wavelengths longer than about 400 microns where the CMB is predominant is obtained. It is found that, in general, earlier galaxy formation predicts stronger far-IR background radiation. The prompt initial enrichment model for the chemical evolution of disk galaxies, in particular those with an exponential star formation rate, produces much larger intensity of the integrated radiation than the accretion model.
The Precision Segmented Reflector program and the Submillimeter Imager and Line Survey mission are overviewed. The temperature requirements, thermal design and environment, as well as the on-orbit thermal performance of a 3.65-m-diameter passively-cooled submillimeter-wavelength telescope are discussed, and focus is placed on the geometric and thermal mathematical models employed in the study. Attention is given to an inflatable space-rigidized sunshade protecting the primary mirror thermally and the highly elliptical orbit chosen to reduce heat input from the earth. Primary-reflector temperature predictions are shown to indicate that a large spatial gradient can exist and the magnitude of the gradient is a strong function of the telescope pitch angle. It is suggested that the cryostat outer-shell temperature may be further lowered with the introduction of a rectangular shield between a solar array and the cryostat.
A novel monolithic power meter has been developed for submillimeter-wave applications (100 GHz to 10 THz). The detector is a large-area bismuth bolometer integrated on a 1.2-micron-thick dielectric membrane. This approach results in a wide-band, high-responsivity detector. The power meter is simple to fabricate, is inexpensive, and can be easily calibrated using a low-frequency network. Quasi-optical measurements at 90, 140, and 240 GHz show that the bolometer is polarization-independent and could be modeled by a simple transmission line model. Absolute power measurements at 90, 140, and 240 GHz show a + or - 5 percent accuracy and agree well with a calibrated Anritsu power meter at 90 GHz. Potential application areas are power calibration, antenna coupling efficiency measurements, and absolute power measurements from solid-state devices and far-infrared lasers at submillimeter wavelengths. Absolute output power measurements on a 220-280 GHz tripler using the quasi-optical power meter are presented as an application example.
Freestanding metallic grids for use as polarizers for electromagnetic radiation at millimeter and submillimeter wavelengths made by simple modification of designs of freestanding square- and nearly-square cell metallic grids, according to proposal. Cross wires provide mechanical support, but distance between cross wires made greater than one wavelength so cross wires have little effect on polarizing characteristics of grid. Possible to fabricate grids commercially for frequencies up to several terahertz.
The superconductor-insulator-superconductor (SIS) mixer is a device which is being used in the construction of very sensitive receivers in the millimeter and submillimeter wavelength regions. With its potential for conversion gain and quantum-limited performance, it is becoming a device of prime importance in radio astronomy as well as earth and planetary atmospheric research. Many of the parameters of the SIS mixer cannot be readily measured in the laboratory, however, since most commercially available test instruments use test signal powers large enough to saturate or destroy SIS junctions. Detailed here is the construction of a microwave network analyzer with extremely low test signal powers. The results of a development performed by Dynamics Technology, Inc., under a Phase 2 SBIR contract from NASA (NAS7-1025) are documented. The work resulted in a network analyzer to be delivered to workers at the Jet Propulsion Laboratory, which should be capable of SIS mixer characterization in support of their ongoing work in this area.
A hemispherical open resonator has previously been used to make relative comparisons of the surface resistivity of metallic thin-film samples in the submillimeter wavelength region. This resonator is fed from a far-infrared laser via a small coupling hole in the center of the concave spherical mirror. The experimental arrangement, while desirable as a coupling geometry for monitoring weak emissions from the cavity, can lead to the introduction of spurious modes into the cavity. Sources of these modes are identified, and a simple alteration of the experimental apparatus to eliminate such modes is suggested.
The superconductor-insulator-superconductor (SIS) junction is the most sensitive nonlinear element for millimeter-wave heterodyne detection. An Nb/Al-Al203/Nb junction fabrication process has been developed which allows the use of planar tuning circuits integrated with the junctions. These tuning elements permit the use of junctions with relatively large areas and small current densities with excellent results. Recent measurements have yielded a double sideband receiver noise temperature less than 50 K from 205 to 240 GHz and 44 K at 230 GHz. This Nb/Al-Al203/Nb trilayer technology is also being extended to the fabrication of sub-square-micron area planar junctions for submillimeter-wavelengths.
A double-dipole antenna backed by a ground plane has been fabricated for submillimeter wavelengths. The double-dipole antenna is integrated on a thin dielectric membrane with a planar detector at its center. Measured feed patterns at 246 GHz agree well with theory and demonstrate a rotationally symmetric pattern with high coupling efficiency to Gaussian beams. The input impedance is around 50 ohms, and will match well to a Schottky diode or SIS detector. The double-dipole antenna served as the feed for a small machined parabolic reflector. The integrated reflector had a measured gain of 37 dB at 119 microns. This makes the double-dipole antenna ideally suited as a feed for high resolution tracking or for long focal length Cassegrain antenna systems.
Local oscillators for heterodyne receivers at submillimeter wavelengths are typically made using a fundamental source followed by a harmonic frequency multiplier. An investigation of the required circuit embedding conditions for a possible new harmonic generator, the quantum-well resonant-tunneling diode, is summarized. A low-frequency multiplier has been tested that employs the resistive nonlinearity of the device as opposed to the reactive nonlinearity. The results show good agreement between practice and theory.