Search NASA⌕ Search

SEARCH · Search NASA

Results for “vanadium”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

174 records · Page 10
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

AGC-4 As-Run Uncertainty Analysis

The concept of measuring neutron flux (or fluence rate) with activation foils has existed since the late 1940s and is a well-used methodology. Activation foils are selected for their unique isotopic cross sections that create reaction products with desirable properties: relatively simple radioactive decay scheme, measurable quantities of gamma-rays or betas, and half-lives appropriate for the irradiation and decay durations of the experiment. The activation materials, deemed flux wires, fluence wires, dosimeters, or flux foils, are fabricated to have a mass appropriate for the irradiation as well so the measurement using a radiation detector following the irradiation is sufficient but not overwhelming in terms of total activity. Activation measurement results are expressed in terms of reaction rate, which can then be used to “adjust” the neutron spectrum. The Advanced Graphite Creep (AGC)-4 experiment contained 26 flux wire packages, each containing an iron and a niobium wire inside a vanadium capsule. For all stackup positions, the value of fast to thermal neutrons is higher than expected, but the total neutron fluence is near the predicted value of ~2 x 1022 n/cm2. As compared to the predicted neutron spectrum, there are four takeaways in the results as compared to the predicted ATR irradiation: 1) Additional fast (fission) neutrons present, 2) Spectrum hardening due to temperature, 3) Spectrum hardening due to container attenuation, 4) Total neutron fluence is close to predicted values. Since the neutron energy spectrum is a key parameter when attributing neutron damage in materials, the adjusted energy-dependent spectrum and the total neutron fluence results from the dosimeters can be incorporated for future calculations.

11 - NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2025

Determination of the nat Ti(d,x) 49 V excitation function by liquid scintillation analysis

Here, the experimental cross-sections for deuteron-induced nuclear reactions on natural titanium were measured using the stacked-foil method. Deuteron beams were provided by a Pelletron tandem accelerator at incident energies up to 8 MeV. The cross-sections for the production of 49 V were determined by liquid scintillation analysis, with the highest measured value of 522(32) mb occurring at 5.59(9) MeV. Additionally, the cross-sections for the production of 44m,46,47,48 Sc and 48 V were evaluated using gamma-ray spectroscopy and compared to some available literature.

43 PARTICLE ACCELERATORS↗
DOE OSTI2025

Solution-Processed Temperature-Adaptive Radiative Paint as a Thermal Imaging Sensitizer

Thermography detects mid-infrared radiation from surfaces based on the Stefan-Boltzmann law, mapping surface temperatures and potentially revealing subsurface thermal activity. Recent developments offer an alternative strategy to traditional camera-based improvements: a thermal imaging sensitizer (TIS) coating whose emissivity increases sharply with local temperature, amplifying small thermal variations into high-contrast signals. Existing TIS structures are nanofabricated solid membranes and face significant challenges in fabrication complexity. Here, in this study, we present a solution-processed, liquid form of TIS, termed temperature-adaptive radiative paint (TARP), to address these limitations. TARP offers drastically reduced fabrication costs, scalability to large areas, applicability to curved surfaces, and an extended operating temperature range, while maintaining the function of temperature amplification. Application of TARP enhances small temperature contrast by more than 3 times, substantially improving ambient thermography and enabling broader applications such as detection of structural defects and hot spots in electronic components.

paint↗
DOE OSTI2026

Modulating Mid-Gap Electronic States Through Site-Selective Modification in B-Pbx/B'-CuyV2O5/CdS Heterostructures for Photocatalytic Hydrogen Evolution

We interfaced ..beta..-Pbx/..beta..'-CuyV2O5 compounds, with varying stoichiometries of precisely positioned Pb-ions (x) and Cu-ions (y) in interstitial sites along a tunnel-structured ?-V2O5 framework, with cysteine-capped CdS (cysCdS) quantum dots (QDs) to yield heterostructured photocatalysts. ..beta..-Pbx/..beta..'-CuyV2O5 compounds exhibit midgap electronic states with orbital contributions from both Cu 3d and stereochemically active Pb 6s states that show distinctive light-initiated reactivity with photoexcited QDs. ..beta..-Pbx/..beta..'-CuyV2O5/CdS heterostructures were prepared by linker-assisted assembly (LAA). Scanning and transmission electron microscopy, energy-dispersive X-ray spectroscopy, and Raman spectroscopy revealed that cysCdS QDs were deposited onto surfaces of ..beta..-Pbx/..beta..'-CuyV2O5 via LAA. HAXPES revealed that the site-selective positioning of Pb-ions and Cu-ions promoted close energetic alignment of the midgap states of ..beta..-Pbx/..beta..'-CuyV2O5 compounds with the valence-band maximum of cysCdS QDs. Transient absorption spectroscopy revealed that photogenerated holes were transferred from CdS QDs to midgap states of ..beta..-Pbx/..beta..'-CuyV2O5 compounds on time scales <50 ps. Finally, photoelectrochemical and photochemical experiments revealed that ..beta..-Pbx/..beta..'-CuyV2O5/CdS heterostructures promoted the photocatalytic reduction of H+ to H2. In photoelectrochemical experiments, under oxidative conditions, for all ..beta..-Pbx/..beta..'-CuyV2O5/CdS heterostructures, H2 was evolved at a Pt counter electrode while a sacrificial donor was oxidized at the heterostructure-functionalized working electrode. In contrast, under reductive conditions, for ..beta..-Pb0.152V2O5/CdS and ..beta..-Pbx/..beta..'-CuyV2O5/CdS heterostructures, H2 was evolved at the working electrode. In photochemical experiments, dispersed ..beta..-Pbx/..beta..'-CuyV2O5/CdS heterostructures promoted the reduction of H+ to H2 under white-light illumination; ..beta..'-Cu0.55V2O5/CdS and ..beta..-Pbx/..beta..'-CuyV2O5/CdS heterostructures, for which midgap states have Cu 3d orbital character, generated 2-fold more H2 than ..beta..-Pb0.152V2O5/CdS heterostructures. Cu-ion insertion thus appends additional acceptor surface states that improve ligand-mediated hole transfer from photoexcited QDs, but such states are intrinsically limited in mediating hole transport to the substrate as a result of the low mobility of holes in narrow Cu 3d-states. Our results reveal that the density and orbital character of midgap states of ..beta..-Pbx/..beta..'-CuyV2O5 compounds, tunable through recently developed site-selective ion insertion strategies, determine efficiencies of charge-transfer and charge-transport mechanisms that underpin photocatalysis.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Single-Atom Manganese-Based Catalysts for the Oxidative Dehydrogenation of Propane

Combinatorial screening of 150 supported metal oxide (manganese and additives) catalysts was carried out via a high-throughput synthesis platform and parallel reactors for the oxidative dehydrogenation (ODH) of propane to propylene. Specifically, an organomanganese (0.05-2.5 Mn atoms/nm 2 ) complex was grafted on metal oxide supports (Al 2 O 3 , SiO 2 , TiO 2 , and ZrO 2 ) premodified with either Lewis acid (Al, Ti, Zn, and Zr) or redox-active (Cu, Cr, Ga Ni, V) additives at various surface coverages (25, 50, and 75%). Catalysts were characterized by high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), Raman spectroscopy, and UV-vis spectroscopy. Catalysts 0.05 Mn/V(50%)/Al 2 O 3 and 0.05 Mn/Ni(50%)/ZrO 2 showed the highest combined propane conversion and propylene selectivities (31/41% and 15/85%), with excellent stability at 500 degrees C for 25 h. The presence of Ni in Mn/Ni/ZrO 2 resulted in a 6-fold increase in turnover frequency (TOF) over the Mn/ZrO 2 . HRTEM identified single Mn atoms after 500 degrees C heat treatment. For the Mn/Ni/ZrO 2 system, Mn was incorporated into the support lattice due to the similar ionic radius of Mn 2+ and Zr 4+ , which was also enhanced by the presence of Ni. For the Mn/V/Al 2 O 3 system, highly active MnO was prevalent as observed by Raman. Both V and Mn contributed to an increase in mutual dispersion, but both species remained on the surface. Finally, it is proposed that the highly dispersed atom and interactions between Mn with either Ni or V are responsible for the ODH performance and stability.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2025

High-Resolution Full-Field Structural Microscopy of the Voltage-Induced Filament Formation in VO 2 -Based Neuromorphic Devices

In order to make neuromorphic functions in memristive devices more efficient, information about the structural properties of filament formation at the micro- and mesoscopic scales is necessary. Despite extensive research on VO 2 , a key material due to its filament formation, local operando structural measurements remain challenging and often involve destructive specimen preparation and long rastering times, greatly limiting the scope of experimental studies. Utilizing dark-field X-ray microscopy (DFXM), a fullfield imaging modality, structural signatures of the filament formation process operando are revealed in VO 2 devices. DFXM experiments illustrate that rutile filaments contain isolated monoclinic clusters, indicating structural nonuniformity interior to the filament. The formation of the rutile phase beneath device electrodes was shown to precede filament development, followed by the formation of filament paths guided by nucleation sites within the device. Finally, a medium-term (<30 min) memory mechanism is observed in VO 2 , mediated by sites within the device gap that tend to switch at significantly lower voltages after electrical cycling, a tendency that persists through a brief thermal reset. High spatial resolution, large field-of-view, structure selectivity, and fast signal acquisition of DFXM provided insight into structural features of the filamentary channel and surrounding regions during voltage cycling.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2025

Editorial: Functionalization of porous materials for sustainable energy applications

Global energy demands are shifting toward a more sustainable future, with the goal of achieving carbon neutrality by 2050. Emerging technologies are driving this transition. The industry, academia, government, non-profit organizations, and the broader community are collaboratively working to reduce greenhouse gas (GHG) emissions and address climate change to ensure a sustainable future. According to the International Energy Agency, in 2022, the production, transportation, and processing of oil and gas resulted in 5.1 billion tons of CO 2 -equivalent emissions, representing nearly 15% of all energy-related GHG emissions. Moreover, the end-use of oil and gas accounted for an additional 40% of emissions. The IEA’s Net Zero Emissions by 2050 Scenario calls for immediate, collective action from the industry, transportation and other stakeholders to mitigate these emissions. In this effort, the development of energy materials will play a critical role in reducing emissions. Among these, porous materials offer an innovative solution, leveraging their high surface area, adjustable pore sizes, and chemical versatility to address these pressing challenges effectively. By carefully designing their nanostructures, the architecture and properties of these materials can be tailored for specific applications. Key factors such as chemical composition, particle size, pore distribution, and surface area optimization enhance the reactivity and energy conversion efficiency. Additionally, pre- and post-functionalization processes can introduce targeted chemical properties, further improving their performance. This Research Topic explores recent advancements in energy and materials science through four scholarly papers, showcasing innovative solutions for sustainable energy technologies while providing valuable insights into the unique properties and structure of porous materials (Figure 1). Li et al. present their work on highly defective NiFeV layered triple hydroxides, highlighting enhanced electrocatalytic activity and stability for oxygen evolution reactions (OER). Kovalskii et al. contribute a mini-review on hydrogen storage using hexagonal boron nitride (h-BN) and BN-based materials, offering an insightful overview of these promising materials. Chava et al. discuss their recent achievements in ceramic electrolytes used for improvement of performance of solid-state batteries. Lastly, Li et al. review the properties of porous materials with a focus on shrinkage behavior during the drying process, shedding light on key considerations for material design.

36 MATERIALS SCIENCE↗
DOE OSTI2024

CCDC 2383610: Experimental Crystal Structure Determination

An entry from the Cambridge Structural Database, the world’s repository for small molecule crystal structures. The entry contains experimental data from a crystal diffraction study. The deposited dataset for this entry is freely available from the CCDC and typically includes 3D coordinates, cell parameters, space group, experimental conditions and quality measures.

bis(pyrrolidin-1-ium) bis(tetrabutylammonium) trid↗
DOE OSTI2024

CCDC 2383611: Experimental Crystal Structure Determination

An entry from the Cambridge Structural Database, the world’s repository for small molecule crystal structures. The entry contains experimental data from a crystal diffraction study. The deposited dataset for this entry is freely available from the CCDC and typically includes 3D coordinates, cell parameters, space group, experimental conditions and quality measures.

Cell Parameters↗
DOE OSTI2024

CCDC 2383612: Experimental Crystal Structure Determination

An entry from the Cambridge Structural Database, the world’s repository for small molecule crystal structures. The entry contains experimental data from a crystal diffraction study. The deposited dataset for this entry is freely available from the CCDC and typically includes 3D coordinates, cell parameters, space group, experimental conditions and quality measures.

Cell Parameters↗