SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
A procedure for the determination of an aerodynamic model structure and aerodynamic parameters is applied to flight data from a high-incidence research model (HIRM) within an angle of attack range of 18 to 40 degrees. The HIRM is a three-surface unpowered model with a swept wing, an all-moving canard and stabilator, and a vertical tail with rudder. The motion of the HIRM was excited first by its release from the helicopter and then by the activation of control surfaces. This paper briefly describes the model, flight and wind tunnel data available, equations of motion and techniques for data analysis. The results presented contain an example of a measured data compatibility and the variation of some important stability derivatives with the angle of attack and canard setting. The derivatives were obtained from various maneuvers and subsets of joined data from several maneuvers by using a stepwise-regression technique. These derivatives agreed, in general, with the results of wind-tunnel measurements. The resulting lateral aerodynamic model equations could predict the motion of the HIRM reasonably well.
An experimental investigation has been made in the Langley stability tunnel at low speed to determine the static longitudinal and lateral stability characteristics of a l/9-scale powered model of the Convair XFY-1 vertically rising airplane. Effects of thrust coefficient were investigated for the complete model and for certain components of the model. Effects of control deflections and of propeller-blade angle were investigated briefly for the complete model. Most of the tests were made through an angle-of-attack range from about -4 deg. to 29 deg, and the thrust-coefficient range was from 0 t o 0.7. In order to expedite distribution of these data to interested persons, no analysis of the data has been prepared for this report,
Explore the source record for details and available documents.
A low-speed investigation was made on a highly-swept arrow-wing model to determine the effect of wing leading-edge contour and vertical-tail configuration on the aerodynamic characteristics in pitch and sideslip. The investigation was made with the trailing-edge flaps deflected over a range of angles of attack from 8 deg to 32 deg. The tests were made at a Mach number of 0.13, which corresponds to a Reynolds number of about 3,000,000 based on the wing reference chord.
A wind tunnel investigation of concepts to improve the high angle-of-attack stability and control characteristics of a high performance aircraft was conducted. The effect of vertical tail geometry on stability and the effectiveness of several conventional and unusual control concepts was determined. These results were obtained over a large angle-of-attack range. Vertical tail location, cant angle and leading edge sweep could influence both longitudinal and lateral-directional stability. The control concepts tested were found to be effective and to provide control into the post stall angle-of-attack region.
A parameterization for the fluxes of sensible heat by large-scale eddies developed in an earlier paper is incorporated into a model for the mean temperature structure of an atmosphere including only these fluxes and the radiative fluxes. The climatic changes in this simple model are then studied in order to assess the strength of the dynamical feedback and to gain insight into how dynamical parameters may change in more sophisticated climatic models. The model shows the following qualitative changes: (1) an increase in the solar constant leads to increased static stability, decreased dynamic stability, and stronger horizontal and vertical winds; (2) an increase in the amount of atmospheric absorption leads to decreased static and dynamic stability, and stronger horizontal and vertical winds; and (3) an increase in rotation rate leads to greater static and dynamic stability, weaker horizontal winds, and stronger vertical winds.
This paper addresses the problem of simulation and stabilization of the yaw motions of a cargo container slung load. The study configuration is a UH-60 helicopter carrying a 6ft x 6 ft x 8 ft CONEX container. This load is limited to 60 KIAS in operations and flight testing indicates that it starts spinning in hover and that spin rate increases with airspeed. The simulation reproduced the load yaw motions seen in the flight data after augmenting the load model with terms representing unsteady load yaw moment effects acting to reinforce load oscillations, and augmenting the hook model to include yaw resistance at the hook. The use of a vertical fin to stabilize the load is considered. Results indicate that the CONEX airspeed can be extended to 110 kts using a 3x5 ft fin.
Multiple wavelength observations made by the Hubble Space Telescope in early 2007 show the presence of a wavy, high-contrast feature in Jupiter's atmosphere near 30 degrees North. The "Jovian Ribbon," best seen at 410 nanometers, irregularly undulates in latitude and is time-variable in appearance. A meridional intensity gradient algorithm was applied to the observations to track the Ribbon's contour. Spectral analysis of the contour revealed that the Ribbon's structure is a combination of several wavenumbers ranging from k equals 8-40. The Ribbon is a dynamic structure that has been observed to have spectral power for dominant wavenumbers which vary over a time period of one month. The presence of the Ribbon correlates with periods when the velocity of the westward jet at the same location is highest. We conducted numerical simulations to investigate the stability of westward jets of varying speed, vertical shear, and background static stability to different perturbations. A Ribbon-like morphology was best reproduced with a 35 per millisecond westward jet that decreases in amplitude for pressures greater than 700 hectopascals and a background static stability of N equals 0.005 per second perturbed by heat pulses constrained to latitudes south of 30 degrees North. Additionally, the simulated feature had wavenumbers that qualitatively matched observations and evolved throughout the simulation reproducing the Jovian Ribbon's dynamic structure.
Time-dependent ionospheric model calculations for day-time and night-time solutions are presented. The behavior of the growth rate and ion-electron recombination rate for the Rayleigh-Taylor instability on the F-region bottomside is examined as a function of the vertical eastward electric field-magnetic field strength drift velocity. It is observed that on the bottomside F-layer the growth rate exceeds the ion-electron recombination rate even without vertical drift; however, an eastward electric field-magnetic field strength drift can produce an increase in the growth rate by an order of magnitude. The calculated data are compared with previous research and good correlation is detected. The formation of bubbles from a seeding mechanism is investigated.
A passive aeromechanical gust alleviation system has been examined for application to a Cessna 172. The system employs small auxiliary wings to sense changes in angle of attack and to drive the wing flaps to compensate the resulting incremental lift. The flaps also can be spring loaded to neutralize the effects of variations in dynamic pressure. Conditions for gust alleviation are developed and shown to introduce marginal stability if both vertical and horizontal gusts are compensated. Satisfactory behavior is realized if only vertical gusts are absorbed; however, elevator control is effectively negated by the system. Techniques to couple the elevator and flaps are demonstrated to restore full controllability without sacrifice of gust alleviation.
A passive aeromechanical gust alleviation system was examined for application to a Cessna 172. The system employs small auxiliary wings to sense changes in angle of attack and to drive the wing flaps to compensate the resulting incremental lift. The flaps also can be spring loaded to neutralize the effects of variations in dynamic pressure. Conditions for gust alleviation are developed and shown to introduce marginal stability if both vertical and horizontal gusts are compensated. Satisfactory behavior is realized if only vertical gusts are absorbed; however, elevator control is effectively negated by the system. Techniques to couple the elevator and flaps are demonstrated to restore full controllability without sacrifice of gust alleviation.
A volumetric pattern analysis of fuselage-mounted airborne antennas at high frequencies was investigated. The primary goal of the investigation was to develop a numerical solution for predicting radiation patterns of airborne antennas in an accurate and efficient manner. An analytical study of airborne antenna pattern problems is presented in which the antenna is mounted on the fuselage near the top or bottom. Since this is a study of general-type commercial aircraft, the aircraft was modeled in its most basic form. The fuselage was assumed to be an infinitely long perfectly conducting elliptic cylinder in its cross-section and a composite elliptic cylinder in its elevation profile. The wing, cockpit, stabilizers (horizontal and vertical) and landing gear are modeled by "N" sided bent or flat plates which can be arbitrarily attached to the fuselage. The volumetric solution developed utilizes two elliptic cylinders, namely, the roll plane and elevation plane models to approximate the principal surface profile (longitudinal and transverse) at the antenna location. With the belt concept and the aid of appropriate coordinate system transformations the solution can be used to predict the volumetric patterns of airborne antennas in an accurate and efficient manner. Applications of this solution to various airborne antenna problems show good agreement with scale model measurements. Extensive data are presented for a microwave landing antenna system.
The effects of thrust reversing on stability, control and vertical tail loads of advanced fighter aircraft are reviewed. Several static test stand and wind tunnel investigations of nonaxisymmetric nozzles with integral thrust reversers are presented, and it is found that base drag on the aft face of reverser panels of blockers provides a significant contribution to in-flight thrust reverser performance. The location of tail surfaces relative to the thrust reverser has significant impact on control surface effectiveness, and depending on thrust reverser location, large vertical tail side force can result from the use of in-flight thrust reversers. It is concluded that highly effective nonaxisymmetric nozzle reversers can be designed to achieve a 50% static reverse thrust.
Models of intermediate complexity have been used to study some aspects of the climatic effects of anomalous heating, but many aspects of the problem have yet to be explored thoroughly. The present study represents a preliminary investigated of the gaps in scientific understanding of the interaction of heating and atmospheric dynamics. The principle research tool is a model of intermediate complexity, including a time-dependent, nonlinear-two-layer quasi-geostrophic model of relatively high horizontal resolution which incorporates simple heating parameterizations. The model is used to examine systematically the interaction of heating arising from anomalies in surface temperature with zonally symmetric and zonally asymmetric flows characterized by different values of static stability and mean vertical wind shear.
Linear stability theory is employed in the present analysis of flow stability between two vertical, infinite, rigid coaxial cylinders at different temperatures. These calculations have been prompted by, and are found to be in general agreement with, experiments on succinonitrile. A long, vertical cylinder sample of this material was heated so that a vertical melt annulus formed between the coaxial heater and the surrounding crystal/melt interface. Above a critical Grashof number of about 200, a helical crystal/melt interface formed which steadily rotated about the cylinder axis and whose wave speed was several orders of magnitude lower than the base flow velocity.
The failure mechanisms, design lessons, and test equipment employed by NASA in establishing the airworthiness and crashworthiness of aircraft components for commercial applications are described. The composites test programs have progressed to medium primary structures such as stabilizers and a vertical fin. The failures encountered to date have been due to the nonyielding nature of composites, which do not diffuse loads like metals, and the presence of eccentricities, irregular shapes, stiffness changes, and discontinuities that cause tension and shear. Testing to failure, which always occurred in first tests before the design loads were reached, helped identify design changes and reinforcements that produced successful products. New materials and NDE techniques are identified, together with aircraft structural design changes that offer greater protection to the passengers, fuel antimisting agents, and landing gear systems.