Search NASA⌕ Search

SEARCH · Search NASA

Results for “APPROXIMATION METHOD”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

New literal approximations for the longitudinal dynamic characteristics of flexible flight vehicles

The goal of the literal approximation method is to obtain simple literal (analytical) approximations for key dynamic characteristics of flexible flight vehicles. A basic question regarding the method is its usefulness as an additional design tool for existing design and simulation procedures. Two aspects of this question are: (1) ease of derivation and use of the literal approximations, and (2) the suitability of one set of literal approximations to describe the dynamics of a large set of significantly different vehicles. These issues are addressed by incorporating symbolic manipulation software into the literal approximation method for the analysis of a fifth order model of the longitudinal dynamics of a flexible flight vehicle. The automated literal approximation generated in this fashion reduces the manual derivation time by an approximate factor of four. A single set of literal approximations is shown to provide adequate approximations for the dynamics of significantly different flight vehicles configurations, such as an aircraft, a missile, and a hypersonic vehicle.

Livneh, Rafael↗
NASA NTRS1990

High order filtering methods for approximating hyberbolic systems of conservation laws

In the computation of discontinuous solutions of hyperbolic systems of conservation laws, the recently developed essentially non-oscillatory (ENO) schemes appear to be very useful. However, they are computationally costly compared to simple central difference methods. A filtering method which is developed uses simple central differencing of arbitrarily high order accuracy, except when a novel local test indicates the development of spurious oscillations. At these points, the full ENO apparatus is used, maintaining the high order of accuracy, but removing spurious oscillations. Numerical results indicate the success of the method. High order of accuracy was obtained in regions of smooth flow without spurious oscillations for a wide range of problems and a significant speed up of generally a factor of almost three over the full ENO method.

Lafon, F.↗
NASA NTRS1985

Probabilistic Structural Analysis Theory Development

The objective of the Probabilistic Structural Analysis Methods (PSAM) project is to develop analysis techniques and computer programs for predicting the probabilistic response of critical structural components for current and future space propulsion systems. This technology will play a central role in establishing system performance and durability. The first year's technical activity is concentrating on probabilistic finite element formulation strategy and code development. Work is also in progress to survey critical materials and space shuttle mian engine components. The probabilistic finite element computer program NESSUS (Numerical Evaluation of Stochastic Structures Under Stress) is being developed. The final probabilistic code will have, in the general case, the capability of performing nonlinear dynamic of stochastic structures. It is the goal of the approximate methods effort to increase problem solving efficiency relative to finite element methods by using energy methods to generate trial solutions which satisfy the structural boundary conditions. These approximate methods will be less computer intensive relative to the finite element approach.

Burnside, O. H.↗
NASA NTRS1993

Aerodynamic optimization of an HSCT configuration using variable-complexity modeling

An approach to aerodynamic configuration optimization is presented for the high-speed civil transport (HSCT). A method to parameterize the wing shape, fuselage shape and nacelle placement is described. Variable-complexity design strategies are used to combine conceptual and preliminary-level design approaches, both to preserve interdisciplinary design influences and to reduce computational expense. Conceptual-design-level (approximate) methods are used to estimate aircraft weight, supersonic wave drag and drag due to lift, and landing angle of attack. The drag due to lift, wave drag and landing angle of attack are also evaluated using more detailed, preliminary-design-level techniques. New, approximate methods for estimating supersonic wave drag and drag due to lift are described. The methodology is applied to the minimization of the gross weight of an HSCT that flies at Mach 2.4 with a range of 5500 n.mi. Results are presented for wing planform shape optimization and for combined wing and fuselage optimization with nacelle placement. Case studies include both all-metal wings and advanced composite wings.

Hutchison, M. G.↗
NASA NTRS1959

Charts and Tables for Estimating the Stability of the Compressible Laminar Boundary Layer with Heat Transfer and Arbitrary Pressure Gradient

The minimum critical Reynolds numbers for the similar solutions of the compressible laminar boundary layer computed by Cohen and Reshotko and also for the Falkner and Skan solutions as recomputed by Smith have been calculated by Lin's rapid approximate method for two-dimensional disturbances. These results enable the stability of the compressible laminar boundary layer with heat transfer and pressure gradient to be easily estimated after the behavior of the boundary layer has been computed by the approximate method of Cohen and Reshotko. The previously reported unusual result (NACA Technical Note 4037) that a highly cooled stagnation point flow is more unstable than a highly cooled flat-plate flow is again encountered. Moreover, this result is found to be part of the more general result that a favorable pressure gradient is destabilizing for very cool walls when the Mach number is less than that for complete stability. The minimum critical Reynolds numbers for these wall temperature ratios are, however, all larger than any value of the laminar-boundary-layer Reynolds number likely to be encountered. For Mach numbers greater than those for which complete stability occurs a favorable pressure gradient is stabilizing, even for very cool walls.

Tetervin, Neal↗
NASA NTRS1985

An experimental and analytical method for approximate determination of the tilt rotor research aircraft rotor/wing download

The XV-15 Tilt Rotor Research Aircraft download phenomenon was analyzed. This phenomenon is a direct result of the two rotor wakes impinging on the wing upper surface when the aircraft is in the hover configuration. For this study the analysis proceeded along tow lines. First was a method whereby results from actual hover tests of the XV-15 aircraft were combined with drag coefficient results from wind tunnel tests of a wing that was representative of the aircraft wing. Second, an analytical method was used that modeled that airflow caused gy the two rotors. Formulas were developed in such a way that acomputer program could be used to calculate the axial velocities were then used in conjunction with the aforementioned wind tunnel drag coefficinet results to produce download values. An attempt was made to validate the analytical results by modeling a model rotor system for which direct download values were determinrd..

Jordon, D. E.↗
NASA NTRS1943

A theoretical investigation of the lateral oscillations of an airplane with free rudder with special reference to the effect of friction

Charts showing the variation in dynamic stability with the rudder hinge-moment characteristics are presented. A stabilizing rudder floating tendency combined with a high degree of aerodynamic balance is shown to lead to oscillations of increasing amplitude. This dynamic instability is increased by viscous-friction in the rudder control system. The presence of solid friction in the rudder control system will cause steady oscillations of constant amplitude if the floating angle of the rudder per unit angle of sideslip is stabilizing and greater than a certain critical value that depends on other airplane parameters, such as vertical-tail area and airplane moment of inertia about the vertical axis. The amplitude of the steady oscillation is proportional to the amount of friction and is generally quite small but increases as the condition of dynamic instability is approached. An approximate method of calculating the amplitudes of the steady oscillation is explained and is illustrated by a numerical example. A more accurate step-by-step calculation of the motion is also made and it is shown that the agreement with the approximate method is good.

Greenberg, Harry↗
NASA NTRS1982

An approximation concepts method for space frame synthesis

A method is presented for the minimum mass design of three dimensional space frames constructed of thin walled rectangular cross-section members. Constraints on nodal displacements and rotations, material stress, local buckling, and cross sectional dimensions are included. A high quality separable approximate problem is formed in terms of the reciprocals of the four section properties of the frame element cross section, replacing all implicit functions with simplified explicit relations. The cross sectional dimensions are efficiently calculated without using multilevel techniques. Several test problems are solved, demonstrating that a series of approximate problem solutions converge rapidly to an optimal design.

Mills-Curran, W. C.↗
NASA NTRS1974

Aeroelastic stability of periodic systems with application to rotor blade flutter

The dynamics of a helicopter blade in forward flight are described by a system of linear differential equations with periodic coefficients. The stability of this periodic aeroelastic system is determined, using multivariable Floquet-Liapunov theory. The transition matrix at the end of the period is evaluated by: (1) direct numerical integration, and (2) a new, approximate method, which consists in approximating a periodic function by a series of step functions. The numerical accuracy and efficiency of the methods is compared, and the second method is shown to be superior by far. Results illustrating the effect of the periodic coefficients and various blade parameters are presented.

Friedmann, P.↗
NASA NTRS1972

Methods and approximations for the computation of transmission profiles in the v4 band of methane in the atmosphere of Jupiter.

This note discusses the validity of certain band models and scaling approximations for computing transmissions in the v4 band of methane along inhomogeneous paths in the atmosphere of Jupiter. It is shown that Goody's random band model approximates the results of a rigorous numerical line-by-line calculation of the transmission profile of a Jovian model atmosphere.

Taylor, F. W.↗
NASA NTRS1976

The Adams formulas for numerical integration of differential equations from 1st to 20th order

The Adams Bashforth predictor coefficients and the Adams Moulton corrector coefficients for the integration of differential equations are presented for methods of 1st to 20th order. The order of the method as presented refers to the highest order difference formula used in Newton's backward difference interpolation formula, on which the Adams method is based. The Adams method is a polynomial approximation method derived from Newton's backward difference interpolation formula. The Newton formula is derived and expanded to 20th order. The Adams predictor and corrector formulas are derived and expressed in terms of differences of the derivatives, as well as in terms of the derivatives themselves. All coefficients are given to 18 significant digits. For the difference formula only, the ratio coefficients are given to 10th order.

Kirkpatrick, J. C.↗
NASA NTRS1976

An investigation of flap-lag stability of wind turbine rotors in the presence of velocity gradients and helicopter rotors in forward flight

The flap-lag equations of motion of a torsionally rigid and centrally hinged spring-restrained rigid blade are developed using quasi-steady blade-element aerodynamic theory. These equations have periodic coefficients and are applicable to both wind-turbine rotors with velocity gradients and helicopter rotors in forward flight. By solving these equations both by the Floquet-Liapunov method and by an approximate method, the range of applicability of the latter method is established. Flap-lag and pure flapping stability boundaries illustrating the effects of flow and rotor parameters are presented. Finally, some discussion on the techniques for generating the Floquet transition matrix and on the relative merits of the coordinate axes system is presented.

Kaza, K. R. V.↗
NASA NTRS1980

Dynamics of rotationally periodic large space structure

The analysis of large area rotationally periodic space structures presented in the paper combines the finite element method, transfer matrix procedures, approximation methods, and periodic structure analysis to obtain computational efficiency. The computations used in the analysis indicate that additive damping mechanisms can be evaluated from the frequency response of the structure. The transient response can also be obtained from the frequency response to complete the dynamic analysis.

Mcdaniel, T. J.↗
NASA NTRS1983

Flux vector splitting and approximate Newton methods

In the present investigation, the basic approach is employed to view an iterative scheme as Newton's method or as a modified Newton's method. Attention is given to various modified Newton methods which can arise from differencing schemes for the Euler equations. Flux vector splitting is considered as the basic spatial differencing technique. This technique is based on the partition of a flux vector into groups which have certain properties. The Euler equations fluxes can be split into two groups, the first group having a flux Jacobian with all positive eigenvalues, and the second group having a flux Jacobian with all negative eigenvalues. Flux vector splitting based on a velocity-sound speed split is considered along with the use of numerical techniques to analyze nonlinear systems, and the steady Euler equations for quasi-one-dimensional flow in a nozzle. Results are given for steady flows with shocks.

Jespersen, D. C.↗