SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Oxidation state of iron and cation distribution over M1 and M2 sites in clinopyroxenes from Apollo 12 by Mossbauer absorption spectroscopy, noting cooling history
A high altitude balloon flight experiment to determine the technical feasibility of employing absorption spectroscopy to measure SO2 and NO2 gases in the earth's atmosphere from above the atmospheric ozone layer is discussed. In addition to the balloon experiment the contract includes a ground-based survey of natural I emissions from geological sources and studies of the feasibility of mapping I2 from spacecraft. This report is divided into three major sections as follows: (1) the planning engineering and execution of the balloon experiment, (2) data reduction and analysis of the balloon data, and (3) the results of the I2 phase of the contract.
Atomic absorption spectroscopy, electron microprobe analysis, and dithizone staining of trophozoites and cysts of Entamoeba invadens demonstrate that these cells have a high concentration of zinc (approximately one picogram per cell or 1% of their dry weight). In the cysts of this organism, the zinc is confined to the chromatoid bodies, which previous work has shown to contain crystals of ribosomes. The chemical state and function of this zinc are unknown.
Rate coefficient data for the recombination reaction H + 02 + Ar yields H02 + Ar have been determined from studies of lean hydrogen-oxygen mixtures behind incident shock waves over the temperature range of 948 to 1125 K. Hydroxyl radical concentration profiles were measured by ultraviolet absorption spectroscopy, and rate data were obtained through analysis of induction time and exponential growth parameter data. Analysis of the data yielded a rate coefficient which was generally lower than most of the more recent values obtained from shock tube studies. The effect of boundary layer formation on the conditions behind the shock was also examined and found to be negligible.
It would appear that over the next few years general diagnostic space exploration by satellite-borne conventional sensors will be well on its way under the sponsorship of many nations. It is the objective of this paper to review two new sensor developments and an application program. The first sensor (the photopolarimeter) makes use of polarized light to determine unique signatures ranging from aerosols to signatures for surface moisture. The second sensor (the correlation interferometer) makes use of absorption spectroscopy to detect anomalous gas concentrations and will be used to explore the CO sink problem, significant in pollution. In the applications area, some demonstration experiments in the general area of space processing, scheduled for the remaining Apollo flights, are described. If successfull, these experiments will give some indication of typical products which could be produced cost effectively in space.
It is shown that the absorption cross section for molecular oxygen at Lyman alpha is about 0.8 times 10 to the minus twentieth power sq cm. It is pointed out that, for application of absorption spectroscopy to the measurement of molecular oxygen density in the atmosphere, no correction for the variation of cross section with wavelength is necessary.
Hydrogen is injected from a downstream facing step in a wall into a high-temperature stream. Temperature and hydroxyl radical concentration are measured downstream of the injection plane by means of ultraviolet absorption spectroscopy. The experimental results are compared with theory which is based on a finite-difference solution of boundary-layer equations. Finite-rate kinetics equations are included in the analysis. The analytic predictions are also compared with previously obtained experimental results which are based on probe measurements. Comparison is made between calculated and observed ignition distances.
A method for the prediction of propellant-material compatibility for periods of time up to ten years is presented. Advanced sensitive measurement techniques used in the prediction method are described. These include: neutron activation analysis, radioactive tracer technique, and atomic absorption spectroscopy with a graphite tube furnace sampler. The results of laboratory tests performed to verify the prediction method are presented.
In view of the possible finding of several tens percent of inert gas in the atmosphere of Mars by an instrument on the descent module of the USSR's Mars 6 spacecraft, the likelihood of the correctness of this result was examined. The basis for the well-known fact that the most likely candidate is radiogenic argon is described. It is shown that, for the two important methods of investigating the atmosphere, earth-based CO2 is infrared absorption spectroscopy and S-band occultation, within the estimated 1 standard deviation uncertainties of these methods about 20% argon can be accommodated. Within the estimated 3 standard deviation uncertainties, more than 35% is possible. It is also stated that even with 35% argon the maximum value of heat transfer rate on the Viking 75 entry vehicle does not exceed the design value.
Hydrogen is injected from a downstream facing step in a wall into a high-temperature stream. Temperature and hydroxyl radical concentration are measured downstream of the injection plane by means of ultraviolet absorption spectroscopy. The experimental results are compared with theory which is based on a finite-difference solution of boundary-layer equations. Finite-rate kinetics equations are included in the analysis. The analytic predictions are also compared with previously obtained experimental results which are based on probe measurements. Comparison is made between calculated and observed ignition distances.
Experiments were performed on silicate compositions in the forsterite-anorthite-silica and forsterite-anorthite-diopside systems to determine the relative amounts of Cr(II), Cr(III), and Cr(VI) over a wide range of oxygen partial pressures from 10 to the -10th to 1 atm at 1500 and 1550 C. Redox states were measured by visible absorption spectroscopy and electron paramagnetic resonance spectroscopy and titration. It was found that Cr is present almost exclusively as Cr(III) in terrestrial basaltic liquids and as a mixture of Cr(III) and Cr(II) in lunar basaltic liquids.
Emission from the J = 1-0 transition of H(N-15)C has been detected in the direction of DR21(OH). The transition frequency of 88,865.69 MHz was measured in the laboratory by microwave absorption spectroscopy. The computed N-15/C-13 isotopic abundance ratio of 1.01 for DR21(OH) is larger than those calculated from isotopes of HCN in other interstellar clouds, perhaps implying a localized enrichment in N-15 in DR21(OH).
A study of atomic absorption spectroscopy as a possible nonobtrusive corrosion indicator for solar-energy systems is described. Procedures were tested for determining low levels of metallic concentration in aqueous glycol formulations. Other methods for determining corrosion are suggested.
A technique devised to permit the measurement of atmospheric species concentrations is described. This technique involves the application of atomic absorption spectroscopy and the quantitative observation of resonance fluorescence in which atomic or molecular species scatter resonance radiation from a light source into a detector. A beam of atomic oxygen and atomic nitrogen resonance radiation, strong unabsorbable oxygen and nitrogen radiation, and visual radiation was sent from Apollo to Soyuz. The density of atomic oxygen and atomic nitrogen between the two spacecraft was measured by observing the amount of resonance radiation absorbed when the line joining Apollo and Soyuz was perpendicular to their velocity with respect to the ambient atmosphere. Results of postflight analysis of the resonance fluorescence data are discussed.
Processes related to the hot corrosion of gas turbine components were examined in two separate investigations. Monochromatic laser light was used to probe condensation onset and condensate film growth (via interference of reflected light) on electrically heated ribbons immersed in seeded, flat flame combustion product gases. Boron trichloride is used as the seed gas in these preliminary experiments conducted to obtain precise measurements of the dew point/deposition rates. Because of the importance of gaseous Na(g) as a precursor to NaSO4 formation, the kinetics and mechanisms of the heterogeneous reaction H(g) + NaCl(s) yields Na(g) + HCl(g) was studied using atomic absorption spectroscopy combined with microwave discharge-vacuum flow reactor techniques at moderate temperatures. Preliminary results indicate the H-atom attack of solid NaCl vaporization is negligible; hence the corresponding gas phase (homogeneous) reaction no role in the observed Na(g) production.
The strong features and limitations of techniques for determining trace elements in aerosols emitted from coal plants are discussed. Techniques reviewed include atomic absorption spectroscopy, charged particle scattering and activation, instrumental neutron activation analysis, gas/liquid chromatography, gas chromatographic/mass spectrometric methods, X-ray fluorescence, and charged-particle-induced X-ray emission. The latter two methods are emphasized. They provide simultaneous, sensitive multielement analyses and lend themselves readily to depth profiling. It is recommended that whenever feasible, two or more complementary techniques should be used for analyzing environmental samples.
Theoretical models of interstellar radiative shocks are constructed, with special attention to the transfer of ionizing radiation. These models are 'self-consistent' in the sense that the emergent ionizing radiation (the UV precursor) is coupled with the ionization state of H, He, and the metals in the preshock gas. For shock velocities of at least 110 km/s the shocks generate sufficient UV radiation for complete preionization of H and He, the latter to He(+). At lower velocities the preionization can be much smaller, with important consequences for the cooling function, the shock structure, and the emission. For models with shock velocities of 40 to 130 km/s the intensities of the strongest emission lines in the UV, optical, and infrared are tabulated, as well as postshock column densities of metal ions potentially observable by UV absorption spectroscopy. Possible applications to supernova remnants and high-velocity interstellar gas are assessed.
A brief review is presented of the operating principles and applications of laser systems for monitoring pollution based on absorption spectroscopy. Particular consideration is given to an active bistatic system involving a cooperative reflector; an active monostatic system involving natural reflectors; an active monostatic system involving aerosol backscattering; and passive monostatic heterodyne detection.