SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The application of electrostatic technology to the protection of optical components in earth-mounted and satellite orbital systems has been investigated. Theory and experiment indicate it is quite practical to prevent dust deposition in an earth environment. A mathematical analysis indicates even better results should be obtained in an orbital vehicle.
Tetrahedral-lattice structure exhibits great complexity in mathematical analysis, and complexity quickly increases with number of elements. Solutions for static and dynamic behavior of structure obtained with model consisting of analogous structure with fewer repeating elements. Advantage of continuum models is analytic solutions can be obtained, either in closed form or in relatively-tractable Taylor series.
A mathematical analysis of a doubly-fed wound rotor machine used as a constant frequency generator is presented. The purpose of this analysis is to derive a consistent set of circuit equations which produce constant stator frequency and constant stator voltage. Starting with instantaneous circuit equations, the necessary rotor voltages and currents are derived. The model, thus obtained, is assumed to be valid, since the resulting relationships between mechanical power and active volt-amperes agrees with the results of others. In addition, the model allows for a new interpretation of the power flow in the doubly-fed generator.
A conceptual framework for the three-dimensional lee wave is given, and the severe limits of mathematical analysis as applied to the problem are described. It is shown that numerical simulation is the only feasible approach and some simulation results are displayed. These results are then compared with those from corresponding simulations of the much more familiar case of two-dimensional flow over a ridge. The problem of predicting in which portions of the lee wave clear air turbulence encounters are most probable is addressed. Here, idealized linear models are employed to establish a few tentative guidelines.
Mathematical analysis for digital data transmission calculates optimum number of binary error-correcting repeaters to install in given number of wideband channel links. Asymptotic results compared to computed numerical results.
A mathematical analysis of a doubly-fed wound rotor generator is presented. The constraints of constant stator voltage and frequency to the circuit equations were applied and expressions for the currents and voltages in the machine obtained. The derived variables are redefined as direct and quadrature components. In addition, the apparent (complex) power for both the rotor and the stator are derived in terms of these redefined components.
The wrinkling phenomenon in elasticity is mathematically defined and described as a special type of instability associated with the loss of hyperbolicity of the governing equations when some of the characteristic speeds of elastic wave propagation become imaginary. The developed criteria of wrinkling are applied to such structural elements as membranes, strings, soft shells, soft rods, and laminated material. The cause of wrinkling in these elements is due to compression in longitudinal directions that exceeds the through-the-thickness shear modulus. For elements with internal fluid flow the critical compression is reduced due to the destabilizing effect of the flow. The most effective mathematical analysis technique is a combination of tensor analysis and index notations.
Mathematical analysis of image sampling and interpolative reconstruction is summarized and extended to two dimensions for application to data acquired from satellite sensors such as the Thematic mapper and SPOT. It is shown that sample-scene phase influences the reconstruction of sampled images, adds a considerable blur to the average system point spread function, and decreases the average system modulation transfer function. It is also determined that the parametric bicubic interpolator with alpha = -0.5 is more radiometrically accurate than the conventional bicubic interpolator with alpha = -1, and this at no additional cost. Finally, the parametric bicubic interpolator is found to be suitable for adaptive implementation by relating the alpha parameter to the local frequency content of an image.
Report prepared for Marshall Space Flight Center summarizes recent advances in mathematical analysis of structural vibrations based on experimental data. Also includes summary of research by author as well as abstracts of technical reports and papers presented at meetings or otherwise published.
Comprehensive mathematical-analysis technique developed for array of solar-photovoltaic panels equipped with truncated-pyramid concentrators. Hollow pyramidal concentrator reflects Sunlight onto panel of photovoltaic cells. Comprehensive optical, thermal, and electrical analysis performed on array of units. Technique applicable, with modifications, to analysis and design of other multiple-cell reflecting photovoltaic systems.
There are three basic versions of the finite element method, called the h, p and h-p versions. They are characterized by the way in which the finite element meshes and polynomial degree of elements are chosen. They differ in computer implementation (program architecture) and mathematical analysis. The manner in which the meshes and polynomial degree of the elements affect the accuracy of finite element solutions is examined. The approach is to fix certain parameters and increase the number of degrees of freedom so that the finie element solutions converge to the exact solution. Such a systematic increase of the number of degrees of freedom is called extension because it can be interpreted as a systematic extension of finite element spaces.
The molten zone/freezing crystal interface system and all the mechanisms were examined. If Marangoni convection produces oscillatory flows in the float zone of semiconductor materials, such as silicon, then it is unlikely that superior quality crystals can be grown in space using this process. The major goals were: (1) to determine the conditions for the onset of Marangoni flows in molten tin, a model system for low Prandtl number molten semiconductor materials; (2) to determine whether the flows can be suppressed by a thin oxide layer; and (3) based on experimental and mathematical analysis, to predict whether oscillatory flows will occur in the float zone silicon geometry in space, and if so, could it be suppressed by thin oxide or nitride films. Techniques were developed to analyze molten tin surfaces in a UHV system in a disk float zone geometry to minimize buoyancy flows. The critical Marangoni number for onset of oscillatory flows was determined to be greater than 4300 on atomically clean molten tin surfaces.
Enhanced electron trapping has been observed in n-channels of rad-hard CMOS devices due to electron and gamma-ray irradiation. Room-temperature annealing results in a positive shift in the threshold potential far beyond its initial value. The slope of the annealing curve immediately after irradiation was found to depend strongly on the gate bias applied during irradiation. Some dependence was also observed on the electron dose rate. No clear dependence on energy and shielding over a delidded device was observed. The threshold shift is probably due to electron trapping at the radiation-induced interface states and tunneling of electrons through the oxide-silicon energy barrier to fill the radiation-induced electron traps. A mathematical analysis, based on two parallel annealing kinetics, hole annealing and electron trapping, is applied to the data for various electron dose rates.
In the lower altitude regions of the ionosphere, the gas present is only slightly ionized, and it behaves as a fluid. It is expected that a turbulent wake will form behind a spacecraft. Information is to be obtained regarding the effect of this turbulence on plasma waves measured by the spacecraft. If the turbulence is two-dimensional (2-D) and carries enstrophy, a fluctuating magnetic field and electric fields are produced. The fields induce fluctuations in the electron population which correlate with the magnetic and electric fluctuations which produced them. This correlation causes diffusion which changes the electron distribution and heats the electrons. As a result, the Langmuir frequency increases, and the Landau damping of Langmuir waves in the plasma decreases. Details regarding these processes are discussed, taking into account the results of a mathematical analysis.
The use of parabolically or spherically-shaped mirrors is being considered in order to increase the solar energy intensity on solar cells. Their use will significantly decrease the size and number of the cells needed for a particular application, hence the total array cost. Questions arise, however, regarding the long-term (five to ten years) efficiency of these devices. Performance degradation of the mirror surfaces might result from known hostile elements in the low earth orbit (LEO) environment (150-350 nautical miles). The degradation issue is addressed in light of present knowledge of this environment. The following characteristics of the LEO environment are identified for study: (1) the vacuum of space; (2) sputtering by the residual atoms and particles in space; (3) solar electromagnetic radiation; (4) contamination of the mirror surface; (5) atomic oxygen interactions with the surface; (6) bombardment of the surface by meteoroids; and (7) irradiation of the surface by ionizing particles (protons). Using the best available information for the magnitudes of the necessary quantities, a mathematical analysis was carried out, where possible, to determine the degradation in reflectance or other loss caused by each characteristic. Otherwise, reasonable estimates are made of corresponding losses, based on already published data.
The model is presented of an electrolyzer for peroxodisulfuric acid, and it is analyzed mathematically. Its application for engineering and economic optimization is investigated in detail. The mathematical analysis leads to conclusions concerning the change in position of the optimum with respect to the various target functions due to changes of the individual design-caused and economic parameters.
A mathematical analysis of a doubly-fed wound rotor generator is presented. The constraints of constant stator voltage and frequency to the circuit equations were applied and expressions for the currents and voltages in the machine obtained. The derived variables are redefined as direct and quadrature components. In addition, the apparent (complex) power for both the rotor and the stator are derived in terms of these redefined components.
Theoretical paper discusses advances in mathematical analysis of phase-locked loops. Presents new results in prediction of false locking. Interest to users of phase-lock circuits and to researchers seeking ways to detect or avoid false lock. Equations solved numerically by Newton-Raphson technique, with Jacobian computed by finite-difference scheme. Algorithm produces results limited only by precision of computer on which executed.