Search NASA⌕ Search

SEARCH · Search NASA

Results for “OPERATIONAL PROBLEM”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11

Design study of shaft face seal with self-acting lift augmentation. 5: Performance in simulated gas turbine engine operation

The feasibility and the noncontact operation of the self-acting seal was demonstrated over a range of simulated gas turbine engine conditions from 200 to 500 ft/sec sliding speed. Sealed pressure differentials were 50 to 300 psi and sealed temperatures were 150 to 1200 F. Low leakage (about 1/10 that of conventional labyrinth seals) was exhibited in two endurance runs (200 and 338 hr) at 400 ft/sec, 200 psi and 1000 F (gas temperature). For these endurance runs, the self-acting pad wear was less than 3.8 micrometers (0.00015 in.); this low wear was attributed to the noncontact operation of the primary seal. Operating problems identified were fretting wear of the secondary seal and erosion of the primary seal by hard particles.

Ludwig, L. P.↗

Study of a heat rejection system using capillary pumping

Results of an analytical study investigating the application of capillary pumping to the heat rejection loop of an advanced Rankine cycle power conversion system are presented. The feasibility of the concept of capillary pumping as an alternate to electromagnetic pumping is analytically demonstrated. Capillary pumping is shown to provide a potential for weight and electrical power saving and reliability through the use of redundant systems. A screen wick pump design with arterial feed lines was analytically developed. Advantages of this design are high thermodynamic and hydrodynamic efficiency, which provide a lightweight easily packaged system. Operational problems were identified which must be solved for successful application of capillary pumping. The most important are the development of start up and shutdown procedures, and development of a means of keeping noncondensibles from the system and of earth-bound testing procedures.

Neal, L. G.↗

Booster recovery following premature space shuttle stage separation

Abort criteria necessary to satisfy space shuttle program requirements to include intact vehicle abort capability are discussed. Intact abort implies the ability of the booster and orbiter to separate and both continue flight to a safe landing, with a full payload aboard the orbiter. Obviously, the requirement to separate early along the ascent trajectory presupposes critical operational problems that are probably booster problems and may preclude booster recovery. On the other hand, some critical problems while mated can become manageable when separated and should result in full booster recovery. All critical orbiter problems fall into this category; since stage separation without orbiter thrust is a capability of some separation system concepts, booster stage recovery following separation is a requirement.

Hurley, M. J.↗

A flight evaluation of a vectored thrust jet V/STOL airplane during simulated instrument approaches using the Kestrel (XV-6A) airplane

An in-flight investigation was made to determine the terminal-area operating problems of a vectored-thrust-jet vertical and short take-off landing (V/STOL) airplane under simulated instrument conditions. Handling-qualities data pertinent to the terminal-area approach and landing task are presented in the text, and additional documentation is included in the appendixes. Problems dealing with the cruise letdown to localizer capture, conversion to powered-lift flight, precise control of the glide slope, approach velocity or deceleration schedule, hover, and landing are discussed.

Morello, S. A.↗

Modifications and additions to NASTRAN at Marshall Space Flight Center, 1969 - 1972

Modifications to NASTRAN code which result from the location, identification, and correction of errors or operational problem areas are reviewed. Addition of improved capability which is structural, executive system oriented, or utility in nature is also considered. NASTRAN efficiencies and inefficiencies are studied.

Jordon, A. J., Jr.↗

NaK loop testing of thermoelectric converter modules (SNAP program)

The history of testing of compact tubular modules in flowing NaK loops is summarized. Test procedures, data handling, and instrument calibration are discussed. Also included is descriptive information of the test facilities, operational problems encountered, and some recommendations for testing.

Johnson, J. L.↗

Liquid rocket engine fluid-cooled combustion chambers

A monograph on the design and development of fluid cooled combustion chambers for liquid propellant rocket engines is presented. The subjects discussed are (1) regenerative cooling, (2) transpiration cooling, (3) film cooling, (4) structural analysis, (5) chamber reinforcement, and (6) operational problems.

Source record↗

Reactivity change in a fast-spectrum space power reactor due to a 328-meter-per-second (1075-ft/sec) impact

Application of nuclear reactors in space will present operational problems. One such problem is the possibility of an earth impact at velocities in excess of 305 m/sec (1000 ft/sec). This report shows the results of an impact against concrete at 328 m/sec (1075 ft/sec) and examines the deformed core to estimate the range of activity inserted as a result of the impact. The results of this examination are that the deformation of the reactor core within the containment vessel left only an estimated 2.7 percent void in the core and that the reactivity inserted due to this impact deformation could be from 4.0 to 10.25 dollars.

Peoples, J. A., Jr.↗

Third Level Air Carrier Service

A proposed Civil Aviation Board approach to regulating commuter air transportation services is discussed. Operating problems of specific air lines are used as examples. Inadequacies in the present service for short haul commuter air transportation are defined. Methods by which improvements in the commuter air transport service are proposed.

Eads, G. C.↗

Results of Apollo 16.

The results of the Apollo 16 mission are summarized, and the present level of hardware and procedures maturity is illustrated. The primary objective was to obtain a sample of the lunar highlands. It appears that the moon and its history are too complex to be explained by any of the models currently available. Contingency plans fell into three categories: (1) emergency recovery from a hazardous situation, (2) alternate plans to maximize the mission return following a hardware malfunction, and (3) alternate procedures to work around specific problems. Operational experience indicates that it is better to execute a plan with some known disadvantages than to replace it with one which has some apparent advantages but is not thoroughly understood.

Mattingly, T. K., II↗

High Reynolds number experimental data for forebody axial force.

Brief review of the operational principle and capability of the high-Reynolds-number wind tunnel developed over the last few years. Its test medium is stored in a Ludwieg tube and held there by means of a diaphragm. When the diaphragm is broken, a rearward-facing centered rarefaction fan propagates upstream through the test section and nozzle into the supply tube, and the useful run time is bounded by the reflected rarefaction wave and the starting shock wave caused by choking at the nozzle. The operating problems center around the ability of model and sting support systems to withstand the loads and to meet the instrumentation requirements. Evaluation tests have shown that satisfactory force and moment measurements can be obtained in this facility.

Davis, J. W.↗

Flight experience with a pivoting traversing boundary-layer probe

A pivoting traversing boundary layer probe was evaluated in flight on an F-104 airplane. The evaluation was performed at free stream Mach numbers from 0.8 to 2.0. The unit is described, and operating problems and their solutions are discussed. Conventional boundary layer profiles containing variations in flow angle within the viscous layer are shown for free stream Mach numbers of 0.8, 1.6, and 2.0. Although the unit was not optimized for size and weight, it successfully measured simultaneously flow angularity, probe height, and pitot pressure through the boundary layer.

Montoya, L. C.↗

Technical evaluation report on AGARD Flight Mechanics Panel Symposium on Flight in Turbulence

The proceedings of a conference on the effects of atmospheric turbulence on flight characteristics are presented. The subjects discussed include the following: (1) turbulent environment, (2) operational problems, (3) design criteria, and (4) artificial aids for flight improvement. One conclusion is that there is a critical need for cross correlation measurements between various low atmosphere turbulence components. Additional discussion were held concerning wake vortex research for wake vortex detection and avoidance.

Aiken, W. S., Jr.↗

Use of a pitot-static probe for determining wing section drag in flight at Mach numbers from 0.5 to approximately 1.0

The use of a pitot-static probe to determine wing section drag at speeds from Mach 0.5 to approximately 1.0 was evaluated in flight. The probe unit is described and operational problems are discussed. Typical wake profiles and wing section drag coefficients are presented. The data indicate that the pitot-static probe gave reliable results up to speeds of approximately 1.0.

Montoya, L. C.↗

Flight experience with Apollo spacecraft propulsion systems

Apollo 17 ended the most successful application of rocket propulsion systems in man's history. A total of 23 developmental and manned operational flights were made. Seven hundred and sixty-three spacecraft rocket engines were flown in the program. Over 6 h of manned rocket flights were logged by the spacecraft propulsion systems and approximately one million rocket engine firings were made. One engine failure was encountered on an early unmanned flight as a result of a failure in the guidance programmer which caused the engine to operate in a manner known to cause failures. Numerous operational problems and malfunctions were observed; however, system and component redundancy prevented loss of mission objectives and never jeopardized crew safety. Performance of all systems was usually nominal and most problems were merely nuisances. This paper will present some highlights of Apollo propulsion performance and will provide a bibliography of all flight results.

Thibodaux, J. G., Jr.↗

New design and operating techniques for improved terminal area compatibility

Current aircraft operating problems that must be alleviated for future high-density terminal areas are safety, dependence on weather, congestion, energy conservation, noise, and atmospheric pollution. The microwave landing system (MLS) under development by FAA provides increased capabilities over the current ILS. It is, however, necessary and urgent to develop the airborne system's capability to take maximum advantage of the MLS capabilities in order to solve the terminal area problems previously mentioned. A major limiting factor in longitudinal spacing for capacity increase is the trailing vortex hazard. Promising methods for causing early dissipation of the vortices are being explored. Also, flight procedures for avoiding the hazard will be explored.

Reeder, J. P.↗

New design and operating techniques and requirements for improved aircraft terminal area operations

Current aircraft operating problems that must be alleviated for future high-density terminal areas are safety, dependence on weather, congestion, energy conservation, noise, and atmospheric pollution. The Microwave Landing System (MLS) under development by FAA provides increased capabilities over the current ILS. The development of the airborne system's capability to take maximum advantage of the MLS capabilities in order to solve terminal area problems are discussed. A major limiting factor in longitudinal spacing for capacity increase is the trailing vortex hazard. Promising methods for causing early dissipation of the vortices were explored. Flight procedures for avoiding the hazard were investigated. Terminal configured vehicles and their flight test development are discussed.

Reeder, J. P.↗

Preliminary results of geothermal desalting operations at the East Mesa test site Imperial Valley, California

The Bureau of Reclamation has erected at its Geothermal Resource Development site two experimental test vehicles for the purpose of desalting hot fluids of geothermal origin. Both plants have as a feed source geothermal well Mesa 6-1 drilled to a total depth of 8,030 feet and having a bottom hole temperature of 400 F. Formation fluid collected at the surface contained 24,800 mg/1 total dissolved solids. The dissolved solids consist mainly of sodium chloride. A multistage distillation (3-stage) plant has been operated intermittently for one year with no operational problems. Functioning at steady-state conditions with a liquid feed rate of 70 g/m and a temperature of 221 F, the final brine blowdown temperature was 169 F. Product water was produced at a rate of about 2 g/m; average total dissolved solids content of the product was 170 mg/1. A product quality of 27.5 mg/1 at a pH of 9.5 was produced from the first stage.

Suemoto, S. H.↗