Search NASA⌕ Search

SEARCH · Search NASA

Results for “ROLLING MOMENTS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11
All sourcesNASA NTRSDOE OSTI
NASA NTRS1954

Wind-tunnel Tests of a Model of a Wingless Fin-controlled Missile to Obtain Static Stability and Control Characteristics Through a Range of Mach Numbers from 0.5 to 0.88

An investigation at medium to high subsonic speeds has been conducted in the Langley low-turbulence pressure tunnel to determine the static stability and control characteristics and to measure the fin normal forces and moments for a model of a wingless fin-controlled missile. The data were obtained at Reynolds number of 2.1 x 10(6) based on the missile maximum diameter or 17.7 x 10(6) based on missile length; this Reynolds number was found to be large enough to avoid any large scale effects between the test and the expected flight Reynolds number. With the horizontal-fin deflection limited to a maximum of 6 degrees, longitudinally stable and trimmed flight could not be maintained beyond an angle of attack of 17 degrees for a Mach number of 0.88 and beyond 20 degrees for a Mach number of 0.50 for any center-of-gravity location without the use of some auxiliary stability or control device such as jet vanes. Mach number had no appreciable effect on the center-of-pressure positions and only a slight effect on neutral-point position. There was a shift in neutral-point position of about 1 caliber as the angle of attack was varied through the range for which the neutral point could be determined. Yawing the model to angles of sideslip up to 7 degrees had little effect on the longitudinal stability at angles of attack up to 15 degrees; however, above 15 degrees, the effect of sideslip was destabilizing. With the vertical fins at a plus-or-minus 6 degree roll deflection, the rolling moment caused by yawing the model at high angles of attack could be trimmed out up to angles of sideslip of 6.5 degrees and an angle of attack of 26 degrees for a Mach number of 0.50; this range of sideslip angles was reduced to 3 degrees at a Mach number of 0.88. The data indicated that, at lower angles of attack, the trim range extended to higher angles of sideslip. The total normal-force and hinge-moment coefficients for both horizontal fins were slightly nonlinear with both angle-of-attack and fin deflection. The effect of Mach number was to reduce the slopes of the hinge-moment coefficient with angle of attack and deflection angle. In general, the effort of increasing the sideslip angle was to reduce the values of the fin normal-force and hinge-moment coefficients.

Burrows, Dale L↗
NASA NTRS1973

Wind tunnel investigation of effects of variations in Reynolds number and leading-edge treatment on the aerodynamic characteristics of an externally blown jet-flap configuration

An investigation has been conducted in a full-scale tunnel to determine the effects of variations in Reynolds number and leading-edge treatment on the aerodynamic characteristics of an externally blown jet-flap transport configuration. The model had a double-slotted trailing-edge flap and was powered by four high-bypass-ratio turbofan engines. Tests were performed by using each of three leading-edge devices (a 30-percent-chord flap and 15- and 25-percent-chord slats) at Reynolds numbers from 0.47 x one million to 1.36 x one million thrust coefficients up to 3.5. The use of a 25-percent-chord slat was found to be more effective than a 15-percent-chord slat or a 30-percent-chord flap in extending the stall angle of attack and in minimizing the loss of lift after the stall. The large slat was also effective in reducing the rolling moments that occurred when the engine-out wing stalled first.

Parlett, L. P.↗
NASA NTRS1973

Theoretical study of lift generated vortex sheets designed to avoid roll up

The random motions of the vortex elements behind a wing that sheds a disturbed, translating array of vortices are analyzed. The analysis indicates that the wake would diffuse and decay rapidly when viscosity is present and would produce small rolling moments on encountering aircraft. It was found that comparable results could also be achieved with an array consisting of vortices that are equal in magnitude but which alternate in sign. This observation indicates that random motion can probably be achieved with a variety of stepped loadings.

Rossow, V. J.↗
NASA NTRS1973

Evaluation of effectiveness of various devices for attenuation of trailing vortices based on model tests in a large towing basin

The effectiveness of various candidate aircraft-wing devices for attenuation of trailing vortices generated by large aircraft is evaluated on basis of results of experiments conducted with a 0.03-scale model of a Boeing 747 transport aircraft using a technique developed at the HYDRONAUTICS Ship Model Basin. Emphasis is on the effects produced by these devices in the far-field (up to 8 kilometers downstream of full-scale generating aircraft) where the unaltered vortex-wakes could still be hazardous to small following aircraft. The evaluation is based primarily on quantitative measurements of the respective vortex velocity distributions made by means of hot-film probe traverses in a transverse plane at selected stations downstream. The effects of these altered wakes on rolling moment induced on a small following aircraft are also studied using a modified lifting-surface theory with a synthesized Gates Learjet as a typical example. Lift and drag measurements concurrently obtained in the model tests are used to appraise the effects of each device investigated on the performance characteristics of the generating aircraft.

Kirkman, K. L.↗
NASA NTRS1974

Wind-tunnel investigation to determine the low speed yawing stability derivatives of a twin jet fighter model at high angles of attack

An investigation was conducted to determine the low-speed yawing stability derivatives of a twin-jet fighter airplane model at high angles of attack. Tests were performed in a low-speed tunnel utilizing variable-curvature walls to simulate pure yawing motion. The results of the study showed that at angles of attack below the stall the yawing derivatives were essentially independent of the yawing velocity and sideslip angle. However, at angles of attack above the stall some nonlinear variations were present and the derivatives were strongly dependent upon sideslip angle. The results also showed that the rolling moment due to yawing was primarily due to the wing-fuselage combination, and that at angles of attack below the stall both the vertical and horizontal tails produced significant contributions to the damping in yaw. Additionally, the tests showed that the use of the forced-oscillation data to represent the yawing stability derivatives is questionable, at high angles of attack, due to large effects arising from the acceleration in sideslip derivatives.

Coe, P. L., Jr.↗
NASA NTRS1974

Lift-induced wing-tip vortex attenuation

It has been shown by a new static airflow visualization method that a drogue device properly positioned downstream of the wing tip causes vortex breakdown. This same result has been obtained by mounting a jet engine simulator at the wing tip and directing the high-energy jet blast downstream into the vortex. These configurations, among others, are now under intensive investigation in the new Langley Vortex Research Facility. In this facility a balance mounted vortex generating model is propelled along the 1800-foot track while a second model trailed at 160 feet (scale distance of 1 mile) measures the far-field rolling moment induced by the vortex of the generating model.

Patterson, J. C., Jr.↗
NASA NTRS1974

Influence of static aeroelasticity on oblique winged aircraft

Interest has recently been expressed about the impact of static aeroelasticity on the lateral control of oblique winged aircraft. An attempt is made to illustrate, by use of a simple example, together with results from published literature, an aeroelastic phenomenon which is believed to be unique to oblique winged aircraft. This phenomenon is the aeroelastic roll moment and occurs because upward bending deflection of the sweptforward wing generates additional lift while the converse is true of sweptback wings.

Weisshaar, T. A.↗
NASA NTRS1975

Low-speed wind-tunnel investigation of forward-located spoilers and trailing splines as trailing-vortex hazard-alleviation devices on an aspect-ratio-8 wing model

An investigation was made in the Langley V/STOL tunnel in order to determine, by the trailing-wing sensor technique, the effectiveness of either a forward-mounted spoiler or a tip-mounted spline as trailing-vortex attenuation devices on an unswept aspect-ratio-8 wing model. The trailing-wing rolling-moment data taken in the tunnel diffuser section show good agreement with the data taken in the tunnel test section. This agreement indicates that reasonable results may be obtained in the Langley V/STOL tunnel in experimental investigations of the trailing-vortex hazard at relatively great distances behind aircraft models.

Croom, D. R.↗
NASA NTRS1975

Flight-Determined Stability and Control Derivatives for an Executive Jet Transport

A modified maximum likelihood estimation (MMLE) technique which included a provision for including a priori information about unknown parameters was used to determine the aerodynamic derivatives of the Lockheed JetStar airplane. Two hundred sixty-five maneuvers were performed with the JetStar airplane, which was modified to include direct lift controls, to obtain lateral-directional and longitudinal derivatives. Data were obtained at altitudes of 3048 meters, 6096 meters, and 9144 meters (10,000 feet, 20,000 feet, and 30,000 feet) and over an angle of attack range from approximately 3 deg to 13 deg and a Mach number range from 0.25 to 0.75. Side force generators were installed and tested in 87 maneuvers to determine their effectiveness and their effect on the other derivatives. Lateral-directional data for four flight conditions were analyzed without using a priori information to assess the effect of this feature on the results. The MMLE method generally gave consistent (repeatable) estimates of the derivatives, with the exception of the rolling moment due to yaw rate, which showed large variances.

Smith, H. J.↗
NASA NTRS1976

A study of the two-control operation of an airplane

The two control operation of a conventional airplane is treated by means of the theory of disturbed motions. The consequences of this method of control are studied with regard to the stability of the airplane in its unconstrained components of motion and the movements set up during turn maneuvers. It is found that the motion of a conventional airplane is more stable when an arbitrary kinematic constraint is imposed in banking than when such constraint is imposed in yawing. Several hypothetical assumptions of piloting procedure, each of which is considered to represent a component of the actual procedure, are studied. Different means of two control operation are also discussed and it is concluded that a reliable rolling moment control that does not give the usual adverse secondary yawing moment should be most satisfactory.

Jones, R. T.↗
NASA NTRS1976

Nonlinear slender wing aerodynamics

On present day high performance aircraft, a large portion of the lift is generated by leading edge vortices generated by flow separation off the highly swept leading edges of the lifting surfaces employed. It has been shown in an earlier paper how the vortex effects can be superimposed on a modified slender wing theory to give the unsteady longitudinal characteristics of sharp-edged delta wings up to very high angles of attack. The present paper extends the previous analysis to include the effects of leading edge roundness and trailing edge sweep on the aerodynamic characteristics. The paper also derives analytic means for prediction of the yaw stability of slender wings and the first order effects of Mach number. Universal scaling laws are defined for rapid preliminary design estimates of the slender wing lift and rolling moment. The results indicate that simple analytic tools can be developed to predict the aeroelastic characteristics of the space shuttle ascent configuration with its complicated flow field and aeroelastic cross-couplings.

Ericsson, L. E.↗
NASA NTRS1976

Transonic wind-tunnel tests of a lifting parachute model

Wind-tunnel tests have been made in the Langley transonic dynamics tunnel on a 0.25-scale model of Sandia Laboratories' 3.96-meter (13-foot), slanted ribbon design, lifting parachute. The lifting parachute is the first stage of a proposed two-stage payload delivery system. The lifting parachute model was attached to a forebody representing the payload. The forebody was designed and installed in the test section in a manner which allowed rotational freedom about the pitch and yaw axes. Values of parachute axial force coefficient, rolling moment coefficient, and payload trim angles in pitch and yaw are presented through the transonic speed range. Data are presented for the parachute in both the reefed and full open conditions. Time history records of lifting parachute deployment and disreefing tests are included.

Foughner, J. T., Jr.↗
NASA NTRS1977

Merging of aircraft trailing vortices

A merging-distance criterion for equal-strength corotational vortices is derived from low-turbulence wind-tunnel flow-visualization data. The vortex separation distance is normalized by defining a vortex core diameter based on circulation defect and angular-momentum defect. Merging may take place for larger separation distances than predicted from earlier two-dimensional inviscid calculations, which indicates that viscosity and possibly three-dimensional effects are important factors in the merging phenomenon. Hot-wire velocity distributions and rolling-moment measurements show that attenuation of the vortex hazard is associated with vortex merging.

Brandt, S. A.↗
NASA NTRS1977

Effect of wing fins on lift-generated wakes

A theoretical and experimental study has been made of the effect of wing-mounted fins on the vortex wakes of subsonic aircraft. The theory is used (a) to gain an understanding of wake alleviation by vortex injection and (b) to guide the experimental investigation. Wind-tunnel tests were used to evaluate the alleviation achievable and to find the optimum values for the various fin parameters. It was found that vertical fins mounted on the upper surface of a wing could lower the wake-induced rolling moments on an encountering wing by a factor of 3 or more. The most promising fin configuration found for the Boeing 747 model is a fin positioned 48% outboard from the centerline to the wingtip with a height of 0.014 span, a chord of 0.085 span, and an 18 deg angle of attack. This fin configuration caused a 10% increase in drag but no lift penalty.

Rossow, V. J.↗
NASA NTRS1977

Evaluation of flight spoilers for vortex alleviation

The paper describes the facilities and test procedures used in a series of wind-tunnel and full-scale flight investigations of the effectiveness of flight spoilers currently existing on wide-bodied transport jet aircraft when used as trailing vortex hazard alleviation devices. Examples of the results of such studies include the variation of trailing wing rolling-moment coefficient with downstream distance behind a B-747 airplane model with various segments of its flight spoilers deflected 45 deg, and comparisons with models without spoilers deflected. It is concluded that the existing flight spoilers on the B-747 are effective as trailing vortex attenuators.

Croom, D. R.↗
NASA NTRS1977

Inviscid modeling of aircraft trailing vortices

A survey is presented of inviscid theoretical methods that are useful in the study of lift-generated vortices. Concepts derived using these invisicid theories are cited which have helped to guide research directed at alleviating the velocities and rolling moments imposed on aircraft entering these wakes.

Rossow, V. J.↗
NASA NTRS1977

Thrust-augmented vortex attenuation

An experimental investigation was conducted to determine the vortex attenuating effect of engine thrust. Tests were made using a 0.03-scale model of the Boeing 747 transport aircraft as a vortex generating model. A Learjet-class probe model was used to measure the vortex induced rolling moment at a scale separation distance of 1.63 km. These tests were conducted at a lift coefficient of 1.4 at a model velocity of 30.48 m/s. The data presented indicate that engine thrust is effective as a vortex attenuating device when the engines are operated at high thrust levels and are positioned to direct the high energy engine wake into the core of the vortex. The greatest thrust vortex attenuation was obtained by operating the inboard engine thrust reversers at one-quarter thrust and the outboard engines at maximum forward thrust.

Patterson, J. C., Jr.↗