SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The propulsion control requirements of supersonic aircraft are presented. Integration of inlet, engine, and airframe controls is discussed. The application of recent control theory developments to propulsion control design is described. Control component designs for achieving reliable, responsive propulsion control are also discussed.
The disturbance wave pattern produced by a harmonic point source in a compressible flat-plate boundary layer is computed using linear stability theory and direct numerical integration approach. Receptivity coefficients are computed for the spectrum of spanwise modes generated at the source. The effect of boundary layer growth on the development of linear waves is determined by using the method of multiple scales. Results are presented for Mach numbers of 0, 2, 4.5, and 7. It is found that disturbances spread in wedge-shaped regions behind the source and the wedge angle decreases with Mach number. The lateral spreading angle for the instability waves turns out to be quite close to the angle found experimentally for turbulence lateral contamination.
Comparisons are made of experimental and theoretical zero-lift wave drag for several nose shapes, wing-body combinations, and models of current airplanes at Mach numbers up to 1.0. The experimental data were obtained from tests in the Ames 6- by6-foot supersonic wind tunnel and at the NACA Wallops Island facility. The theoretical drag was found by use of linear theory utilizing model area distributions. The agreement between theoretical and experimental zero-lift wave-drag coefficients was generally very good, especially for a fuselage or for fuselage-wing combinations that were vertically symmetrical. For other models that had rapid changes in body shape and/or were not vertically symmetrical, the agreement of theory with experiment ranged from fair to poor, depending on the severity of the change in shape.
An investigation into the kinetics of molecular clustering processes which occur in the highly supersaturated vapor of a CO2 free jet is described. Terminal cluster concentrations in expansions from room temperature and reservoir pressures in the range from 400 to 900 torr were determined for trimeric CO2 for nozzle diameters of .0076 cm, .015 cm, and .023 cm and in the case of CO2 tetramer and pentamer for .015 cm nozzle diameter. The measurements were made mass spectrometrically in a supersonic molecular beam apparatus. A kinetic analysis was developed from an extension of the critical nucleus concept of nucleation theory and rate equations based on intermolecular collisions. The observed cluster populations could be accounted for by the theory by adopting sticking probabilities of approximately .03 for monomer impinging on dimer, trimer, and tetramer.
The plasma waves, MHD waves, energetic electrons and ions associated with the proximity of the region upstream from terrestrial, planetary and interplanetary shocks are discussed in view of observations and current theories concerning their origin. These waves cannot be separated from the study of shock structure. Since the shocks are supersonic, they continually overtake any ULF waves created in the plasma in front of the shock. The upstream particles and waves are also of intrinsic interest because they provide a plasma laboratory for the study of wave-particle interactions in a plasma which, at least at the earth, is accessible to sophisticated probing. Insight may be gained into interstellar medium cosmic ray acceleration through the study of these phenomena.
An asymptotic analysis based on the Mach surface structure of the field of a supersonic helical source distribution is applied to predict thickness and loading noise radiated by high speed propeller blades. The theory utilizes an integral representation of the Ffowcs-Williams Hawkings equation in a fully linearized form. The asymptotic results are used for chordwise strips of the blade, while required spanwise integrations are performed numerically. The form of the analysis enables predicted waveforms to be interpreted in terms of Mach surface propagation. A computer code developed to implement the theory is described and found to yield results in close agreement with more exact computations.
Flat panel flutter at high supersonic Mach number is analyzed using NASTRAN Level 16.0 by means of modifications to the code. Two-dimensional plate theory and quasi-steady aerodynamic theory are employed. The finite element formulation and solution procedure are presented. Modifications to the NASTRAN code are discussed. Convergence characteristics of the iteration processes are also briefly discussed. Effects of aerodynamic damping, boundary support condition and applied in-plane loading are included. Comparison of nonlinear vibration and linear flutter results with analytical solutions demonstrate that excellent accuracy is obtained with NASTRAN.
Observed spectral data from supersonic jet aircraft are known to contain much more high frequency energy than can be explained by linear acoustic propagation theory. It is believed that the high frequency energy is an effect of nonlinear distortion due to the extremely high acoustic levels generated by the jet engines. The objective, to measure acoustic waveform distortion for spherically diverging high intensity noise, was reached by using an electropneumatic acoustic source capable of generating sound pressure levels in the range of 140 to 160 decibels (re 20 micro Pa). The noise spectrum was shaped to represent the spectra generated by jet engines. Two microphones were used to capture the acoustic pressure waveform at different points along the propagation path in order to provide a direct measure of the waveform distortion as well as spectral distortion. A secondary objective was to determine that the observed distortion is an acoustic effect. To do this an existing computer prediction code that deals with nonlinear acoustic propagation was used on data representative of the measured data. The results clearly demonstrate that high intensity jet noise does shift the energy in the spectrum to the higher frequencies along the propagation path. In addition, the data from the computer model are in good agreement with the measurements, thus demonstrating that the waveform distortion can be accounted for with nonlinear acoustic theory.
Slender sharp-edge wings having leading-edge sweep angles of 74 deg have been studied at Mach numbers from 0.60 to 2.80, at angles of attack from about minus 4 deg to 22 deg, and at angles of sideslip from 0 deg to 5 deg. The wings had delta, arrow, and diamond planforms. The experimental tests were made in the Langley 8-foot transonic pressure tunnel and the Langley Unitary Plan wind tunnel test section number 1. The theoretical predictions were made using the theories of NASA TN D-3767 and NASA TN D-6243. The results of the study indicated that the lift and drag characteristics as affected by planform and Mach number could be reasonably well predicted for the delta wing in the subsonic and transonic Mach number range. In the supersonic range, the delta and diamond wings were about equally good in the degree of agreement between experiment and theory. In making drag-due-to-lift predictions the vortex lift effects must be taken into account if reasonable results are to be obtained at moderate or high lift coefficients.
A theoretical basis for the scaling of broadband shock noise intensity In supersonic jets was formulated considering linear shock-shear wave interaction. Modeling of broadband shock noise with the aid of shock-turbulence interaction with special reference to linear theories is briefly reviewed. An hypothesis has been postulated that the peak angle of incidence (closer to the critical angle) for the shear wave primarily governs the generation of sound in the interaction process with the noise generation contribution from off-peak incident angles being relatively unimportant. The proposed hypothesis satisfactorily explains the well-known scaling law for the broadband shock-associated noise in supersonic jets.
Electrostatic production of low frequency (about 1 Hz) acoustic pulses associated with electrical discharges in thunderclouds has been theoretically described (e.g., Wilson, 1920; Dessler, 1973) and experimentally observed (e.g., Bohannon et al., 1977; Balachandran, 1983). The measured waveforms differ consistently with the theories in that the observed wave has an initial positive (or condensation) pulse followed by a negative (or rarefaction) pulse; whereas theories predicted only a negative pulse. The electrical heating of the air by positive streamer systems during the discharge is computed in this theoretical paper. This rapid (supersonic) electrical heating, although small (about 10 to the -6th T sub zero), produces a positive pressure perturbation (of about 10 to the -1st Pa), which when added to the negative electrostatic pressure perturbation generates an acoustic wave consistent with measured signals. A positive pulse always precedes the negative pulse in this model, and the positive pulse is always smaller in amplitude than the negative. The durations of the positive and negative pulses are similar. When more realistic models are employed, the observed signal can be related through theory to physical parameters in the thundercloud.
A summary is presented of experiences in connection with flight flutter testing of supersonic interceptors. The planning and operational aspects involved are described along with the difficulties encountered, and the correlation between measurement and theory. Recommendations for future research and development to advance the science of flight flutter testing are included.
The incremental wave drag penalty due to nose blunting of a fuselage was investigated using a three dimensional finite difference scheme. An aircraft typical of current supersonic cruise concepts was considered. Computational problems with the finite difference scheme as the fuselage afterbody closes were addressed. A linear theory method was employed to compute the afterbody aerodynamics and effectively extends the finite difference scheme to closing afterbodies. Acceptable drag increments for various levels of nose bluntness were demonstrated using this approach.
The results of an experimental investigation of the load distribution over two triangular wings in sideslip at Mach numbers from 1.20 to 1.79 are presented and compared with theory. The two wings tested have identical plan form, 45 degrees sweepback of the leading edge, and an aspect ratio of 4.0. One model was composed of round-nose airfoil sections and the other of sharp-nose, biconvex sections. For both wings the maximum thickness of streamwise sections was 6 percent and was located at the 30-percent chord.
The transonic similarity rules have been applied to the correlation of experimental data for a series of 22 rectangular wings having symmetrical NACA 63A-series sections, aspect ratios from 1/2 to 6, and thicknesses from 2 to 10 percent. The data were obtained by use of the transonic bump technique over a Mach number range from 0.40 to 1.10, corresponding to a Reynolds number range from 1.25 to 2.05 million. The results show that it is possible to correlate experimental data throughout the subsonic, transonic, and moderate supersonic regimes by using the transonic similarity parameters in forms which are consistent with the Prandtl-Glauert rule of linearized theory. The multiple families of basic data curves for the various aspect ratios and thickness ratios have been summarized in single presentations involving only one geometric variable - the product of the aspect ratio and the l/3 power of the thickness ratio.
A study of the high-temperature oxidation of several aircraft construction materials was undertaken to assess the possibility of ignition under high-temperature flight conditions.Tests have been made both in open and closed jets, and, in addition, the burning of metals has been observed under static conditions in a pressurized vessel containing either air, oxygen, or nitrogen. When heated in an atmosphere of oxygen or when heated and plunged into a supersonic airstream, titanium, iron, carbon steel, and common alloys such as 4130 were found to have spontaneous-ignition temperatures in the solid phase (below melting) and they melted rapidly while burning. Inconel, copper, 18-8 stainless steel, Monel, and aluminum could not be made to ignite spontaneously at temperatures up to melting with the equipment available. Magnesium ignited spontaneously in either type of test at temperatures just above the melting temperature.A theory for the spontaneous ignition of metals, based on the first law of thermodynamics, is presented. Good correlation was obtained between calculated spontaneous-ignition temperatures and values measured in supersonic jet tests. There appears at the present time to be no need for concern regarding the spontaneous ignition of Inconel, the stainless steels, copper, aluminum, or magnesium for ordinary supersonic airplane or missile applications where the material temperature is kept within ordinary structural limits or at least below melting. For hypersonic applications where the material is to be melted away to absorb the heat of convection, the results of the present tests do not apply sufficiently to allow a conclusion.
Acoustic measurements collected during the Propfan Test Assessment (PTA) program in 1989 had demonstrated that cruising Propfans have undesirably high far-field noise level. This study attempts to investigate the source of these noise disturbances generated by a single-rotating propeller with supersonic tip speed. Various atmospheric and propagation effects responsible for shaping the far-field acoustics will be examined. A methodology for analyzing Propfan propagation noise is proposed based on the theory of geometrical acoustics. This approach allows acoustic rays to be traced into the far-field via Snell's law. Amplitude variation along the rays are evaluated by applying the Blokhintzev energy invariant principle. Additional terms are appended to the energy invariant principle to account for propagation and atmospheric effects. A FORTRAN program is written to analyze the rays emitted from a helicoidal source path traced by supersonic helical speed blade tip. Earlier papers by Myers and Farassat have demonstrated the presence of Mach envelopes that lead to formation of caustics. Linear geometric acoustics is used to ascertain the existence of these nonlinear caustics in the far-field. The importance of caustics to Propfan noise generation is then studied.
System of computer programs uses linear theories to evaluate static and dynamic stability, trim state, inertial, and aerodynamic loading, and elastic deformations of aircraft configurations at subsonic and supersonic speeds. Primary emphasis is on analysis of stability and control characteristics of flexible aircraft. System also solves simple rigid aerodynamic problems.