Search NASASearch

SEARCH · Search NASA

Results for “computers orbits”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11

Computational chemistry and aeroassisted orbital transfer vehicles

An analysis of the radiative heating phenomena encountered during a typical aeroassisted orbital transfer vehicle (AOTV) trajectory was made to determine the potential impact of computational chemistry on AOTV design technology. Both equilibrium and nonequilibrium radiation mechanisms were considered. This analysis showed that computational chemistry can be used to predict (1) radiative intensity factors and spectroscopic data; (2) the excitation rates of both atoms and molecules; (3) high-temperature reaction rate constants for metathesis and charge exchange reactions; (4) particle ionization and neutralization rates and cross sections; and (5) spectral line widths.

Cooper, D. M.

Artificial-Satellite-Analysis Program

Artificial Satellite Analysis Program (ASAP) is general orbit-predicting computer program incorporating sufficient orbit-modeling accuracy for design and planning of missions and analysis of maneuvers. Suitable for study of planetary-orbit missions with spacecraft trajectories of reconnaissance (flyby) and exploratory (mapping) nature. Not written for specific mission and intended use for almost any planetary orbiting mission. Written in FORTRAN 77.

Kwok, Johnny H.

Aerodynamics of Shuttle Orbiter at high altitudes

The high-altitude/high-Knudsen number aerodynamics of the Shuttle Orbiter are computed from Low-Earth Orbit down to 100 km using three-dimensional direct simulation Monte Carlo and free molecule codes. Results are compared with Blanchard's latest Shuttle aerodynamic model, which is based on in-flight accelerometer measurements, and bridging formula models. Good comparison is observed, except for the normal force and pitching moment coefficients. The present results were obtained for a generic Shuttle geometry configuration corresponding to a zero deflection for all control surfaces.

Rault, Didier F. G.

Analysis of error in TOMS total ozone as a function of orbit and attitude parameters

Computer simulations of orbital scenarios were performed to examine the effects of orbital altitude, equator crossing time, attitude uncertainty, and orbital eccentricity on ozone observations by future satellites. These effects were assessed by determining changes in solar and viewing geometry and earth daytime coverage loss. The importance of these changes on ozone retrieval was determined by simulating uncertainties in the TOMS ozone retrieval algorithm. The major findings are as follows: (1) Drift of equator crossing time from local noon would have the largest effect on the quality of ozone derived from TOMS. The most significant effect of this drift is the loss of earth daytime coverage in the winter hemisphere. The loss in coverage increases from 1 degree latitude for + or - 1 hour from noon, 6 degrees for + or - 3 hours from noon, to 53 degrees for + or - 6 hours from noon. An additional effect is the increase in ozone retrieval errors due to high solar zenith angles. (2) To maintain contiguous earth coverage, the maximum scan angle of the sensor must be increased with decreasing orbital altitude. The maximum scan angle required for full coverage at the equator varies from 60 degrees at 600 km altitude to 45 degrees at 1200 km. This produces an increase in spacecraft zenith angle, theta, which decreases the ozone retrieval accuracy. The range in theta was approximately 72 degrees for 600 km to approximately 57 degrees at 1200 km. (3) The effect of elliptical orbits is to create gaps in coverage along the subsatellite track. An elliptical orbit with a 200 km perigee and 1200 km apogee produced a maximum earth coverage gap of about 45 km at the perigee at nadir. (4) An attitude uncertainty of 0.1 degree in each axis (pitch, roll, yaw) produced a maximum scan angle to view the pole, and maximum solar zenith angle).

Gregg, W. W.

Description of a computer simulation of an orbital SAR system

In order to predict the performance of a synthetic aperture radar for a wide variety of system and environmental parameters a computer simulation of the SAR system was developed. This model is a detailed description of the SAR imaging process on a pulse-by-pulse basis. The simulation is implemented as seven computer programs for a CDC Cyber 171 digital computer.

Crow, G. L.

An Analytical Satellite Orbit Predictor (ASOP)

The documentation and user's guide for the Analytical Satellite Orbit Predictor (ASOP) computer program is presented. The ASOP is based on mathematical methods that represent a new state-of-the-art for rapid orbit computation techniques. It is intended to be used for computation of near-earth orbits including those of the shuttle/orbiter and its payloads.

Starke, S. E.

Adjoint Sensitivity Analysis of Orbital Mechanics: Application to Computations of Observables' Partials with Respect to Harmonics of the Planetary Gravity Fields

An approach is presented to the inversion of gravity fields based on evaluation of partials of observables with respect to gravity harmonics using the solution of adjoint problem of orbital dynamics of the spacecraft. Corresponding adjoint operator is derived directly from the linear operator of the linearized forward problem of orbital dynamics. The resulting adjoint problem is similar to the forward problem and can be solved by the same methods. For given highest degree N of gravity harmonics desired, this method involves integration of N adjoint solutions as compared to integration of N2 partials of the forward solution with respect to gravity harmonics in the conventional approach. Thus, for higher resolution gravity models, this approach becomes increasingly more effective in terms of computer resources as compared to the approach based on the solution of the forward problem of orbital dynamics.

gravity fields

Shuttle orbit IMU alignment. Single-precision computation error

The source of computational error in the inertial measurement unit (IMU) onorbit alignment software was investigated. Simulation runs were made on the IBM 360/70 computer with the IMU orbit alignment software coded in hal/s. The results indicate that for small IMU misalignment angles (less than 600 arc seconds), single precision computations in combination with the arc cosine method of eigen rotation angle extraction introduces an additional misalignment error of up to 230 arc seconds per axis. Use of the arc sine method, however, produced negligible misalignment error. As a result of this study, the arc sine method was recommended for use in the IMU onorbit alignment software.

Mcclain, C. R.

Flowfield computation of an aerobrake orbital transfer vehicle

Viscous real gas and ideal gas supersonic flowfields over the forebody of a aeroassisted orbital transfer vehicle are determined using a unsteady factored implicit algorithm. Air in chemical equilibrium is considered and its local thermodynamic properties are computed by an equilibrium composition method. Numerical solutions are obtained for both real and ideal gases at a Mach number of 30 and at angles of attack up to 20 degrees. Shock stand-off distances and surface pressure distributions are presented for the gas models with and without viscous effects. For the freestream conditions considered, viscous effects dominate the flow.

Balakrishnan, A.

Experimental and Computational Analysis of Shuttle Orbiter Hypersonic Trim Anomaly

During the high-Mach-number, high-altitude portion of the first entry of the Shuttle Orbiter, the vehicle exhibited a nose-up pitching moment relative to preflight prediction of approximately Delta Cm = 0.03. This trim anomaly has been postulated to be due to compressibility, viscous, and/or real-gas (lowered specific heat ratio gamma) effects on basic body pitching moment, body-flap effectiveness, or both. In order to assess the relative contribution of each of these effects, an experimental study was undertaken to examine the effects of Mach number, Reynolds number, and ratio of specific heats. Complementary computational solutions were obtained for wind-tunnel and flight conditions. The primary cause of the anomaly was determined to be lower pressures on the aft windward surface of the Orbiter than deduced from hypersonic wind-tunnel tests with ideal- or near-ideal-gas test flow. The lower pressure levels are a result of the lowering of the flowfield gamma due to high-temperature effects. This phenomenon was accurately simulated in a hypersonic wind tunnel using a heavy gas, which provided a lower, gamma, and was correctly predicted by Navier-Stokes computations using nonequilibrium chemistry.

Brauckmann, Gregory J.

Cloud Computing Methods for Near Rectilinear Halo Orbit Trajectory Design

Complicated mission design problems require innovative computational solutions. As spacecraft depart from a proposed Gateway in a Near Rectilinear Halo Orbit (NRHO), recontact analysis is required to avoid risk of collision and ensure safe operations. Escape dynamics from NRHOs are governed by multiple gravitational bodies, yielding a trajectory design space that is exhaustively large. This paper summarizes the recontact analysis for departure from the NRHO and describes how the Deep Space Trajectory Explorer (DSTE) trajectory design software incorporates high performance cloud computing to compute and visualize the orbit design space. Recent focus on exploration missions to cislunar space has kindled accelerated interest in multibody orbit solutions. Trajectory analysis in the presence of multiple gravity fields is complex, and innovative computational tools are needed to simplify complicated design spaces, to generate large quantities of data quickly, and to visualize the output for user accessibility. The Gateway mission is a prime example. The Gateway1 is proposed as a human outpost in deep space. The current baseline orbit for the Gateway is a Near Rectilinear Halo Orbit (NRHO) near the Moon.2 The NRHO exists in a regime that experiences the gravitational effects of the Earth and the Moon simultaneously, complicating orbit analysis. The mission design process benefits greatly from updated computational tools for multibody missions like the Gateway. As an example, consider the problem of assessing the risk of collision in an NRHO. As a staging location to missions to the lunar surface and beyond the Earth-Moon system, the Gateway will experience spacecraft and other objects regularly arriving and departing. Departing objects potentially include spent logistics modules, visiting crew vehicles, debris objects, wastewater particles, and cubesats. Each departure is governed by the dynamics of the Gateway orbit and the surrounding dynamical environment. Over time, any unmaintained object in such an orbit eventually departs due to the small instabilities associated with the NRHOs. A separation maneuver speeds the departure from the NRHO, but the effects of the maneuver on the spacecraft behavior depend on the location, magnitude, and direction of the burn. Escape dynamics from the NRHO with regard to these maneuver options open up an enormous potential trajectory design space where subtle changes in input can produce dramatically large changes in the results. Any departing object must avoid recontacting the Gateway as it leaves the lunar vicinity, and a recontact analysis thus involves a significant number of computations and extensive output data. To explore the dynamics of this extensive design space, the Deep Space Trajectory Explorer3 (DSTE) trajectory design software incorporates new High Performance Computing (HPC) services and novel interactive visualizations. This paper details the HPC and cloud infrastructure techniques that are implemented in the DSTE, applying the new capabilities to analysis of recontact risk with the Gateway in NRHO. NEAR RECTILINEAR HALO ORBITS The Gateway is planned to fly in a lunar NRHO as its baseline orbit. The NRHO families of orbits are subsets of the larger halo families, which originate from planar orbits near the L1 and L2 libration points; the Earth-Moon L2 halo family appears in Figure 1. Each halo orbit is perfectly periodic in the Circular Restricted 3-Body Problem (CR3BP) and becomes a quasi-periodic orbit in a higher fidelity ephemeris force model. The NRHOs are defined as those members of the halo family with bounded stability properties;2 they pass near the Moon at perilune and are nearly polar. Families exist with apolunes located both above the lunar north pole and above the lunar south pole; the Gateway is planned to reside in a southern L2 NRHO in a 9:2 resonance with the lunar synodic period. The 9:2 NRHO is characterized by a period of about 6.5 days, a perilune radius of about 3,500 km, and an apolune radius of about 71,000 km; it is strongly affected by the gravity of both the Earth and the Moon simultaneously. This NRHO offers extended communications with assets on the south pole of the Moon,4 as well as low-cost orbit maintenance and attitude control,5 favorable eclipse avoidance properties,6 and inexpensive transfers from Earth and to other destinations.5,7 The NRHO portion of the southern L2 halo family is highlighted in black in Figure 1, and the 9:2 NRHO appears in blue.

Phillips, Sean M.