Search NASA⌕ Search

SEARCH · Search NASA

Results for “ANGLE OF ATTACK”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1951

Wind-tunnel investigation of six shielded total-pressure tubes at high angles of attack subsonic speeds

The effect of inclination of the air stream on the measured pressures of six shielded total-pressure tubes (all designed for end-mounting on a horizontal boom) has been determined for an angle-of-attack range of approximately -30° to 65°. The tests were conducted at a Mach number of 0.26 in the Langley stability tunnel and at Mach numbers of 0.50, 0.70, 0.90, and 0.95 in the Langley high-speed 7- by 10-foot tunnel. The results of the tests showed that curved venturi entries are less sensitive to inclination of the air stream than the conical entry of the standard Kiel design. Of the three curved entries tested, the tube having the bluntest entry proved the least sensitive to inclination. The critical angle (that is, the sngle.at which the total-pressure error equals 1 percent of the impact pressure) for this tube was ±63.2° at a Mach number of 0.26. The tests also showed that the critical angle of a shielded tube could be extended to higher positive angles of attack by means of a slant profile. The critical angle of a tube having a conical entry with a 10° slant profile, for example, was found to average 9° greater than that of a similar tube having a square profile. Although the critical angle of this tube at angles of yaw was less than that at angles of attack, the critical angle in yaw was equal to that of the tube with the square profile. Tests of the effect of varying the position of the total-pressure probe in the shield showed that, in general, no advantage was to be gained by changing from the position used in the standard Kiel design. Limited tests of the effect of varying the internal diameter of the shield showed that an increase in the diameter of the throat corresponding an increase in the internal area of 50 percent resulted in a relatively small increase (2.5°) in the critical angle. The effect of Mach number on the sensitivity of the tubes to inclination was shown to be appreciable. An increase in Mach number from 0.26 to 0.90, for example, resulted in a decrease in the critical angle of most of the tubes of about 4°.

Walter R Russell↗
NASA NTRS1959

Low-Subsonic Measurements of the Static and Oscillatory Lateral Stability Derivatives of a Sweptback-Wing Airplane Configuration at Angles of Attack from -10 to 90 deg

An investigation has been conducted in the Langley free-flight tunnel at low-subsonic speeds to provide some basic information on the stability and control characteristics in the high angle-of-attack range of an airplane configuration typical of current design trends. The investigation consisted of static- and dynamic-force tests over an angle-of- attack range from -10 to 90 deg. The dynamic-force tests, which consisted of both linear- and rotary-oscillation tests, were conducted at values of the reduced-frequency parameter k of 0.10, 0.15, and 0.20. The configuration was directionally unstable for all angles of attack above about 15 deg but maintained positive effective dihedral, control effectiveness, and damping in roll and yaw over most of the angle-of-attack range tested. The effects of frequency on the oscillatory stability derivatives were found to be generally small, but in a few cases the effects were relatively large.

Hewes, Donald E.↗
NASA NTRS1992

Evaluation of electrolytic tilt sensors for measuring model angle of attack in wind tunnel tests

The results of a laboratory evaluation of electrolytic tilt sensors as potential candidates for measuring model attitude or angle of attack in wind tunnel tests are presented. The performance of eight electrolytic tilt sensors was compared with that of typical servo accelerometers used for angle-of-attack measurements. The areas evaluated included linearity, hysteresis, repeatability, temperature characteristics, roll-on-pitch interaction, sensitivity to lead-wire resistance, step response time, and rectification. Among the sensors being evaluated, the Spectron model RG-37 electrolytic tilt sensors have the highest overall accuracy in terms of linearity, hysteresis, repeatability, temperature sensitivity, and roll sensitivity. A comparison of the sensors with the servo accelerometers revealed that the accuracy of the RG-37 sensors was on the average about one order of magnitude worse. Even though a comparison indicates that the cost of each tilt sensor is about one-third the cost of each servo accelerometer, the sensors are considered unsuitable for angle-of-attack measurements. However, the potential exists for other applications such as wind tunnel wall-attitude measurements where the errors resulting from roll interaction, vibration, and response time are less and sensor temperature can be controlled.

Wong, Douglas T.↗
NASA NTRS1987

Aerodynamic characteristics of cruciform missiles at high angles of attack

An aerodynamic prediction method for missile aerodynamic performance and preliminary design has been developed to utilize a newly available systematic fin data base and an improved equivalent angle of attack methodology. The method predicts total aerodynamic loads and individual fin forces and moments for body-tail (wing-body) and canard-body-tail configurations with cruciform fin arrangements. The data base and the prediction method are valid for angles of attack up to 45 deg, arbitrary roll angles, fin deflection angles between -40 deg and 40 deg, Mach numbers between 0.6 and 4.5, and fin aspect ratios between 0.25 and 4.0. The equivalent angle of attack concept is employed to include the effects of vorticity and geometric scaling.

Lesieutre, Daniel J.↗
NASA NTRS1962

Effects of Booster Transition Section and Rudder Deflection on the Low-Angle-of-Attack Static Stability of a Winged Reentry Vehicle at Mach Numbers of 10.8 and 17.8 in Helium

An investigation has been carried out to obtain aerodynamic stability and control data on a model of a winged reentry vehicle at Mach numbers of 10.8 and 17.8 in helium. The effects of a booster transition section on the static stability were obtained at angles of attack from -5 deg to 15 deg and at angles of sideslip from -5 deg to 10 deg at an angle of attack of 0 deg. Directional control data were also obtained at an angle of attack of 0 deg for sideslip angles from -5 deg to 10 deg. No detailed analysis of the data has been made.

Ladson, Charles L.↗
NASA NTRS1984

Aerodynamic characteristics of two general aviation canard configurations at high angles of attack

The results of wind tunnel tests of two propeller driven canard general aviation aircraft models at high angles of attack are reported. Both tractor and pusher prop configurations were examined. Angles of attack of -6 to 40 deg were used with the pusher model at Re of 1,600,000, and from -30 to 90 deg and Re of 550,000 for the tractor model. The tests showed that the canard would stall long before the wing and produce a nose-down tendency, thus effectively keeping the aircraft out of the stall regime. However, a sequence of pilot actions or design factors such as the airfoils, relative geometry of the canard and wing, the propeller location and the center of gravity location could introduce a wide variance in stall characteristics from one aircraft to another.

Chambers, J. R.↗
NASA NTRS2004

LDV Surveys Over a Fighter Model at Moderate to High Angles of Attack

The vortex flowfield over an advanced twin-tailed fighter configuration was measured in a low-speed wind tunnel at two angles of attack. The primary test data consisted of 3-component velocity surveys obtained using a Laser Doppler Velocimeter. Laser light sheet and surface flow visualization were also obtained to provide insight into the flowfield structure. Time-averaged velocities and the root mean square of the velocity fluctuations were obtained at two cross-sections above the model. At 15 degrees angle of attack, the vortices generated by the wing leading edge extension (LEX) were unburst over the model and passed outboard of the vertical tail. At 25 degrees angle of attack, the vortices burst in the vicinity of the wing-LEX intersection and impact directly on the vertical tails. The RMS levels of the velocity fluctuations reach values of approximately 30% in the region of the vertical tails.

Sellers, William L., III↗
NASA NTRS1992

An aerodynamic design study of a series of lifting bodies at angles of attack from 10 to 53 degrees at Mach numbers from 2.30 to 4.62

The aerodynamic characteristics in the transition from high to low angles of attack at supersonic speeds have been experimentally and theoretically studied for a series of lifting bodies with various upper and lower surface camber designs. The configurations under consideration have a 75-degree swept delta planform with a rounded nose. Data obtained indicate that changes in the camber design cause some distinct changes in the aerodynamic characteristics that shoud be taken into account in the selection of a lifting body shape. The flat bottom designs with upper surface camber are found to provide greater drag for retardation at high angles of attack but are considerably out of trim longitudinally. The flat top designs with lower surface camber provide less drag at high angles of attack but can be more easily trimmed. Calculated results are found to be in good agreement with the experimental data.

Spearman, M. L.↗
NASA NTRS1986

A numerical analysis applied to high angle of attack three-dimensional inlets

The three-dimensional analytical methods used to analyze subsonic high angle of attack inlets are described. The methods are shown to be in good agreement with experimental results for various three-dimensional high angle of attack inlets. The methods are used to predict aerodynamic characteristics of scarf and slotted-lip inlets.

Hwang, D. P.↗
NASA NTRS1986

A numerical analysis applied to high angle of attack three-dimensional inlets

The three-dimensional analytical methods used to analyze subsonic high angle of attack inlets are described. The methods are shown to be in good agreement with experimental results for various three-dimensional high angle of attack inlets. The methods are used to predict aerodynamic characteristics of scarf and slotted-lip inlets.

Hwang, D. P.↗
NASA NTRS2005

Shuttle Orbiter Contingency Abort Aerodynamics: Real-Gas Effects and High Angles of Attack

An important element of the Space Shuttle Orbiter safety improvement plan is the improved understanding of its aerodynamic performance so as to minimize the "black zones" in the contingency abort trajectories [1]. These zones are regions in the launch trajectory where it is predicted that, due to vehicle limitations, the Orbiter will be unable to return to the launch site in a two or three engine-out scenario. Reduction of these zones requires accurate knowledge of the aerodynamic forces and moments to better assess the structural capability of the vehicle. An interesting aspect of the contingency abort trajectories is that the Orbiter would need to achieve angles of attack as high as 60deg. Such steep attitudes are much higher than those for a nominal flight trajectory. The Orbiter is currently flight certified only up to an angle of attack of 44deg at high Mach numbers and has never flown at angles of attack larger than this limit. Contingency abort trajectories are generated using the data in the Space Shuttle Operational Aerodynamic Data Book (OADB) [2]. The OADB, a detailed document of the aerodynamic environment of the current Orbiter, is primarily based on wind-tunnel measurements (over a wide Mach number and angle-of-attack range) extrapolated to flight conditions using available theories and correlations, and updated with flight data where available. For nominal flight conditions, i.e., angles of attack of less than 45deg, the fidelity of the OADB is excellent due to the availability of flight data. However, at the off-nominal conditions, such as would be encountered on contingency abort trajectories, the fidelity of the OADB is less certain. The primary aims of a recent collaborative effort (completed in the year 2001) between NASA and Boeing were to determine: 1) accurate distributions of pressure and shear loads on the Orbiter at select points in the contingency abort trajectory space; and 2) integrated aerodynamic forces and moments for the entire vehicle and the control surfaces (body flap, speed brake, and elevons). The latter served the useful purpose of verification of the aerodynamic characteristics that went into the generation of the abort trajectories.

Prabhu, Dinesh K.↗
NASA NTRS1991

Vortical flow control on a slender body at high angles of attack

Attention is given to the possibility of using tangential blowing to control vortical flow on a missile-like slender body at high angles of attack. Emphasis is placed on smoke- and surface oil-flow visualization, force measurements, and velocity and pressure measurements using a 5-hole probe. It is shown that the tangential blowing significantly alters the flow field downstream of the slot and creates large side forces and yawing moments to very high angles of attack. Effectiveness of the tangential blowing is discussed in terms of jet momentum, blowing location, slot area, and Reynolds number. The concept proved to be efficient at small blowing rates and at high angles of attack.

Celik, Zeki Z.↗
NASA NTRS1991

A two camera video imaging system with application to parafoil angle of attack measurements

This paper describes the development of a two-camera, video imaging system for the determination of three-dimensional spatial coordinates from stereo images. This system successfully measured angle of attack at several span-wise locations for large-scale parafoils tested in the NASA Ames 80- by 120-Foot Wind Tunnel. Measurement uncertainty for angle of attack was less than 0.6 deg. The stereo ranging system was the primary source for angle of attack measurements since inclinometers sewn into the fabric ribs of the parafoils had unknown angle offsets acquired during installation. This paper includes discussions of the basic theory and operation of the stereo ranging system, system measurement uncertainty, experimental set-up, calibration results, and test results. Planned improvements and enhancements to the system are also discussed.

Meyn, Larry A.↗