Search NASA⌕ Search

SEARCH · Search NASA

Results for “Oxide Reduction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
DOE OSTI2026

Optimizing a chemical cleaning protocol to determine the nickel isotopic composition of ancient seawater from carbonates

Reconstructing the ancient marine cycle of Ni, a trace metal in the oceans essential to enzymes regulating the C, N, and O cycles, would inform how Ni bioavailability shaped early life. The Ni isotopic composition of seawater (δ 60 Ni SW ) through time could provide insight, but this approach requires sedimentary archives that faithfully record δ 60 Ni SW . Carbonates are an often-used record of seawater chemistry, but contaminants could bias the measured δ 60 Ni of bulk sediment. To isolate the true carbonate-bound δ 60 Ni signal, we optimized a chemical cleaning protocol designed to minimize non‑carbonate Ni contributions and maximize carbonate recovery. We analyzed ODP Site 1007 sediments and evaluated oxidative and reductive pre-cleaning steps and carbonate dissolution protocols. Our results show that only reductive cleaning significantly altered the subsequent carbonate leachate composition, lowering Ni/Ca ratios by up to 60% and δ 60 Ni values by as much as 0.4 ‰. In contrast, δ 60 Ni values were largely insensitive to premature carbonate dissolution during pre-cleaning or to partial leaching of silicates during carbonate dissolution, even at higher acid molarities or longer reaction times. We recommend an evidence-based protocol that removes hydro-soluble salts and clays, applies reductive cleaning and oxidative cleaning for certain sample compositions, and dissolves carbonate using 0.5 M acetic acid, adjusted to pH 5. Using these results, we infer a ∼ 0.9 ‰ Ni isotopic fractionation between chemically cleaned deep-water carbonates (+0.4 ± 0.1 ‰) and deep seawater. This method development is a key step toward accurately reconstructing ancient marine Ni cycles.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Carbon dioxide reduction in solid oxide electrolyzer cells using transition metals infiltrated into Gd 0.1 Ce 0.9 O 1.95 (GDC10) scaffolds

Here, this study reports the catalytic activity of transition metal electrocatalysts (Co, Ni, and Cu) incorporated into Gd 0.1 Ce 0.9 O 1.95 (GDC10) cathodes for the electroreduction of CO 2 in solid oxide electrolyzer cells (SOECs). CO 2 electroreduction performance of cells having porous and non-infiltrated GDC10 cathodes was compared with the performance of cells containing transition metal electrocatalysts infiltrated into porous GDC10 cathodes at 750, 800, and 850°C. Results showed that cells with Co infiltrated cathodes had the best catalytic activity towards CO 2 electroreduction. Furthermore, these cells displayed good stability towards CO electroreduction, having a faradaic efficiency value close to 100% with insignificant voltage increase when tested for 48h at 750 and 850°C under the current densities of 0.2, and 0.4Acm -2 , respectively.

25 ENERGY STORAGE↗
DOE OSTI2022

Reflection Optical Imaging to Study Oxygen Evolution Reactions

Discovery of high-efficiency water-splitting catalysts is critical for clean hydrogen fuel generation. Quantitative and reliable chemical imaging methods can play a crucial role in providing critical catalyst efficiency information for materials development and screening. Here, we developed a reflection optical imaging method to map the performance of transition metal oxide catalysts for oxygen evolution reaction (OER). The generated high concentration of oxygen in the electrolyte will decrease the refractive index of the solutions near the electrode and change the reflectivity of optical images. We successfully imaged and measured the OER on cobalt oxide, and the localized current density and overpotential distribution maps have been extracted. The oxidation and reduction of cobalt oxide can be imaged with our reflection optical imaging method as well. These maps showed that the catalytic activities are quite different at different locations, and some regions showed much higher activities. This is due to the non-uniformity created by the catalyst synthesis process and demonstrates the importance of using the optical imaging method to map the localized catalytic efficiency. In addition, the NiFe alloy’s OER catalytic activities have been studied as well. The proposed reflection optical imaging method could find many applications in catalyst activity measurement and screening.

Electrochemistry↗
DOE OSTI2025

Design of Twisted Two-Dimensional Heterostructures and Performance Regulation Descriptor for Electrocatalytic Ammonia Production from Nitric Oxide

The electrocatalytic reduction of nitric oxide (NO) to ammonia (NH 3 ) represents an attractive alternative for valorizing waste NO streams (NORR). However, discovering efficient catalysts for NO-to-NH 3 conversion remains challenging. We have designed metal-intercalated twisted graphene-BN heterostructures, in which metal atoms act as electron-transfer bridges. The twisted configuration facilitates cross-interface charge transfer, redistributing electrons from the graphene–metal interface to the metal–BN interface and BN surface. This electronic modulation enables boron atom adjacent to the metal center in BN to serve as active sites, promoting strong chemisorption and enhanced activation of NO. After high-throughput screening of the stability and NO capture ability of various transition metal-intercalated twisted heterostructures, we have investigated systematically the NORR pathways across 30 candidates. The results show that the rBN-Ti-Gθ and rBN-V-Gθ heterostructures exhibit exceptional NO-to-NH 3 catalytic performance under optimized twisting conditions. Additionally, using sure independence screening and sparsifying operator (SISSO) for model training, we propose a descriptor and establish a relationship between the twist angle and catalytic activity. This study bridges the gap in applying twisted heterostructures to NORR electrocatalysis and provides new insights and strategies for designing high-performance NORR catalysts.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Long-Lived Triplet Excited State in a Heterogeneous Modified Carbon Nitride Photocatalyst

Heterogeneous carbon nitrides have numerous advantages as photocatalysts, including strong light absorption, tunable band edges, and scalability, but their performance and continued development are limited by fast charge recombination and an under-developed mechanistic understanding of photodriven interfacial electron transfer. These shortcomings are a result of complex photophysics, leading to rate asynchrony between oxidation and reduction, as well as redox processes driven out of electronic trap states rather than excited states. We show that a well-defined triplet excited state in cyanamide-modified carbon nitride is realized with appropriately sized particles. The utility of this long-lived excited state is demonstrated by its ability to drive a hydroamidation photoredox cycle. By the tuning of the particle size of CN x , the oxidation–reduction photochemistry of carbon nitride may be balanced to achieve a redox-neutral closed photocatalytic cycle. Here, these results uncover a triplet excited state chemistry for appropriately sized CNx particles that preludes a rich energy and electron transfer photochemistry for these materials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Reactive Fe anode for electrolytic reduction of solid metal oxide in molten LiCl-Li 2 O

Iron metal was investigated for use as a consumable anode for electrolytic reduction of solid metal oxides in molten LiCl-Li 2 O (2.0 - 2.4 wt%). Tests were performed where the potential of Fe anodes was increased incrementally from 0.1 to 1.0 V (vs Ni/NiO). Oxide formation on the anode started at a potential of 0.4 V and was identified as FeO via X-ray diffraction. In the absence of a pre-formed oxide layer, severe attack of the anode started at a potential of 0.7 V and was accompanied by an increase in Fe concentration in the salt. When an oxide layer was allowed to form on the anode, the Fe concentration did not increase in the salt. O 2 was detected in the headspace gas at an anode potential of 1.0 V only when an oxide layer was present on the anode. Finally, the results of this study support the idea that an inexpensive sacrificial anode could be an ideal replacement for expensive Pt that is currently widely used for this process.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Reduction of Iron (III) Oxide in Microwaves Toward Gasification Studies

The purpose of this study is to reduce hematite (Fe2O3) using hydrogen (H2), carbon monoxide (CO), and methane (CH4) gases using microwave irradiation. Conventional temperature programmed reduction of iron phase transformation under H2, CO, and CH4 agree with the literature. Furthermore, the activation energy for the iron phase transformation in a conventional reactor was in the order of H2>CO>CH4, suggesting that CH4 was the best reductant to initiate the reduction at a much lower temperature than CO, and CO was significantly better than H2 atmosphere. Due to the uneven temperature distribution, the apparent activation energy of microwave reduction under H2 was approximately 1/4th when compared to the conventional reduction in H2. X-ray diffraction (XRD) analysis showed a mixed oxide phase in microwave reduction as opposed to the clear phase transformation in conventional studies. To combat the temperature measurement issues in microwave studies, fiber optic sensors and Forward Looking InfraRed (FLIR) sensors were used to acquire the actual temperature distribution in the catalyst bed. Therefore, a reasonably accurate activation energy estimation was achieved in the catalyst bed. Combining these with the characterization and quantification of the different iron phases in microwave reduction will provide a blueprint for future microwave-assisted gasification studies.

Aireddy, Divakar Reddy↗
DOE OSTI2024

Addressing Limitations of the Endpoint Slippage Analysis

Some rate of oxidation and reduction side-reactions will inevitably coexist in most rechargeable batteries. While parasitic reduction traps electrons, parasitic oxidation donates electrons to the cell’s inventory and may cause temporary capacity gain. Consequently, capacity measurements can provide unreliable information about the total extent of side-reactions occurring in the cell. The most widely used method to determine the rate of both these parasitic processes involves analyzing the slippage of endpoints, which consists in tracking the termination of cell charge and discharge when data is represented along a cumulative capacity axis. Here, we argue that this approach could lead to inaccuracies when applied to certain systems, which includes Si electrodes in Li-ion batteries and hard carbon in Na-ion batteries. This inaccuracy originates from the smooth nature of the voltage profiles of these materials at low and high alkali-ion content, causing the termination of charge and discharge to be dictated by voltage changes at both the positive and negative electrodes. We analyze this issue in quantitative terms and propose equations that can provide true rates of parasitic processes from experimental endpoint slippage data. This work shows that, in battery science, well-established analytical approaches may not be directly transferrable to new electrode systems.

25 ENERGY STORAGE↗
DOE OSTI2020

Flow-based anode for the electrocatalytic oxidation of a fuel or other reductant

Anode half-cells for the electrocatalytic oxidation of a liquid or gaseous fuel or other reductant are disclosed, along with electrochemical cells that include such half-cells. The anode half-cells include redox mediator/heterogeneous redox catalyst pairs within an electrolyte solution that is also in contact with an electrode. The electrode is not in direct contact with the heterogeneous catalyst. The redox mediator must include at least one carbon atom and be capable of transferring or accepting electrons and protons while undergoing reduction or oxidation.In operation, the fuel or other reductant is oxidized and the redox mediator is reduced at the heterogeneous catalyst. The reduced form of the redox mediator can then migrate to the electrode, where it is converted back to its oxidized form, which can then migrate back to the heterogeneous catalyst, where the cycle is repeated. The disclosed anode half-cells can be used in electrochemical cells, such as in fuel cells that produce electricity, or in electrosynthetic cells that produce one or more desired chemical products.

30 DIRECT ENERGY CONVERSION↗
DOE OSTI2021

Investigation of the NO reduction by CO reaction over oxidized and reduced NiO x /CeO 2 catalysts

CeO 2 -supported NiO x catalysts have been widely studied in various catalytic reactions including NO reduction by CO. This work is mainly focused on investigation of the impact of catalyst synthesis conditions (e.g., oxidation and reduction) on the physicochemical properties of NiO x /CeO 2 catalysts and the catalytic response for the NO reduction by CO reaction. The oxide NiO x /CeO 2 sample was prepared by an incipient wetness impregnation (IWI) method and reduced under hydrogen reduction treatment at high temperatures (500 and 700 °C). The physicochemical properties of the synthesized samples were characterized by BET analysis, Raman spectroscopy, XRD, XPS, EELS and high-resolution transmission electron microscopy (HR-TEM). The results showed that higher reduction temperature led to the decrease in specific surface area (SSA), fewer oxygen vacancy/defect site, larger crystallite size of the CeO 2 support, and formation of metallic Ni on the surface. The oxidized NiO x /CeO 2 catalyst showed the highest catalytic activity, indicating that the presence of oxygen vacancy/defect sites, Ni 2+ oxidation state, and smaller crystallite size are believed to enhance the catalytic activity. In situ DRIFTS confirmed the generation of several intermediate species, such as nitrate, carbonate, and N 2 O. Finally, on the basis of in situ DRIFTS and activity results, the possible reaction mechanism of NO reduction by CO over NiO x /CeO 2 was proposed.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

Facilitating Hydrogen Dissociation over Dilute Nanoporous Ti–Cu Catalysts

The dissociation of H 2 is an essential elementary step in many industrial chemical transformations, typically requiring precious metals. Here, we report a hierarchical nanoporous Cu catalyst doped with small amounts of Ti (npTiCu) that increases the rate of H 2 –D 2 exchange by approximately one order of magnitude compared to the undoped nanoporous Cu (npCu) catalyst. The promotional effect of Ti was measured via steady-state H 2 –D 2 exchange reaction experiments under atmospheric pressure flow conditions in the temperature range of 300–573 K. Pretreatment with flowing H 2 is required for stable catalytic performance, and two temperatures, 523 and 673 K, were investigated. The experimentally determined H 2 –D 2 exchange rate is 5–7 times greater for npTiCu vs the undoped Cu material under optimized pretreatment and reaction temperatures. The H 2 pretreatment leads to full reduction of Cu oxide and partial reduction of surface Ti oxide species present in the as-prepared catalyst as demonstrated using in situ ambient pressure X-ray photoelectron spectroscopy and X-ray absorption spectroscopy. The apparent activation energies and pre-exponential factors measured for H 2 –D 2 exchange are substantially different for Ti-doped vs undoped npCu catalysts. Density functional theory calculations suggest that isolated, metallic Ti atoms on the surface of the Cu host can act as the active surface sites for hydrogen recombination. Furthermore, the increase in the rate of exchange above that of pure Cu is caused primarily by a shift in the rate-determining step from dissociative adsorption on Cu to H/D atom recombination on Ti-doped Cu, with the corresponding decrease in activation entropy that it produces.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗