Search NASA⌕ Search

SEARCH · Search NASA

Results for “SPECTRAL ANALYSIS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12

Diagnostic analysis and spectral energetics of a blocking event in the GLAS climate model simulation

A synoptic and spectral analysis of a blocking event is presented, with attention given to the temporal evolution, maintenance, and decay of the block. The GLAS numerical climate model was used to generate a blocking event by the introduction of SST anomalies. Wavenumbers 2 and 3 became stationary around their climatological locations, and their constructive interference produced persistent blocking ridges over the west coast of North America and the other over western Europe. Time variations of the kinetic and potential energies and energy conversions during the blocking were performed. Spectrally filtered Hovmoller diagrams were developed for the winter of 1976-77, and showed that long waves were stationary over most of the interval, which featured severe weather conditions.

Chen, T.-C.↗

Data analysis techniques: Spectral processing

The individual steps in the data processing scheme applied to most radars used for wind sounding are analyzed. This processing method uses spectral analysis and assumes a pulse Doppler radar. Improvement in the signal to noise ratio of some radars is discussed.

Strauch, R. G.↗

Semiconducting polymers for gas detection

Conjugated polyenes, and polyesters containing phthalocyanine in their backbone, were synthesized. These polymers were characterized by chemical analysis, thermogravimetric analysis, spectral analysis, and X-ray diffraction studies for crystallinity, as well as for their film-forming capability and gas/polymer interactions. Most of the polymers were relatively insensitive to water vapor up to 50 percent relative humidity, but the polyester/phthalocyanine (iron) polymer was relatively insensitive up to 100 percent RH. On the other hand, poly(p-dimethylaminophenylacetylene) was too conductive at 100 percent RH. Of the gases tested, the only ones that gave any evidence of interacting with the polymers were SO2, NOx, HCN and NH3. Poly(imidazole)/thiophene responded to each of these gases at all relative humidities, while the other polymers gave varying response, depending upon the RH. Thus, since most of these gases were electron-accepting, the electron-donating character of poly(imidazole)/thiophene substantiates the concept of electronegativity being the operating principle for interaction effects. Of the six polymers prepared, poly(imidazole)/thiophene first showed a very good response to smoldering cotton, but it later became nonresponsive; presumably due to oxidation effects.

Byrd, N. R.↗

A discussion of dynamic stability measurement techniques

Techniques for the measurement of the dynamic stability of linear systems are discussed. Particular attention is given to an analysis of the errors in the procedures, and to methods for calculating the system damping from the data. The techniques discussed include: transient decay, moving block analysis, spectral analysis, random decrement signatures, transfer function analysis, and parameter identification methods. The special problems of rotorcraft dynamic stability testing are discussed.

Johnson, W.↗

ROSAT data analysis with EXSAS

For the x-ray observatory ROSAT, data from survey and pointed mission phases taken with different focal plane instruments and according to a complex mission timeline have to be handled. Data analysis therefore puts high demands on appropriate software tools. With EXSAS - the Extended Scientific Analysis System developed with an effort of 20 man years by the German ROSAT Scientific Data Center - a comfortable system for the reduction of data from the ROSAT x-ray and XUV instruments has been made available. EXSAS comprises a large collection of application modules as typically required in analyzing data of this wavelength regime and runs as a specific context in the wide-spread ESO-MIDAS environment. EXSAS, completely written in FORTRAN 77, takes full advantage of all the standards used in MIDAS and therefore, reflects the same portability (different UNIX installations and VMS). If required, the FORTRAN code also enables users to adapt the software in an easy way to their specific needs. To maintain independence from the specifics of different operating systems also on the data input side, all ROSAT data redistributed in the widely accepted FITS format. Although EXSAS has been developed specifically for data analysis of the ROSAT instruments, its structural design is sufficiently general to serve equally well also data from other X-ray and XUV instruments. EXSAS analysis modules are grouped into 4 application packages dealing with Data Preparation and Instrument Correction, Spatial Analysis, Spectral Analysis and Timing Analysis. A special EXSAS header, read and updated by each application, maintains the general information transfer on the origin, the history and the parameter space of the data stored in tables and images. About 100 genuine commands (most of which offer several additional options) allow to interactively explore the functionality of the system. Up to now 40 institutes all over the world have requested the EXSAS software. Maintenance and regular updates of the software and the comprehensive documentation are provided by the ROSAT Scientific Data Center at Garching.

Zimmermann, H. U.↗

XTE J1946+274 = GRO J1944+26: An Enigmatic Be/X-Ray Binary

XTE J1946+274 = GRO J1944+26 is a 15.8 s Be/X-ray pulsar discovered simultaneously in 1998 September with the Burst and Transient Source Experiment (BATSE) on the Compton Gamma Ray Observatory (CGRO) and the All-Sky Monitor (ASM) on the Rossi X-Ray Timing Explorer (RXTE). Here we present new results from BATSE and RXTE including a pulse timing analysis, spectral analysis, and evidence for an accretion disk. Our pulse timing analysis yielded an orbital period of 169.2 days, a moderate eccentricity 0.33, and implied a mass function of 9.7 solar masses. We observed evidence for an accretion disk, a correlation between measured spin-up rate and flux, which was fitted to obtain a distance estimate of 9.5 +/- 2.9 kpc. XTE J1946+274 remained active from 1998 September to 2001 July, undergoing 13 outbursts that were not locked in orbital phase. Comparing RXTE Proportional Counter Array observations from the initial bright outburst in 1998 and the last pair of outbursts in 2001, we found energy and intensity-dependent pulse profile variations in both outbursts and hardening spectra with increasing intensity during the fainter 2001 outbursts. In 2001 July, optical H alpha observations indicated that a density perturbation appeared in the Be disk as the X-ray outbursts ceased. We propose that the equatorial plane of the Be star is inclined with respect to the orbital plane in this system and that this inclination may be a factor in the unusual outburst behavior of the system.

Wilson, Colleen A.↗

Objective determination of image end-members in spectral mixture analysis of AVIRIS data

Spectral mixture analysis has been shown to be a powerful, multifaceted tool for analysis of multi- and hyper-spectral data. Applications of AVIRIS data have ranged from mapping soils and bedrock to ecosystem studies. During the first phase of the approach, a set of end-members are selected from an image cube (image end-members) that best account for its spectral variance within a constrained, linear least squares mixing model. These image end-members are usually selected using a priori knowledge and successive trial and error solutions to refine the total number and physical location of the end-members. However, in many situations a more objective method of determining these essential components is desired. We approach the problem of image end-member determination objectively by using the inherent variance of the data. Unlike purely statistical methods such as factor analysis, this approach derives solutions that conform to a physically realistic model.

Tompkins, Stefanie↗

Transformation Aids Crop Analysis From Spectral Data

Crop analysis aided by mathematical transformation that optimizes perspective of six-dimensional, six-band, spectral data taken from spacecraft or aircraft. Transformation applied to any temperatureclimate vegetated scene, providing direct view of regions of data concentration resulting from band correlations and fundamental reflectance properties of scene classes. Almost all of data variability captured in three spectral features, thus reducing by factor of 2 number of spectral features carried, incurring minimal loss of important information. Three-dimensional representation with two principal planes retains about 95 percent of six-dimensional spectral data used to distinguish among scenes containing green plants and bare soil with varying degrees of moisture.

Crist, E. P.↗

Simulation of gamma-ray spectra for a variety of user-specified detector designs

The gamma-ray spectrum simulation program BSIMUL was designed to allow the operator to follow the path of a gamma-ray through a detector, shield and collimator whose dimensions are entered by the operator. It can also be used to simulate spectra that would be generated by a detector. Several improvements have been made to the program within the last few months. The detector, shield and collimator dimensions can now be entered through an interactive menu whose options are discussed below. In addition, spectra containing more than one gamma-ray energy can now be generated with the menu - for isotopes listed in the program. Adding isotopes to the main routine is also quite easy. Subroutines have been added to enable the operator to specify the material and dimensions of a collimator. This report details the progress made in simulating gamma-ray spectra for a variety of user-specified detector designs. In addition, a short discussion of work done in the related areas of pulse shape analysis and the spectral analysis is included. The pulse shape analysis and spectral analysis work is being performed pursuant to the requirements of contract F-94-C-0006, for the Advanced Research Projects Agency and the U.S. Air Force.

Rester, A. C., Jr.↗

Quantitative Analysis of Spectral Interference of Spontaneous Raman Scattering in High-Pressure Fuel-Rich H2-Air Combustion

We present a theoretical study of the spectral interferences in the spontaneous Raman scattering spectra of major combustion products in 30-atm fuel-rich hydrogen-air flames. An effective methodology is introduced to choose an appropriate line-shape model for simulating Raman spectra in high-pressure combustion environments. The Voigt profile with the additive approximation assumption was found to provide a reasonable model of the spectral line shape for the present analysis. The rotational/vibrational Raman spectra of H2, N2, and H2O were calculated using an anharmonic-oscillator model using the latest collisional broadening coefficients. The calculated spectra were validated with data obtained in a 10-atm fuel-rich H2-air flame and showed excellent agreement. Our quantitative spectral analysis for equivalence ratios ranging from 1.5 to 5.0 revealed substantial amounts of spectral cross-talk between the rotational H2 lines and the N2 O-/Q-branch; and between the vibrational H2O(0,3) line and the vibrational H2O spectrum. We also address the temperature dependence of the spectral cross-talk and extend our analysis to include a cross-talk compensation technique that removes the nterference arising from the H2 Raman spectra onto the N2, or H2O spectra.

Kojima, Jun↗

NGC7009: Testing the Wind-Wind Interaction Formation of Planetary Nebulae

We have successfully obtained the XMM-Newton observations of NGC 7009. X-ray emission is detected from the interior of NGC 7009, and it is definite resolved, indicating a plasma emission. We have carried out both a spatial analysis and a spectral analysis. The spatial analysis is limited by the angular resolution of the telescope. It is possible to confirm the existence of diffuse emission from hot gas, but the detailed distribution of the hot gas and the amount of stellar emission cannot be determined. The spectral analysis shows that the plasma temperature is only about 2 x 10(exp 6) K. This is the coolest PN interior ever detected. A mixing of shocked fast stellar wind and the cool nebular material is needed. The results of our analysis have been reported in a paper published in the Astronomy and Astrophysics Letters, as given below.

Chu, You-Hua↗

Spectral mixture analysis of multispectral thermal infrared images

Remote spectral measurements of light reflected or emitted from terrestrial scenes is commonly integrated over areas sufficiently large that the surface comprises more than one component. Techniques have been developed to analyze multispectral or imaging spectrometer data in terms of a wide range of mixtures of a limited number of components. Spectral mixture analysis has been used primarily for visible and near-infrared images, but it may also be applied to thermal infrared data. Two approaches are reviewed: binary mixing and a more general treatment for isothermal mixtures of a greater number of components.

Gillespie, Alan R.↗

Power spectral density analysis of the electromyogram from a work task performed in a full pressure suit

Surface electromyograms (EMG) taken from three upper torso muscles during a push-pull task were analyzed by a power spectral density technique to determine the utility of the spectral analysis for identifying changes in the EMG caused by muscular fatigue. The results confirmed the value of the frequency analysis for identifying fatigue producing muscular performance. Data revealed reliable differences between muscles in fatigue induced responses to various locations in the reach envelope at which the subjects were required to perform the push-pull exercise, and the differential sensitivity of individual muscles to the various reach positions; i.e., certain reach positions imposed more fatigue related shifts in EMG power than did others. It was found that a pressurized space suit changed the pattern of normal shirtsleeve muscle fatigue responses in all three of the muscles.

Lafevers, E. V.↗

A spectral energetics analysis of atmospheric blocking

The spectral energetics of two blocking case studies from the winter of 1978-79 are calculated. One case occurred over the North Atlantic and the other over the North Pacific. The temporal evolution and geographical distribution of the energetics of the planetary-scale (zonal harmonic wavenumbers 1-4) and the intermediate-scale (wavenumbers 5-10) wave ensembles are examined to identify the physical mechanisms important in the blocking process. The Atlantic block was forced by the nonlinear interaction of intense baroclinic cyclone-scale waves with barotropic, ultralong waves. The Pacific blocking resulted from the baroclinic amplification of planetary-scale waves. In addition, at least two necessary conditions are required for the development of blocking. First, one of the forcing mechanisms must be in operation, and second, the phase of the antecedent planetary-scale waves must be such that the forcing mechanism can amplify them into a blocking pattern. In each of the cases studied, the blocking developed downstream of intense intermediate- or large-scale cyclogenesis.

Hansen, A. R.↗