Search NASA⌕ Search

SEARCH · Search NASA

Results for “STALLING - PREVENTION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Force and pressure measurements on an airfoil oscillating through stall, part 2

Details of force, moment, and pressure distributions on a two dimensional, four foot chord, NACA 0012 airfoil, oscillating in pitch through stall, in a 7 ft. x 10 ft. low speed wind tunnel, are presented. Tests were run with the airfoil in a closed test section and also in a test section having four longitudinal slots in each sidewall set to provide minimum tunnel interference on the wing in steady flow. In unsteady flow, differences between the results for the closed and 2% open case are small. The dynamic stall process is not triggered by the bursting of a laminar separation bubble but rather by the separation of the turbulent boundary layer downstream of the bubble.

Parker, A. G.↗
NASA NTRS1976

Force and pressure measurements on an airfoil oscillating through stall

Details of force, moment, and pressure distributions on a two-dimensional, 4-ft chord, NACA 0012 airfoil, oscillating in pitch through stall, in a 7 ft x 10 ft low-speed wind tunnel are presented. Tests were run with the airfoil in a closed test section and also in a test section having four longitudinal slots in each sidewall set to provide minimum tunnel interference on the wing in steady flow. In steady flow, differences between the results for the closed and 2% open case are small. The dynamic stall process is not triggered by the bursting of a laminar separation bubble but rather by the separation of the turbulent boundary layer downstream of the bubble.

Parker, A. G.↗
NASA NTRS1976

Stall flutter and nonlinear divergence of a two-dimensional flat plate wing

Tests were conducted in a small wind tunnel to study the torsional stall flutter behavior of a two-dimensional flat-plate wing pivoted about the midchord. The nonlinear static divergence equilibrium properties of the wing were well predicted from the measured static moment characteristics. Large amplitude limit cycles ranging from plus or minus 11 degrees to plus or minus 100 degrees were observed. Stall flutter occurred above a critical value of a reduced frequency of about 2. Self-excitation occurred for initial angles of attack between 0 and 8 degrees. Nondimensional harmonic coefficients were extracted from the free transient vibration tests for amplitudes up to 80 degrees.

Dugundji, J.↗
NASA NTRS1976

The effect of varying freestream velocity on dynamic stall characteristics

A low speed wind tunnel equipped with an axial gust generator to simulate the aerodynamic environment of a helicopter rotor was used to study the dynamic stall of a pitching blade. The objective of this investigation was to find out to what extent harmonic velocity perturbations in the freestream affect dynamic stall. The study involved making measurements of the aerodynamic moment on a two-dimensional, pitching blade model in both constant and pulsating airstreams. Using an operational analog computer to perform on-line data reduction, plots of moment versus angle of attack and work done by the moment were obtained. The data taken in the varying freestream were then compared to constant freestream data, and to the results of two analytical methods. These comparisons showed that the velocity perturbations had a significant effect on the pitching moment which could not be consistently predicted by the analytical methods, but had no drastic effect on the blade stability.

Pierce, G. A.↗
NASA NTRS1977

Laser velocimeter systems analysis applied to a flow survey above a stalled wing

A laser velocimeter operating in the backscatter mode was used to survey the flow above a stalled wing. Polarization was used to separate the two orthogonal velocity components of the fringe-type laser velocimeter, and digital counters were used for data processing. The velocities of the kerosene seed particles were measured with less than 2 percent uncertainty. The particle velocity measurements were collected into histograms. The flow field survey was carried out above an aspect-ratio-8 stalled wing with an NACA 0012 section. The angle of attack was 19.5 deg, the Mach number was 0.49, and the Reynolds number was 1,400,000. The flow field was characterized by the periodic shedding of discrete vortices from near the crest of the airfoil.

Young, W. H., Jr.↗
NASA NTRS1978

Simulation study of the oscillatory longitudinal motion of an airplane at the stall

Hybrid simulation of the longitudinal motion of a straight-wing airplane at the stall was studied to investigate the effect of hysteresis in the development of lift and pitching moments on the wing as a function of angle of attack on the occurrence of longitudinal oscillations at the stall. Flight data for the simulated airplane and for various other airplanes are shown for the simulated airplane and for comparison. The results show that oscillations similar to those measured in flight may be obtained by incorporating hysteresis in the lift and pitching-moment curves.

Phillips, W. H.↗
NASA NTRS1978

Analysis of supersonic stall bending flutter in axial-flow compressor by actuator disk theory

An analytical model was developed for predicting the onset of supersonic stall bending flutter in axial-flow compressors. The analysis is based on two-dimensional, compressible, unsteady actuator disk theory. It is applied to a rotor blade row by considering a cascade of airfoils. The effects of shock waves and flow separation are included in the model. Calculations show that the model predicts the onset, in an unshrouded rotor, of a bending flutter mode that exhibits many of the characteristics of supersonic stall bending flutter. The validity of the analysis for predicting this flutter mode is demonstrated.

Adamczyk, J. J.↗
NASA NTRS1979

The prediction of two-dimensional airfoil stall progression

A generalized boundary condition potential flow calculation method was combined with a momentum integral boundary layer method and a base flow theory of separation to predict airfoil viscous-inviscid interference up to and beyond stall. The resultant program considers laminar and turbulent separation and is, therefore, applicable to thin or thick airfoil stall. The calculated flow field includes the airfoil and the separation bubble recombination region behind the airfoil. Calculated pressure distributions and equivalent airfoil shapes, including the displacement thickness of the viscous regions, are compared with flow field measurements for several airfoils. The measured displacement thicknesses and wake centerlines corroborate the calculated shape. The comparison also suggests the use of the analytical solution to evaluate the measurements.

Gross, L. W.↗
NASA NTRS1981

Testing and evaluation of a stall-flutter-suppression system for helicopter rotors using individual-blade-control

The development and testing of a feedback system designed to alleviate the violent blade first torsion mode oscillations associated with stall flutter are described. The system, based on previously developed M.I.T. Individual-Blade-Control hardware, employs blade-mounted accelerometers to sense torsional oscillations and feeds back rate informaton to increase the damping of the first torsion mode. A linear model of the blade and control system dynamics is developed and is used to give qualitative and quantitative guidance in the design process as well as to aid in analysis of experimental results. System performance in wind tunnel tests, both in hover and forward flight, is described, and evidence is given of the system's ability to provide substantial additional damping to stall-induced blade oscillations.

Quackenbush, T. R.↗
NASA NTRS1978

Two-dimensional dynamic stall as simulated in a varying freestream

A low speed wind tunnel equipped with a axial gust generator to simulate the aerodynamic environment of a helicopter rotor was used to study the dynamic stall of a pitching blade in an effort to ascertain to what extent harmonic velocity perturbations in the freestream affect dynamic stall. The aerodynamic moment on a two dimensional, pitching blade model in both constant and pulsating airstream was measured. An operational analog computer was used to perform on-line data reduction and plots of moment versus angle of attack and work done by the moment were obtained. The data taken in the varying freestream were then compared to constant freestream data and to the results of two analytical methods. These comparisons show that the velocity perturbations have a significant effect on the pitching moment which can not be consistently predicted by the analytical methods, but had no drastic effect on the blade stability.

Pierce, G. A.↗
NASA NTRS1981

Supersonic stall flutter of high-speed fans

An analytical model is proposed for predicting the onset of supersonic stall bending flutter in high-speed rotors. The analysis is based on a modified two-dimensional, compressible, unsteady actuator disk theory. The stability boundary predicted by the analysis is shown to be in good agreement with the measured boundary of a high speed fan. The prediction that the flutter mode would be a forward traveling wave sensitive to wheel speed and aerodynamic loading is confirmed by experimental measurements. In addition, the analysis shows that reduced frequency and dynamic head also play a significant role in establishing the supersonic stall bending flutter boundary of an unshrouded fan.

Adamczyk, J. J.↗
NASA NTRS1982

Analytical investigation of nonrecoverable stall

A lumped parameter model of the TF34 engine is formulated to study nonrecoverable stall. Features of the model include forward and reverse flow, radial flow in the fan, and variable corrected speed. The purpose of the study is to point out those parameters to which recoverability is highly sensitive but are not well known. Experimental research may then be directed toward identification of the parameters in that category. Compressor performance in the positive flow region and radial flow in the fan are shown to be important but unknown parameters determining recoverability. Other parameters such as compressor performance during reverse flow and in-stall efficiency have relatively small impact on recoverability.

Wenzel, L. M.↗
NASA NTRS1981

A simple system for helicopter Individual-Blade-Control and its application to stall flutter suppression

A new, advanced type of active control for helicopters and its application to a system for stall flutter suppression is described. The system, based on previously developed M.I.T. Individual-Blade-Control hardware, employs blade-mounted accelerometers to sense torsional oscillations and feeds back rate information to increase the damping of the first torsion mode. A linear model of the blade and control system dynamics is used to give qualitative and quantitative guidance in the design process as well as to aid in analysis of experimental results. System performance in wind tunnel tests is described, and evidence is given of the system's ability to provide substantial additional damping to stall-induced blade oscillations.

Ham, N. D.↗
NASA NTRS1981

A simple system for helicopter individual-blade-control and its application to stall-induced vibration alleviation

A new, advanced type of active control for helicopters and its application to a system for stall flutter suppression is described. The system, based on previously developed M.I.T. Individual-Blade-Control hardware, employs blade-mounted accelerometers to sense torsional oscillations and feeds back rate information to increase the damping of the first torsion mode. A linear model of the blade and control system dynamics is used to give qualitative and quantitative guidance in the design process as well as to aid in analysis of experimental results. System performance in wind tunnel tests is described and evidence is given of the system's ability to provide substantial additional damping to stall-induced blade oscillations.

Ham, N. D.↗
NASA NTRS1982

Stall induced instability of a teetered rotor

Recent tests on the 38m Mod-0 horizontal experimental wind turbine yielded quantitative information on stall induced instability of a teetered rotor. Tests were conducted on rotor blades with NACA 230 series and NACA 643-618 airfoils at low rotor speeds to produce high angles of attack at relatively low wind speeds and power levels. The behavior of the rotor shows good agreement with predicted rotor response based on blade angle of attack calculations and airfoil section properties. The untwisted blades with the 64 series airfoil sections had a slower rate of onset of rotor instability when compared with the twisted 230 series blades, but high teeter angles and teeter stop impacts were experienced with both rotors as wind speeds increased to produce high angles of attack on the outboard portion of the blade. The relative importance of blade twist and airfoil section stall characteristics on the rate of onset of rotor unstability with increasing wind speed was not established however. Blade pitch was shown to be effective in eliminating rotor instability at the expense of some loss in rotor performance near rated wind speed.

Glasgow, J. C.↗
NASA NTRS1983

Laser holographic interferometry for an unsteady airfoil in dynamic stall

Laser holographic interferometry was used to study a two-dimensional NACA 0012 airfoil undergoing dynamic stall. The airfoil, fabricated from graphite fiber and epoxy, was tested at Mach numbers of 0.3 to 0.6, at Reynolds numbers of 500,000-2,000,000, at reduced frequencies of 0.015 to 0.15, and at mean angles of attack of 0-10 deg with amplitudes of 10 deg. Density and pressure fields were obtained from dual-plate interferograms. Double-pulse interferograms, which seemed to show the wake boundaries better, were also taken. Comparisons of pressures with orifice pressures were good for the attached flow cases. For the separated flow cases, which had a vortex enbedded in the flow, the comparisons were poor. Vortices, wake structures, and the dynamic stall process can be seen by holographic interferometry.

Lee, G.↗
NASA NTRS1983

The effect of a leading-edge slat on the dynamic stall of an oscillating airfoil

The dynamic stall characteristics of a slatted airfoil were investigated experimentally on a 2-ft-chord airfoil oscillating in pitch at M = 0.2 for a range of reduced frequency and mean angle of oscillation. The slat produced a flow that remained attached to the airfoil for angles well above those normally attained by the retreating blade of a helicopter during high speed flight. The dynamic stall vortex usually associated with these flight conditions was completely eliminated for all angles under 30 deg. Instantaneous surface pressure, lift, and pitching moment data are presented as a function of incidence throughout the oscillation cycle; a detailed analysis of instantaneous boundary-layer flow behavior for the various test conditions is included.

Carr, L. W.↗
NASA NTRS1984

Determination of compressor in-stall characteristics from engine surge transients

A technique for extracting the in-stall pumping characteristics for an axial flow compressor operating in an engine system environment is developed. The technique utilizes a Hybrid computer simulation of the compressor momentum equation into which actual transient data are used to provide all terms but the desired compressor characteristic. The compressor force characteristic as a function of corrected flow and speed result from the computation. The critical problem of data filtering is addressed. Results for a compressor operating in a turbofan engine are presented and comparison is made with the conventional compressor map. The relationship of the compressor surge characteristic with its rotating stall characteristic is explored. Initial interpretation of the measured results is presented.

Lorenzo, C. F.↗