SEARCH · Search NASA

Results for “Saturation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12

All sources NASA NTRS DOE OSTI

NASA NTRS1972

On the definition of crater saturation diameter

A theoretical model is developed for determining the diameter D sub p such that the density of lunar craters exceeding D sub p constitutes a specified proportion p of the maximum number that could be observed on a crater-saturated surface. It is shown that this diameter is sensitive to the value of the exponent in the fresh crater size distribution, and is much more informative than usual log-log plot intercept definition of satureation diameter.

Marcus, A. H.↗

NASA NTRS1975

Saturation spectrum of the parametric decay instability in the presence of an external magnetic field

The effects of an external magnetic field on the saturation spectrum of parametric decay instabilities is examined by means of a modification of the Kuo and Fejer (1972) analysis. The main effect of the magnetic field is shown to be a decrease of the wavenumber with increasing angle between the wave vector and the magnetic field, particularly when the pump frequency is near the second harmonic of the cyclotron frequency. The spread of the phase velocities as measured in the direction of the magnetic field is significantly greater in the saturation spectrum when the pump frequency is near the second harmonic of the cyclotron frequency, facilitating the acceleration of tail electrons to energies of a few electron volts. It is suggested that this effect accounts for the greatly enhanced airglow observed (Haslett and Megill, 1974) under these conditions.

Chen, H. C.↗

NASA NTRS1976

Measurements of solar magnetic fields by Fourier transform techniques. II - Saturated and blended lines

Fourier techniques have been exhaustively calibrated using Unno's (1956) results for the absorption profile of a simple Zeeman triplet. If a simple transformation is applied to the normalized line depths, then magnetic-field strengths and inclination angles can be measured very accurately from noisy saturated line profiles. Systematic errors caused by saturation effects can be estimated and reduced by varying one parameter. When a significant fraction of the line profile is unsplit and unpolarized, large errors may be made in measurements of low fields, unless the line is sufficiently weak. For a weak line, a vertical field of 1600 gauss can be measured to 10% accuracy even when 70% of the line profile is stray light. These stray-light errors are troublesome in measuring fields of gaps and pores but not sunspots. Numerical results of the error analysis are presented graphically.

Tarbell, T. D.↗

NASA NTRS1978

Diode laser saturation spectroscopy of NH3

Saturation of molecular transitions using a tuneable diode laser was demonstrated for the first time using a standing-wave cavity configuration with an f/8 beam focussed at the sample. Observed saturation effects in NH3 transitions near 888/cm include sub-Doppler (Lamb-dip) resonances at line center.

Jennings, D. E.↗

NASA NTRS1978

Absolute flux density calibrations: Receiver saturation effects

The effect of receiver saturation was examined for a total power radiometer which uses an ambient load for calibration. Extension to other calibration schemes is indicated. The analysis shows that a monotonic receiver saturation characteristic could cause either positive or negative measurement errors, with polarity depending upon operating conditions. A realistic model of the receiver was made by using a linear-cubic voltage transfer characteristic. The evaluation of measurement error for this model provided a means for correcting radio source measurements.

Freiley, A. J.↗

NASA NTRS1978

Saturation of fluorescence in flames with a Gaussian laser beam

The method of saturated fluorescence for measuring species concentrations in flames is usually performed with laser beams that do not provide a constant intensity distribution across the focal volume. Because of the intensity distribution across the beam, the fluorescence signal does not depend on laser power or intensity in the same manner as for uniform illumination. This leads to anomolous apparent saturation intensities. In the following, the effect is considered for atomic fluorescence. Relations for the fluorescence signal under two common excitation geometries are derived and uncertainty relations used to consider the benefits of high laser intensity.

Daily, J. W.↗

NASA NTRS1975

The saturated activities of Na-22, Mn-54, and Co-56 and the depth of sampling of soils

A multivariate linear regression study shows that the saturated activities of Na-22, Co-56, and Mn-54 are functions of the chemical composition and the reciprocal of the cube root of the sample weight. A procedure for taking the temporal variation in these short-lived radionuclides into account is described. The regression results are used to estimate the average depths of sampling of soil material. The data indicate that all 28 samples were in the same conditions of exposure when recovered as they had been for the last approximately 10 years. The saturation activity of Mn-54 is a very weak function of time.

Keith, J. E.↗

NASA NTRS1978

Saturated absorption in NH3 demonstrated using a tuneable diode laser

Saturation of molecular transitions using a tunable diode laser has been demonstrated for the first time using a standing-wave-cavity configuration with the laser beam focused at the sample. Observed saturation effects in NH3 transitions near 888 kaysers include sub-Doppler (Lamb-dip) resonances at the line center.

Jennings, D. E.↗

NASA NTRS1979

Predicting dynamic performance limits for servosystems with saturating nonlinearities

A generalized treatment for a system with a single saturating nonlinearity is presented and compared with frequency response plots obtained from an analog model of the system. Once the amplitude dynamics are predicted with the limit lines, an iterative technique is employed to determine the system phase response. The saturation limit line technique is used in conjunction with velocity and acceleration limits to predict the performance of an electro-hydraulic servosystem containing a single-stage servovalve. Good agreement was obtained between predicted performance and experimental data.

Webb, J. A., Jr.↗

NASA NTRS1979

Efficiency enhancement of dual-mode traveling wave tubes at saturation and in the linear range by use of spent-beam refocusing and multistage depressed collectors

An axisymmetric, multistage depressed collector of fixed geometric design was evaluated in conjunction with an octave-bandwidth, dual-mode TWT. The TWT was operated over a wide range of conditions to simulate different applications. The collector was operated in three-, four-, and five-stage configurations, and its performance was optimized (within the constraint of fixed geometric design) over the range of TWT operating conditions covered. For operation of the dual-mode TWT at and near saturation, the collectors increased the TWT overall efficiency by a factor of 2 1/2 to 3 1/2. Collector performance was relatively constant for both the high and low TWT modes and for operation of the TWT across an octave bandwidth. For operation of the TWT in the linear, low-distortion range, collector efficiencies of 90 percent and greater were obtained, leading to a five- to twelvefold increase in the TWT overall efficiency for the range of operating conditions covered and reasonably high (greater than 25 percent) overall efficiencies well below saturation.

Ramins, P.↗

NASA NTRS1980

Effects of various assumptions on the calculated liquid fraction in isentropic saturated equilibrium expansions

The saturated equilibrium expansion approximation for two phase flow often involves ideal-gas and latent-heat assumptions to simplify the solution procedure. This approach is well documented by Wegener and Mack and works best at low pressures where deviations from ideal-gas behavior are small. A thermodynamic expression for liquid mass fraction that is decoupled from the equations of fluid mechanics is used to compare the effects of the various assumptions on nitrogen-gas saturated equilibrium expansion flow starting at 8.81 atm, 2.99 atm, and 0.45 atm, which are conditions representative of transonic cryogenic wind tunnels. For the highest pressure case, the entire set of ideal-gas and latent-heat assumptions are shown to be in error by 62 percent for the values of heat capacity and latent heat. An approximation of the exact, real-gas expression is also developed using a constant, two phase isentropic expansion coefficient which results in an error of only 2 percent for the high pressure case.

Bursik, J. W.↗

NASA NTRS1982

Density measurement in air with saturable absorbing seed gas

Approaches which have the potential to make density measurements in a compressible flow, where one or more laser beams are used as probes, were investigated. Saturation in sulfur hexafluoride iodine and a crossed beam technique where one beam acts as a saturating beam and the other is at low intensity and acts as a probe beam are considered. It is shown that a balance between an increase in fluorescence intensity with increasing pressure from line broadening and the normal decrease in intensity with increasing pressure from quenching can be used to develop a linear relation between fluorescence intensity and number density and lead to a new density measurement scheme. The method is used to obtain a density image of the cross section of an iodine seeded underexpanded supersonic jet of nitrogen, by illuminating the cross section by a sheet of laser light.

Baganoff, D.↗

NASA NTRS1982

Gain saturation in semiconductor lasers - Theory and experiment

The semiconductor stimulated gain saturation model of Zee has been extended using reasonable approximations to obtain an analytical solution for the gain saturation process in PbSnTe and to determine the limit to single mode power directly from the gain expression, the intraband relaxation time, and device and material parameters. The theoretical results are compared with experimental observations for single transverse mode cavity narrow stripe buried heterostructure PbSnTe lasers. Those results are interpreted in terms of an intraband relaxation time on the order of 2 x 10 to the -12th s in the temperature range 20-80 K.

Kasemset, D.↗

NASA NTRS1982

Sulfide saturation of basalt and andesite melts at high pressures and temperatures

When the sulfur content of an Fe-bearing magma exceeds the saturation limit for the bulk composition, an immiscible iron sulfide melt fraction separates. For an understanding of the geochemistry of sulfur-bearing magmatic systems, more information is needed regarding the solubility of metal sulfide in silicate melt at its source and the solubility changes as a function of changing intensive and extensive variables. In the present investigation, the sulfur saturation surface is determined for the pressure range from 12.5 to 30 kbar and the temperature range from 1300 to 1460 C for three silicate melt compositions representing a range of SiO2 and FeO compositions.

Wendlandt, R. F.↗

NASA NTRS1983

Saturation of the lower-hybrid-drift instability by mode coupling

A nonlinear mode-coupling theory of the lower-hybrid-drift instability is presented. It is found that the instability saturates by transferring energy from the growing, long wavelength modes to the damped, short wavelength modes. The saturation energy, mean square of the potential fluctuations, and diffusion coefficient are calculated self-consistently.

Drake, J. F.↗

NASA NTRS1983

Particle-sampling statistics in laser anemometers Sample-and-hold systems and saturable systems

The effect of the data-processing system on the particle statistics obtained with laser anemometry of flows containing suspended particles is examined. Attention is given to the sample and hold processor, a pseudo-analog device which retains the last measurement until a new measurement is made, followed by time-averaging of the data. The second system considered features a dead time, i.e., a saturable system with a significant reset time with storage in a data buffer. It is noted that the saturable system operates independent of the particle arrival rate. The probabilities of a particle arrival in a given time period are calculated for both processing systems. It is shown that the system outputs are dependent on the mean particle flow rate, the flow correlation time, and the flow statistics, indicating that the particle density affects both systems. The results are significant for instances of good correlation between the particle density and velocity, such as occurs near the edge of a jet.

Edwards, R. V.↗

NASA NTRS1983

Use of olivine and plagioclase saturation surfaces for the petrogenetic modeling of recrystallized basic plutonic systems

During petrogenetic studies of basic plutonic rocks, there are at least three major questions to be considered: (1) what were the relative proportions of cumulate crystals and intercumulus melt in a given sample? (2) what is the composition and variation in composition of the melts within the pluton? and (3) what is the original composition of the liquids, their source and evolution prior to the time of emplacement? Use of both saturation surfaces can place strong limits on the compositions of potential cumulate phases and intercumulus melts. Consideration of appropriate trace elements can indicate whether a sample is an orthocumulate, adcumulate or mesocumulate. Thus, when trace element and petrographic data are considered together with the saturation surfaces, it should be possible to begin to answer the three major questions given above, even for strongly recrystallized basic plutons.

Hanson, G. N.↗

NASA NTRS1984

Saturation Phenomena in LIF Measurements, Appendix B

Optical saturation is the phenomenon in which the laser-induced rates of absorption and spontaneous emission between two levels, induced by a laser, become comparable to or greater than the spontaneous emission and collision rates connecting these levels. This results in the excited state population N(u) acquiring a value of similar magnitude to that of the ground state, N(e). Under these conditions the observed fluorescence signal, which is proportional to N(u), is no longer linearly dependent on laser intensity I, but increases at a slower rate, and in principle ultimately becomes independent of I. A conceptual picture of optical saturation using a two-level picture is described. This is, however, inadequate for the description of a real experiment involving a molecule, such as OH, for several reasons, which will be explained briefly; these are the multi-level nature of the electronic states and energy transfer among them and effects due to spatial, spectral, and temporal fluctuations in the laser pulse.

Source record↗