Search NASA⌕ Search

SEARCH · Search NASA

Results for “Stand”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12

The formation of a standing shock in a polytropic solar wind model within 1-10 Rs

It is shown how a one-fluid polytropic solar wind model exhibits properties similar to an isothermal wind when localized momentum and/or rapid area divergence produce multiple critical points in the flow. In particular, it is shown that when the sonic transition in the flow occurs closer to the coronal base, multiple steady solutions can exist. These multiple steady solutions consist of a contiuous solution passing through the innermost critical point and other steady solutions involving a steady shock transition. By following the temporal evolution of the solar wind from a steady state with one critical point to a steady state with three critical points, it is shown that a standing shock solution is more likely to develop than a continuous solution when momentum deposition occurs close to the coronal base and the equation of motion admits multiple steady solutions. This result is particularly relevant to the solar wind when momentum deposition occurs as a result of a rapidly diverging coronal hole geometry.

Habbal, S. R.↗

Force on a heated sphere in a horizontal plane acoustic standing wave field

The force on a heated sphere in a horizontal plane acoustic standing wave field is the subject of this investigation. The heated sphere produces a thermal gradient in the resonance chamber. The force on the sphere in a direction perpendicular to that of gravity is measured. This force is enhanced in the region near the pressure node, and is weakened in the region near the pressure antinode. Measurements of the force on a heated sphere with sound pressure levels between 148 and 156 dB are presented.

Leung, E. W.↗

Status of DOE and AID stand-alone photovoltaic system field tests

The NASA Lewis Research Center (LeRC) is managing stand-alone photovoltaic (PV) system projects sponsored by the U.S. Department of Energy (DOE) and the U.S. Agency for International Development (AID). The DOE project includes village PV power demonstration projects in Gabon (four sites) and the Marshall Islands, and PV-powered vaccine refrigerator systems in six countries. The AID project includes a large village power system, a farmhouse system and two water pumping-irrigation systems in Tunisia, a water pumping/grain grinding system in Upper Volta, five medical clinic systems in four countries, PV-powered vaccine refrigerator systems in 18 countries and a PV-powered remote earth station in Indonesia. This paper reviews these PV projects and summarizes significant findings to date.

Bifano, W. J.↗

Spectral Characterization of Suspected Acid Deposition Damage in Red Spruce (picea Rubens) Stands from Vermont

In an attempt to demonstrate the utility of remote sensing systems to monitor sites of suspected acid rain deposition damage, intensive field activities, coupled with aircraft overflights, were centered on red spruce stands in Vermont during August and September of 1984. Remote sensing data were acquired using the Airborne Imaging Spectrometer, Thematic Mapper Simulator, Barnes Model 12 to 1000 Modular Multiband Radiometer and Spectron Engineering Spectrometer (the former two flown on the NASA C-130; the latter two on A Bell UH-1B Iroquois Helicopter). Field spectral data were acquired during the week of the August overflights using a high spectral resolution spectrometer and two broad-band radiometers. Preliminary analyses of these data indicate a number of spectral differences in vegetation between high and low damage sites. Some of these differences are subtle, and are observable only with high spectral resolution sensors; others are less subtle and are observable using broad-band sensors.

Vogelmann, J. E.↗

Development of a microprocessor controller for stand-alone photovoltaic power systems

A controller for stand-alone photovoltaic systems has been developed using a low power CMOS microprocessor. It performs battery state of charge estimation, array control, load management, instrumentation, automatic testing, and communications functions. Array control options are sequential subarray switching and maximum power control. A calculator keypad and LCD display provides manual control, fault diagnosis and digital multimeter functions. An RS-232 port provides data logging or remote control capability. A prototype 5 kW unit has been built and tested successfully. The controller is expected to be useful in village photovoltaic power systems, large solar water pumping installations, and other battery management applications.

Millner, A. R.↗

Use of remotely sensed data for assessing forest stand conditions in the Eastern United States

Techniques for the detection, classification, and measurement of forest disturbances, using digital Landsat data for three study areas (Pennsynvania, North Carolina, and Maine) are reported. Results with respect to (1) the delineation and assessment of forest damage due to the use of two forest insect defoliators, and (2) qualitative assessment of the Multispectral Scanner (MSS) and the Thematic Mapper data for delineating forest stand characteristics are presented. Key results include a development of a statewide MSS digital data base and associated image-processing techniques for accurately delineating insect-damaged and healthy forest areas. For classification of broad land-cover classes which are spectrally homogeneous, the accuracy yielded by the use of either MSS data or TM Simulator data is similar. However, the TMS data provided 20 percent accuracy improvement over the MSS results when detailed (Level III) forest classes were mapped.

Williams, D. L.↗

Outdoor test stand performance of a convertible engine with variable inlet guide vanes for advanced rotorcraft propulsion

A variable inlet guide van (VIGV) type convertible engine that could be used to power future high-speed rotorcraft was tested on an outdoor stand. The engine ran stably and smoothly in the turbofan, turboshaft, and dual (combined fan and shaft) power modes. In the turbofan mode with the VIGV open fuel consumption was comparable to that of a conventional turbofan engine. In the turboshaft mode with the VIGV closed fuel consumption was higher than that of present turboshaft engines because power was wasted in churning fan-tip airflow. In dynamic performance tests with a specially built digital engine control and using a waterbrake dynamometer for shaft load, the engine responded effectively to large steps in thrust command and shaft torque. Previous mission analyses of a conceptual X-wing rotorcraft capable of 400-knot cruise speed were revised to account for more fan-tip churning power loss than was originally estimated. The new calculations confirm that using convertible engines rather than separate lift and cruise engines would result in a smaller, lighter craft with lower fuel use and direct operating cost.

Mcardle, Jack G.↗

Traveling and standing waves in binary-fluid convection in finite geometries

The effect of finite geometry on the competition between traveling waves and standing waves in systems with a Hopf bifurcation to a state with spatial structure is considered in the linear and weakly nonlinear regimes. The spatial structure observed by Kolodner et al. (1986) in binary-fluid convection is explained in terms of the reflection of the linear traveling waves. The reflection coefficient is calculated, and is found to go to zero as the frequency of the waves becomes small. The pattern expected in a saturated nonlinear state is discussed.

Cross, M. C.↗

Test stand performance of a convertible engine for advanced V/STOL and rotorcraft propulsion

A variable inlet guide vane (VIGV) convertible engine that could be used to power future high-speed V/STOL and rotorcraft was tested on an outdoor stand. The engine ran stably and smoothly in the turbofan, turboshaft, and dual (combined fan and shaft) power modes. In the turbofan mode with the VIGV open, fuel consumption was comparable to that of a conventional turbofan engine. In the turboshaft mode with the VIGV closed, fuel consumption was higher than that of present turboshaft engines because power was wasted in churning fan-tip air flow. In dynamic performance tests with a specially built digital engine control and using a waterbrake dynamometer for shaft load, the engine responded effectively to large steps in thrust command and shaft torque.

Mcardle, Jack G.↗

Parametric analysis of synthetic aperture radar data for characterization of deciduous forest stands

The SAR sensor parameters that affect the estimation of deciduous forest stand characteristics were examined using data sets for the Gulf Coastal Plain region, acquired by the NASA/JPL multipolarization airborne SAR. In the regression analysis, the mean digital-number values of the three polarization data are used as the independent variables to estimate the average tree height (HT), basal area (BA), and total-tree biomass (TBM). The following results were obtained: (1) in the case of simple regression and using 28 plots, vertical-vertical (VV) polarization yielded the largest correlation coefficients (r) in estimating HT, BA, and TBM; (2) in the case of multiple regression, the horizontal-horizontal (HH) and VV polarization combination yielded the largest r value in estimating HT, while the VH and HH polarization combination yielded the largest r values in estimating BA and TBM. With the addition of a third polarization, the increase in r values is insignificant.

Wu, Shih-Tseng↗

Test stand performance of a convertible engine for advanced V/STOL and rotorcraft propulsion

A variable inlet guide vane (VIGV) convertible engine that could be used to power future high-speed V/STOL and rotorcraft was tested on an outdoor stand. The engine ran stably and smoothly in the turbofan, turboshaft, and dual (combined fan and shaft) power modes. In the turbofan mode with the VIGV open, fuel consumption was comparable to that of a conventional turbofan engine. In the turboshaft mode with the VIGV closed, fuel consumption was higher than that of present turboshaft engines because power was wasted in churning fan-tip air flow. In dynamic performance tests with a specially built digital engine control and using a waterbrake dynamometer for shaft load, the engine responded effectively to large steps in thrust command and shaft torque.

Mcardle, Jack G.↗

The alpha-effect generated by standing Alfven waves

The mean electromotive force generated by nonlinear standing Alfven waves propagating along the mean magnetic field is investigated. It is shown that the alpha-effect can exist owing to the interaction between oppositely propagating two waves, provided that the initial fields have nonzero helicity. The result is discussed in the context of field-aligned currents and periodic particle flux variations in the earth's magnetosphere.

Namikawa, Tomikazu↗

Stand Alone Pressure Measurement Device (SAPMD) for the space shuttle Orbiter, part 1

The specifications for the Stand Alone Pressure Measurement Device (SAPMD) are as follows: the SAPMD shall measure ambient pressure at the surface of the Orbiter TPS in the range of 0 to 15 pounds per square inch absolute (PSIA). Measurement will begin at solid rocket booster (SRB) ignition as sensed by appropriate vibration sensing elements in the SAPMD. Pressure and corresponding real-time data are to be recorded every one tenth second for 140 seconds and at the end of the recording period, the operation will be discontinued with the data preserved for interrogation subsequent to Orbiter re-entry and landing. The type and size of the battery shall be such as to allow the vibration sensing elements and a real-time clock to be initialized a minimum of 30 day prior to launch and still provide power as necessary to perform the 140 second data recording period after SRB ignition. Battery installation shall be in such a manner as to allow battery replacement without removing the SAPMD from its position or removing more than one TPS tile. The SAPMD must be mounted in specific locations under tile of the TPS. To accommodate such mounting, the absolute maximum physical dimensions much not exceed 6.0 inches in length, 1.5 inches in width, and 0.4 inches in height, and the device shall be of such configuration that it can be bonded to the Orbiter skin at the joint line of two TPS tiles with the pressure sensing port at the surface of the tile. The SAPMD must remain operational in the temperature range of -40 to +85 C and survive storage temperature of -55 to +125 C. The pressure port must withstand 934 C without causing damage to the TPS during entry and must remain functional at 262 C during ascent. The accuracy of the pressure measurement must be plus or minus one-half PSIA over a temperature range of 0 to +36 C. All the specifications were met and verified by prototype testing and documented in the enclosed test data. Four flight-qualified models were fabricated and of these, two were delivered and successfully flown in the cargo bay of STS-26.

Tomlinson, Bill↗

Changes in impedance of Ni electrodes upon standing and cycling

Impedances of Ni electrodes vary with many factors including voltage, cycling, and manufacturer. However, results from Ni/H2 cells being tested for Space Station Freedom show that consistent results are obtained within a group of cells from the same manufacturer if the cells are cycled and stored in the same manner. Impedance changes with storage and cycling are being investigated. Impedances are low in the fully charged state but rise abruptly by several orders of magnitude at a voltage corresponding to a very low state-of-charge. After standing for several months, this increase occurred at a higher voltage, consistent with an increase in structural order during storage which hinders diffusion of protons and reduces high rate capacity. Early measurements on the effects of cycling on Ni/H2 cells being tested for Space Station Freedom show differences between cells from different manufacturers.

Reid, Margaret A.↗

Standing shocks in the inner solar wind

It has been pointed out by several authors that the equations describing rapidly diverging flow in the solar wind and in related astrophysical systems allow for solutions with standing shocks in the acceleration region of the flow. The range of plasma and flow-geometry parameters that allow for such solutions are investigated. It is shown that, for reasonable geometries, shocks can occur only for a very narrow range of flow parameters in the case of the solar wind. Similar results can be expected for related astrophysical systems.

Leer, Egil↗

Spectral line and white-light intensities in the corona in the presence of propagating or standing shocks

The effect of a propagating shock on the H I Ly-alpha line and the polarization brightness in the inner solar wind region is investigated. The shock produces measurable changes in both, and, provided the measurements are made simultaneously, the alteration of the density and velocity across the shock can be derived. For a standing shock, the effect of the Ly-alpha line and the white-light radiation is much smaller.

Esser, Ruth↗

Radar modeling of tropical mangal forest stands

Radar modeling of mangal forest stands in the Sundarbans area of southern Bangladesh is discussed. The modeling uses radar system parameters with forest data on tree height, spacing, biomass, species combinations, and water content (including slightly conductive water) in leaves and trunks of the mangal. For Sundri and Gewa tropical mangal forests, six model components are proposed; the models are required to explain the contributions of various combinations of forest species in the attenuation and scattering of mangal-vegetated nonflooded or flooded surfaces. Statistical data of simulated images have been compared with those of SIR-B images both to refine the modeling procedures and to characterize the model output appropriately. The possibility of delineation of flooded or nonflooded boundaries is discussed.

Wang, Yong↗